• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.9B
• /
• pp.1608-1615
• /
• 1999

In this study, we investigate the inter cell interference of LMDS(Local multipoint Distribution Service) system cell in LMDS system design process. There are several interference sources in LMDS system but we consider co-channel adjacent interference, cross-polarization interference, tx/rx interworking interference as three major factors. As the summation of each interference, C/N is keep 19 dB in 2km range but decreased gradually over 2km. Based on theoretical results, we process the experimental test and get results that C/I=20 dB have to be maintained to transmit the data successfully under rain fall attenuation condition. This experiential results are similar to the theoretical analysis results we examined.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.5
• /
• pp.383-387
• /
• 2002

N-channel metal-ferroelectric-insulator-semiconductor field-effect-transistors (MFISFET's) by using $SrBi_2Ta_2O_9$/Silicon Nitride/Si (100) structure were fabricated. The fabricated devices exhibit comfortable memory windows, fast switching speeds, good fatigue resistances, and long retention times that are suitable for advanced ferroelectric memory applications. The estimated switching time and polarization ($2P_r$) of the fabricated FET measured at applied electric field of 376 kV/cm were less than 50 ns and about 1.5 uC/$\textrm{cm}^2$, respectively. The magnitude of on/off ratio indicating the stored information performance was maintained more than 3 orders until 3 days at room temperature. The $I_DV_G$ characteristics before and after being subjected to $10^11$ cycles of fatigue at a frequency of 1 MHz remained almost the same except a little distortion in off state.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.6
• /
• pp.799-803
• /
• 2018

We demonstrated memory thin-film transistors (MTFTs) with organic ferroelectric polymer poly(vinylidene fluoride-co-trifluoroethylene) and an amorphous oxide semiconducting indium gallium zinc oxide channel on the elastomeric substrate. The dielectric constant for the P(VDF-TrFE) thin film prepared on the elastomeric substrate was calculated to be 10 at a high frequency of 1 MHz. The voltage-dependent capacitance variations showed typical butterfly-shaped hysteresis behaviors owing to the polarization reversal in the film. The carrier mobility and memory on/off ratio of the MTFTs showed $15cm^2V^{-1}s^{-1}$ and $10^6$, respectively. This result indicates that the P(VDF-TrFE) film prepared on the elastomeric substrate exhibits ferroelectric natures. The fabricated MTFTs exhibited sufficiently encouraging device characteristics even on the elastomeric substrate to realize mechanically stretchable nonvolatile memory devices.

• BioChip Journal
• /
• v.12 no.4
• /
• pp.317-325
• /
• 2018

This paper investigated the effects of ionic strength in the medium on a preconcentrator for a protein sample with low concentration. The preconcentration chip was designed and fabricated using a polydimethylsiloxane replica through standard lithophotography. A glass substrate is silanized prior to functionalizing the nanoparticles for self-assembly at a designed region. Due to the overlap of electrical double layers in a nanofluidic channel, a concentration polarization effect can be achieved using an electric field. A nonlinear electrokinetic flow is induced, resulting in the fast accumulation of proteins in front of the induced ionic depletion zone, so called exclusion-enrichment effect. Thus, the protein sample can be driven by electroosmotic flow and accumulated at a specific location. The chip is used to collect fluorescein isothiocyanate-labeled bovine serum albumin (FITC-BSA) diluted in phosphate-buffered saline (PBS) buffer solution. Different concentrations of the buffer media were studied herein. Fluorescence intensity images show that the buffer concentration of 4 mM is more appropriate than all the other ones. The sample of FITC-BSA with an initial concentration of $10{\mu}M$ in the 4 mM PBS solution increases its concentration at the desired region by up to 50 times within 30 min, demonstrating the results in this investigation.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.7 s.110
• /
• pp.694-705
• /
• 2006

In this paper, the linear active phased array antenna system operated in Ku DBS band was designed and experimented. The antenna system was composed of sixteen radiating active channels and Wilkinson power combiners with 16-channel inputs, a stabilizing DC bias and phase control board. Electrical beams of the antenna system can be formed by controling the phase-states of 3-bit digital phase shifter inside each active channel by virtue of the phase control board. The amplitude and phase deviations measured between active channels were less than ${\pm}0.8dB$ and ${\pm}15^{\circ}$, respectively, and the noise figure of each active channel was measured less than 1.2 dB in the operating band. The measured performances of the overall antenna system showed the antenna gain of more than 23.07 dBi and the sidelobe level of less than -11.17 dBc, and the bore-sight cross-polarization level of less than -12.75 dBc in the operating band. Also, by phase-controlling active channels, the beam scan patterns at $10^{\circ},\;20^{\circ},\;30^{\circ}$ were measured, and the losses caused by the corresponding beam scanning were 1.1 dB, 2.5 dB and 3.6 dB from the measurements, respectively.

• Journal of Distribution Science
• /
• v.13 no.6
• /
• pp.79-86
• /
• 2015

Purpose - The cosmetics industry is a traditional high value-added industry in terms of the domestic demand, small batch production systems, exclusive competition, and raw materials highly dependent on overseas countries as well as an oligopolistic market structure. However, new foreign brands and growing consumer awareness of inexpensive products, has triggered a shift. In line with changing lifestyles and the polarization of consumption, the industry faces a new market structure. Among its key characteristics is the cosmetics industry's numerous distribution channels (i.e., department stores, door-to-door sales, online shopping malls, brand shops, and discount stores). Therefore, the study of its distribution channels is essential. Research design, data, and methodology - The study analyzed channel distribution power divided into coercive and non-coercive power. The factors of coercive power included: unilateral request of an increase in commissions, interference in sales by taking advantage of a superior status, unilateral buck-passing at the time of a problem, unilateral request to stop sales activities, and a unilateral business contract; the factors of non-coercive power included favorable payment conditions, offers of various kinds of information, policy on commission reduction, pride in market entrance, and promotion support. In addition, the mediating variable "interdependence" was applied to the execution of department store (or mart) power and their shop conflicts and satisfaction to examine direct and indirect influential power. The methodology was a survey of managers of cosmetics shops in department stores (or marts). The questionnaire, based on a five-point Likert scale, included questions about basic personal information, execution of power, interdependence, conflict, and satisfaction. The study distributed 198 questionnaires and collected 131. Ten questionnaires with missing or hard to analyze data were excluded. Thus, 121 copies were analyzed. Results - According to the analysis, the execution of coercive power by department stores (or marts) did not affect interdependence, but the execution of non-coercive power did. Interdependence did not influence conflict, but did affect satisfaction. Additionally, the analysis revealed direct influential power: the execution of coercive power positively affected conflict and negatively influenced satisfaction; the execution of non-coercive power positively affected satisfaction. Conclusions - To offer suggestions for distribution business relations in the cosmetics industry, this study investigated how the execution of power by department stores (or marts) affected their shops. More specifically, it examined how much the execution of both coercive power and non-coercive power influenced conflict and satisfaction, and analyzed the mediating role of interdependence. In line with previous study results in various areas, coercive power was shown to be the source of conflict, leading to a decrease in satisfaction, whereas non-coercive power significantly positively influenced satisfaction. Moreover, non-coercive power increased interdependence, which led to greater satisfaction. As a result, interdependence had a mediating effect on non-coercive power and satisfaction. Based on the results, department stores (or marts) should look for improvements plans that increase interdependence. Such plans could alleviate conflict with the shops, increasing their satisfaction.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.5 s.108
• /
• pp.461-475
• /
• 2006

In this paper, it is described about the tri-band mobile antenna system design to provide broadband multimedia and direct broadcasting services using goo-stationary Koreasat 3, simultaneously operated in Ka/K/Ku band. The radiating part of the antenna system with a fan beam characteristic in the elevation plane is composed of the quasi-offset dual shaped reflector and the tri-band feeder. The tri-band feeder is also composed of the Ka/K dual band feeder with the protruding dielectric rod, the circular polarizer, the ortho-mode transducer and the circular-polarized Ku band feed array. Especially, the Ka/K dual band circular polarizer was realized firstly using the comb-type structure. For fast satellite-tracking on the movement, the Ku band feed array has the structure of the $2{\times}2$ active phased array which can make electrical beams. And, the circular-polarized characteristic in the feed array was improved by $90^{\circ}$ rotating arrangement of four radiating elements polarized circularly by a $90^{\circ}$ hybrid coupler, respectively. Four beam forming channels to make electrical beams at Ku band are divided into the main beam channel and the tracking beam channel in the output, and noise temperature characteristics of each channel were analyzed on the basis of the contributions of internal sub_units. From the fabricated antenna system, the output power at $P_{1dBc}$ of Ka_Tx channel was measured more than 34.1 dBm and the measured noise figures of K/Ku_Rx channels were less than 2.4 dB and 1.5 dB, respectively, over the operating band. The radiation patterns with co- and cross-polarization in the tri-band were measured using a near-field measurement in the anechoic chamber. Especially, Ku radiation patterns were measured after correcting each initial phase of active channels with partial radiation patterns obtained from the independent excitation of each channel. The antenna gains measured in Ka/K/Ku band of the antenna system were more than 39.6 dBi, 37.5 dBi, 29.6 dBi, respectively. And, the antenna system showed good system performances such as Ka_Tx EIRP more than 43.7 dBW and K/Ku_Rx G/T more than 13.2 dB/K and 7.12 dB/K, respectively.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.8
• /
• pp.1220-1225
• /
• 2009

In this paper, a tunable fiber feedback laser based on the use of Sagnac loop filter and fiber Bragg grating (FBG) is proposed. The Sagnac loop filter using a high birefringence fiber provides precise 0.33-nm channel spacing as a multi-wavelength grid filter. Ni-Cr wire wound on the FBG is useful to induce the thermo-optic effect of the fiber. Two types of FBG structures, which have a different length of wire, are demonstrated to show the wavelength shift and separation. To tune FBG by resistant heat, some current is supplied into the wire. When the wavelength matched with one of the cavity modes of Sagnac loop filter, the mode-locked lasing is occurred. The electrical power sensitivity of the resonant wavelength is measured to 1.75pm/mW. This laser configuration can be applied the electrical power system for monitoring the power fluctuation.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.8
• /
• pp.865-871
• /
• 2010

A compact dual-band(IEEE 802.11b: 2.4~2.5 GHz, 11a: 5.15~5.825 GHz) 2-channel MIMO antenna for PMP applications is presented. The proposed antenna is composed of a planar inverted F-shape antenna(PIFA) operating at 2 GHz band and a loop antenna operating at 5 GHz band. The proposed antenna is orthogonally arranged at the edge of the ground plane for polarization and pattern diversities with excellent isolation characteristics. The two PIFA antennas operating 2 GHz have connecting line($\lambda_g$/4) face to the feed point for high isolation and low correlation at 2 GHz band. The two loop antennas connected each other in the bottom side to improve the isolation at 5 GHz band. The proposed antenna has a sufficient gain in WLAN service band and is compact sized for the portable media player (PMP) applications.

• The Journal of Engineering Geology
• /
• v.10 no.2
• /
• pp.172-188
• /
• 2000

This paper presents the state of art and the role of geophysical exploration techniques with evaluating the trend of domestic and worldwide seawater intrusion research, and illustrates advanced techniques obtained through the project of 'Development of the techniques for estimation, prediction, and prevention of seawater intrusion' funded by the Ministry of Science and Technology of Korea. The advanced geophysical interpretation was achieved by adding the digital geophysical logging data. DC resistivity and TEM monitorings were applied to determine whether or not the seawater intrusion was in progress. Induced Polarization technique using electric current monitoring channel was introduced to discriminate seawater contaminated zone from highly conductive layer caused by clay minerals. A conceptual model was suggested with spatial visualization of the study area to predict the diffusion of seawater contamination. Finally, the future work of the development of geophysical techniques was suggested with the base of the present level of them.