• The Journal of the Korea institute of electronic communication sciences
• /
• v.19 no.3
• /
• pp.507-514
• /
• 2024

In the semiconductor manufacturing line, continuous efforts are being made to reduce the cost of products produced, and the demand for this is accelerating in the chemical mechanical polishing(CMP) process, and a representative example of these cost reduction items is the 5-Zone Ring. After about 150 hours of use in the CMP process, the thickness of the ring decreases to less than 1 mm and must be replaced with a new product. Therefore, in this study, bonding dispensers and press machines with a dispensing amount error of 10g±0.8% or less and a pressure uniformity of ±1.8% or less were developed to reduce semiconductor manufacturing costs by repeatedly regenerating worn parts of the retainer ring, and to minimize environmental pollution caused by industrial waste treatment.

• Tribology and Lubricants
• /
• v.38 no.3
• /
• pp.93-100
• /
• 2022

Micro-light emitting diode (micro-LED) displays offer numerous advantages such as high brightness, fast response, and low power consumption. Hence, they are spotlighted as the next-generation display. However, defective LEDs may be created due to non-uniform contact loads or LED alignment errors. Therefore, a repair process involving the replacement of defective LEDs with favorable ones is necessitated. The general repair process involves the removal of defective micro-LEDs, interconnection material transfer, as well as new micro-LED transfer and bonding. However, micro-LEDs are difficult to repair since their size decreases to a few tens of micron in width and less than 10 ㎛ in thickness. The conventional nozzle-type dispenser for fluxes and the conventional vacuum chuck for LEDs are not applicable to the micro-LED repair process. In this study, transfer conditions are determined using a micro stamp for repairing micro-LEDs. Results show that the aging time should be set to within 60 min, based on measuring the aging time of the flux. Additionally, the micro-LEDs are subjected to a compression test, and the result shows that they should be transferred under 18.4 MPa. Finally, the I-V curves of micro-LEDs processed by the laser and hot plate reflows are measured to compare the electrical properties of the micro-LEDs based on the reflow methods. It was confirmed that the micro-LEDs processed by the laser reflow show similar electrical performance with that processed by the hot plate reflow. The results can provide guidance for the repair of micro-LEDs using micro stamps.