• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.2
• /
• pp.202-208
• /
• 2003

In this paper, we proposed a microstrip patch array antenna for DBS reception which had high gain and high tilted angle through mutual coupling driver patch to parasitic patch in H-plane edge and broadside direction in different layers. It was designed and fabricated in 16$\times$8 array by using low cost polyester based copper-clad laminate and foam instead of high cost dielectric substrate. It had gain of 22.9 dBi, beamwidth of 4.6$^{\circ}$, and tilted angle from broadside direction of 43.9$^{\circ}$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.9
• /
• pp.961-966
• /
• 2009

In this paper, a novel voltage-controlled oscillator(VCO) using the metamaterial broadside coupled spiral resonators(BC-DSRs) is presented for reducing the phase noise. For reducing of the phase noise, the series spiral structures have been applied for the signal plane and ground plane at each in order to have the large coupling. Compared with the conventional VCO, the proposed VCO has the larger coupling coefficient constant, which makes a higher Q-factor and has reduced the phase noise of the VCO. The proposed VCO has the phase noise of $-121{\sim}-117.16\;dBc$/Hz at 100 kHz in the tuning range, $5.749{\sim}5.853\;GHz$. The figure of merit(FOM) of this VCO is $-198.45{\sim}-194.77\;dBc$/Hz at 100 Hz in the same tuning range, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.4
• /
• pp.351-356
• /
• 2009

A dual-mode annular ring antenna for both global positioning system(GPS) and satellite digital multimedia broad-casting(DMB) is designed. The proposed antenna consists of a coupling feed line and four slots on the annular ring patch. The gap between the feed line and the annular ring patch is used for an input impedance matching, and the slot length is used for adjusting the resonant frequency of the $TM_{21}$ mode at the DMB frequency. The antenna was fabricated and measured. The experimental results show that the antenna resonants at the GPS and DMB frequencies with suitable bandwidths, and had a broadside radiation pattern at the GPS band and a conical beam radiation pattern at the DMB band.

• Journal of electromagnetic engineering and science
• /
• v.18 no.2
• /
• pp.108-116
• /
• 2018

In this paper, a method of designing a Vivaldi type phased array antenna (PAA) which operates at S-band (2.8-3.3 GHz) is presented. The presented antenna uses broadside coupled split ring resonators (BC-SRRs) for high isolation, wide field of view, and good active S-parameter characteristics. As an example, we design a $1{\times}8$ array antenna with various BC-SRR structures using theory and EM simulations. The antenna is fabricated and measured to verify the design. With the BC-SRR implemented between the two radiating elements, the isolation is shown to be enhanced by 6 dB, up to 23 dB. The scan angle is shown to be within ${\pm}53^{\circ}$ based on a -10 dB active reflection coefficient. The operation of the scan angle is possible within ${\pm}60^{\circ}$ with a little larger reflection coefficient (-7 dB to -8 dB). The proposed design with BC-SRRs is expected to be useful for PAA applications.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.3
• /
• pp.18-24
• /
• 2003

The resonator using two layer microstrip structure was proposed and the bandpass filter was designed using this resonator in this paper. The proposed resonator structure is constructed by placing a U-shape of resonator in the first layer and then placing a broadside coupling strip in the second layer just above of the U-shape of resonator's edge part. Because these structure has various design parameters than general single layer coupled line structure, filter design is more flexible. In this paper, the narrow band filter was designed using multi-layer structure that had been applied to broadband filter because it's high coupling nature. The filter was designed to have 4MHz center frequency and 3 % fractional bandwidth, and finally confirmed that can be realizable narrow band filter by using multi-layer structure through fabrication and measurement.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.5
• /
• pp.981-989
• /
• 1997

In this paper, the 5-element active phased array antennas coupled through slotline between elements are designed and fabricated. A recent studies on the active phased array antennas using the transmission line coupling which can be designed to provide strong coupling and the appropriate coupling phase. But this sturucture has limitation of expanding in two dimensions for planar active phased array antennas and distortion of the radiation pattern caused by coupling network. Thus our work proposes the slotline coupling structure asthe broadband coupling network for the active phased array antenna. In experiment, 5-elements active phased array antenas have steering range from -30.deg. to 20.deg. off broadside as the free-running frequencies of end elements are controlled. The overall results show that the proposed slotline coupling structure is suited for the coupling network in the actie phased array antenna system. And the proposed coupling structire solves the expansion problem and eliminates the distortion of the radiation pattern caused by the spurious radiation of the transmission line coupling network. Thus thiscan be expanded to two dimensional coupling network for the planar active phased array antenna system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.9
• /
• pp.1968-1974
• /
• 1997

In this paper, the spectral domain approach is employed to investigate the characteristics of symmetrical and asymmetrical broadside-coupleed coplanar waveguides(BSC-CPW). These structures have large even(c)-odd(.pi.) mode-velocity ratio, suitable for wide-band and tight-coupling microwave circuit design. Efficient design parameters can be obtained from the effective dielectric constants and characteristic impedances calculated by varying the strip widths and slot widths in the BSC-CPW structure.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.3
• /
• pp.997-1001
• /
• 2014

In this paper, the interference in small MIMO antennas having two identical composite right- and left-handed transmission-line(CRLH-TL)-based radiating elements is remarkably decreased. The radiating element has the broadside-capacitive coupling as well as slots to be equivalent to the CRLH-TL to prevent the size from increasing for an LTE high band. The suspended line bridging the two radiating elements is optimized to lower the interference between them down to -23 dB, while the overall MIMO antenna system is compact and its antenna performance is acceptable. The design is tested for 2.5 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.2
• /
• pp.253-264
• /
• 1998

In this paper, a design method for directional couplers using bilevel microstrip substrates is proposed. This kind of broadside-coupled coupler provides large coupling factors and broadband characteristics which can not be provided by conventional edge-coupled couplers. Physical dimensions needed for design are obtained by numerical analysis of characteristic parameters of the coupler using the least squares residual method, a kind of variational method, and an eigenvalue problem analysis method. A 3[dB] directional coupler is designed by the proposed method at the center frequency of 1 GHz, built, and tested. The validation and accuracy of the method are confirmed by comparing the numerical results with the experimental results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.8
• /
• pp.1963-1970
• /
• 1998

In this paper, a two-dimensional slotline coupling structure is proposed for the planar active phased array antenna system with scanning the beam by coupled oscillators without phase shifters. The operating characteristics are analyzed and experimentally demonstrated. The proposed two-dimensional slotline coupling structure consists of $|{=}|$-type slotline in the ground plane for the coupling of E-plane and H-plane. From the simulation results of coupling strength with the variation of width, length and the number of slotlines, the optimal coupling structure is proposed and applied to $2{\times}5$ elements of planear phased array antenna. The experimental results show that the beamwidth of E-plane and H-pland are $42^{\circ}$ and $15^{\circ}$, respectivly, and the scanning range is from $-20^{\circ}$ to $15^{\circ}$ from the broadside. Therefore, it is shown the two-dimensional slotline coupling structure for oscillator-type active phased array antenna can be applied to the planar phased array antenna system.