• Journal of Electrical Engineering and Technology
• /
• 제8권6호
• /
• pp.1261-1268
• /
• 2013

This study proposes a voltage and reactive coordinative control strategy with distributed generator (DG) in a distribution power system. The aim is to determine the optimum dispatch schedules for an on-load tap changer (OLTC), distributed generator settings and all shunt capacitor switching on the load and DG generation profile in a day. The proposed method minimizes the real power losses and improves the voltage profile using squared deviations of bus voltages. The results indicate that the proposed method reduces the real losses and voltage fluctuations and improve receiving power factor. This paper proposes coordinated voltage and reactive power control methods that adjust optimal control values of capacitor banks, OLTC, and the AVR of DGs by using a voltage sensitivity factor (VSF) and dynamic programming (DP) with branch-and-bound (B&B) method. To avoid the computational burden, we try to limit the possible states to 24 stages by using a flexible searching space at each stage. Finally, we will show the effectiveness of the proposed method by using operational cost of real power losses and voltage deviation factor as evaluation index for a whole day in a power system with distributed generators.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제17권11호
• /
• pp.3204-3217
• /
• 2023

In this paper, the downlink of the multicast based spatial modulation systems is investigated. Specifically, physical layer multicasting is introduced to increase the number of access users and to improve the communication rate of the spatial modulation system in which only single radio frequency chain is activated in each transmission. To minimize the bit error rate (BER) of the multicast based spatial modulation system, a joint optimizing algorithm of antenna selection and multicast precoding is proposed. Firstly, the joint optimization is transformed into a mixed-integer non-linear program based on single-stage reformulation. Then, a novel iterative algorithm based on the idea of branch and bound is proposed to obtain the quasioptimal solution. Furthermore, in order to balance the performance and time complexity, a low-complexity deflation algorithm based on the successive convex approximation is proposed which can obtain a sub-optimal solution. Finally, numerical results are showed that the convergence of our proposed iterative algorithm is between 10 and 15 iterations and the signal-to-noise-ratio (SNR) of the iterative algorithm is 1-2dB lower than the exhaustive search based algorithm under the same BER accuracy conditions.

• Management Science and Financial Engineering
• /
• 제19권2호
• /
• pp.19-29
• /
• 2013

Refuse collection network design, one of major decision problems in reverse logistics, is the problem of locating collection points and allocating refuses at demand points to the opened collection points. As an extension of the previous models, we consider capacity and maximum allowable distance constraints at each collection point. In particular, the maximum allowable distance constraint is additionally considered to avoid the impractical solutions in which collection points are located too closely. Also, the additional distance constraint represents the physical distance limit between collection and demand points. The objective is to minimize the sum of fixed costs to open collection points and variable costs to transport refuses from demand to collection points. After formulating the problem as an integer programming model, we suggest an optimal branch and bound algorithm that generates all feasible solutions by a simultaneous location and allocation method and curtails the dominated ones using the lower bounds developed using the relaxation technique. Also, due to the limited applications of the optimal algorithm, we suggest two heuristics. To test the performances of the algorithms, computational experiments were done on a number of test instances, and the results are reported.

• Journal of Information Technology Applications and Management
• /
• 제18권1호
• /
• pp.125-141
• /
• 2011

As the sales volume of online shops increases, the job burden in the back-offices of the online shops also increases. Order picking is the most labor-intensive operation among the jobs in a back-office and mid-size pure click online shops are experiencing the time delay and complexity in order picking nowadays while fulfilling their customers' orders. Those warehouses of the mid-size shops are based on manual systems, and as order pickings are repeated, the warehouses get a mess and lots of products in those warehouses are getting missing, which results in severe delay in order picking. To overcome this kind of problem in online clothing shops, we research a methodology to locate warehousing products. When products arrive at a warehouse, they are packed into a box and located on a rack in the warehouse. At this point, the operator should determine the box to be put in and the location on the rack for the box to be put on. This problem could be formulated as an Integer Programming model, but the branch-and bound algorithm to solve the IP model requires enormous computation, and sometimes it is even impossible to get a solution in a proper time. So, we relaxed the problem, developed a set of heuristics as a methodology to get a semi-optimum in an acceptable time, and proved by an experiment that the solutions by our methodology are satisfactory and acceptable by field managers.

• 한국경영과학회:학술대회논문집
• /
• 한국경영과학회/대한산업공학회 2005년도 춘계공동학술대회 발표논문
• /
• pp.506-516
• /
• 2005

This paper deals with an investment scheduling problem of maximizing net present value of dividend with reinvestment allowed, where each investment has certain capital requirement and generates deterministic profit. Such deterministic profit is calculated at completion of each investment and then allocated into two parts, including dividend and reinvestment, at each predetermined reinvestment time point. The objective is to make optimal scheduling of investments over a fixed planning horizon which maximizes total sum of the net present values of dividends subject to investment precedence relations and capital limit but with reinvestment allowed. In the analysis, the scheduling problem is transformed to a kind of parallel machine scheduling problem and formulated as an integer programming which is proven to be NP-complete. Thereupon, a depth-first branch-and-bound algorithm is derived. To test the effectiveness and efficiency of the derived algorithm, computational experiments are performed with some numerical instances. The experimental results show that the algorithm solves the problem relatively faster than the commercial software package (CPLEX 8.1), and optimally solves the instances with up to 30 investments within a reasonable time limit.

• 한국경영과학회지
• /
• 제23권2호
• /
• pp.187-200
• /
• 1998

This paper presents an original approach for solving short-term power scheduling in extended power system with two fuels in a unit and a limited fuel using Lagrangian relaxations. The underlying model incorporates the full set of costs and constraints including setup, production, ramping, and operational status, and takes the form of a mixed integer nonlinear control problem. Moreover, the mathematical model developed includes two fuels in a unit and a limited fuel, regulation reserve requirements of prespecified group of units. Lagrangian relaxation is used to disaggregate the model by generator into separate subproblems which are then solved with a nested dynamic program including empirical knowledges. The strength of the methodology lies partially in its ability to construct good feasible solutions from information provided by the dual. Thus, the need for branch-and-bound is eliminated. In addition, the inclusion of two fuels in a unit and a limited fuel provides new insight into the limitations of current techniques. Computational experience with the proposed algorithm indicates that Problems containing up to 23 units including 8 unit used two fuels and 24 time periods can be readily solved in reasonable times. Duality gaps of less than 4％ were achieved.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제12권8호
• /
• pp.4021-4037
• /
• 2018

In network intrusion detection research, two characteristics are generally considered vital to building efficient intrusion detection systems (IDSs): an optimal feature selection technique and robust classification schemes. However, the emergence of sophisticated network attacks and the advent of big data concepts in intrusion detection domains require two more significant aspects to be addressed: employing an appropriate big data computing framework and utilizing a contemporary dataset to deal with ongoing advancements. As such, we present a comprehensive approach to building an efficient IDS with the aim of strengthening academic anomaly detection research in real-world operational environments. The proposed system has the following four characteristics: (i) it performs optimal feature selection using information gain and branch-and-bound algorithms; (ii) it employs machine learning techniques for classification, namely, Logistic Regression, Naïve Bayes, and Random Forest; (iii) it introduces bulk synchronous parallel processing to handle the computational requirements of large-scale networks; and (iv) it utilizes a real-time contemporary dataset generated by the Information Security Centre of Excellence at the University of Brunswick (ISCX-UNB) to validate its efficacy. Experimental analysis shows the effectiveness of the proposed framework, which is able to achieve high accuracy, low computational cost, and reduced false alarms.

• 한국컴퓨터정보학회논문지
• /
• 제19권3호
• /
• pp.109-117
• /
• 2014

본 논문은 회로 최소화 문제에 대한 Quine-McCluskey 법을 개선한 알고리즘을 제안하였다. Quine-McCluskey 법은 주 내포 항을 반복적인 방법으로 찾고, 회로 최소화 방법으로 시행착오법, 분기한정법 또는 Petrick 법을 적용한다. 반면에 제안된 알고리즘은 사전에 항표를 생성하여 주 내포 항을 간단히 찾는 방법을 제안하였으며, 집합피복을 결정하는 방법을 적용하여 1차와 2차 필수 주 내포 항을 간단히 찾는 방법을 제안하였다. 3-변수와 4-변수 실험 데이터에 적용한 결과 제안된 알고리즘이 Quine-McCluskey 법에 비해 보다 간단하면서도 정확히 해를 구할 수 있었다.

• International Journal of Control, Automation, and Systems
• /
• 제4권5호
• /
• pp.601-614
• /
• 2006

In this paper, a study on task assignment strategies for a complex real-time network system is presented. Firstly, two task assignment strategies are proposed to improve previous strategies. The proposed strategies assign tasks with meeting end-to-end real-time constraints, and also with optimizing system utilization through period modulation of the tasks. Consequently, the strategies aim at the optimizationto optimize of system performance with while still meeting real-time constraints. The proposed task assignment strategies are devised using the genetic algorithmswith heuristic real-time constraints in the generation of new populations. The strategies are differentiated by the optimization method of the two objectives-meeting end-to-end real-time constraints and optimizing system utilization: the first one has sequential genetic algorithm routines for the objectives, and the second one has one multiple objective genetic algorithm routine to find a Pareto solution. Secondly, the performances of the proposed strategies and a well-known existing task assignment strategy using the BnB(Branch and Bound) optimization are compared with one other through some simulation tests. Through the comparison of the simulation results, the most adequate task assignment strategies are proposed for some as system requirements-: the optimization of system utilization, the maximization of running tasktasks, and the minimization of the number of network node nodesnumber for a network system.

• 한국항해학회지
• /
• 제14권4호
• /
• pp.1-15
• /
• 1990

With increasing ship's speed turnround and port time becomes a large percentage of total roundtrip time and this causes to accelerate the introduction of the various kind of modern handling equipment, the standardization of cargoes, and the improvement of the ship. However, it is still a drag on efficient operation of ship. Similarly, the turnround time at the container port is very important as a measure for the decision of the efficiency of port. To decrease operating coasts, the minimization of the time need to cargo handling at the ports of call must be achieved. Thus the optimization of the time need to cargo handling at the ports of call must be achieved. Thus the optimized Container Loading Plan is necessary, especially under the rapid speed of container operations. For the container loading plan, in this thesis, we use the hungarian method and the branch and bound method to get the initial disposition of both maximization of ship's GM and minimization of shift number to the obstructive container in a yard area. We apply the dynamic programming algorithm to get the final disposition for minimizing total turnroudn time and finally we analyzed the results to check whether the initial disposition is proper or not.