• 한국태양에너지학회 논문집
• /
• 제29권4호
• /
• pp.7-14
• /
• 2009

Nucleate pool boiling experiments with constant heat flux condition were performed using pure R11 and R113 for various surface angles under saturated pool condition. A circular heater of 1 mm diameter, with artificial cavity in the center, fabricated using MEMS technique and the high-speed controller were used to maintain the constant heat flux. Images of bubble growth were taken at 5,000 frames per second using a high-speed CCD camera. The bubble geometry was obtained from the captured bubble images. The effects of surface angles on the bubble growth behaviors were analyzed as dimensional scales for the initial and thermal growth regions. The parameters for the bubble growth behaviors were bubble radius, bubble growth rate, sliding velocity, bubble shape and advancing and receding contact angles. These phenomena require further analysis for various surface angles, but this study will provide good experimental data with constant heat flux boundary condition for such works.

• Journal of the Optical Society of Korea
• /
• 제12권3호
• /
• pp.126-130
• /
• 2008

We propose and experimentally demonstrate an effective method to reduce near-field speckle noise at the output of a 50 ${\mu}m$ graded index multimode fiber using a short cylindrical piezoelectric transducer(PZT) vibrating in the radial direction. The fiber was coiled as tightly as possible around the mandrel of the PZT and a periodic stretching effect was caused by the radial oscillations of the actuator. The output of the optical fiber using the He-Ne laser source was intensively observed by a CCD camera. By counting all the pixels corresponding to relative intensity graded into 256 levels in the selected area and by calculating standard deviation and mean value of the intensity, we could measure the speckle contrast and vibration effect quantitatively with reduction ratio of pixels and line profile of the illuminated region. It was clearly observed that the characteristics of the speckle pattern in the vibration-on state were significantly improved over that of the vibration-off state due to time-averaged smoothing.

• 제어로봇시스템학회논문지
• /
• 제19권12호
• /
• pp.1061-1066
• /
• 2013

In the steel industry, the detection of tiny defects including its 3D characteristics on steel surfaces is very important from the point of view of quality control. A multi-spectral photometric stereo method is an attractive scheme because the shape of the defect can be obtained based on the images which are acquired at the same time by using a multi-channel camera. Moreover, the calculation time required for this scheme can be greatly reduced for real-time application with the aid of a GPU (Graphic Processing Unit). Although a more reliable shape reconstruction of defects can be possible when the numbers of available images are increased, it is not an easy task to construct a camera system which has more than 3 channels in the visible light range. In this paper, a new 6-channel camera system, which can distinguish the vertical/horizontal linearly polarized lights of RGB light sources, was developed by adopting two 3-CCD cameras and two polarized lenses based on the fact that the polarized light is preserved on the steel surface. The photometric stereo scheme with 6 images was accelerated by using a GPU, and the performance of the proposed system was validated through experiments.

• 전자공학회논문지S
• /
• 제36S권10호
• /
• pp.94-102
• /
• 1999

본 논문에서는 카메라의 조명궤적과 화상내의 광휘점 (highlight) 영역의 화소들이 형성하는 색도좌표 군집에 대한 근사된 직선과의 교점을 카메라 촬영 장면에서의 조명색으로 결정하는, 카메라 촬영 장면의 조명색을 화상으로부터 직접 추정하는 방법을 제안하였다. 이 방법은 카메라의 조명에 대한 반응 특성을 사전 정보로 제공함으로써 기존의 화상내의 광휘점 정보망을 이용하던 방법에 비해 더욱 정확한 조명색 추정을 가능하게 한다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 춘계학술대회 논문집
• /
• pp.19-23
• /
• 1998

Water tree degradations have been considered as one of the most important causes of failure in underground distribution cables with polymeric insulation. Water tree growth is a preliminary step in the sequence of electrical tree initiation and electrical breakdown of the insulation. In this paper, needle electrode is made use of the etching methods and the pellet type specimen is made to observe the water tree in succession. In previous methods are able to observe the tree degradations without cutting and dyeing. The water tree image is recorded on VTR with CCD camera. The tree length of X, Y axis direction and aging area(treeing area) are calculated with image measurement. As a result of this study, water tree is observed by non-destructive method. Electrical tree is initiated from needle electrode tip only but water tree is initiated from total area of water electrode. Electrical tree owing to water treeing is initiated at low electric field and grown with discontinuously. Namely, water tree is shown up a different characteristics of tree growth.

• Journal of Advanced Marine Engineering and Technology
• /
• 제24권4호
• /
• pp.446-453
• /
• 2000

The closed cycle diesel system is operated in closed circuit system where there is non air breathing with working fluid consisted of the combination of oxygen, argon and recycled exhaust gas for obtaining underwater or underground power sources. this study has been carried out to analysis the performance of closed cycle system by means of investigation on the combustion characteristics of diesel engine MTU8V183TE52 operating in open, semi-closed, and closed cycle modes. The combustion in closed mode starts a little bit earlier than in open cycle mode. The oxygen concentration and fuel consumption at 240kW closed cycle running are 21∼24% by volume and 77∼79kg/h, respectively. The maximum cylinder pressure and ignition delay time are investigated 110bar and 8.9degree. Also, The combustion simulation program has been studied to predict whether or not combustion. The results from numerical prediction for the basic, cylinder averaged quantities such as the cylinder pressure and the heat release showed excellent with the experimental data.

• 중소기업융합학회논문지
• /
• 제6권3호
• /
• pp.85-91
• /
• 2016

이 논문의 목적은 낮은 화소 수나 어두운 렌즈를 사용하는 CCTV는 자동차의 번호판이나 범죄자를 인식하기 어렵기 때문에 화소수를 높이고 밝은 렌즈를 사용하기 위함이다. 구면수차와 왜곡수차를 줄이기 위하여 2매의 비구면 렌즈를 적용하고 300만 화소에 적절한 줌렌즈의 설계와 이에 의한 특성을 제시하였다. 초점거리는 6-60mm를 적용하였고 F수는 1.2를 구현하였다. 적외선 보정을 실시하여 주야 초점거리가 같도록 설계하였다. 결과적으로 이 규격은 6-60mm 10배줌 렌즈의 규격 중 가장 우수하다. 이 렌즈를 적용한다면 50m거리에서 얼굴이나 차번호의 인식이 가능하다. 향후 이 렌즈의 자동화 구현이 필요하다.

• 대한영양사협회학술지
• /
• 제23권1호
• /
• pp.14-26
• /
• 2017

The purpose of this study was to determine the optimal recipe of rice cookies with two different amounts of Stevia rebaudiana leaf and grape seed oil, using a central composite design (CCD). In addition, mixing conditions of rice cookies were optimized by sensory evaluation and mechanical and physicochemical analysis using response surface methodology (RSM). RSM was used to obtain 10 experimental points (including two replicates of Stevia rebaudiana leaf and Grape seed oil), and the formulation of Stevia rebaudiana leaf added rice cookies was optimized using rheology. The results of mechanical and physicochemical analysis showed significant values for lightness, redness, yellowness, hardness, spread factor, loss rate, leavening rate, sweetness, moisture, pH, and density (P<0.001), results of the sensory evaluation showed significant values for color, flavor, taste, texture, appearance, and overall quality (P<0.05). As a results, optimal sensory ratio was found to be 1.98 g of Stevia rebaudiana leaf and 37.94 g of Grape seed oil.

• 천문학회보
• /
• 제36권1호
• /
• pp.65.1-65.1
• /
• 2011

We built a simple Adaptive Optics (AO) system at laboratory. This AO system is a step toward developing AO system for astronomical use. In this step, the AO system consists of He-Ne laser as a artificial light source, wavefront sensor, MEMS (Micro electro mechanical system) type deformable mirror and several lenses. MEMS deformable mirror allows the compact system at low cost and the only several mm sized collimated beam. We made Shack-Hartmann wavefront sensor using a lenslet array and a fast frame CCD. Its performance is verified using an artificial phase disturber and noting the movement of spot images by the lenslet array. The frame rate of the driving software is about 70 fps, depending on the control parameters. The characteristics of MEMS deformable mirror was measured which includes the voltage-to-deflection relation, influence function, and cross-talk. The total system is operated under closed-loop control for the artificial phase disturber and the wavefront is found to be compensated successfully.

• Journal of information and communication convergence engineering
• /
• 제11권3호
• /
• pp.185-189
• /
• 2013

A digital hologram generated by a computer calculation (computer-generated hologram or capture using charge-coupled device [CCD] camera) is one of the most expensive types of content, and its usage is expanding. Thus, it is highly necessary to protect the ownership of digital holograms. This paper presents an efficient visual security scheme for holographic image reconstruction with a low scrambling cost. Most recent studies on optical security concentrate their focus on security authentication using optical characteristics. However, in this paper, we propose an efficient scrambling method to protect a digital hologram. Therefore, we introduce in this paper several scrambling attempts in both the spatial domain and frequency domain on the basis of the results of analyzing the properties of the coefficients in each domain. To effectively hide the image information, 1/4, 1/256, and 1/16,384 of the original digital hologram needs to be scrambled for the spatial-domain scheme, Fresnel-domain scheme, and discrete cosine transform-domain scheme, respectively. The encryption schemes and the analyses in this paper can be expected to be useful in the research on encryption and other works on digital holograms.