• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07a
• /
• pp.387-390
• /
• 2002

This paper presents deposition and characterizations of microcrystalline silicon(${\mu}$c-Si:H) films prepared by hot wire chemical vapor deposition at substrate temperature below 300$^{\circ}C$. The SiH$_4$ concentration[F(SiH$_4$)/F(SiH$_4$).+(H$_2$)] is critical parameter for the formation of Si films with microcrystalline phase. At 6% of silane concentration, deposited intrinsic ${\mu}$c-Si:H films shows sufficiently low dark conductivity and high photo sensitivity for solar cell applications. P-type ${\mu}$c-S:H films deposited by Hot-Wire CVD also shows good electrical properties by varying the rate of B$_2$H$\_$6/ to SiH$_4$ gas. The solar cells with structure of Al/nip ${\mu}$c-Si:H/TCO/g1ass was fabricated with single chamber Hot-Wire CVD. About 3% solar efficiency was obtained and applicability of HWCVD for thin film solar cells was proven in this research.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.17 no.1
• /
• pp.1-5
• /
• 2007

The structural and morphological properties of planar, nonpolar (11-20) a-plane GaN layers grown by hydride vapor phase epitaxy on (1-102) r-plan sapphire substrates are characterized. We report on the effect of low temperature ($500/550/600/660^{\circ}C$) AIN buffer layers on the structural properties of HVPE grown a-GaN kayers. and for the comparison, low temperature GaN and InGaN buffer layers are also tried for the growth of a-plane GaN layers. The structural geometry of a-GaN layers is severely affected on the growth condition of low temperature buffer layers. The most planar a-GaN could be obtained with $GaCl_3$ pretreatment at the growth temperature of $820^{\circ}C$.

• Radiation Oncology Journal
• /
• v.16 no.2
• /
• pp.91-98
• /
• 1998

Purpose : The relationship between environmental PH on the radiation induced-apoptosis in SCK mammary adenocarcinoma cells and cell cycle dependence was investigated. Material and Methods : Mammary adenocarcinoma cells of A/J mice(SCK cells) in exponential growth phase were irradiated with a $l37^Cs$ irradiator at room temperature. The cells were irradiated 1 hour after the media was replaced with fresh media at a different pHs. After incubation at $37^{\circ}C$ for 0-48 h, the extent of apoptosis was determined using agarose gel electrophoresis and flow cytometry. The progression of cells through the cell cycle after irradiation in different pHs was also determined with flow cytometry. Bssults : The induction of apoptosis by irradiation in pH 6.6 medium was markedly less than that in pH 7.5 medium. When the cells were irradiated and maintained in pH 7.5 medium, the percentage of cells in $G_2/M$ phase rapidly increased to about $70\%$ at 12 h after an exposure to 120y and returned to control level by 36 h. The percentage of cells in G1 phase decreased as the percentage of cells in $G_2/M$ increased. On the other hand, in pH 6.6 medium the percentage of cells in G2/M phases gradually increased to about $45\%$ at 24 h after 12Gy irradiation and then slowly recessed and consequently, as much as $30-35\%$ of the cells were still in the Ga/M phase 48 h after irradiation. The percentage of cells in G1 phase then increased as the Ga/M arrest began to recede. The radiation-induced Ga/M arrest in PH 0.0 medium lasted markedly longer than that in pH 7.5 medium. Conclusion : Radiation-induced apoptosis in SCK tumor cells are reversely suppressed in an acidic environment. Radiation-induced Ga/M arrest is prolonged in an acidic environment indicating that the suppression of radiation-induced apoptosis and prolongation of radiation-induced Ga/M arrest in an acidic environment are related.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07a
• /
• pp.468-471
• /
• 2003

Fault of under ground power cable occurs usually from the water tree such as the vented tree, the bow tree and the water-rich halo. The water tree penetrates to the polyethylene cable insulations. Sometimes, the water tree also diffuses to mother cable in the substation. In this paper, instead of replacement of the faulty cable, we tried to cure an electrical power cable degraded by the water trees with silicon injection method. And measured the results with the isothermal relaxation current analysis method. After cable cure, Chonil line was improved from 2.27 to 1.96 in a phase, from 2.148 to 2.020 in b phase, and from badness to 2.192 in c phase. And Keumam line was also improved from 2.419 to 1.920 in a phase, from 2.301 to 2.000 in b phase, and from badness to 1.957 in c phase.

• Proceedings of the KOSOMBE Conference
• /
• v.1998 no.11
• /
• pp.307-308
• /
• 1998

In this paper, we describe a field measurement technique using multiple gradient echo method. For this purpose, 3 differential phase map is used between two images obtained in a single scan. The phase map is further processed to unfold phase folding (2n $\pi$). The inhomogeneity map is used to correct image distortion along readout gradient direction. Some experimental results obtained at 1.0 Tesla whole body MR system are shown with the proposed technique.

• Applied Chemistry for Engineering
• /
• v.5 no.4
• /
• pp.573-579
• /
• 1994

1-O-oleoyl glycerol, 2-O-oleoyl myo-inositol and methyl 2-O-oleoyl-${\alpha}$-D-glucopyranoside were used as surfactants in this study. The solution properties and solubilization process of those nonionic surfactants were examined by the phase equilibria. As a result of this study, we have found that phase behavior of two component systems of surfactants/$H_2O$/cyclohexane depends on temperature respectively. The three phase regions of three component systems appeared in the temperature range of $27^{\circ}C{\sim}32^{\circ}C$, $36^{\circ}C{\sim}45^{\circ}C$ and $38^{\circ}C{\sim}52^{\circ}C$ and solubilization of water and oil was high in those three phase ranged As the temperature was varied in the two component systems, liquid crystals of hexagonal were observed to in the case of 1-O-oleoyl glycerol, and liquid crystal of lamella types were observed in the case of 2-O-oleoyl myo-inositol and methyl 2-O-oleoyl-${\alpha}$-D-glucopyranoside.

• Proceedings of the KIEE Conference
• /
• 2003.07b
• /
• pp.933-935
• /
• 2003

The single-phase line start permanent magnet motor(LSPM) have a rotor cage bar for induction starting and permanent magnets, providing synchronous torque. So, LSPM is vary complex and difficult to analysis transient characteristics and rotor design. In this paper, F.E.M analysis about single-phase line start permanent magnet motor and compare of the single-phase line start permanent magnet synchronous motor's transient characteristics by size and position of rotor bar.

• Proceedings of the KIEE Conference
• /
• 1998.11a
• /
• pp.37-39
• /
• 1998

The hybrid step motor has found applications in a wide range of mechanical systems as a low cost, open-loop positioning device. The step motor provides good stiffness at rest against disturbing load influences, a combination of moderate speed fine resolution, high reliability and simplicity. In recent years, considerable competition has arisen over the technological issue of wheather the device should be applied as a 2-Phase or 5-Phase machine. In this paper, to compare two systems, we have atempted to derive the mathematical. model, and analysed operating detent torque with this model. The analysis shows that a fundamental component of the permeance distribution produces the average torque and that harmonic components produce the ripple torque.

• Journal of Pharmaceutical Investigation
• /
• v.25 no.3
• /
• pp.239-247
• /
• 1995

The physico-chemical stability of aucubin, a hepatoprotective iridoid glucoside, in buffered aqueous solutions was studied using a stability-indicating reversed-phase high performance liquid chromatography. The degradation of aucubin followed the pseudo-first-order kinetics. In strong acidic regions, aucubin was rapidly degraded by the specific acid catalysis, forming dark brown precipitates. From the rate-pH profiles, it was found that aucubin was most stable at the pH of about 10. From the temperature dependence of degradation, activation energies for aucubin at pH 2.1 and 4.9 were calculated to be 22.0 and 24.3 kcal/mole, respectively. The shelf-life $(t_{90%})$ for aucubin at pH 9.07 and $20^{\circ}C$ was predicted to be about 603 days. A higher ionic strength accelerated the degradation of aucubin at pH 4.01. The effect of metal ions on the degradation rate of aucubin at pH 7.16 was in the rank order of $Cu^{2+}\;>\;Fe^{3+}\;>\;Co^{2+}\;>\;Fe^{2+}\;>\;Mg^{2+}$. On the other hand, $Mn^{2+}\;and\;Ba^{2+}$ slowed the degradation rate.

• Journal of the Korean Society for Heat Treatment
• /
• v.16 no.2
• /
• pp.78-82
• /
• 2003

Nitrided compound layer and diffusion layer structure were observed by SEM. The compound layer and the constituent of nitrided surface of STS 304, STS 316, STS 410 and SACM 645 steel were analysed using EMPA and XRD respectively. The depth of nitriding layer that is obtained from similar nitriding condition decrease in the order of SACM 645 > STS 410 > STS 316 > STS 304. Result of phase transformation of the nitrided at $550^{\circ}C$ by XRD analysis were as follows; The austenitic stainless steel was mainly consist of $Cr_2N$ accompanying with $Fe_4N$ and $Fe_{2-3}N$ phase and martensitic stainless steel was mainly consist of present $Fe_{2-3}N+Cr_2N$ phase, but SACM 645 steel was $Fe_{2-3}N$ phase present only.