• Proceedings of the IEEK Conference
• /
• 2004.06b
• /
• pp.517-520
• /
• 2004

Organosilicate films are promising porous low-dielectric materials, which can replace the silicon dioxide films. It was researched that organosilicate films have two different chemical shifts according to the increase of the flow rate ratio. There are the red shift due to the electron deficient substitution group, and the blue shift of the electron rich substitution group. Among these chemical shifts, the blue shift from $1000 cm^{-1}$ to $1250 cm^{-1}$ was related with the formation of pores. The methyl radicals of the electron-rich substitution group terminate easily the Si-O-Si cross-link, and the Si-O-C cage-link near $1057 cm^{-1}$ is originated from the cross-link breakdown due to much methyl radicals.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.11 no.3
• /
• pp.247-257
• /
• 2006

This paper shows the comparison of operating characteristics between squirrel cage induction generator and DFIG(Double Fed Induction Generator). Because squirrel cage induction generator consume the reactive power due to magnetizing reactance, the capacitor is need to compensate the reactive power. Otherwise, two back-to-back PWM voltage-fed inverters connected between the stator and the rotor allow sub/super synchronous operation with low distortion currents. In this paper, the response characteristics of squirrel cage induction generator and DFIG, were analyzed and investigated using PSCAD/EMTDC.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.33 no.2
• /
• pp.132-140
• /
• 1997

The basic experiment on the telemetry system of temperature and salinity, which is a study for the effective management of costal fishing-ground nowadays, was carried of 8 days from April 5, 6, 26, 27 , 1996 to May 31 and June 1, 21, 22, 1996 at the fish farm of Yooksam at Samyang-Myun, tongyongkun(34。45.02'N, 128。24.79'E). The results obtained were as follows : 1. The average temperature and salinity of STD of telemetry system was coincided with that of ICTD system calibration precisely. 2. A daily variation of temperature in fish cage which was measured by the telemetry system was influenced mainly by sunrise and sunset. 3. A daily variation of salinity in fish cage which was measured by the telemetry system was influenced mainly by tidal current. 4. The fish school in fish cage was distributed mainly 2~7 m layer during daylight and was arisen to the surface at sunset, was settled down to the bottom at sunrise.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2004.10a
• /
• pp.1154-1159
• /
• 2004

Unexpected postoperative changes, such as growth in rib hump, has been occasionally reported after corrective surgery for scoliosis. However there has been experimental data for explanation of these changes, nor the suggestion of optimal correction method. This numerical study was designed to investigate the main correlating elements in operative kinematics with post-operative changes of vertebral rotation and rib cage deformation in the corrective surgery of scoliosis. To develop a scoliotic spine model automatically, a special program for converting normal spine model to scoliotic spine model was developed. A mathematical finite element model of normal spine including rib cage, sternum, both clavicles, and pelvis was developed with anatomical details. The skeletal deformity of scoliosis was reconstructed, by mapping the X-ray images of a scoliosis into this three dimensional normal spine and rib cage model. The geometric mapping was performed by translating and rotating the spinal colume with the amount analyzed from the digitized 12 built-in coordinate axes in each vertebral image. By utilizing this program, problems generated in mapping procedure such as facet joint overlapping, vertebral body deformity could be automatically resolved.

• Journal of Advanced Marine Engineering and Technology
• /
• v.27 no.6
• /
• pp.776-782
• /
• 2003

This paper describes a newly developed double squirrel cage induction motor in which the rotor is located outside the stator. The outside rotor type brushless dc motor has been used for VTR's head drum and PC's cooling fan, but this kind of induction motor has not been developed yet. The parameters of outside rotor type induction motor were measured from the locked rotor test and no load test. It is possible to determine the parameters which are presented in the steady-state equivalent-circuit of the outside rotor type induction motor. Load test of induction motor was carried out using a dynamometer. For the characteristics of torque, efficiency, power factor and output. the developed double squirrel cage induction motor is compared with the ordinary induction motor It is believed that the results of this paper can be used for the development of the outside rotor type induction motor.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.10 no.2
• /
• pp.71-77
• /
• 1996

The end-ring may contribute a significant influence to the performance of machine. The induced currents flow through the bars of a cage rotor and complete their closed paths by passing around the end-ring. This dissertation is to describe a method for calculating end-ring resistance of squirrel cage rotor, based on 3-D finite element method(A-$\Phi$). The resistance under consideration of skin effect is calculated by using Joule's loss equation.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.7
• /
• pp.38-46
• /
• 2015

This paper propose a variable parameter estimations for variable over current load of five-phase squirrel-cage induction motor(IM) to servo control system. In order to high performance control of AC motor using a field oriented control(FOC) and direct torque control(DTC) algorithm, there are required precise motor parameters for slip calculation, flux observer, controller gain, torque command of current components, rotor position, speed estimation, and so on. We are suggest a analyzed estimation results of the motor parameters that developing five-phase squirrel-cage IM have a stator of concentrated winding for experimental within variable over current load at rated input frequency. There are results of stator winding measurement, no-load test, locked-rotor test, variable over current load test, and estimated parameters of equivalent circuits using manufactured experimental apparatus by IEEE Standard Test Procedure for Polyphase Induction Motors and Generators 112-2004.

• Bulletin of the Korean Chemical Society
• /
• v.26 no.9
• /
• pp.1381-1384
• /
• 2005

Surface modification of tridimensional cubic mesoporous silica, SBA-16, was investigated with pendant arm functionalized cobalt diaminosarcophagine (diAMsar) cage complex which covalently grafted onto the silica surface through the silication with sylanol group. The spectroscopic results showed that the mesoporous structure was preserved under the $[Co(diAMsar)]^{3+}$ grafting reaction condition. Successful grafting prevented the cobalt diAMsar cage from leaching out from the SBA-16 support.

• Journal of the Korea Furniture Society
• /
• v.10 no.2
• /
• pp.17-27
• /
• 1999

As a countermeasure to reach self-sufficiency for wood supply and demand, we have to develop wood substitutes. Rice hull is the cheapest fiber material we can get in Korea, What is better the yield of rice hull amounts to 1 million tons per year. Before carrying out this study, new ecomaterial rice hull board for housing materials was developed successfully. In order to evaluate whether the rice hull board with or without bioceramic treatment is suitable for housing materials, we studied the environmental effect of the above materials in comparison with the polycarbonate, stainless, or concrete on the adaptation (body weight, water/feed consumption, general signs, urinalysis, autopsy, etc) and the reproduction(litter size, newborn adaptation, etc)of mice. In conclusion, the concrete cage was the worst in the adaptation and so was the stainless steel cage in the reproduction. The rice hull board cage with or without bioceramic treatment was superior or equivalent to other material cages from the standpoints of the adaptation and reproduction.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.323-326
• /
• 2006

This paper shows the comparison of operating characteristics between squirrel cage induction generator and DFIG(Double Fed Induction Generator). Because squirrel cage induction generator consume the reactive power due to magnetizing reactance, the capacitor is need to compensate the reactive power. Otherwise, two back-to-back PWM voltage-fed inverters connected between the stator and the rotor allow sub/super synchronous operation with low distortion currents. In this paper, the response characteristics of squirrel cage induction generator and DFIG, were analyzed and investigated using PSCAD/EMTDC.