• Journal of Sericultural and Entomological Science
• /
• v.31 no.2
• /
• pp.121-126
• /
• 1989

Two kinds of solution for the measurement of solubilities of Sericin are prepared as followings at temperature 90 deg. C. One has the total carbonate concentration as 0, 50, 100mg CO2/l prepared with non-carbonate distilled water, sodium hydrogen carbonate and 0.1N HCI and NaOH, the other has total hardness, that is, calcium hardness or magnesium hardness as 0, 20, 50, 100mg CaCO2/l respectively prepared with non-carbonate distilled water, calcium carbonate and magnesium oxide. Solubilities of Cocoon layer Sericin at above solution gives following results ; 1. pH shows little effect on the solubility of Sericin at the non-carbonate solution but at the carbonate solution pH shows a sensitive effect on the solubility of Sericin. These means that pH controls the concentration of H2CO3, HCO3-and CO32- which prevent and promote the solution of Sericin. 2. After the cocoon layer treatment at the solution, the initial pH of 4.0, 7.0, 9.0 of the solution changed to 6.0-6.5 at the lower total carbonate solution. However in the higher total carbonate solution pH did not changed very much. This may be explained by the buffer action of carbonate. 3. The effect of the hardness on the solubility of Sericin was not found in the non-carbonate solution with the standard hardness after treatment of cocoon layer.

• Fibers and Polymers
• /
• v.3 no.1
• /
• pp.1-7
• /
• 2002

Cellulose carbonate was prepared by the reaction of cellulose pulp and $CO_2$ with treatment reagents, such as aqueous $Zncl_2$ (20-40 wt%) solution, acetone or ethyl acetate, at -5-$0^{\circ}C$ and 30-40 bar ($CO_2$) for 2 hr. Among the treatment reagents, ethyl acetate was the most effective. Cellulose carbonate was dissolved in 10% sodium hydroxide solution containing zinc oxide up to 3 wt% at -5-$0^{\circ}C$. Intrinsic viscosities of raw cellulose and cellulose carbonate were measured with an Ubbelohde viscometer using 0.5 M cupriethylenediamine hydroxide (cuen) as a solvent at $20^{\circ}C$ according to ASTM D1795 method. The molecular weight of cellulose was rarely changed by carbonation. Solubility of cellulose carbonate was tested by optical microscopic observation, UV absorbance and viscosity measurement. Phase diagram of cellulose carbonate was obtained by combining the results of solubility evaluation. Maximum concentration of cellulose carbonate for soluble zone was increased with increasing zinc oxide content. Cellulose carbonate solution in good soluble zone was transparent and showed the lowest absorbance and the highest viscosity. The cellulose carbonate and its solution were stable in refrigerator (-$5^{\circ}C$ and atmospheric pressure).

• Nuclear Engineering and Technology
• /
• v.56 no.2
• /
• pp.419-425
• /
• 2024

The purpose of this study is to improve the concentration of U(VI) in carbonate solution reasonably, which to improve the application potential of the alkaline reprocessing processes. The dissolution behavior of U₃O₈ in carbonate peroxide solutions was investigated under different conditions, including pH, carbonate concentration, and solid-liquid ratio. The results showed that the dissolution rate of U₃O₈ increased with the increase of pH from 8 to 11 in the mixed carbonate solution containing 0.5 mol/L H₂O₂. The role of carbonate ions in the dissolution of U₃O₈ was further elucidated by observing the dissolution of UO₄⋅4H₂O in carbonate solutions. Furthermore, the concentration of U(VI) in 3 mol/L Na₂CO₃ solution was successfully increased to 350 g/L under ultrasonic-assisted conditions at 60 ℃ and a solid-liquid ratio at 1/2 g/mL. Meanwhile, it is suggested that increasing the concentration of carbonate ions can improve the stability of the dissolved solution containing uranyl peroxycarbonate complex.

• Journal of the Korean Ceramic Society
• /
• v.33 no.3
• /
• pp.332-338
• /
• 1996

This study was investigated on the recycle feasibility of the waste AC(Ammonium Carbonate) solution produ-ced in a commercial AUC(Ammonium Uranyl Carbonate) conversion plant. AUC particles were produced with the AC solution which was prepared with AC solid-agent instead of ammonia and carbon-dioxide gases. As the results particles of monoclinic shapes has been obtained regardless of the pH change if the carbonate concentration is sufficient in the mother liquore. Also a lot of twinned or aggregated particles were formed in case of the increase of pH in the reaction system but not affected in the change of temperature. Consequen-tly the characteristics of the particles which converted for AUC were produced withAC solution to UO2, particles specific surface area shape sintered density and others were similar to that of the particles which were produced with gases only when the pellets are fabricated in the nuclear fuel manufacturing process So the waste AC solution which is produced in the commercial AUC conversion plant is possible to recycle.

• Journal of the Korea Furniture Society
• /
• v.19 no.5
• /
• pp.358-364
• /
• 2008

Wood-inorganic material composite (WIC) was prepared by impregnating wood with copper sulfate ($CuSO_4\;5H_2O$) solution and by immersed wood in sodium carbonate($Na_2CO_3$) solution in order to introduce insoluble copper compounds {copper carbonate hydroxide, $CuCO_3\;Cu(OH)_2$} into the wood to give fungicidal effects in treated-wood. The weight percent gains (WPGs) of treated wood reached maximum value by impregnation of 20% copper sulfate solution and immersion in about 15% sodium carbonate solution for 24 hrs. Inorganic substances were present mainly in the lumina and cross-field pitting of tracheides. These substances were proved to be the insoluble copper carbonate hydroxide against water by the energy dispersive X-ray analyzer in conjunction with a scanning electron microscope (SEM-EDXA). The treated specimens showed high preservative effectiveness because the weight losses were hardly occurred by the fungi degradation test.

• Journal of the Korean Wood Science and Technology
• /
• v.20 no.4
• /
• pp.57-64
• /
• 1992

The unique cell wall micropores of pulp fiber can be utilized as loading site in variety of important practical application which could be the basis of new papermaking technologies. One of these includes the manufature of paper containing higher levels of in situ filler precipitated. Hardwood pulp fiber were first impregnated with the solution of sodium carbonate($Na_2CO_3$). The micropores in cell wall of pulp fibers were filled with the liquid salt solution. The second calcium nitrate($Ca(NO_3)_2$) solution formed an insoluble calcium carbonate($CaCO_3$) precipitate within the cell wall micropores by interacting with the first sodium carbonate solution. The effects of chemical concentration and dryness of pulp fibers on the retention of cell wall micropore loaded filler were investigated. The paper properties of cell wall micropore loaded pulp fibers were compared with those of conventionally loaded and lumen loaded pulp fibers. Also the presense of the fillers within the cell wall micropore was observed by SEM. Increasing the chemical concentration to generate the calcium carbonate increased the retention of filler in cell wall micropore loaded pulp fibers. The particle size distribution of precipitated calcium carbonate ranged from $0.1{\mu}m$ to $80{\mu}m$. But, the average particle size of cell wall micropore loaded calcium carbonate was $4{\mu}m$. The paper made from never dried pulp fibers, the cell wall micropores which were filled with calcium carbonate, had better mechanical and optical properties than those of conventionally loaded or lumen loaded pulp fibers.

• Geomechanics and Engineering
• /
• v.29 no.1
• /
• pp.79-90
• /
• 2022

Soybean-urease induced carbonate precipitation (EICP), as an alternative to microbially induced carbonate precipitation (MICP), was employed for soil improvement. Meanwhile, soluble calcium produced from industrial waste carbide slag powder (CSP) via the acid dissolution method was used for the EICP process. The ratio of CSP to the acetic acid solution was optimized to obtain a desirable calcium concentration with an appropriate pH. The calcium solution was then used for the sand columns test, and the engineering properties of the EICP-treated sand, including unconfined compressive strength, permeability, and calcium carbonate content, were evaluated. Results showed that the properties of the biocemented sand using the CSP derived calcium solution were comparable to those using the reagent grade CaCl₂. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) analyses revealed that spherical vaterite crystals were mainly formed when the CSP-derived calcium solution was used. In contrast, spherical calcite crystals were primarily formed as the reagent grade CaCl₂ was used. This study highlighted that it was effective and sustainable to use soluble calcium produced from CSP for the EICP process.

• Journal of the Korean Ceramic Society
• /
• v.35 no.6
• /
• pp.559-568
• /
• 1998

Studies of preparation condition and characteristics of AUC(ammonium uranyl carbonate) were carried out to optimize AUC process with different reactor sizes and precipitation methos. As results four types of precipitates with different chemical compositions and morphologies were obtained from the reaction of {{{{ {(NH }_{4 }) { }_{2 } {CO }_{3 } }} with {{{{ {UO }_{2 }( {NO }_{3 }) { }_{2 } }} solution. A phase diagram has been made and crystal structure and chemical composition of each phase have been characterized by using SEM X-ray IR and thermal analysis. It was found that ammonium uranyl carbonate {{{{ {(NH }_{4 }) { }_{4 } {UO }_{2 } {(CO }_{3 }) { }_{3 } }} with monoclinic crystal morphology could be syn-thesized when the mole ratio of in {{{{ {(NH }_{4 }) { }_{2 } {CO }_{3 }/ {UO }_{2 } {(NO }_{3 }) { }_{2 } }} in the solution was higher than 5 Also a mechanism and a precipitating condition on rounding of the AUC particle were examined in the course of the AUC pre-cipitation. The rounding of the AUC particle was possible only by external circulation using pump not by internal circulation using agitator.

• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.11
• /
• pp.597-606
• /
• 2015

This work investigates the carbonation of KOH-dissolved methanol and ethanol solution systems carried out for $CO_2$ fixation. Potassium methyl carbonate (PMC) and potassium ethyl carbonate (PEC) were synthesized during the reaction in each solution as the solid powder, and they were characterized in detail. The amount of $CO_2$ chemically absorbed to produce the PMC and PEC precipitates were calculated to be 97.90% and 99.58% of their theoretical values, respectively. In addition, a substantial amount of $CO_2$ was physically absorbed in the solution during the carbonation. PMC precipitates were consisted of the pure PMC and $KHCO_3$ with the weight ratio of 5:5, respectively. PEC precipitates were also mixture of the pure PEC and $KHCO_3$ with the weight ratio of 8:2, respectively. When these two precipitates were dissolved in excess water, methanol and ethanol were regenerated remaining solid $KHCO_3$ in the solutions. Therefore, the process has the potential to be one of the efficient options of CCS and CCU technologies.

• Nuclear Engineering and Technology
• /
• v.55 no.1
• /
• pp.63-70
• /
• 2023

Ultrasound-assisted dissolution of U₃O₈ powder in carbonate solution was explored to determine if and how ultrasound act during the dissolution. The variation of U₃O₈ solid particles and uranyl complexes under ultrasound treatment and magnetic stirring was observed in carbonate media. The results show that the use of ultrasound can increase the solubility and dissolution rate of U₃O₈ powder than that under magnetic stirring. The crush of U₃O₈ particles and the reduction of the activation energy (Ea, kJ/mol) of U₃O₈ dissolution reaction were observed, which both play an important role in the ultrasonic-assisted dissolution of U₃O₈ in carbonate-peroxide solution. Meanwhile, there is no observation of the ultrasound effect on the distribution of uranyl species and hydrolysis of uranyl complexes during the ultrasound treatment in carbonate-peroxide solution. Although the generation of ·OH radicals under ultrasound (22 ± 2 kHz) was observed, the oxidation of ·OH had little effect on the dissolution of U₃O₈ in the carbonate-peroxide solution system.