• 한국환경보건학회지
• /
• 제40권1호
• /
• pp.38-46
• /
• 2014

Objectives: This study was carried out in order to estimate atmospheric polycyclic aromatic hydrocarbon (PAH) concentrations and sources using pine needles as a passive air sampler (PAS) in urban (Pyeongtaek), semirural (Anseong) and rural (Jincheon) sites. Methods: One-year-old pine needles were collected for analysis of their PAH concentrations ($C_{p,n}g/g$ dry) at the end of December. PAHs concentrations in the ambient air ($C_a$, $ng/m^3$) were calculated with a $Log(C_p/C_a)-LogK_{oa}$ correlational equation. Results: PAHs concentrations in ambient air ($C_a$) were high, in the order of urban ($114.03ng/m^3$), semirural ($105.17ng/m^3$) and rural ($61.91ng/m^3$) sites. However, distributions of PAH isomer concentrations were very similar. PAHs of which molecular weight is smaller than 228.30 (AcPy, Acp, Flu, Phen, Ant, Flt, Pyr, BaA, Chry) made up most of the PAHs in the ambient air (96.6-98.5%). Conclusion: At urban, semirural and rural sites, it was concluded that the main source of PAHs in the ambient air ratio of each PAH isomer concentration was cars, especially diesel vehicles.

• 대한환경공학회지
• /
• 제27권2호
• /
• pp.170-176
• /
• 2005

한국과 일본의 환경대기 시료를 대상으로 PCB 전이성질체 분석을 통하여, 오염정도 및 이성질체 분포 특성을 파악하고 통계적 처리기법을 통하여 발생원을 추정하였다. 환경대기 중 PCB 농도는 한국이 $0.003{\sim}1.01\;pgTEQ/m^3$ (평균 $0.22\;pgTEQ/m^3$), 일본이 $0.002{\sim}0.014\;pgTEQ/m^3$(평균 $0.007\;pgTEQ/m^3$)으로 나타났다. 한국의 환경대기 중 PCB 농도는 공단지역이 도시지역간의 농도 변화폭이 매우 크게 나타났다. 이성질체 분포에 있어서는 대체로 유사한 경향을 나타내었으나 한국의 공단 지역에서는 $7{\sim}10CB$의 고염소화 동족체가 검출되어 특정한 오염원이 존재할 가능성이 시사되었다. 주성분 분석을 통하여 한국과 일본의 환경대기 중 PCB 오염원을 추정한 결과 한국 환경대기 시료가 일본 환경대기 시료에 비하여 소각로 영향을 많이 받고 있으며 PCB 제품 영향은 일본에 비해 상대적으로 적은 것으로 판단된다.

• 한국입자에어로졸학회지
• /
• 제4권1호
• /
• pp.9-20
• /
• 2008

The effect of light intensity on the ozone formation and the aerosol number concentration during the photochemical reactions of ambient air was investigated in an indoor smog chamber. The smog chamber consists of a housing, 64 blacklights, and a $2.5-m^3$ reaction bag made of Teflon film. The bag was filled with the unfiltered ambient air in Seoul from January 10 to March 18, 2002. In this work, the photolysis rate of $NO_2$, $k_1$ was used as an index of light intensity. Three levels of light intensity were controlled by changing the number of blacklights turned on among 64 blacklights: $0.29min^{-1}$ (50%), $0.44min^{-1}$ (75%), $0.57min^{-1}$ (100%). The ozone concentration increased rapidly within 10 minutes after irradiation irrespective of light intensity, thereafter it increased linearly during the irradiation. The ozone production rate seems to be dependent on both the light intensity and the quality of ambient air introduced into the reaction bag. The change in aerosol number concentration also depended on both the light intensity and the ambient air quality, especially aerosol size distribution. Based on the initial ambient aerosol size distributions, the photochemical potential for aerosol formation and growth is classified into two cases. One is the case showing aerosol formation and growth processes, and the other is the case showing no apparent change in particle size distribution.

• Korean Journal of Geomatics
• /
• 제2권2호
• /
• pp.145-151
• /
• 2002

GIS technique is applied to the analysis of ambient air quality information. For this study, the TMS-monitored air quality information was imported with the geographical information of the TMS stations in Capital Area. It is found that currently available GIS technique has a great extend of potential for air quality management. From the analysis of air quality information, the GIS application demonstrates the poor air quality in the central Capital Area and the it is improved as it travels down to the suburb area. The ambient air quality is also proven to be highly influenced by the ozone concentration in a mid-summer day.

• The Korean Journal of Ceramics
• /
• 제2권3호
• /
• pp.137-141
• /
• 1996

Ambient air aged anodically etched porous silicon (PS) and spark-processed silicon (sp-Si) show interesting similarities and dissimilarities in some of their luminescence-related properties. Among these similarties are: (1) the photoluminescence (PL) peak maximum in the blue/violet (410 nm);(2) the blue/violet PL peak positions are essentially unchanged with temperature ; (3) PL decay times in the nanosecond region which are independent of the detection wavelength, which is much faster in decay times compared to that of observed decay time in $SiO_2$.Among the dissimilarities are: (1) the PL intensity of blue/violet luminescence, namely, the PL intensity of sp-Si is at least 2 orders of magnitude larger than that of an ambient air aged PS; (2) the blue/violet PL intensity of sp-Si is more stable than that of ambient air aged PS under UV illuminations; (3) FTIR spectra of sp-Si favor those modes, which involve silicon -oxygen bonds in $SiO_2$ stoichiometry, whereas ambient air aged PS can be considered as a nonstoichiometric oxide judging from the observed vibrational spectra.

• 설비공학논문집
• /
• 제16권5호
• /
• pp.438-443
• /
• 2004

The objective of this paper is to study the effects of the input gas flow rate and the ambient temperature variation on the absorption cycle performance. An air-cooled NH$_3$-$H_2O$ absorption chiller is tested in the present study. The nominal cooling capacity of the single effect maching is 17.6 ㎾ (5.0 USRT). The cooling capacity, coefficient of performance, burner efficiency, and each state point are measured with the variations of the heat input and the ambient temperature. It is found that the COP and cooling capacity increase with increasing the generator exit temperature up to a certain temperature and then decrease. It is also found that the COP and the cooling capacity decrease with increasing the ambient temperature. The maximum COP of 0.51 is obtained from the present experiment.

• 대한기계학회논문집B
• /
• 제24권1호
• /
• pp.68-74
• /
• 2000

Experimental investigation on flame spread along suspended droplet arrays have been conducted with various droplet spacings and ambient air velocities. Especially, an opposed air stream is introduced to simulate fundamental flame spread behaviors in spray combustion. High-speed chemiluminescence imaging technique of OH radicals has been adopted to measure flame spread rates and to observe various flame spread behaviors. The fuel used is n-Decane and the air velocity varies from 0 to 17cm/s. The pattern of flame spread is grouped into two: a continuous mode and an intermittent one. It is found that there exists droplet spcings, above which flame spread does not occur. The increase of ambient air velocity causes the limit droplet spacing of flame spread to become small due to the increase of apparent flame stretch. As the ambient air velocity decreases, flame spread rate increases and then decreases after taking a maximum flame spread rate. This suggests that there exists a moderate air flowing to give a maximum flame spread rate due to enhanced chemical reaction by the increase of oxidizer concentration.

• 한국태양에너지학회 논문집
• /
• 제21권2호
• /
• pp.27-34
• /
• 2001

The greenhouse heating system using solar energy has been realized in the protective agriculture in this study in order to analyse the thermal energy characteristics of the system the effects of ambient air temperature, solar radiation, relative humidities and water content of ambient air on the greenhouse air temperature were investigated through computer simulation experimental analysis for validation of the simulation. The results from this study are summarized as follows: 1) The expected values of inside air temperature for the system solar energy were very much close to the experimental values. 2) In the system using solar energy, the expected values of daytime surface temperature of soil by computer simulation were very much similar to the measured values, but those of nighttime were higher than the measured value by almost $2.5^{\circ}C$. 3) Heat loss of daytime was found to be larger than that of night time as much as 2.0 to 4.2 times for the system using solar energy. 4) In the system using solar energy. while the ambient air temperature varied between $-7^{\circ}C$ and $-3.8^{\circ}C$, the temperature of the inside air was maintained between $0^{\circ}C$ and $22^{\circ}C$. 5) At the minimum ambient temperature of $-7^{\circ}C$, the temperature of the inside air was $0^{\circ}C$.

• Journal of Biosystems Engineering
• /
• 제30권3호
• /
• pp.155-160
• /
• 2005

The objective of this research was to establish a domestically available cooling storage technique by cold-air in winter, using winter cool air ventilation fur determining rough rice cooling method in the storage and dry bin. The rough rice storage characteristics of two test conditions, winter cool-air ventilation storage and ambient temperature storage, were evaluated from January to July 2001, using a storage and dry bin of 300-ton capacity. Results of this research are as follows: Grain temperature was from $-5.1\~-8.5^{\circ}C$ after winter cool-air ventilation, and grain initial temperature for ambient temperature bin storage was $0.3\~1.9^{\circ}C$. Moisture content of rough rice decreased from $0.28\;to\;0.93\%$ and from $1.53\;to\;1.92\%$ to compare with original moisture contents for winter cool-air ventilation, and for ambient temperature bin storage, respectively. Broken ratio of brown rice from winter cool-air ventilation bin increased from $0.16\;to\; 0.92\%$, and brown rice broken ratio was from $2.24\;to\;2.86\%$ for ambient temperature bin storage to compare with initial broken ratio. Hardness of stored rice increased along storage period increase in alt storage methods, and cooling bin storage increased rice hardness of 0.271kgf: this increasing was lower then the other methods from 0.059 to 2.239kgf. Germination rates were decreased approximately 9.03, 3.14 and $3.20\%$ for upper, middle, and bottom of ventilating winter air bin, respectively, and germination rates of 2.70, 3.47 and $4.14\%$ were approximately decreased for upper, middle, and bottom parts of ambient temperature bin storage, respectively.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2006년도 하계학술발표대회 논문집
• /
• pp.436-441
• /
• 2006

In recent European telecommunication base transceiver stations(BTS) a membrane laminated air filter is reported to replace a heat exchanger in order to cool internal digital units of BTS. The concept of using the air filter is for the direct ambient cooling(DAC) of BTSs without heat loss generally found ill the heat exchanger type BTS. In the present study, a performance evaluation experiment was conducted to investigate the pressure drop characteristics with dust loading and the particle collection efficiency of the air filter for the DAC of BTS.