• Journal of The Korean Astronomical Society
• /
• v.48 no.1
• /
• pp.1-7
• /
• 2015

The orbital period changes of the W UMa eclipsing binary AU Ser are studied using the (O-C) method. We conclude that the period variation is due to mass transfer from the primary star to the secondary one at a very low and decreasing rate $dP/dt=-8.872{\times}10^{-8}$, superimposed on the sinusoidal variation due to a third body orbiting the binary with period $42.87{\pm}3.16$ years, orbital eccentricity $e=0.52{\pm}0.12$ and a longitude of periastron passage ${\omega}=133^{\circ}.7{\pm}15$. On studying the magnetic activity, we have concluded that the Applegate mechanism failed to describe the cycling variation of the (O-C) diagram of AU Ser.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.2
• /
• pp.12-18
• /
• 1997

An efficient synthesis method of cellular architecture FPgA is proposed in this paper. To generate a logical representation called complex term which is to be directly mapped onto the cellular architecture FPGA, and SO or ESOP minimization tool was used in previous methods. Instead, we use a logic function transformed into BDD (binary decision diagram) in the actual generation of the complex temrs. In this process it estimates the cost(i.e. the number of complex terms) for three branches, 0-branch and 1-branches. This process is continued over the whole BDD to do such computation, and we observed that the number of complex terms has been reduced compared to the previous results.

• Journal of the Korean Society for Heat Treatment
• /
• v.27 no.2
• /
• pp.72-78
• /
• 2014

Isothermal transformation behavior of a 10% Cr heat resistant steel fabricated by centrifugal casting process was investigated. Normalized specimen at $1100^{\circ}C$ for 1 hour was isothermally annealed at temperature range between $600^{\circ}C$ and $700^{\circ}C$ with various time. The annealed specimen had eutectoid structure which was generated along austenitic grain boundary during isothermal annealing. Areal fraction of eutectoid structure increased up to 25% after holding at $700^{\circ}C$ for 20 hours. It was observed that austenitic matrix was transformed to ferrite structure and fine $M_{23}C_6$ carbides with increase of annealing time. Time-temperature-transformation diagram of the centrifugally cast 10% Cr steel with 0.18 wt% C was plotted based on the results of isothermal transformation behavior.

• Korean Journal of Oriental Medicine
• /
• v.12 no.2 s.17
• /
• pp.85-92
• /
• 2006

Pulse is one of the basic diagnostic information of TKM(Traditional Korean Medicine). To quantify and standardize pulse diagnosis, we had collected an amount of clinical data from May 2005 by using newly developed pulse analyzer. But there were many noises in pulse wave according to measuring method, environment, operator and condition of patient. So some data can’t be included for analyzing diagnosis. To reduce noises from measuring pulse and to collect reliable pulse wave data, we made the process map of measuring method and applied six sigma project. With this we can improved the method of measuring pulse wave in collecting clinical data. The project follows a disciplined process of five macro phases: define, measure, analyze, improve and control (DMAIC). A process map and C-E diagram are used to identify process input and output variables. The major input variables are selected by using C&E matrix, and process map is developed by analyzing input variables. And the optimum process conditions are going to be controled to avoid in increasing loss of collecting pulse wave data.

• Korean Journal of Materials Research
• /
• v.5 no.5
• /
• pp.560-567
• /
• 1995

Interfacial reactions, phase equilibria and elecrrical properties of Co films on (001) oreinted GaAs substrate, in the temperature range 300-$700^{\circ}C$ for 30min. have been investigated using x-ray diffraction and Augger electron spectropcopy. Cobalt started to react with GaAs at 38$0^{\circ}C$ by formation of Co$_{2}$GaAs phase. At 42$0^{\circ}C$, CoGa and CpAs nucleated at the Co and Co$_{2}$GaAs interface and grew with Co$_{2}$GaAs upto 46$0^{\circ}C$. contacts produced in this annealing regime were rectifying and Schottky varrier heights increased from 0.688eV(as-deposite state) up to 0.72eV(42$0^{\circ}C$). In the subsequent reation, the ternary phase started to decompose and lost stoichiometry at 50$0^{\circ}C$. At higher temperature, Co$_{2}$GaAs disappered and CoGa/CoAs/GaAs layer structures were formed. Contacts produced at higher temperature regime(>50$0^{\circ}C$) showed very low effective barriers. The results of interfacial reactions can be understood from the Co-Ga-As ternary phase diagram.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2001.05a
• /
• pp.20-23
• /
• 2001

Hypereutectic Al-25Si alloy, which is expected to be applied to the cylinder-liner-part of the engine-block of an automobile due to its excellent wear resistance, low density and low thermal expansion coefficient, has been fabricated through a spray forming process. The obtained microstructure of the hypereutectic Al-25Si alloy appeared to consist of Al matrix and equiaxed Si particles of average diameter of 5-7 mm. To characterize the deformation behavior of this alloy, a series of load relaxation and compression tests have been conducted at temperatures ranging from RT to $500^{\circ}C$. The strain rate sensitivity parameter (m) of this alloy has been found to be very low (0.1) below $400^{\circ}C$ and reached maximum value of about 0.2 at $500^{\circ}C$. During the deformation above $300^{\circ}C$ in compression, strain softening has been observed. The diagram of extrusion pressure vs. ram-speed has been constructed. The extrusion has been successfully conducted at the temperatures of $300^{\circ}C$ and above with the ratio of area reduction of 28 and 40 in this study.

• Journal of the Mineralogical Society of Korea
• /
• v.15 no.3
• /
• pp.161-169
• /
• 2002

high pressure and temperature conditions. However, those results are not consistent with one another, and phase boundary between ilmenite and perovskite phases determined only from the quenching method may be not so reliable at all. Therefore, in-situ high pressure-temperature (hP-T) X-ray diffraction measurements were performed up to 19 GPa and $700^{\circ}C$ in a large volume press apparatus using synchrotron radiation. Experimental results show that perovskite phase is stable at pressures above 16 GPa, and transforms back to $LiNbO_3$phase near 15 CPa at room temperature, and that the perovskite-ilmenite transition is back and forth near 15 CPa at $500^{\circ}C$. LiNbO$_3$phase transforms to ilmenite at 13 CPa and $300^{\circ}C$ and at 10.8 CPa and $400^{\circ}C$, respectively. These data indicate that $LiNbO_3$phase may have a stability region in the hP-T phase diagram and that the perovskite-ilmenite phase boundary would be quite different from that previously reported.

• Journal of Pharmaceutical Investigation
• /
• v.37 no.5
• /
• pp.291-295
• /
• 2007

Prostaglandin $E_1\;(PGE_1)$ was formulated as two self-microemulsifying drug delivery systems (SMEDDS) composed of Cremophor $EL^{(R)}$ or Cremophor $ELP^{(R)}$ as a surfactant, ethanol as a cosurfactant and Labrafac $CC^{(R)}$ as an oil to develop liquid preparation for the treatment of erectile dysfunction. In pseudo-ternary phase diagram, viscous gel area and microemulsion area were defined. In the measurement of viscosity, the viscosity of two formulations increased gradually upon the addition of water and it decreased from the water contents over 40%. With excessive water, the present systems formed a microemulsion spontaneously. From these results, rte could expect that the present liquid $PGE_1$ SMEDDS formulations might stay within the urethra in the viscous state when contacting the moisture of the urethra and can be easily eliminated by urination. In long-term stability study, we could select one formulation more stable at the shelf storage condition of $4^{\circ}C$.

• Economic and Environmental Geology
• /
• v.34 no.6
• /
• pp.523-537
• /
• 2001

The physical properties of pH, turbidity, TDS and salt contents in the stream water near the entrance of Woonjcongdong sanitary landfill area with a drainage pipe are higher than those in neighbored drainage system, but DO it lower than that in neighbored drainage system blue to the eutrophication. In the ground water, pH, turbidity, TDS and salt contents at A ,F and C where may be under effect of the Woonjeongdong sanitary landfill area, are also shown higher values in contrast to other groundwater site, like B , D , and E , Particularly, the groundwater in A , F and C are plotted in Na-Cl type (If the piper diagram, which is an another important prolf of the contaminapion by the leachate and washing water from the Woonjeongdong sanitary landfill area. Some elements and physical properties of the waters in rainy season are desplayed a clear characteristics of contaminaton, compared to the theose of winter in thes study. Elements such as Ca, Mg, Na, K, Cl­,$SO_4^{2-} , \;and \;F­^-$) are accompanied well with each other by the result of water in the vicinity of landfillarea.

• Journal of The Korean Astronomical Society
• /
• v.46 no.4
• /
• pp.151-159
• /
• 2013

We discuss the orbital period changes of the Algol semi-detached eclipsing binary DI Peg by constructing the (O-C) residual diagram via using all the available precise minima times. We conclude that the period variation can be explained by a sine-like variation due to the presence of a third body orbiting the binary, together with a long-term orbital period increase (dP/dt=0.17 sec/century) that can be interpreted to be due to mass transfer from the evolved secondary component (of rate $1.52{\times}10^{-8}M_{\odot}/yr$) to the primary one. The detected low-mass third body ($M_{3min.}=0.22{\pm}0.0006M_{\odot}$) is responsible for a periodic variation of about 55 years light time effect. We have determined the orbital parameters of the third component which show a considerable eccentricity $e_3=0.77{\pm}0.07$ together with a longitude of periastron ${\omega}_3=300^{\circ}{\pm}10^{\circ}$.