• 한국환경과학회지
• /
• 제14권1호
• /
• pp.61-69
• /
• 2005

Adsorption characteristics of toluene vapor, which is one of important source of volatile organic compounds (VOCs), by activated carbon were investigated using a fixed bed adsorption column. The operating parameters such as breakthrough curve, adsorption capacity, mass transfer zone (MTZ), and length of unused bed (LUB) were studied. The experimental results showed that the breakthrough time decreased with increasing inlet toluene concentration and gas flow rate. MTZ and LUB increased with the increase of inlet concentration, gas flow rate, and particle size of activated carbon. The adsorption capacity increased with the increase of inlet toluene concentration, while it decreased with increasing particle size. However, it was kept at constant value regardless of the increase of gas flow rate. Adsorption isotherm of toluene vapor could be represented by the Freundlich adsorption equation fairly well. From the adsorption experiments using some VOC gases such as toluene, xylene, butyl acetate. butanol and acetone, it was also found that the adsorption capacity was higher in the case of gas with higher boiling point and lower vapor pressure.

• Bulletin of the Korean Chemical Society
• /
• 제27권8호
• /
• pp.1175-1180
• /
• 2006

Si-C composites were prepared by the carbonization of polyaniline (PAn) coated on silicone powder. The physical and electrochemical properties of the Si-C composites were characterized by particle-size analysis, X-ray diffraction, scanning electron microscopy, and battery electrochemical tests. The average particle size of Si was increased by the coating of Pan but somewhat reduced by the carbonization to give silicone-carbon composites. The co-existence of crystalline silicone and amorphous-like carbon was confirmed by XRD analyses. SEM photos showed that the silicone particles were well covered with carbonaceous materials, depending on the PAn content. Si-C$\mid$Li cells were fabricated using the Si-C composites and tested using galvanostatic charge-discharge. Si-C$\mid$Li cells gave better electrochemical properties than Si|Li cells. Si-C$\mid$Li cells using Si-C from HCl-undoped precursor PAn showed better electrochemical properties than precursor PAn doped in HCl. The addition of an electrolyte containing 4-fluoroethylene carbonate (FEC) increased the initial discharge capacity. Also, another electrochemical test, the galvanostatic charge-discharge test with GISOC (gradual increasing of the state of charge) was carried out. Si-C(Si:PAn = 50:50 wt. ratio)|Li cell showed 414 mAh/g of reversible specific capacity, 75.7% of IIE (initial intercalation efficiency), 35.4 mAh/g of IICs (surface irreversible specific capacity).

• 한국입자에어로졸학회지
• /
• 제15권4호
• /
• pp.127-137
• /
• 2019

Recently, high electrochemical performance anode materials for lithium ion secondary batteries are of interest. Here, we present silicon-carbon-graphene (Si-C-GR) composites for high performance anode materials of lithium ion secondary battery (LIB). Aerosol process and heat-treatment were employed to prepare the Si-C-GR composites using a colloidal mixture of silicon, glucose, and graphene oxide precursor. The effects of the size of the silicon particles in Si-C-GR composites on the material properties including the morphology and crystal structure were investigated. Silicon particles ranged from 50 nm to 1 ㎛ in average diameter were employed while concentration of silicon, graphene oxide and glucose was fixed in the aerosol precursor. Morphology of as-fabricated Si-C-GR composites was generally the shape of a crumpled paper ball and the Si particles were well wrapped in carbon and graphene. The size range of composites was about from 2.2 to 2.9 ㎛. The composites including silicon particles larger than 200 nm in size exhibited higher performance as LIB anodes such as capacity and coulombic efficiency than silicon particles less than 100 nm, which were about 1500 mAh/g at 100 cycles in capacity and 99% in coulombic efficiency, respectively.

• KSBB Journal
• /
• 제18권5호
• /
• pp.385-392
• /
• 2003

초임계 이산화탄소를 이용한 효율적인 DDS 설계를 위한 기초연구로서 순수한 초임계 이산화탄소와 초임계 이산화탄소와 상용성이 있으면서 고분자에 대해서는 비용매로 작용하는 극성 공용매로 변형된 초임계 이산화탄소를 이용하여 생체분해성 고분자인 L-PLA의 미세입자 형성에 대하여 고찰하였다. L-PLA용액의 농도가 증가할수록 입자 크기는 증가하였으며, 약 4%이상의 농도에서는 입자들 간의 강한 응집으로 인하여 입자의 형태가 구형에서 섬유상으로 변화하였다. 침전기 내 초임계 유체의 온도가 높아짐에 따라 생성된 입자의 크기가 증가하였으며, 온도가 높아질수록 입자의 분포는 불균일하게 나타났다. 용액 유량이 증가함에 따라 전체적으로 구형 입자의 생성이 증가하였으며, 입자의 평균 크기는 증가하는 것으로 나타났다. 순수한 초임계 이산화탄소를 사용한 경우 모든 실험 조건에서 입자 회수율은 약 30∼40% 정도로 나타났다. 입자 회수율을 향상시키기 위해 극성 공용매를 초임계 이산화탄소와 혼합하여 입자를 제조하였다. 메탄올과 에탄올을 이산화탄소 대비 몰비 0.5로 혼합한 경우 회수율은 각각 80%와 70%로 매우 높은 값을 나타냈으며, 평균 직경 1 $\mu\textrm{m}$이하의 매우 작은 입자를 제조할 수 있었다.

• 공업화학
• /
• 제1권2호
• /
• pp.224-231
• /
• 1990

백금촉매의 분산을 향상시키기 위하여 카본블랙의 표면처리, 용매, 계면활성제 및 초음파분산기에 따른 효과를 고찰하였다. 카본블랙을 산화처리하여 카본블랙 표면에 친수성기인 작용기들을 도입함으로써 작용기들이 염화백금산 이온의 anchorage center역할을 하여 이 염화백금산을 환원시킬 때 백금입자(이온)의 이동이나 성장을 억제시켜 미립화 시킬 수 있다고 생각되었다. 혼합용매, 계면활성제, 초음파분산기 등을 이용한 경우, 염화 백금산이온이 anchorage center 역할을 하고 있는 작용기들에 까지 잘 스며들어감으로써 백금촉매의 분산성이 향상됨을 알았다. 혼합용매에 초음파분산기를 사용하여 공기산화시킨 카본블랙에 백금촉매를 담지시킨 결과, 분산성이 가장 우수하였으며 입자크기는 $30A^{\circ}$ 이하로 미립화 되었다.

• 한국수소및신에너지학회논문집
• /
• 제22권5호
• /
• pp.686-698
• /
• 2011

Mathematical models for char-slag interaction and near-wall particle segregation developed by Montagnaro et. al. were applied to predict various aspects of coal gasification in an up-flow entrained gasifier of commercial scale. For this purpose, some computer simulations were performed using gPROMS as the numerical solver. Typical design parameters and operating conditions of the commercial gasifiers were used as input values for the simulation. Development of a densely dispersed phase of solid carbon was found to have a critical effect on both carbon conversion and ash flow behavior. In general, such a slow-moving phase was turned out to enhance carbon conversion by lengthening the residence time of char or soot particles. Furthermore, it was also found that guiding the transfer of char or soot into the closer part of the wall to coal burner is favorable in terms of gasification efficiency and vitrified ash collection. Finally, to a certain degree densely dispersed phase of carbon showed an yield-enhancing effect of syngas.

• Advances in materials Research
• /
• 제13권3호
• /
• pp.161-171
• /
• 2024

This study aimed to investigate the effect of physicochemical properties and mix ratios of iron ore (oxide feed): coke (reductant) on the carbothermic reductions of iron ore. Coke size was fixed at ≤63 ㎛ while iron ore size varied between 150-63 ㎛ and ≤63 ㎛ respectively. Mix ratios were changed from 100:0 (reference) to 80:20 and 60:40 while the temperature, heating rate and soaking duration in muffle furnace were fixed at 1100 ℃, 10 ℃/min and 1 hour. Particle size analyzer, XRF, CHNS and XRD analyses were used for determination of raw feed characteristics. The occurrence of phase transformations from various forms of iron oxides to iron during the carbothermal reductions were identified through XRD profiles and supported with weight loss (%). XRF analysis proved that iron ore is of high grade with 93.4% of Fe₂O₃ content. Other oxides present in minor amounts are 2% Al₂O₃ and 1.8% SiO₂ with negligible amounts of other compounds such as MnO, K₂O and CuO. Composite pellet with finer size iron particles (≤63 ㎛) and higher carbon content of 60:40 exhibited 45.13% weight lost compared to 32.30% and 3.88% respectively for 80:20 and 100:0 ratios. It is evident that reduction reactions can only occur with the presence of coke, the carbon supply. The small weight loss of 3.88% at 100:0 ratio occurs due to the removal of moisture and volatiles and oxidations of iron ore. Higher carbon supply at 60:40 leads into better heat and mass transfer and diffusivity during carbothermic reductions. Overall, finer particle size and higher carbon supply improves reactivity and gas-solid interactions resulting in increased reductions and phase transformations.

• 전기화학회지
• /
• 제10권2호
• /
• pp.145-149
• /
• 2007

본 논문은 마이크로전극 측정시스템을 사용하여 니켈수소전지의 전극 소재로 사용되고 있는 수산화니켈의 단일 입자에 대해 전기화학적 평가를 수행 하였다. 즉 Carbon fiber 마이크로전극을 수산화니켈 입자 한개 위에 전기적인 접촉을 이루도록 조정하고 전기화학적 평가를 수행하였다. Cyclic Voltammetry 실험 결과 수산화니켈의 산화 환원 반응과 산소 발생 반응(OER)이 명확하게 분리 되고 있음을 확인하였으며, 전위주사속도를 증가 시킬 경우 환원 전하량은 주사 속도에 의존하지 않고 거의 일정한 수치를 보여 주고 있으나, 산화 전하량은 환원 전하량 보다 크고 주사속도 구간에서 부반응인 산소발생이 증가하고 있음을 확인했다. 그리고 Calvanostat에 의한 정전류 충방전 실험의 결과 수산화니켈 단일 입자의 방전용량은 이론용량 289 mAh/g에 근접한 수치(약 250 mAh/g)를 보여 주었으며 또한 Potential Step에 의해 단일 입자내의 수소이온 확산계수($D_{app}=3{\sim}4{\times}10^{-9}\;cm^2/s$)가 얻어졌다.

• 한국대기환경학회지
• /
• 제19권4호
• /
• pp.415-425
• /
• 2003

A single particle analysis, called low-Z electron probe X-ray microanalysis was applied to characterize the atmospheric aerosols collected during Asian Dust storm events in the year of 2000 and 2001. Most frequently encountered chemical species were the soil-originated species such as aluminosilicates, silicon dioxide, and calcium carbonate. Also various species such as carbon -rich, organics, sea salts, and some reacted calcium carbonate were identified. The observation of internally mixed particles oi calcium carbonate, calcium nitrate and/or calcium sulfate shows the occurrence of the heterogeneous reaction between Asian Dust particles and NO$_{x}$ and/or SO$_{x}$ species in the atmosphere.ere.

• 한국대기환경학회지
• /
• 제19권5호
• /
• pp.503-513
• /
• 2003

A single particle analytical technique, called low-Z electron probe X-ray microanalysis (low-Z EPMA) was applied to characterize atmospheric particles collected in Busan, Korea, over a daytime period in Dec. 2001. The ability to quantitatively analyze the low-Z elements, such as C, N, and 0, in microscopic volume enables the low-Z EPMA to specify the chemical composition of individual atmospheric particle. Various types of atmospheric particles such as organics, carbon-rich, aluminosilicates, silicon oxide, calcium carbonate, iron oxide, sodium chloride, sodium nitrate, ammonium sulfate, and titanium oxide were identified. In the sample collected in Busan, sodium nitrate particles produced as a result of the reaction between sea salt and nitrogen oxides in the atmosphere were most abundantly encountered both in the coarse and fine fractions. On the contrary, original sea salt particles were rarely observed. The fact that most of the carbonaceous particles were distributed in the fine fraction implies that their origin is anthropogenic.