• Journal of Environmental Science International
• /
• v.16 no.7
• /
• pp.813-821
• /
• 2007

Laboratory scale experiments were conducted to investigate the removal characteristics of nitrogen and phosphorus in two sequencing batch biofilm reactors (SBBRs). SBBR1 had a short first non-aeration period and SBBR2 had a long first non-aeration period. The removal characteristics of nitrogen and phosphorus in each SBBR were precisely observed according to the variation of influent TOC concentration, and the operation control parameters (pH, DO concentration, ORP) in each reactor were measured. In biological nitrogen removal, there was little difference between SBBR1 and SBBR2 and the nitrogen removal efficiencies were very low. The nitrogen and phosphorus removal characteristics in high influent TOC concentration were different from those in low TOC. Nitrogen removals by simultaneous nitrification/denitrification (SND) were occurred in both SBBR1 and SBBR2. The P removal in SBBR1 was superior to that in SBBR2. The second P release was observed in SBBR1 which had long second non-aeration period.

• Journal of Environmental Science International
• /
• v.9 no.4
• /
• pp.339-343
• /
• 2000

Activated carbons were prepared from Youngwall coal by steam activation in this study. The feasibility of the Youngwall coal to commercial activated carbon was examined. The variation of pore structures and the development of porosity in activated carbons were investigated by changing activation conditions in batch type apparatus. The values of BET surface area and adsorption capacity of iodine and methylene blue of the resulting activated carbons were obtained as high as 1,000$m^2$m^2$$/g, 900mg/g, 150$m\ell$/g, respectively. Youngwall activated carbon prepared in this study showed much higher pore volume in pore diameter over 10 than that of commercial reference activated carbon(Ningxia Taihua ZJ-15C) produced from China anthracite.

• Journal of Korean Society of Water and Wastewater
• /
• v.12 no.1
• /
• pp.96-101
• /
• 1998

Substrate inhibition of 2,4-dinitrophenol (DNP) degradation was investigated using activated sludge which had been adapted to mineralize DNP. DNP is a metabolic uncoupler, preventing cells from making energy for growth and it has been suggested that pH may be important in mitigating effects of uncouplers. After acclimation of the activated sludge, the effect of pH on toxicity of DNP at high concentration (75 mg/L) was investigated, over a pH range of 5 to 9. DNP inhibition was found to be strongly dependent on mixed liquor pH. The DNP degradation rate was highest in the pH range of 6.95 to 7.84; at pH 5.94 degradation of 75 mg/L DNP was significantly inhibited; at pH < 5.77, DNP degradation was completely inhibited after approximately 30% of the DNP was degraded. By comparison, no significant effect of pH variation in the same range was seen on glucose uptake by the activated sludge culture.

• 한국생물공학회:학술대회논문집
• /
• 2000.04a
• /
• pp.219-222
• /
• 2000

Physiological changes of Escherichia coli during the fed-batch fermentation process were characterized in this study. Overall cellular protein samples prepared at the different stage of fermentation were separated by 2-dimensional gel electrophoresis (2-DE), and differently expressed 15 proteins, Phosphotransferase enzyme I, GroEL, Trigger factor, ${\beta}$ subunit of ATP synthase, Transcriptional regulator KDGR, Phosphoglycerate mutase 1, Inorganic pyrophosphatase, Serine Hydroxymethyl-transferase, ${\alpha}$ subunit of RNA polymerase, Elongation factor Tu, Elongation factor Ts, Tyrosine-tRNA ligase, DnaK suppressor protein, Transcriptional elongation factor, 30S ribosomal protein S6 were identified using matrix-assisted laser desorption / ionization time-of-flight mass spectrometry (MALDI-TOF MS). When bacterial cells grow to high cell density, and IPTG-inducible heterologous protein is produced, expression level of overall cellular proteins was decreased. According to their functions in the cell, identified proteins were classified into three groups, proteins involved in transport process, small-molecule metabolism, and synthesis and modification of macromolecules.

• KSBB Journal
• /
• v.6 no.3
• /
• pp.299-307
• /
• 1991

In this paper the effect of light on non-aerated Baker's Yeast(Saccharomyces cereuisiae) production and the protein excretion to the extracellular fluid is studied. Previous results in our laboratory indicate that at pH=5 and T-32$^{\circ}C$ yeast may be affected by light, but those differences seem to be within statistical variation of the data. In this paper, cell and extracellular protein concentrations along with redox potential are monitored for batch fermentations in the presence and absence of light at pH levels of 3 and 5 and at 31$^{\circ}C$, in order to explore whether possible light effects can be more readily discerned at lower pH values. Yeast particle size distributions are also determined over the course of fermentation using a particle counter in order to add one more measuring tool to our usual cell and total protein measurements. An apparently noticeable difference in the redox potential is observed between the light and the dark runs for early times for the pH=3 runs. The particle size distributions show differences in the particle diameters between light and dark runs at pH=3, but those differences fall within one standard deviation of the mean particle diameters.

• Journal of Environmental Health Sciences
• /
• v.34 no.1
• /
• pp.76-85
• /
• 2008

Biological nutrient removal (BNR) sludge was added to a sequencing batch reactor (SBR) in the addition ratios of 0%, 20%, 40%, 50% while observing the variation of nutrient removal characteristics and microorganism groups. When the BNR sludge was added in a ratio over 40%, the characteristics of EBPR (enhanced biological phosphorus removal) was shown at the 27 days. However, a distinct BNR was not shown when the addition ratio of BNR sludge was lower than 40%. The organic removal efficiency were shown as 90% in all SBRs irrespective of the addition ratio of BNR sludge. At the 27 days, the phosphorus removal efficiencies were shown as 40%, 55%, 77% and 69%, respectively, according to the addition ratio of BNR sludge. Overall, efficient nitrification and phosphorus removal was shown when the added BNR sludge ratio was over 40%.

• Korea-Australia Rheology Journal
• /
• v.13 no.2
• /
• pp.89-95
• /
• 2001

Effects of particulate size and frictional characteristics were examined on the melting behavior of PP(polypropylene) in a twin screw extruder. Powder and pellet types of PP were used and each component was blended with PE(polyethylene) wax and clay, respectively. It was observed that small size particulates, 1.e. powder systems exhibit accelerated melting behavior; and it was also found that the abrasive auditive acts as an effective agent for fast melting of PP powder. Retardation of melting due to the reduced friction was observed in both types of PP, contrary to the result found in a batch mixer. The tendency observed in variation of torque and exit temperature was explained in terms of frictional effect and length of compacted region formed during evolution of melting.

• Macromolecular Research
• /
• v.9 no.2
• /
• pp.122-128
• /
• 2001

Monodisperse composite latex particles with size of ca. 300 nm, which consist ofn-butyl acrylate as a soft phase and methyl methacrylate as a hard phase with different morphology, were synthesized by seeded multi-stage emulsion polymerization. Three types of composite latex particles including random-, core/shell-, and gradient-type particles were obtained by using different monomer feeding methods during semi-batch emulsion polymerization. Effect of poly(butyl acrylate)-poly(methyl methacrylate) rubber particle morphology on the mechanical and rheological properties of rubber toughened poly(methyl methacrylate) was investigated. Among three different rubber particles, the gradient-type rubber particle showed better toughening effect than others. No significant variation of rheological property of poly(methyl methacrylate)/rubber blends was observed for the different rubber particle morphology.

• Journal of Korean Society of Water and Wastewater
• /
• v.20 no.3
• /
• pp.451-460
• /
• 2006

While sludge settles down in a batch column, sludge concentration becomes high. Sludge concentration change is one of the most critical causes of the sludge settling velocity variation. Therefore, sludge concentration change causes sludge index to change. SVI is more sensitive than other sludge indexes to the change of sludge concentration. And if sludge-water interface has reached final height within 30minutes, SVI is not suitable for prediction of sludge settling characteristic, Therefore, SVIs of each sludge are, in some cases, different although each sludge has the same settling velocity. But SVI has been widely used to interpret sludge settling characteristic by a simple testing method. This work has two purposes. The first purpose is to predict sludge settling velocity by using sludge-water interface settling velocity. And the second purpose is to develop new sludge settling characteristic index to exactly interpret sludge settling characteristic by overcoming the limit of SVI.

• Journal of Life Science
• /
• v.11 no.2
• /
• pp.116-119
• /
• 2001

Xinlei studies on the production of pullulan by Aureobasidium pullulans using batch culture in a 15L bioreactor were carried out. The mathematical models were obtained in this study, which provided a reasonable description for the biomass, the product, and the substrate variation with time. The values frets the mathematical models were satisfactorily coincided with the experimental data for the biomass of A. pullulans, the production of pullulan and the utilization of sucrose as the sole carbon source.