• Journal of the Korean Institute of Navigation
• /
• v.25 no.1
• /
• pp.1-9
• /
• 2001

It is well known that, especially in the case of full-bodied ship, the course stability may become the severest among 4 items of requirement in Interim Standards for Ship Manoeuvrability adopted by IMO in 1993. The purpose of this study is to find some ideas for characteristics of fluid flow pattern around ship's stern in manoeuvring motion with parameter of changes in rudder size. We carried out two kinds of model experiment in obliquely running condition at circulating water channel. One is measurement on straightening effect of incoming flow to rudder and the other is experiment on flow visualization around the gap between rudder and stern-bottom. We discuss the correlation between the flow characteristics around ship's stem and flow straightening effect at rudder from the viewpoint of course stability. As a result, it is clarified that the gap between rudder and stern-bottom plays an important role in course stability of full-bodied ship. It is pointed out that there is quite a possibility of bad course stability as the gap between rudder and stern-bottom decreases.

• Journal of Korea Water Resources Association
• /
• v.46 no.9
• /
• pp.885-896
• /
• 2013

SEMMA (Soil Erosion Model for Mountain Areas) should be revised to apply on mountain watershed of large scale. In this study, the basic structure of original SEMMA and methods to calculate main parameters are reviewed and the revised parameters are presented to expand a range of application. SEMMA-Ic is new model revised by a rate of vegetation cover which is substituted for index of vegetation structure to use specially NDVI for large scale areas. The correlation coefficient and the Nash-Sutcliffe simulation efficiency for the revised model decreased rather than those of original model. However the evaluation of the revised model on watershed showed the approximate simulation with measured sediment yield and the underestimated simulation when sediment yield is large. The additional research for channel erosion is needed so that soil erosion model for hillslopes is used to estimate sediment yield from a watershed.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.258-258
• /
• 2014

Spark discharge in water generates shockwaves which have been utilized to generate mechanical actuation for potential use in pumping application. Discharge pulses of several microseconds generate shockwaves and vapor bubbles which subsequently displace the water for a period of milliseconds. Through the use of a sealed discharge chamber and metal bellow spring, the fluid motion can be used create an oscillating linear actuator. Continuous actuation of the bellow has been demonstrated through the use of high frequency spark discharge. Discharge in water forms a region of high electric field around the electrode tip which leads to the creation of a thermal plasma channel. This process produces fast thermal expansion, vapor and bubble generation, and a subsequent shockwave in the water which creates physical displacement of the water [1]. Previous work was been conducted to utilize the shockwave effect of spark discharge in water for the inactivation of bacteria, removal of mineral fouling, and the formation of sheet metal [2-4]. Pulses ranging from 25 to 40 kV and 600 to 900 A are generated inside of the chamber and the bellow motion is captured using a slow motion video camera. The maximum displacements measured are from 0.7 to 1.2 mm and show that there is a correlation between discharge energy input to the water and the displacement that is generated. Subsequent oscillations of the bellow are created by the spring force of the bellow and vapor in the chamber. Using microsecond shutter speed ICCD imaging, the development of the discharge bubble and spark can be observed and measured.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.30 no.5
• /
• pp.98-106
• /
• 2002

This study was designed to present a river model with the aim of restoring the ecosystem and improving the landscape along the urban rivers on the basin of the Namhanl river, a core life channel for the National Capital regin. The revelation of botanical status, transition trend and correlation of plants might lead to providing the urban river restoration projects and ecological river formation projects with basic data for a model of ideal aquatic ecology and landscape. The outcomes of this study could be summed up as follows: 1. The plant communities of river flora found on the basin of the Namhan river could be categorized largely into 39 plant communities 2. Most diverse plants were distributed in the rivers lower reaches such as Unsim-ri where the protected zone of Paldang reservoir for city water borders the body of Jodae swamp where natural streams flow nearby. 3. One of the greatest threats to the biomass of the River Namhan is that the communities of such invasive alien plants as Panicum dichotomiflorum and Ambrosia artemisiifolia var. elatior dominate most parts of the area, a fact that has resulted in a reduced variety of plants and will, sooner or later, be likely to cause an ecological imbalance in the hitherto healthy Aquatic plant life. It is highly advisable to gradually diversify the species of trees and to return the plants bark to their original state since, besides the naturalized plants, plantations afforested with Erigeron canadensis and Erigeron annuus stocks in buckwheat field, Robinia Pseudo-accacia in riverside forest, Pinus rigida in terrestrial forest on the river basin and Larix leptolepis are anticipated to act as interceptors of normal migrations of the fluvial and terrestrial ecosystems. Finally, it seems also desirable to continue to explore the relationship between fluvial and terrestrial ecologies with the purpose of building up a model of natural streams in urban areas based on the surveyed factors for plant life, soil and landscape and, moreover, on the forecasting for overall influences derived from the rotation upon the ecosystem.

• The KIPS Transactions:PartB
• /
• v.13B no.3 s.106
• /
• pp.245-254
• /
• 2006

In this work, a new rate control algorithm for transmission of H.264/AVC video bit stream through CBR(constant bit rate) channel is proposed. The proposed algorithm predicts target bit rate and MAD(mean of absolute difference) for current frame considering image complexity variance between neighboring backward and current images. In details, respective linear regression analysis for MAD and encoded bit rate against image complexity variance produce correlation parameters. Additionally, it uses frame skip technique to maintain bit stream within a manageable range and protect buffer from overflow or underflow. Implementation and experimental results show that the proposed algorithm can provide accurate bit allocation, and can effectively visual degradation after scene changes. Also our proposed algorithm encodes the video sequences with less frame skipping compared to the existing rate control for H.264/AVC.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.207-207
• /
• 2011

Amorphous transparent oxide semiconductors (a-TOS) have been widely studied for many optoelectronic devices such as AM-OLED (active-matrix organic light emitting diodes). Recently, Nomura et al. demonstrated high performance amorphous IGZO (In-Ga-Zn-O) TFTs.1 Despite the amorphous structure, due to the conduction band minimum (CBM) that made of spherically extended s-orbitals of the constituent metals, an a-IGZO TFT shows high mobility.2,3 But IGZO films contain high cost rare metals. Therefore, we need to investigate the alternatives. Because Aluminum has a high bond enthalpy with oxygen atom and Alumina has a high lattice energy, we try to replace Gallium with Aluminum that is high reserve low cost material. In this study, we focused on the electrical properties of IZO:Al thin films as a channel layer of TFTs. IZO:Al were deposited on unheated non-alkali glass substrates (5 cm ${\times}$ 5 cm) by magnetron co-sputtering system with two cathodes equipped with IZO target and Al target, respectively. The sintered ceramic IZO disc (3 inch ${\phi}$, 5 mm t) and metal Al target (3 inch ${\phi}$, 5 mm t) are used for deposition. The O2 gas was used as the reactive gas to control carrier concentration and mobility. Deposition was carried out under various sputtering conditions to investigate the effect of sputtering process on the characteristics of IZO:Al thin films. Correlation between sputtering factors and electronic properties of the film will be discussed in detail.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.5
• /
• pp.1702-1707
• /
• 2010

As quantities of the data that transmitting by the wireless are more increased, the interest and application are extending about 802.11n that uses by combination two existing 20MHz wireless LAN Channel. 802.11n use dual band of 2.4GHz band and 5.8GHz. So this is expected in mass wireless transmission method because of interference evasion effect in compliance with the radio communication of existing 2GHz neighborhood band. Like this 802.11n uses the radio as well and transmits information there is not only a possibility of undergoing an influence in radio wave environment of circumference. Specially the interior environment and outdoor environment is a possibility of saying that will be defined with each other different modeling as affects in radio communication is different. In this paper, we'll compare the influence to RF feature (802.11n) by (Indoor/Outdoor) environment difference through compared with 802.11n RF feature and Network feature in (Indoor/Outdoor) environment and also examine the correlation between RF feature and Network feature.

• Science of Emotion and Sensibility
• /
• v.8 no.4
• /
• pp.403-413
• /
• 2005

The purpose of the present study was to investigate the responses to positive/negative emotional stimuli for the different sensitivities of behavioral activation system (BAS) and behavioral inhibition system (BIS). We recorded If-channel EEG data for 8 BAS sensitive subjects an48 BIS sensitive subjects. EEGs were analyzed with LORETA (Low-resolution electromagnetic tomography) From scalp-recorded electrical potential distribution, LORETA computes the three-dimensional intracerebral distributions of current density for specified EEG frequency bands. hs results , significant differences between the BAS sensitive group ant the BIS sensitive group appeared LORETA alpha activities over the prefrontal lobe and the cingulate gyrus. Prefrontal regions and limbic system including cingulate gyrus are involved in emotional processing. Moreover, subjects with the high BAS sensitivity. responded more sensitively to the positive stimulation than subjects with the high BIS sensitivity. Therefore, our results suggest the possibility of correlation between BAS/BIS sensitivity and positive/negative emotional stimuli.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.11A
• /
• pp.1004-1011
• /
• 2005

In OFDM (Orthogonal Frequency Division Multiplexing) system, sampling frequency offset causes performance degradation due to increase of ICI. Sampling frequency offset can be generally estimated by correlation of the pilot signal or the known pattern within two contiguous OFDM symbol however, this method has the throughput degradation and the difficulty in applying to various OFDM systems. In this paper, we propose a new algorithm for sampling frequency offset estimation which can solve aforementioned issues. The proposed algorithm uses a single OFDM symbol to prevent throughput degradation and to apply to various OFDM-based communication systems flexibly Also, the proposed algorithm can enhance reliability by observing more number of correlations compared to the established algorithm in frequency domain. Extensive computer simulation shows that the proposed algorithm can improve the system performance in various channel conditions.

• Nuclear Engineering and Technology
• /
• v.42 no.5
• /
• pp.568-575
• /
• 2010

Flow Accelerated Corrosion is an active degradation mechanism of CANDU feeder. The tight bend downstream to Gray loc weld connection, close to reactor face, suffers significant wall thinning by FAC. Extensive in-service inspection of feeder wall thinning is very difficult because of the intense radiation field, complex geometry, and space restrictions. Development of a knowledge-based inspection program is important in order to guarantee that adequate wall thickness is maintained throughout the whole life of feeder. Research results and plant experiences are reviewed, and the plant inspection databases from Wolsong Units One to Four are analyzed in order to support developing such a knowledge-based inspection program. The initial thickness before wall thinning is highly non-uniform because of bending during manufacturing stage, and the thinning rate is non-uniform because of the mass transfer coefficient distributed non-uniformly depending on local hydraulics. It is obvious that the knowledge-based feeder inspection program should focus on both fastest thinning locations and thinnest locations. The feeder wall thinning rate is found to be correlated proportionately with QV of each channel. A statistical model is proposed to assess the remaining life of each feeder using the QV correlation and the measured thicknesses. W-1 feeder suffered significant thinning so that the shortest remaining life barely exceeded one year at the end of operation before replacement. W-2 feeder showed far slower thinning than W-1 feeder despite the faster coolant flow. It is believed that slower thinning in W-2 is because of higher chromium content in the carbon steel feeder material. The average Cr content of W-2 feeder is 0.051%, while that value is 0.02% for W-1 feeder. It is to be noted that FAC is reduced substantially even though the Cr content of W-2 feeder is still very low.