• Journal of Broadcast Engineering
• /
• v.17 no.2
• /
• pp.237-251
• /
• 2012

Recently, the direct terrestrial broadcasting reception has been reduced rapidly and not been improved even in digital broadcast environment. The distribution plan of 700MHz frequency band(Ch.52~69) will make the problem worse because the spectrum might be allocated to mobile communication use. In this paper, we investigated the efficient frequency usage for DTV signal reception improvement and next generation broadcasting. The frequency amount required for reception improvement and for next generation broadcasting service is presented. We estimated the beneficial effect when the spectrum(108MHz Frequency Width) is used for SFN transmission technology, UHDTV and Full-HD 3DTV.

• ETRI Journal
• /
• v.35 no.3
• /
• pp.546-549
• /
• 2013

A Ka-band 6-W high power microwave monolithic integrated circuit amplifier for use in a very small aperture terminal system requiring high linearity is designed and fabricated using commercial 0.15-${\mu}m$ GaAs pHEMT technology. This three-stage amplifier, with a chip size of 22.1 $mm^2$ can achieve a saturated output power of 6 W with a 21% power-added efficiency and 15-dB small signal gain over a frequency range of 28.5 GHz to 30.5 GHz. To obtain high linearity, the amplifier employs a class-A bias and demonstrates an output third-order intercept point of greater than 43.5 dBm over the above-mentioned frequency range.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.599-603
• /
• 2003

In this paper, the efficient channel estimationschemes for DRM system(AM band digital radio broadcasting standard) are investigated. In frequency domain, by means of the linear interpolation, the second order interpolation, cubic spline interpolation, and time domain interpolation, the channel impulse response is estimated respectively to compensate the attenuation due to the fading. And in time domain, the frequency channel impulse response is averaged to reduce the attenuation due to the AWGN. By the simulation, the performance of MSE, BER and the complexity of calculation is compared and analysized for each interpolation scheme.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.2
• /
• pp.217-222
• /
• 2004

In this paper, the efficient channel estimation schemes for DRM system(AM band digital radio broadcasting standard) are investigated. In frequency domain, by means of the linear interpolation, the second order interpolation, cubic spline interpolation, and time domain interpolation, the channel impulse response is estimated respectively to compensate the attenuation due to the fading. And in time domain, the frequency channel impulse response is averaged to reduce the attenuation due to the AWGN. By the simulation, the performance of MSE, BER and the complexity of calculation is compared and analyzed for each interpolation scheme.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.5
• /
• pp.193-197
• /
• 2017

In this paper, we present a low-power delta-sigma based digital frequency synthesizer with high frequency resolution for bio sensor networks. Biomedical radio-frequency (RF) transceivers require miniaturized forms with a long battery life and low power consumption. For the technology scaling, digital circuits have become preferable compared to analog circuits because of the aggressive cost, size, flexibility, and repeatability. Therefore, the digital circuits based on standard-cell library are used to reduce a power consumption. Additionally, a delta-sigma is used for making fractional frequency tuning range. From the simulation, we confirmed that proposed scheme has good performance in accordance with power and frequency resolution.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.2
• /
• pp.73-78
• /
• 2021

To minimize the resonance frequency error when design Inset-Fed Microstrip Patch Antenna using current formulas. Especially It is found that a constant relation between Antenna patch width and frequency error. Using this relation, calculation frequency and simulation frequency are compared. Finally the comparison induced a formula of revised antenna patch width for accurate frequency in 2-10 GHz. And this formula reduced 2.54% of average frequency error. Last, the Antenna which has same variation with the simulation was producted and measured. It proved the formula's validity.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.6
• /
• pp.71-76
• /
• 2010

In this paper, a 120 GHz local oscillator(LO) for the sub-harmonic mixer in the THz transceiver with a carrier frequency of 240 GHz was designed and fabricated. A 120 GHz local oscillator was composed of 40 GHz PLL(Phase Locked Loop), 40 GHz BPF(Band Pass Filter), frequency tripler and 120 GHz BPF. The commercial model of the frequency tripler was used. The measured result of the 40 GHz PLL showed the phase noise of -105 dBc/Hz at the 100 kHz offset frequency. The measured result of 120 GHz BPF showed the insertion loss of 1.3 dB at center frequency of 119 GHz with bandwidth of 5 GHz. The output power of 120 GHz LO was measured to 6.6 dBm.

• Journal of Broadcast Engineering
• /
• v.20 no.1
• /
• pp.82-91
• /
• 2015

The purpose of this paper is to propose the frequency allocation plan for the terrestrial UHDTV in 700MHz frequency band. Currently 700MHz frequency band is being requested by broadcasting, communication, and public safety sites for the use of UHDTV, LTE/LTE-A and PPDR (Public Protection and Disaster Relief) by each site. Validity and proper timing of each request is examined by references, and the frequency allocation plan is proposed. As results 9 channels and guard bands are allocated for the UHDTV service, under the consideration of two 10MHz frequency bands of the PPDR in700MHz band.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.6
• /
• pp.9-14
• /
• 2009

In this paper, we proposed spreading code slicing technique for efficient transmitter detection in AT-DMB system with single frequency network. At the transmitter, the spreading code for transmitter identification inserted using slicing technique on forehead of null symbol and then transmitted. In this point, it requires high correlation characteristic spreading code. At the receiver, peak to peak value calculated by correlation process before signal demodulation. The transmitter information by proposed technique is employed to implement the single frequency network (SFN) which is proposed for solving a frequency inefficiency problem of the MFN. The results of the paper can be applied to wireless multimedia digital broadcasting system.

• ETRI Journal
• /
• v.37 no.6
• /
• pp.1077-1086
• /
• 2015

This paper presents a general-purpose design scheme of a filter bank (FB)-based radio frequency (RF) transceiver that operates across the entire ultra-high frequency (UHF) TV band from 470 MHz to 698 MHz and complies with the TV white space (TVWS) regulatory requirements. To this end, an intermediate frequency (IF) band-pass filter (BPF) with a sharp skirt characteristic is considered as a solution for handling the incoming signals from a baseband modem. Specifically, an FB-based BPF structure with four ceramic resonator filters that effectively rejects unwanted signals is proposed to extract a desired signal in the TV band. Achievable data rates of a cognitive radio system (CRS) employing the proposed FB-based RF transceiver at the application layer are investigated in both wired and wireless environments. The service coverage of the CRS network is measured according to several modulation and coding schemes (MCSs) of the CRS. The results show that the coverage of a wireless network in a nearly open area can be extended by more than 9.3 km in the TVWS. Experimental results also confirm that the proposed FB-based RF transceiver is adequate for utilization in TVWS applications.