• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.12
• /
• pp.2241-2251
• /
• 1992

This work is concerned with the investigation of end effects of a cylinder on a structure where a circular plate is attached to a solid circular cylinder. Three-dimensional elasticity solutions are used in a cylinder whereas the classical thin plate theory is employed for a plate. The end effect of the cylinder on the flexibility and the structural response is demonstrated by several numerical examples.

• Journal of Mechanical Science and Technology
• /
• v.17 no.11
• /
• pp.1628-1637
• /
• 2003

The vortex-induced vibrations of a circular cylinder at low Reynolds (Re) numbers are simulated by applying a method of the two-dimensional computational fluid dynamics coupled with the structural dynamics based on the multi-physics. The fluid solver is first tested on the case of a fixed cylinder at Re$\leq$160, and shows a good agreement with the previous high-resolution numerical results. The present study then reports on the detailed findings concerning the vibrations of an elastic cylinder with two degrees of translational freedom for a number of cases in which Re is fixed at 200, a reduced damping parameter Sg=0.01, 0.1, 1.0, 10.0 and the mass ratio M$\^$*/ = 1, 10.

• Wind and Structures
• /
• v.6 no.5
• /
• pp.347-356
• /
• 2003

Experimental studies on drag reduction of a circular cylinder of diameter D were conducted in the subcritical flow regime at Reynolds numbers in the range $4{\times}10^4{\leq}Re{\leq}10^5$. To shield the cylinder rear surface from the pressure deficit of the unsteady vortex generation in the near wake, two shield plates were attached downstream of the separation points to form a cavity at the base region. The chord of the shield plates, L, ranged from 0.22 to 1.52 D and the cavity width, G, was in the range from 0 to 0.96 D. It is concluded that significant drag reductions from that of a plain cylinder may be achieved by proper sizing of the shield plates and the base cavity. The study shows that using a pair of shield plates at G/D of 0.86 and angular position ${\theta}$ of ${\pm}121^{\circ}$ results in a configuration with percentage drag reduction of 40% for L/D of 0.5, and 55% for L/D of 1.0.

• 한국전산유체공학회:학술대회논문집
• /
• 2005.04a
• /
• pp.51-56
• /
• 2005

A new feedback control system based on system identification is proposed and preliminarily tested on Van der Pol equation which has a similar characteristic to circular cylinder. The same principle is applicable to circular cylinder in a uniform flow for suppresing the vortex shedding. The feedback controller is designed to impose feedback signal at the phase which is located outside the range of lock-on. The lift coefficient (CL) is employed as a feedback signal and the control forcing is given by a rotational oscillation of the cylinder. By applying the feedback control system, the lift coefficient is reduced.

• Proceedings of the KSME Conference
• /
• 2000.04b
• /
• pp.508-513
• /
• 2000

An experimental investigation has been carried out for two circular cylinders having different groove configurations(U and V-shape). The results were compared with those for the smooth circular cylinder. The drag force, mean velocity and turbulent intensity profiles of wake behind the cylinders were measured with varying the Reynolds number $Re=8000{\sim}14,000$ based on the cylinder diameter. As a results, the U-groove circular cylinder was found to be most effective riblet shape with reducing the drag up to 21%. As the Reynolds number increases, the vortex shedding frequency of the grooved cylinders becomes a little larger, compared to the smooth cylinder. The flow visualization using the smoke-wire technique was also carried out to see the flow structure qualitatively.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.20 no.6
• /
• pp.2014-2022
• /
• 1996

Flow characteristics of the wake behind a finite circular cylinder(FC) mounted on a flat plate was experimentally investigated. Three finite cylinder models having aspect ratio (length to diameter ratio, L/D) of 6,10 and 13 were tested in this study. Wake velocity was measured by a hot-wire anemometry at Reynolds number of 20,000, and the results were compared with those of two-dimensional circular cylinder. As a result, the free-end effect on the wake structure becomes more dominant with decreasing the aspect ratio(L/D) of the finite cylinder. Invisid flow entrained into the wake region decreases the turbulence intensity and periodicity of the vortex shedding due to existence of the free end. From spectral analysis and cross correlation of the velocity signals, vortices having 24Hz frequency characteristics are found in the down wash flow just behind the free end. There exists very complicated flow near the free end due to interaction between the entrained flow and streamwise vortices. Vortex formation region is destroyed significantly in the near wake and shows quite different wake structures from those of 2-D cylinder.

• Proceedings of the KSME Conference
• /
• 2008.11b
• /
• pp.2704-2707
• /
• 2008

We perform an active control on flow over a circular cylinder using a synthetic jet at Re=3900. The synthetic jet is issued from a cavity located inside the cylinder, generating a train of vortices near the surface. These vortices interact with and weaken the main vortices, resulting in drag reduction at a high frequency.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.12
• /
• pp.975-982
• /
• 2014

This study evaluates the effect of a heated circular cylinder's size on three-dimensional natural convection in a cubical enclosure. The Rayleigh number was varied between $10^3$ and $10^5$, and the Prandtl number was maintained at 0.7. In this study, the radius of the circular cylinder was changed by 0.1 L within a range of 0.1-0.4 L. The thermal and fluid flow characteristics were regarded to be independent of time in the range of the Rayleigh number and cylinder radius considered in this study. The surface-averaged Nusselt numbers of the cylinder and the enclosure were found to increase with the increase in the radius of the cylinder. The effect of the cylinder's size on natural convection in the enclosure was analyzed across the thermal and flow fields, and the distributions of the Nusselt numbers.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2004.05a
• /
• pp.222-228
• /
• 2004

The effects of rotation on the unsteady laminar flow past a circular cylinder is numerically investigated in the present study. We obtained the numerical solutions for unsteady two-dimensional governing equation for the flow using two different numerical schemes. One is an accurate spectral method and another is finite volume method. Above all, the flow around a stationary circular cylinder is investigated to understand the basic phenomenon of flow separation, bluff body wake. Also, the validation of our own codes, expecially based on FVM, is carried out by the comparison of results obtained from our simulations using two different schemes and previous numerical and experimental studies. By the effect of rotation, the mean lift increases and drag deceases, which well represent the previous study.

• Journal of the Society of Naval Architects of Korea
• /
• v.43 no.3 s.147
• /
• pp.285-293
• /
• 2006

Three-dimensional and time-dependent solution for the fluid flow and heat transfer past a circular cylinder with fins is obtained using accurate and efficient spectral methods. A Fourier expansion with a corresponding uniform grid is used along the circumferential direction. A spectral multi-domain method with a corresponding Chebyshev collocation is used along r-z plane to handle fins attached to the surface of a circular cylinder. At the Reynolds number of 300 based on a cylinder diameter, results with fins are compared with those without fins in order to see the effects of the presence of fins on three-dimensional and unsteady fluid flow and heat transfer past a bluff body. The detail structures of fluid flow and temperature field are obtained as a function of time to investigate how the presence of fins changes heat transfer mechanism related to the vortical structure in the wake region.