• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.12
• /
• pp.133-138
• /
• 2008

A 50-60GHz continuous-wave(cw) millimeter-wave(MMW) was converted(generated) by applying optical technology for future wireless and ubiquitous communications. The optical power of 22.5mW was injected into optical waveguide in this experiment. The generated MMW signals were radiated in a millimeter waveguide and detected through a millimeter detector on the inside of a millimeter waveguide in this experiment. The spectral linewidth of the MMW signals was less than 1 kHz. The power fluctuation of the MMW was less than 1.2 dBm over 50-60 GHz range.

• Journal of Sericultural and Entomological Science
• /
• v.40 no.1
• /
• pp.60-62
• /
• 1998

To understand expression of some early and late genes of Bombyx mori nuclear polyhedrosis virus (BmNPV) in the B. mori-derived BmN cell line, the transcripts were analyzed by polymerase chain reaction with synthetic primers. After infection, the transcript of early genes, which include p35, IE1 and helicase p143, was immediately detected in the infected cells. In addition, the transcript of late genes, which include p10 and polyhedrin, was also detected in just-infected cells. In conclusion, our results revealed that transcripts of early and late genes of BmNPV are immediately expressed from the cells after infection.

• Publications of The Korean Astronomical Society
• /
• v.14 no.1
• /
• pp.39-45
• /
• 1999

We have carried out measurements of 1.2-1.6GHz radio interferences around Seoul Radio Astronomy Observatory located in the campus of Seoul National University. We received interference signals using a pyramidal horn antenna and measured its power using a spectrum analyzer with 1MHz resolution after $\~60dB$ amplification. In order to check the spatial characteristics, we made observations at every $30^{\circ}$ in azimuth at elevation of $30^{\circ}\;and\;60^{\circ}$. Also, in order to check the temporal characteristics, we repeated the all-sky observations five times at every six hours. The results may be summarized as follows: (1) There are strong $({\geq}-20dBm)$ interferences between 1.2 and 1.4GHz. Particularly strong interferences are observed at 1.271 and 1.281GHz, which have maximum powers of -0.34dBm and -0.56dBm, respectively. (2) The characteristics of the interferences do not depend strongly on directions, although the interferences are in general weak at high elevation and in east-west direction. (3) The interferences appear for a very short $(\leq0.01s)$ period of time, so that the average power is much smaller than the maximum power. Strong interferences with large $(\leq-49.0dBm)$ average power have been observed at 1.271, 1.281, 1.339, and 1.576GHz. At these frequencies, the interferences appear repeatedly with a period of $\leq0.1s$ By analyzing the observed power, we find that, for the strongest 1.271GHz interference, the average intensity is $-171dBW/m^2/Hz$ and that the maximum intensity is $-122dBW/m^2/Hz$. If this interference is delivered to the detector without any shielding, then its power would be much greater than the rms noise of a typical line spectrum. Therefore, it is important to shield all the parts of receiver carefully from radio interferences. Also, without appropriate shielding, the sensitivity of a receiver could be limited by the interference.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.2
• /
• pp.45-49
• /
• 2009

In this paper, a direct down conversion LNA/Mixer has been designed and tested for 900Mhz UHF RFID application. The designed circuit has been implemented in 0.18um CMOS technology with 3.3V operation. In this work, a common gate input architecture has been used to cope with the higher input self jamming level. This LNA/Mixer is designed to support two operating modes of high gain mode and low gain mode according to the input jamming levels. The measured results show that the input referred P1dBs are 4dBm of high gain mode and 11dBm of low gain mode, and the conversion gains are 12dB and 3dB in high and low gain mode respectively The power consumptions are 60mW for high gain mode and 79mW for low gain mode. The noise figures are 16dB and 20dB in high gain mode and low gain mode respectively.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.12
• /
• pp.242-246
• /
• 2012

This paper presents an integrated low noise and highly linear wideband RF front-end for a digital terrestrial and cable TV tuner, which are used as a part of double-conversion TV tuner. The low noise amplifier (LNA) has a low noise figure and high linearity by adopting a noise canceling technique based on current amplification. The up-conversion mixer and SAW buffer have high linearity by employing a third order intermodulation cancellation technique. The proposed RF front-end is designed in a $0.18{\mu}m$ CMOS and draws 60 mA from a 1.8 V supply voltage. The RF front-end shows a voltage gain of 30 dB, an average single side-band noise figure of 4.2 dB, an IIP2 of 40 dBm, and an IIP3 of -4.5 dBm for the entire band from 48 MHz to 862Hz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.3 s.333
• /
• pp.1-8
• /
• 2005

In this paper, design and implement 60W Doherty power amplifiers for 3GPP repeater and base station transceiver system. Efficiency improvement and high power property of Doherty power amplifier is distinguishable; however implementation of assistance amplifer is difficult, though. To solve the problem, therefore, GCHD (Gate Control Hybrid Doherty) power amplifier is embodied to gate bias adjusament circuit of assistance amplifier to General Doherty power amplifier. Experiment result shows that $2.11\~2.17GHz$, 3GPP operating frequency band, with 62.55 dB gain, PEP output is 50,76 dBm, W-CDMA average power is 47.81 dBm, and -40.05 dBc ACLR characteristic in 5MHz offset frequency band. Each of the parameter satisfied amplifier specification which we want to design. Especially, GCHD power amplifier shows proper efficiency performance improvement in uniformity ACLR than general power amplifier.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.10
• /
• pp.779-787
• /
• 2017

In this paper, we designed a RF transceiver for small unmanned aerial vehicle(UAV) using power switching method. To apply for the UAV, several characteristics such as size, weight, and power consumption are very important. To reduce power consumption, we propose a new power switching method. Using the proposed method, we fabricated the RF transceiver needed to establish the data link for a small UAV. The fabricated RF transceiver shows an output power of +25 dBm, a noise figure of 4.56 dB and a received signal strength of -100 dBm. By performing power measurement of proposed switching method, 25 % of power could be reduced. The size of the fabricated RF transceiver is $100{\times}60{\times}5.7mm^3$ and the weight is as small as 38 g.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.1
• /
• pp.92-95
• /
• 2016

In this paper, an UHF-band 1 kW solid-state pulsed power amplifier was designed and implemented for the thermoacoustic imaging(TAI) at 900 MHz. The designed power amplifier has a pulse width of $80{\mu}s$ and a duty cycle of 1 % for short-pulse operation. The overall amplifier was implemented by combining of 16 single-power amplifiers adopting MRFE6P9220HR3 LDMOSFET using wilkinson power dividers. The solid-state pulsed power amplifier shows 25 % drain efficiency with a gain of 76.2 dB when the output power is 60.2 dBm for a -16 dBm input power at center frequency.

• Journal of electromagnetic engineering and science
• /
• v.10 no.1
• /
• pp.6-12
• /
• 2010

In this paper, highly efficient class-F power amplifiers(PAs) with harmonic-controlling transmission lines(TLs) were built for cellular and WLAN applications at 840 MHz and 2.4 GHz each. Also, based on these single-band PAs, a dualband class-F PA was designed after a careful investigation into the harmonics of the two frequencies. The harmonic-controlling TL was designed for the class-F operation at dualband by switching the length of the shunt $\lambda$/4 TL part, while the series $\lambda$/4 TL is optimized for both frequencies. To verify the performance, two class-F PAs optimized at each frequency and a dualband class-F PA at the corresponding frequencies were built with the secondand the third-harmonic control circuits at each frequencies. As a result, the PA#1 at 840 MHz has a peak drain efficiency of 81.2 % with an output power of 24.4 dBm, while the PA#2 at 2.35 GHz shows a drain efficiency of 94.5 % with an output of 22.8 dBm. Finally, the dualband class-F PA#3 showed 60.5 % and 50.9 % drain efficiencies at 840 MHz and 2.4 GHz, with powers of 23.8 dBm and 19.62 dBm, respectively.

• Journal of Information Technology Applications and Management
• /
• v.22 no.3
• /
• pp.65-81
• /
• 2015

This study reports a preliminary finding of the types and numbers of graphs being presented in the annual reports of about thirty top listed companies trading publicly in the stock markets of three countries-Thailand (SET), Malaysia (BM), and Singapore (SGX)-that were chosen based on their inclusion in the ASEAN Stars Index under the ASEAN Trading Link project. A total of 6,753 graphs from nineteen sectors were extracted and examined. Banking, real estate, and telecommunications are ranked the three most condense sectors, accounting for 50.2% of the total number of graphs observed. The three most used graphs are the Conservative Bar, Donut graph and Stack Bar. Less than one percent of Infographic type graphs were used. The five most depicted graphed variables are Asset, Revenue, Net profit, Liability, and Dividend. Using rudimentary framework to detect distorted or misleading statistical graphs, the study found 60.6% of the graphs distorted across the three markets, SET, BM, and SGX. BM ranked first in percentages of graphs being distortedly presented (73%). The other two markets, SET and SGX, have about the same proportions, 53.88% and 53.03%, respectively. Likewise, the proportions of Well-designed versus Inappropriate-designed graphs of the latter two markets are a little over one time (SET = 1 : 1.17; SGX = 1 : 1.13), whereas the proportion is almost triple for the BM market (BM = 1 : 2.70). In addition, the trend of distorted graphs found is slightly increasing as the longevity of the ASEAN Stars Index increases. One possible explanation for the relatively equal proportion of inappropriate graphs found is that SET is the smallest market and SGX, though the largest, is the most regulated market. BM, on the other hand, may want to present their financial data in the most attractive manner to prospective investors, thus, regulatory constraints and governance structure are still lenient.