• 한국가시화정보학회지
• /
• 제17권3호
• /
• pp.24-31
• /
• 2019

Recently, an air-lift bio-reactor operated by micro bubbles has been utilized to product hydrogen fuel. To enhance the performance, characteristics of hydrodynamics inside the bio-reactor were analyzed using a numerical simulation for two-phase flow. An Eulerian model was employed for both of liquid and gas phases. The standard k-ε model was used for turbulence induced by micro bubbles. A Population Balance Model was employed to consider size distribution of bubbles. A hollow cylinder was introduced at the center of the reactor to reduce a dead area which disturbs circulation of CO bubbles. An appropriate diameter of the draft tube and hollow cylinder were optimized for better performance of the bio-reactor. The optimum model could be obtained when the cross-sectional area ratio of the hollow cylinder to the reactor, and the width ratio of the riser to the downcomer approached 0.4 and 3.5, respectively. Consequently, it is expected that the optimum model could enhance the performance of the bio-reactor with the homogeneous distribution and higher density of CO, and more effective mixing.

• 대한방사선기술학회지:방사선기술과학
• /
• 제18권2호
• /
• pp.49-59
• /
• 1995

Recently, general radiography became to variety because of the continuous development of Inverter type generator and ortho chromatic system. Therefore, we must re-evaluate about patient exposure dose and image quality. I studied about chest radiography which has frequency among general radiography being used during FEB. to AUG., 1994 over 151 medical facilities from medical facilities that are located in Seoul area. The result obtained were as follows ; 1) The rectification method of the generator were employing mainly single phase full wave in 82.8 %, three phase full wave in 11.26 % and Inverter type in 4.64 % and condenser type is 1.32 %. 2) Exposure kV was used below 80 kV in most medical facilities and 21.8 % of the medical facilities was using high tube voltage higher than 120 kV. 3) The exposure time was used below the 0.05 sec in 28.4 %, in 29.8 % of the medical facilities used above 0.1 sec. 4) The usage frequency of the added filter is 15.3 %, and among them compound filter was used only 4 %. 5) Rare earth screen was used in 37.7 %. 6) The average skin entrance dose was 0.25 mSv, the range of dose is $0.05{\sim}0.79\;mSv$ in each medical facilities. 7) The average density of the lung field is 1.76, 0.49 in lung side, 0.30 in mediastinum and 0.37 in heart shadow. Therefore it is required to improve all of these for increasing image quality and reducing patient exposure dose as soon as possible.

• 한국자동차공학회논문집
• /
• 제19권5호
• /
• pp.134-142
• /
• 2011

Although combustion is essential in most energy generation processes, it is one of the major causes of air pollution. Exhaust pipes with circular fin were designed to study the effect of cooling the recirculated exhaust gases (EGR) of Diesel engines on the chemical composition of the exhaust gases and the reduction in the percentages of pollutant emissions. The gases examined in this study were oxides of nitrogen (NOx), carbon dioxide ($CO_2$) and carbon monoxide (CO). In addition, $O_2$ concentration in the exhaust was measured. The designs adopted in this study were about exhaust pipes with solid and hollow fins around them direct surface force measurement in water using a nano size colloidal probe technique. The direct force measurement between colloidal surfaces has been an essential topic in both theories and applications of surface chemistry. As particle size is decreased from micron size down to true Carbon nano Colloid size (<10 nm), surface forces are increasingly important. Nano particles at close proximity or high solids loading are expected to show a different behavior than what can be estimated from continuum and mean field theories. The current tools for directly measuring interaction forces such as a surface force apparatus or atomic force microscopy (AFM) are limited to particles much larger than nano size. This paper use Water and CNC fluid at normal cooling system of EGR. Experimental result showed all good agreement at Re=$2.54{\times}10^4$ by free convection and Re=$3.36{\times}10^4$ by forced air furnace.

• 한국자동차공학회논문집
• /
• 제19권5호
• /
• pp.58-66
• /
• 2011

A 2-loop waste heat recovery system with Rankine steam cycles for the improvement of fuel efficiency of gasoline vehicles has been investigated. A high temperature loop(HT loop) is a system to recover the waste heat from the exhaust gas, a low temperature loop(LT loop) is for heat recovery from the engine coolant cold relatively. This paper has dealt with a layout of a LT loop system, the review of the working fluids, and the design of the cycle. The design point and the target heat recovery of the LT boiler, a core part of a LT loop, has been presented and analytically investigated. Considering the characteristics of the cycle, the basic concept of the LT boiler has been determined as a shell-and tube type counterflow heat exchanger, the performance characteristics for various design parameters were investigated.

• Macromolecular Research
• /
• 제11권5호
• /
• pp.334-340
• /
• 2003

In order to fabricate new sustained delivery device of nerve growth factor (NGF), we developed NGF-loaded biodegradable poly(L-lactide-co-glycolide) (PLGA, the mole ratio of lactide to glycolide 75:25, molecular weight: 83,000 and 43,000 g/mole, respectively) film by novel and simple sandwich solvent casting method for the possibility of the application of neural tissue engineering. PLGA was copolymerized by direct condensation reaction and the molecular weight was controlled by reaction time. Released behavior of NGF from NGF-loaded films was characterized by enzyme linked immunosorbent assay (ELISA) and degradation characteristics were observed by scanning electron microscopy (SEM) and gel permeation chromatography (GPC). The bioactivity of released NGF was identified using a rat pheochromocytoma (PC-12) cell based bioassay. The release of NGF from the NGF-loaded PLGA films was prolonged over 35 days with zero-order rate of 0.5-0.8 ng NGF/day without initial burst and could be controlled by the variations of molecular weight and NGF loading amount. After 7 days NGF released in phosphate buffered saline and PC-12 cell cultured on the NGF-loaded PLGA film for 3 days. The released NGF stimulated neurite sprouting in cultured PC-12 cells, that is to say, the remained NGF in the NGF/PLGA film at 37 $^{\circ}C$ for 7 days was still bioactive. This study suggested that NGF-loaded PLGA sandwich film is released the desired period in delivery system and useful neuronal growth culture as nerve contact guidance tube for the application of neural tissue engineering.

• Nuclear Engineering and Technology
• /
• 제44권5호
• /
• pp.551-560
• /
• 2012

The Wolsong-1 (W-1) Phase-B pre-simulations were carried out in preparation for tests to be conducted for the restart of the reactor after a major refurbishment project that included replacement of the pressure tube. These pre-simulations for Wolsong-1 Phase-B differ from those in the past that were performed for the Wolsong-1,2,3,4 tests in that these tests use the WIMS/DRAGON/RFSP-IST code suite for verification of the tests and gadolinium instead of the traditional PPV/MULTICELL/RFSP code system and boron as poison in the moderator system. The use of gadolinium is deemed not to have domestically accumulated experience gained from the previous Phase-B tests. Thus, it is appropriate to conduct a study in order to gain a correct understanding and interpretation of potential differences in test results stemming from using gadolinium rather than boron. Although the calibration of the reactivity device will not be noticeably different using boron and gadolinium at a constant moderator temperature, the temperature dependency of the neutronic behavior due to the presence of gadolinium in the moderator system might be pronounced. The results of the pre-simulations using gadolinium revealed that the moderator temperature reactivity coefficients indeed showed significant differences in comparison with those with boron. In order to secure the validity of the analysis results, the newly acquired WIMS/DRAGON/RFSP-IST code suite was verified against the W-2,3,4 Phase-B test results. The results of the new code suite verifications revealed some overall improvements in accuracy; justification of the use of the code can be claimed for the validation of the W-1 Phase-B test results.

• The Plant Pathology Journal
• /
• 제32권5호
• /
• pp.460-468
• /
• 2016

To study the control of postharvest decay caused by Colletotrichum gloeosporioides and Penicillium expansum, gamma irradiation alone or in combination with fumigation was evaluated to extend the shelf life of apples in South Korea. An irradiation dose of 2.0 kGy resulted in the maximum inhibition of C. gloeosporioides and P. expansum spore germination. The gamma irradiation dose required to reduce the spore germination by 90% was 0.22 and 0.35 kGy for C. gloeosporioides and P. expansum, respectively. Microscopic observations revealed that when the fungal spores were treated with gamma irradiation (4.0 kGy), conidial germination was stopped completely resulting in no germ tube formation in C. gloeosporioides. Treatment with the eco-friendly fumigant ethanedinitrile had a greater antifungal activity against C. gloeosporioides and P. expansum in comparison with the non-treated control under in vitro conditions. The in vitro antifungal effects of the gamma irradiation and fumigation treatments allowed us to further study the effects of the combined treatments to control postharvest decay on stored apples. Interestingly, when apples were treated with gamma irradiation in combined with fumigation, disease inhibition increased more at lower (< 0.4 kGy) than at higher doses of irradiation, suggesting that combined treatments reduced the necessary irradiation dose in phytosanitary irradiation processing under storage conditions.

• 대한지역사회영양학회지
• /
• 제27권4호
• /
• pp.273-285
• /
• 2022

Objectives: This study compared the nutritional intakes of early and late preterm infants in a neonatal intensive care unit (NICU) and at home. The dietary problems and the need for community care services for premature infants were further investigated. Methods: This is a cross-sectional and descriptive study on 125 preterm infants and their parents (Early preterm n = 70, Late preterm n = 55). The data were collected by surveying the parents of preterm infants and from hospital medical records. Results: No significant differences were obtained between the early and late preterm infant groups when considering the proportion of feeding types in the NICU and at home. Early preterm infants were fed with a greater amount of additional calories at home and had more hours of tube feeding (P = 0.022). Most preterm infants had feeding problems. However, there was no significant difference between early and late preterm infants in the mental pain of parents, sleeping, feeding, and weaning problems at home. Many parents of preterm babies had no external support, and more than half the parents required community care to take care of their preterm babies. Conclusions: Regardless of the gestational age, most preterm infants have several problems with dietary intake. Our study indicates the need to establish community care services for preterm infants.

• Journal of Plant Biotechnology
• /
• 제49권4호
• /
• pp.271-291
• /
• 2022

Pectin methylesterase (PME) plays an important role in vegetative and reproductive development and biotic/abiotic stress responses by regulating the degree of methyl-esterification of pectic polysaccharides in the plant cell wall. PMEs are encoded by a large multigene family in higher land plant genomes. In general, the expression of plant PME genes shows tissue- or cell-specific patterns and is induced by endogenous and exogenous stimuli. In this study, we identified PME multigene family members (CsPMEs) from the sweet orange genome and report detailed molecular characterization and expression profiling in different citrus tissues and two fruit developmental stages. We also discussed the possible functional roles of some CsPME genes by comparing them with the known functions of PMEs from other plant species. We identified 48 CsPME genes from the citrus genome. A phylogenetic tree analysis revealed that the identified CsPMEs were divided into two groups/types. Some CsPMEs showed very close phylogenetic relationships with the PMEs whose functions were formerly addressed in Arabidopsis, tomato, and maize. Expression profiling showed that some CsPME genes are highly or specifically expressed in the leaf, root, flower, or fruit. Based on the phylogenetic relationships and gene expression profiling results, we suggest that some CsPMEs could play functional roles in pollen development, pollen tube growth, cross incompatibility, root development, embryo/seed development, stomata movement, and biotic/abiotic stress responses. Our results shed light on the biological roles of individual CsPME isoforms and contribute to the search for genetic variations in citrus genetic resources.

• 자원리싸이클링
• /
• 제23권1호
• /
• pp.58-63
• /
• 2014

전기로 제강분진(EAFD)으로부터 환원배소에 의해 회수한 조산화 아연 내에는 다양한 종류의 비등점이 낮은 물질이 존재한다. 따라서 일반적으로 산화배소를 통한 정제과정을 통해 염화물 형태로 존재하는 물질들을 기화시켜 고순도의 기능성 산화아연을 생산하게 된다. 따라서 본 연구에서는 조산화 아연의 산화배소 특성을 체계적으로 규명하여 대량생산공정에 적용할 때의 효율성을 극대화하고자 하였다. 조산화 아연을 적절한 방법을 통해 직경 1-3 mm, 10 mm의 펠렛을 제조하여, 각 시편을 분말시편과 함께 수직 관상로에서 로타리 킬른의 실조업을 묘사하여 산화분위기에서 $600{\sim}1200^{\circ}C$ 온도영역까지 $20^{\circ}C/hr$ 승온속도로 가열하면서 체재시간을 유지하였다. 실험결과 펠렛의 크기에 따른 기화속도의 변화가 $950^{\circ}C$ 이상의 온도에서는 현저히 증가함을 알 수 있었다. 회수된 시편은 ICP-OES, XRF장비를 통하여 성분분석을 실시한 결과 Zn의 농도는 비례적으로 증가함을 알 수 있었으며, Cl 등의 불순물의 농도도 현저히 감소하였다. XRD 분석결과 온도가 증가할수록 염화물 피크는 관찰되지 않았으며, 본 산화배소실험을 통하여 98%이상의 고순도 산화아연을 얻을 수 있었다.