• Journal of the Korean Solar Energy Society
• /
• v.29 no.2
• /
• pp.70-75
• /
• 2009

In this experiment, we did sampling 6 kinds of photovoltaic modules and analyzed the discrepancy of measurement results between l laboratory and 4 PV makers to have performance repeatability at Standard Test Condition(STC) condition. From the KIER's results, Korea's standard test laboratory, other laboratory showed -10% measurement variation. The causes came from correction of reference cell, test condition and the state of skill. Form the comparison test, we analyzed the problems. But three PV maker reduced measurement variation, other one PV maker and one test laboratory didn't improve the problems of correction of reference cell, test condition and the state of skill. Also, High Efficiency Module had a big discrepancy of -10.0$\sim$-6.2% among 3 laboratories which have a less than 10msec light pulse duration time. This made low spectrum response speed so the Fill Factor decreased maximum output power under 10msec light pulse duration time

• Journal of the Korean GEO-environmental Society
• /
• v.18 no.11
• /
• pp.13-18
• /
• 2017

In a banking process for construction of a complex, non-compaction construction has been applied in most sites, which is a method that soils are compacted by the equipment load without being compacted separately. However, there are no specific descriptions in the construction manual or specifications, so it is unclear to evaluate the excavation volume. Hence, this study is a basic study to compare the soil conversion factor at a design stage and the actual soil conversion factor of a banking ground under a non-compaction condition in order to examine the feasibility in constructing the ground for construction of the complex and to examine appropriateness of the earth work in the site by conducting an indoor, field, and load-settlement test and proposing a reasonable soil conversion factor. Under the non-compaction condition, the soil conversion factor C is set to be 1.0 at the design stage, but the result of the field test was 0.86 which is smaller than the value at the design stage. It was expected that this result would increase the banking volume, and the construction result actually showed a difference in the banking volume. Therefore, for the baking ground under the non-compaction condition, it is necessary to apply the value C suitable for the site condition after performing test by considering the site's condition and the banking height.

• Journal of the Korean Electrochemical Society
• /
• v.12 no.1
• /
• pp.1-10
• /
• 2009

This article reviewed transport behaviours of electroactive species in ionic compounds, focusing on chemical diffusion of Li through the transition metal oxide in a current flowing condition. For this purpose, a distinction has been first briefly made between migration and diffusion with respect to current, driving force and charge of electroactive species considered. Then, the equations for chemical diffusion are derived theoretically in open-circuit and current flowing conditions. Finally, the experimental methods such as ac impedance spectroscopy and current (potential) transient techniques are described in details for characterising chemical diffusion. In addition, the role of the thermodynamic enhancement factor in chemical diffusion is discussed.

• Journal of the Korean Solar Energy Society
• /
• v.29 no.6
• /
• pp.56-61
• /
• 2009

The effects of design parameters for small scale hydro power(SSHP) plants due to climate change have been studied. The model to predict hydrologic performance for SSHP plants is used in this study. The results from analysis far rainfall conditions based on KIER model show that the capacity and load factor of SSHP site had large difference between the period. Especially, the hydrologic performance of SSHP site due to rainfall condition of recent period varied in design flowrate sensitively. However climate change gave small effect in load factor of existing SSHP plant. And also, the methodology represented in this study can be used to decide the primary design specifications of SSHP sites.

• International journal of advanced smart convergence
• /
• v.4 no.1
• /
• pp.64-70
• /
• 2015

This paper proposes fluorescent electronic ballast with high power factor and low line input current harmonics. The system performance can be improved by a charged pump circuit. Details of design and circuit operation are described. The proposed electronic ballast is modified from single-stage half bridge class D electronic ballast by adding capacitor parallel with each power switch and setting the circuit parameter to operate under class DE inverter condition. By using this proposed method the DC bus voltage can be reduced around by 50% compare with conventional class D inverter circuit. Because the power switches are operated at zero voltage switching condition and low dv/dt of class DE switching. The experimental results show that the proper frequency of the prototype is around 50 kHz with input power factor of 0.982, $THD_i$ 10.2% at full load and efficiency of more than 90%.

• Journal of Life Science
• /
• v.17 no.8 s.88
• /
• pp.1104-1110
• /
• 2007

The number of investigated fish collected from the Andong and the Imha reservoir were 2,540 individuals 20 species belonging to 7 families, 850 individuals 11 species belonging to 4 families respectively from May 2005 to March 2006. The total number of the common 3 species individuals investigated caught from the Andong reservoir and the Imha reservoir were 486 individuals and 124 individuals respectively. The investigated individuals is similar(${\pm}2.5$ mm) to 171 individuals make a comparative study. The Opsariichthys uncirostris, Culter brevicauda, Hemiculter eigenmanni of length-weight relationship were TW = $0.00007TL^{3.0543}$, TW = $0.0000009TL^{3.3654}$, TW = $0.00000^{3.3872}$ in the Andong reservoir and TW = $0.00002TL^{2.8493}$, TW = $0.00001TL^{2.8744}$, TW = $0.000004TL^{3.1082}$ in the Imha reservoir respectively. The Condition factor(K) of the Andong reservoir showed the positive slopes in all three species and to be in a good nutrition condition; where as the condition factor(K) of the Imha reservoir showed the negative slopes in two species except in H. eigenmanni and appeared to be in a little bad nutrition condition. Relative condition factor(Kn) indicating that O. uncirostris and C. brevicauda in Andong reservoir is more rotund than ones of Imha reservoir but H. eigenmanni in the Imha reservoir is more rotund than the ones of the Andong reservoir.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.71-78
• /
• 2010

The stability analysis of unsaturated infinite slope under rainfall-induced infiltration condition was performed using the generalized effective stress that unifies both saturated and unsaturated condition recently proposed by Lu and Likos(2004, 2006). The Soil-Water Characteristic Curve (SWCC) of the sand with the relative density of 75% was first measured for both drying and wetting processes. The Hydraulic Conductivity Function (HCF) and Suction Stress Characteristic Curve (SSCC) were subsequently estimated. Also, under the rainfall-induced infiltration condition transient seepage analysis of unsaturated infinite slope was performed using the finite element program, SEEP/W. Based on these results, the stability of unsaturated infinite slope under rainfall-induced infiltration condition was examined considering the suction stress. According to the results, the negative pore water pressure and water content within the soil changed with time due to the infiltration. Also, the variation of those caused the variation of suction stress and then the factor of safety of slope changed consequently during the rainfall period.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.13 no.5
• /
• pp.51-58
• /
• 2010

This study was done to recommend a method for conserving the habitat of Amblyotropis verna grown naturally in campus of the Kyungpook National University at Daegu city. Vegetation characteristics and morphological characteristics of each individual were analyzed for the condition of the population at the growing season from May to June in 2010. Totally 11 vegetation data were collected and analyzed, and one vegetation community including Amblyotropis verna (Amblyotropis verna-Zoysia japonica community) was found. We found that the growing condition was not good with severe stamping and disturbance. The location-determining method by PCoA analysis showed the physical texture in soil was a critical factor determining the spatial distribution of the Amblyotropis verna-Zoysia japonica community. And the analysis of morphological characteristics found that light condition and soil hardness were the main ecological factor determining the size and form of each individual. Finally, this study recommend that minimizing impacts by human stamping and artificial disturbance and reducing the water stress were the best ways for the conservation of Amblyotropis verna habitats.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.29 no.4
• /
• pp.149-158
• /
• 2017

In general, the air-side j and f factors of evaporators or condensers are obtained through single-design tests performed under air-dry and wet-bulb temperatures. Considering that the indoor or outdoor air temperatures vary significantly during the operation of an air conditioner, it is necessary to confirm that the experimentally-obtained j and f factors are widely applicable under variable air conditions. In this study, a series of tests were conducted on a two-row slit-finned heat exchanger to confirm the applicability. The results showed that, for the dry-surface condition, the changes of the tube-side water temperature, water-flow rate, and air temperature had virtually no effect on the air-side j and f factors. For the wet condition, however, the f factor was significantly affected by these changes; contrarily, the j factor is relatively independent regarding this change. The formulation of the possible reasoning is in consideration of the condensation behavior underneath the tube. The wet-surface j and f factors are larger than those of the dry surface, with a larger amount for the f factor.

• Journal of Environmental Science International
• /
• v.17 no.5
• /
• pp.485-491
• /
• 2008

The present study examined the relation between land cover condition and temperature in various types of urban green spaces. The diagram of temperature distribution showed that high-temperature zones are formed around paved areas, and low temperature zone around planted areas and grassy areas. Even in planted areas where low-temperature zones were formed, temperature was different according to hierarchical structure. That is, temperature was relatively low in areas covered with arbor + sub-arbor. With regard to land cover ratio, the increase of planted areas and grassy areas had an effect on the fall of temperature and the effect was higher in order of planted areas and grassy areas. On the contrary, paved areas and bare areas had an effect on the rise of temperature. According to the results of factor analysis, in case of the highest temperature, planted area and grassy area were put together into a factor lowering temperature, paved area and temperature into a factor raising temperature, and bare area alone into a factor of low significance. In case of the lowest temperature, grassy area and bare area were put together into a factor, and the validity of the factor analysis was proved by the analysis of urban heat islands. An increase in the number of trees by height was effective in lowering temperature, and the effect was high in order to arbor and sub-arbor, and the source of coldness in planted area was tall trees.