• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.12
• /
• pp.93-102
• /
• 1998

In noisy environments, human speech productions are influenced by noises(Lombard effect), and speech signals are contaminated. These distortions dramatically reduce the performance of speech recognition systems. This paper proposes a method of the Lombard effect compensation and noise suppression in order to improve speech recognition performance in noise environments. To estimate the intensity of the Lombard effect which is a nonlinear distortion depending on the ambient noise levels, speakers, and phonetic units, we formulate the measure of the Lombard effect level based on the acoustic speech signal, and the measure is used to compensate the Lombard effect. The distortions of speech under noisy environments are cancelled out as follows. First, spectral subtraction and band-pass filtering are used to cancel out noise. Second, energy nomalization is proposed to cancel out the variation of vocal intensity by the Lombard effect. Finally, the Lombard effect level controls the transform which converts Lombard speech cepstrum to clean speech cepstrum. The proposed method was validated on 50 korean word recognition. Average recognition rates were 82.6%, 95.7%, 97.6% with the proposed method, while 46.3%, 75.5%, 87.4% without any compensation at SNR 0, 10, 20 dB, respectively.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.1
• /
• pp.34-40
• /
• 2004

The PLDRO(Phase-Locked Dielectric Resonator Oscillator) with low phase noise is designed for X-band. The phase of VCDRO(Voltage Controlled Dielectric Resonator Oscillator) is locked to that of a high stable reference oscillator by using a SPD(Sampling Phase Detector) to improve phase noise performance in the loop bandwidth. And, the VCDRO is implemented using a high impedance inverter coupled with dielectric resonator to improve the phase noise performance out of the loop bandwidth. This PLDRO exhibits the harmonic rejection characteristics of 51.67㏈c and requires below 1.95W. The phase noise characteristics are performed as -107.17㏈c/Hz at 10KHz offset frequency and -113.0㏈c/Hz at 100KHz offset frequency, respectively, at ambient. And the output power of 13.0㏈m${\pm}$0.33㏈ is measured over the temperature range of $-20 ∼ +70^{\circ}C$ .

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.13 no.11
• /
• pp.890-896
• /
• 2003

It is said that the goal of the design of good acoustical environment is at first the reduction of undesirable sounds. and in addition the introduction of desirable sounds by which our minds are soothed. The task of creating the desirable sounds leads to the realization of a comfortable acoustic environment and the design of soundscape. It may be an important starting point of soundscape design to select suitable sounds for the target spaces. because each space has a different surrounding condition and requires a special ambient sound. This paper aims to survey preference of the environmental sounds suitable for the public spaces in urban areas such as parks. bus terminals. 35 kinds of natural sounds are. rated by 26 pairs of adjectives. The results of psycho-acoustic experiments are as follows. 1. The proper adjectives for expressing the environmental sounds are classified into 6 groups of comfort, pleasure, fullness. variety, distinctness. and naturalness. 2. Bird singing. murmuring of a stream, artificial sounds. singing of insects and animals are the affirmative rank of preference. 3. Green musics consisted of music and natural sounds are preferred to the pure natural sounds. 4. Sound level relative to background noise causes various preferences to natural sounds in public spaces.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.10
• /
• pp.148-158
• /
• 2015

It is difficult to test a detection system in underwater acoustics channel environments. The system can be evaluated by using simulation analysis tool. In this paper, a simulation tool is proposed to analyze the effectiveness of underwater acoustics detection based on database for real environments. First, the underwater environment is built based on HYCOM underwater environment database. Then, a multipath characteristic is considered through calculating underwater acoustics propagation path/pressure based on the ray theory. Also, hydrophone thermal noise and underwater ambient noise are considered to reflect underwater noise characteristics.

• The Journal of the Acoustical Society of Korea
• /
• v.19 no.4
• /
• pp.16-22
• /
• 2000

In order to predict the performance and the usefulness of the narrow-band underwater acoustic measurement system at design stage, whose error variance is not clearly described, in this study a boundary equation to estimate the measurement accuracy is proposed based on the confidency as SNR variation. The boundary is presented as a function of SNR and the number of samples. In this paper, the measurement performance for narrow-band signal is simulated by the proposed boundary equation and the results are reviewed in the biased noise condition and separately in the background noise rejected condition.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.20 no.5
• /
• pp.44-52
• /
• 2012

Fuel cell electric vehicles have some noise problems due to its air processing unit which is required to feed the ambient air into the fuel cell stack. Discrete-frequency noises are radiated from a centrifugal blower due to rotor-stator interaction. Their fundamental frequency is the blade passing frequency, which is determined by the number of rotor blades and their rotating speed. To reduce such noises, multi-chamber perforated muffler has been designed. In this paper, in order to improve the transmission loss of a perforated muffler, the relationship between the impedance model of a perforated hole and its noise reduction performance is studied, and the applicability of a short-length perforated muffler to air processing unit of fuel cell system is described using acoustic simulation results and experimental data. The acoustic velocity vector across the neck of a perforated hole is very important design factor to optimize the transmission of an intake muffler. The suggested short-length perforated muffler is effective on discrete-frequency noises while keeping the volume of intake muffler minimized.

• Journal of Institute of Control, Robotics and Systems
• /
• v.22 no.10
• /
• pp.797-802
• /
• 2016

This paper proposes a noble voice recognition method based on an adaptive MFCC and deep learning for embedded systems. To enhance the recognition ratio of the proposed voice recognizer, ambient noise mixed into the voice signal has to be eliminated. However, noise filtering processes, which may damage voice data, diminishes the recognition ratio. In this paper, a filter has been designed for the frequency range within a voice signal, and imposed weights are used to reduce data deterioration. In addition, a deep learning algorithm, which does not require a database in the recognition algorithm, has been adapted for embedded systems, which inherently require small amounts of memory. The experimental results suggest that the proposed deep learning algorithm and HMM voice recognizer, utilizing the proposed adaptive MFCC algorithm, perform better than conventional MFCC algorithms in its recognition ratio within a noisy environment.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.05a
• /
• pp.1010-1013
• /
• 2003

It is said that the goal of the design of good acoustical environment is at first the reduction of undesirable sounds, and in addition the introduction of desirable sounds by which our minds are soothed. The task of creating the desirable sounds leads to the realization of a comfortable acoustic environment and the design of soundscape. It may be an important starting point of soundscape design to select suitable sounds for the target spaces, because each space has a different surrounding condition and requires a special ambient sound. This paper aims to survey preference of the environmental sounds suitable for the public spaces in urban areas such as parks, bus terminals. 35 kinds of natural sounds are rated by 26 pairs of adjectives. The results of psycho-acoustic experiments are as follows. 1. The proper adjectives for expressing the environmental sounds are classified into 6 groups of comfort, pleasure, fullness, variety, distinctness, naturalness. 2. Bird singing, murmuring of a stream, artificial sounds, singing of insects and animals are the affirmative order of preference. 3. Green musics consisted of music and natural sounds are preferred to the pure natural sounds. 4. Sound level relative to background noise causes various preferences to natural sounds in public spaces.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.12 no.6
• /
• pp.1057-1064
• /
• 2017

High sensitivity magnetic sensor having foreign metal detection capability is proposed utilizing giant magneto-impedance effect. Strip sensor showed the increasing output voltage when the external magnetic field was applied along with strip from strip grounding point, although the initial DC voltage varied depending on the pointing direction of strip sensor. Proposed sensor was able to eliminate more than half of background noise using active noise filter to achive high sensitivity, and it showed the capability to detect magnetized foreign metal object independent of ambient electro-magnetic noise and earth magnet. In case of ferrous sphere, the metal detection up to 0.8mm diameter was experimentally demonstrated at 5mm distance from strip sensor.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.16 no.4
• /
• pp.456-464
• /
• 2013

Passive sonar in submarine can detect the target in long range and can attack using it. There are many noises which can be received at passive sonar of submarine. When noise received in the sonar it make diverse interference pattern depend on the ocean ambient and movement scenario. Interference pattern can be explained by theory of waveguide invariant. In this paper, analyze the interference pattern according to the relative motions of surface ship and submarine. And analyze the occurrence reason of 2 kinds of interference patterns those are usually display on the submarine console. The results show that if relative speed of submarine and target increase then gradient of interference pattern will increase. And closest point approach of submarine and target decrease then gradient of interference pattern will increase. Bathtube pattern usually appear when target pass though close to submarine and Pinetree pattern appear target pass though above of submarine.