• Journal of the Korean Institute of Telematics and Electronics
• /
• v.11 no.2
• /
• pp.27-32
• /
• 1974

The characteristic impedance of a biconical antenna which is the conical cage consisting of 4m conical wires is obtained analytically under some assumption. The effect of the number of the elements on the characteristic impedance is observed according to the equation of the characteristic impedance derived in this paper. The equation is not convenient for practical use. However, a compact form of the equation is obtained by assuming that the apexangle is not very large. The numerical solution of this approximate equation is found to show errors no more than 2% over a wide range of the apex angle .

• Journal of electromagnetic engineering and science
• /
• v.8 no.1
• /
• pp.1-5
• /
• 2008

In this paper, a biconical type antenna is proposed for EMI test site validation above 1 GHz. To achieve broadband and omni-directional radiation patterns required by international standard(CISPR), the proposed antenna consists of general bicones with cylindrical loads and adopts side feeding method to minimize the influence on H-plane pattern due to feeding cable, balun, and connector. The radiation patterns of the fabricated antenna are measured and the results are compared with CISPR criteria and commercial antenna in our interest frequencies. Although the proposed antenna has a few problems in frequency range of 1 GHz to 2 GHz, it has relatively better performance than commercial antenna.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.4
• /
• pp.563-570
• /
• 2022

We designed a biconical antenna with sleeve baluns that exhibited an improved radiation pattern from 3-40 GHz. In the antenna, the edges of the ring of the upper cone are blended to a cylinder. Sleeve baluns operating at specific frequencies are connected to the antenna to minimize leakage currents on the surface of the feeding coaxial cable. The radiation pattern was improved with the sleeve baluns, and the angular 3-dB beamwidth ranged from 67.1-101.1° over 3-40 GHz, which is much broader than the 21-99° of the conventional antenna.

• Proceedings of the IEEK Conference
• /
• summer
• /
• pp.181-184
• /
• 2004

In this paper, we propose the dual band(2.4GHz and 5GHz) antenna for access point of WLAN(Wireless Local Area Network) which has similar radiation patterns for each band. Simulation results by using HFSS(High Frequency Structure Simulator) for the proposed antenna are presented. The electrical characteristics of the proposed antenna are measured with HP 8510C network analyzer and included. And radiation patterns are measured with rectangular anechoic far field antenna chamber. Measured results show that $S_{11}$ is less than - 14dB and VSWR(Voltage Standing Wave Ratio) is less than 1.5 for all frequency bands of interest. The measured maximum gain for elevation pattern at 2.40GHz is about 2.46dBi at $theta=-78^{\circ}$ and maximum gain for 5.825GHz is about 2.70dBi at $theta=-80^{\circ}.$ And the implemented antenna has good radiation pattern characteristic, therefore, we expect that the implemented dual band antenna is applicable for access point of WLAN.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.11 s.114
• /
• pp.1096-1104
• /
• 2006

In this paper, the broadband antenna for the combined base station of Cellular/PCS/IMT-2000/Wibro and S-DMB services is designed and the proposed antenna allows having sufficient coverage for each service band. In order to get the broadband impedance matching, the tapered sections are applied on the both terminus of hi-conical respectively. The design parameter is calculated and simulated by using FDTD method. As a result, the measured bandwidth of the proposed antenna is $0.79GHz{\sim}2.93GHz$ and the gain is distributed from 5.5 dBi up to 8.19 dBi.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.65-66
• /
• 2006

In this paper, we designed and fabricated a broadband antenna for EMI site validation above 1 GHz. To develop the antenna which is satisfied omni-directional radiation pattern and broadband characteristics required by CISPR, we designed biconical type with cylindrical load. The developed antenna has good characteristics of the radiation patterns and VSWR<2 the frequency range from 1 GHz to 18 GHz.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2001.11a
• /
• pp.145-149
• /
• 2001

The most of faults in gas insulation of power facilities are caused by partial discharge. Therefore we simulated partial discharge and measured the radiated electromagnetic wave emitted from partial discharge in SF$_{6}$ gas by biconical antenna. This paper describes time delay and electric fields pulse characteristics of radiated electromagnetic waves with distance(1[m], 3[m], 5[m]) between antenna and discharge source.e.

• Proceedings of the KIEE Conference
• /
• 1998.07e
• /
• pp.1656-1658
• /
• 1998

This paper deals with a measurement system of a distance between lightning strokes and observatory station and spectrum analysis of electric fields radiated from lightning discharges. The distance measurement system, which consists of a loop type magnetic field sensor, a microphone and one chip microprocessor, is connected to a personal computer through RS232 port to acquire and process the data. This system is to use a difference of propagation velocity between an electromagnetic wave and a sonic wave produced by lightning discharge. Also, an electric field waveform and a frequency spectrum were investigated by an electric field measurement system with a hemisphere antenna and a spectrum analyzer with a biconical antenna and a log-periodic antenna, respectively. The results would be used as a basic reference to protect the power systems and electric circuits from lightning overvoltages.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.17 no.2
• /
• pp.81-87
• /
• 2003

This paper simulated discharge progress and partial discharge using needle-plan electrode system in air, in this time with discharge progress, studied the distribution of frequency spectrum of the radiated electromagnetic waves using biconical antenna and spectrum analyzer. From results of this study, a method was introduced for measurement and analyzation of the radiated electromagnetic waves in accordance with AC discharge progress in air, Besides, according to the consideration of the mutual relation between frequency spectrum of the radiated electromagnetic waves and discharge progress, it was confirmed that detecting partial discharge and estimating discharge progress were possible.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.9 s.339
• /
• pp.19-28
• /
• 2005

We establish a statistical model for the ultra-wide bandwidth (UMB) indoor channel based on over 2000 frequency response measurements campaign in a Practical apartment. The approach is based on the investigation of the statistical properties of the multipath profiles measured in different place with different rooms. Based on the experimental results, a characterization of the propagation channel from theoretic view point is described. Also we describe a method for measurement of the channel impulse response and channel transfer function. Using the measured data, the authors compares channel impulse responses obtained from time-domain and channel transfer functions obtained from frequency-domain with statistical path loss model. The bandwidth of the signal used in this experiment is from 10MHz to 8.01 GHz. The time-domain results such as maximum excess delay, men excess delay and ms delay spread are presented. As well as, omni-directional biconical antenna were used for transmitter and receiver In addition, measurements presented here support m channel model including the antenna characteristics.