• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권2호
• /
• pp.1108-1111
• /
• 2007

OLED driving voltage shift can reduce the OLED display lifetime, especially for digitally driven AMOLED. By operating OLED at high frequency, we were able to suppress OLED voltage shift degradation, expecting improved AMOLED lifetime. We describe frequency dependence of voltage shift obtained from bias stress test of OLED.

• 대한의용생체공학회:의공학회지
• /
• 제4권1호
• /
• pp.29-36
• /
• 1983

In this paper, center frequency down slift of ultrasonic echo signals which for the measurements of frequency dependent attenuation in the biological tissue are estimated. Center frequency down shift of echo-signals are estimated after signal spectrum analysis of whole echo-signals. In case of signal spectrums are simple, estimation of down shift frequency is very simple and in case of complicate spectrum, estimation of down shift frequency is depend on spectral shape. In case of unable to estimate, frequency dependence of medium is nonlinear(n) 1), in which upper shift of spectrums are presented. In case of unable to estimate, spectrum analysis are performed at local position. At consquence, we know that spectral dispersions are caused complicately by biological tissue layer.

• Journal of the Optical Society of Korea
• /
• 제16권2호
• /
• pp.181-184
• /
• 2012

We report, for the first time, operation frequency dependence of current density-voltage ($J_{OLED}-V_{OLED}$) shift for multi-layer organic light-emitting diodes (OLEDs). When the OLEDs were electrically stressed for 21 hours with 50% duty voltage pulses at 60, 120, 240, and 360 Hz, the JOLED-VOLED shifts were suppressed by half for 360 Hz operation compared with 60 Hz operation, but with little change in emission efficiencies. This frequency dependent $J_{OLED}-V_{OLED}$ shift is believed to be commonly observed for typical multi-layer OLEDs and can be used to further improve lifetime of digitally-driven active-matrix OLED displays.

• 센서학회지
• /
• 제17권4호
• /
• pp.289-294
• /
• 2008

The purpose of this study is to materialize the viscosity sensor by using the SH-SAW sensor of which the center frequency is operated at higher than 50 MHz. In order to measure the viscosity, SAW sensor of which the center frequency is operated at 100 MHz is developed. By using the developed sensor, phase shift, delay time, insertion loss, and frequency variation are measured at different viscosity. The result shows that the phase shift difference between the viscosity variations is such that the difference between the distilled water and the 100 % glycerol solution is approximately $45^{\circ}$, the change of the insertion loss is approximately 9 dB, and the difference of frequency variation is approximately 5.9 MHz. Therefore, it is shown that viscosity of unknown solution can be measured with the surface acoustic wave sensor.

• 전기학회논문지
• /
• 제61권7호
• /
• pp.998-1000
• /
• 2012

By cascading RHTL (Right-Handed Transmission Line) and LHTL (Left-Handed Transmission Line), we fabricated a BPF (Band Pass Filter) in which the phase propagation at the pass band center frequency is fixed as we want. We utilized a positive phase propagation of a RHTL which is a form of LPF (Low Pass Filter) and negative phase propagation of LHTL which is a form of HPF (High Pass Filter). Therefore, if RHTL and LHTL are cascaded, a BPF can be constructed and the phase propagation inside the passband is decided by the number of RHTLs and LHTLs. In this paper, we provide a detailed theory related to it and proved the theory with an actual experiment. In the experiment, we fabricated two BPFs with similar passband. One with $90^{\circ}$ phase shift and the other with $-90^{\circ}$ phase shift at the center of passband. The result of simulation and actual experiment agrees well. This proves the suggested theory is correct and feasible.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2003년도 춘계전력전자학술대회 논문집(1)
• /
• pp.227-230
• /
• 2003

In this paper, a full bridge edge-resonant zero voltage mode based soft-switching PWM DC-DC power converter with a high frequency center tapped transformer link stage is presented from a practical point of view. The power MOSFETS operating as synchronous rectifier devices are implemented in the rectifier center tapped stage to reduce conduction power losses and also to extend the transformer primary side power MOSFETS ZVS commutation area from the rated to zero-load without a requirement of a magnetizing current. The steady-state operation of this phase-shift PWM controlled power converter is described in comparison with a conventional ZVS phase-shift PWM DC-DC converter using the diodes rectifier. Moreover, the experimental results of the switching power losses analysis are evaluated and discussed in this paper. The practical effectiveness of the ZVS phase-shift PWM DC-DC power converter treated here is actually proved by using 2.5kW-32kHz breadboard circuit. An actual efficiency of this converter is estimated in experiment and is achieved as 97$\%$ at maximum.

• 전기전자학회논문지
• /
• 제16권1호
• /
• pp.51-55
• /
• 2012

본 논문에서는 순환천이변조 (CCSK: cyclic code shift keying) 시퀀스로 삼진 시퀀스를 적용하는 것을 제안하였다. 그리고 순환천이변조를 적용한 주파수도약대역확산/시분할다중접속 (FHSS/TDMA: frequency hopping spread spectrum/time division multiple access) 시스템에서 성능을 모의실험 하였다. 실험에서 무선 채널은 레일레이(Rayleigh) 페이딩 채널로 모델링하였다. 모의 실험 결과로부터 순환천이변조 시퀀스로 무작위 시퀀스를 사용한 시스템보다 삼진 시퀀스를 적용한 시스템이 더 높은 성능을 보이는 것이 증명되었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.787-789
• /
• 2000

High temperature superconducting YBCO films have been grown on MgO substrates by pulsed laser deposition (PLD) with Nd:YAG laser Superconducting microwave filter was fabricated by conventional photolithography method. We have designed filter with the center frequency of 14 GHz. We have measured the center frequency of filter at 77 K and its critical temperature 89K. Also we have designed another filter to compare frequency responses. The measured frequency responses will be presented.

• 비파괴검사학회지
• /
• 제15권2호
• /
• pp.364-370
• /
• 1995

본 논문은 초음파법을 이용하여 소결 재료의 비파괴적인 평가 방법을 확립하는데 목적을 두고 있다. 소결 재료의 밀도는 소결체로 제작되는 동안 금형과 분말사이의 마찰 때문에 부분적으로 불균질한 분포를 가지고 있으며 이 불균질성은 에너지 감쇠 계수 및 초음파 반사 에코의 주파수 스펙트럼에 있어 중심 주파수의 변화량에 의해 조사되었다. 초음파의 속도, 탄성계수, 포와송 비는 소결 재료의 밀도와 비례 관계에 있었으며 저면 반사파의 중심 주파수는 초음파의 전파 거리의 증가 및 밀도의 감소에 따라 저주파수 쪽으로 이동하였으나 에너지 감쇠 계수는 밀도의 증가에 따라 감소하고 있었다. 본 논문에서는 반사파의 주파수 스펙트럼에 있어 중심 주파수의 변화가 소결 재료의 비파괴적인 평가 방법으로써의 가능성을 보여주고 있다.

• Journal of Power Electronics
• /
• 제19권6호
• /
• pp.1337-1350
• /
• 2019

This paper proposes a Phase-Shift Triple Full-Bridge (PSTB) Zero-Voltage Zero-Current-Switching (ZVZCS) converter with a high switching frequency and high efficiency. In the proposed converter, all three bridge legs are shared leading-legs, and all three transformers work in the Discontinuous Conduction Mode (DCM). Thus, all of the switches and diodes in the PSTB ZVZCS can be soft switched. Moreover, since all of the transformers can pass energy from the primary-side to the secondary-side when their primary-side currents are not zero, there is no circulating current. As a result, the PSTB ZVZCS converter can achieve a high efficiency at high operating frequencies. A theoretical analysis and the characteristics of the proposed converter are presented and verified on a 1MHz 200~300V/24V 1.2kW hardware prototype. The proposed converter can reach a peak efficiency of 96.6%.