• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제55권4호
• /
• pp.199-203
• /
• 2006

This paper presents an ASER (Accelerated Soft Error Rate) integral model. The model is based on the facts that the generated EHP/s(electron hole pairs) are diminished after some residual range of the incident alpha particle, where residual range is a function of the incident angle and the capping layer thickness over the semiconductor junction. The ASER is influenced by the flux of the alpha particles, the junction area ratio, the alpha particle incident angle when the critical charge is same as the collected charge, and the sizes of the alpha source and the chip. The model was examined with 8M static RAM samples. The measured ASER data showed good agreement with the calculated values using the model. The ASER decreased exponentially with respect to the operational voltage. As the capping layer thickness increases up to $16{\mu}m$, the ASER increases, and after that thickness, the ASER decreases. The ASER increased as the depth of BNW increased from $0{\mu}m\;to\;4{\mu}m$. and then saturated. The ASER decreased as the node capacitance increased from 2fF to 5fF.

• Journal of Radiation Protection and Research
• /
• 제13권2호
• /
• pp.1-8
• /
• 1988

3MeV에 서 5.4MeV 사이의 $\alpha$-입자에 대한 저지능과 저지 단면적을 He, Ar, 및 $N_2$ 가스에 대해서 측정했다. Srivastava의 저지능 공식을 본 실험결과에 적용시켜 그 타당성을 알아보았다. 그결과 Ar의 경우는 매우 잘 일치됨을 보여주며, He의 경우는 27-28%, $N_2$의 경우는 13-26%의 불일치를 보여주고 있다.

• 한국세라믹학회지
• /
• 제33권5호
• /
• pp.547-555
• /
• 1996

Porous alumina ceramics were fabricated by pseudo-boehmite phydosol-gel process within/without commercial $\alpha$-alumina particles average 1 and 40 micron respectively. The pore characteristics of fired specimens were studied by the measurement of bulk density total porosity thyermal analysis pore volume pore distribution BET area XRD and SEM. with increasing of firing temperature pore volume and BET surface area were decreased and the average pore size was increased to approximately 146$\AA$ upto 80$0^{\circ}C$ by de-watering of [OH] and formation of $\alpha$-alumina. The fired relative density of the alumina-dispersed specimen with average 1 micron particle was increased with the amounts of dispersed particle by bimodal packing theory which is compared to the ones of specimen including of average 40 micron particle. It was confirmed that the percola-tion threshold in porous ceramics with coarser particle (40 micron) has formed between the transformed-alumina from hydrogel and dispersed-alumina of above 50 vol% particle and the total porosity was increased at the threshold point above.

• 한국세라믹학회지
• /
• 제26권4호
• /
• pp.583-587
• /
• 1989

Various $\alpha$-silicon carbied and colloidal graphite particles were sintered at 155$0^{\circ}C$ in vacuum atmosphere by reaction bonding sintering method, and the physical properties and microstructural analysis of specimen were investigated. With decreasing particle size, sintered density and 3-point bending strength of materials were increased and 3.2${\mu}{\textrm}{m}$ specimen showed high density and strength, 3.05g/㎤, 40kg/$\textrm{mm}^2$, respectively. The results of X-ray diffractometer and optical micrographs analysis showed that graphite and silicon melt reacted to convert to fine $\beta$-SiC particle and the body was changed to dense material.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1996년도 춘계학술발표회논문집(4)
• /
• pp.133-138
• /
• 1996

For the application of hydrogenated amorphous silicon (a-Si:H) p-i-n structural diode as the alpha particle spectroscopy, the induced charge collection was simulated based on a relevant non-uniform charge generation model. The simulation was accomplished for two extreme cases of the incident direction of alpha particle, p-and n-side, respectively. As expected, for the complete charge collection, the hole collection should be severely considered due to its poor mobility and the full depletion bias required. For the comparison of signal corresponding to the detector configuration or structure, although n-i-p configuration shows a wider range of linearity to the energy, p-i-n configuration is more suitable in the viewpoint of linearity and signal value for the considering energy range.

• Nuclear Engineering and Technology
• /
• 제28권4호
• /
• pp.397-404
• /
• 1996

The hydrogenated amorphous silicon (a-Si : H) holds good promise for radiation detection from its inherent merits over crystalline counterpart. For the application to alpha spectroscopy, the induced charge collection in a-Si : H pin detector diodes ons simulated based on a relevant non-uniform charge generation model. The simulation was peformed for the initial energy and the range of incident alpha particles, detector thickness and the operational parameters such as the applied reverse bias voltage and shaping time. From the simulation, the total charge collection was strongly affected by hole collection as expected. To get a reasonable signal generation, therefore, the hole collection should be seriously considered for detector operational parameters such as shaping time and reverse voltage etc. For the spectroscopy of alpha particle from common alpha sources, the amorphous silicon should have about 70${\mu}{\textrm}{m}$ thickness.

• 한국세라믹학회지
• /
• 제40권8호
• /
• pp.730-734
• /
• 2003

This research examined the effect, which it follows in particle size distribution change of CaHPO$_4$ㆍ2$H_{2}O$ (DCPD). We used two kinds of compositions; tetracalcium phosphate (TTCP)/dicalcium phosphate dihydrate (DCPD) composition and $\alpha$-tricalcium phosphate ($\alpha$-TCP)TTCP/DCPD composition. As the result, the mean particle size of the DCPD decreased, the setting tine shortened at all compositions. The reference powder (DR), which did not milling, showed about 2 times strength value compared with other milling sample. Especially, the compressive strength of 60 : 20 : 20 sample (DR(do$_{0.5}$)=12.08 $\mu\textrm{m}$) after curing 7 days in simulated body fluid solution was 40$\pm$0.5 MPa, which was the highest. This resulted from the packing density at $\alpha$-TCP/TTCP/DCPD combination.

• 한국결정성장학회지
• /
• 제9권2호
• /
• pp.191-196
• /
• 1999

수열합성법을 이용한 $\alpha$-$SiO_2$ 단결정 분말 제조시 교반의 추가와 승온속도의 변화가 입자의 결정성, 입도분포 및 평균입경에 미치는 영향을 조사하였다. KOH를 광화제로 사용하였으며, $350^{\circ}C$에서 3시간 동안 반응을 시켜 평균입자 크기가 1~3.2$\mu\textrm{m}$인 결정 분말을 제조하였다. 실험결과 반응초기부터 교반을 한 경우에는 교반속도가 증가함에 따라 평균입경이 감소했으나, 결정성은 나빠지다가 150r/min 이상에서는 다시 좋아졌다. 또한 반응 도중에 교반을 추가하면 반응초기부터 교반을 한 경우보다 입자의 크기가 커졌다. 그러나 교반속도를 일정하게 한 후 승온속도를 느리게 하면 입자의 크기가 작아졌다.

• 한국지반공학회논문집
• /
• 제29권11호
• /
• pp.61-72
• /
• 2013

Sabkha층 탄산질 모래의 입자파쇄발생시 이차압축특성을 파악하기 위하여 압밀시험을 수행하여 입자파쇄응력을 파악하였다. 입자파쇄 항복응력에서 순간적으로 발생한 입자파쇄 압축침하를 해석하기 위하여 이차압축률 대신 이차 파쇄압축률 $C_{{\alpha}{\epsilon}}{^*}$를 도입하였다. 입자파쇄 발생시의 간극비 $e_p{^*}$와 침하량 $H_p{^*}$가 이차압축거동의 기준점으로 사용되었다. 일차압축지수와 이차파쇄압축률을 비교한 결과 현장 Sabkha층의 경우 $C_{{\alpha}{\epsilon}}{^*}/C_c$ 값이 0.0105~0.0187로 나타났으며 일반적인 석영질 사질토에 비해 입자파쇄 발생으로 인한 이차압축거동이 매우 크게 나타났다. 동일한 재하응력에서는 Sabkha층의 심도가 깊을수록 입자파쇄침하량과 이차파쇄압축률이 증가함을 확인할 수 있었다.

• 한국자기학회지
• /
• 제4권3호
• /
• pp.282-284
• /
• 1994

물의 양성자완화에 의하여 기생 강자성 ${\alpha}-Fe_{2}O_{3}$의 유효 자기능률 결정을 위한 이론식을 유도하였다. 그 이론식을 유도함에 있어서 그 결정입자의 대응전자스핀과 물분자의 양성자 스핀사이의 거리가 상대적 거리보다 오히려 동경벡터로 고려되어야 한다는 사실을 제외하고서 자유 상자성 이론들을 함유함고 있는 수용액에 적용된 수학적 과정과 정확히 동일하다는 것을 알았다. 또한 유도된 이론식에 의하여 계산된 결정입자의 유효자기능률이 Hiral에 의하여 결정된 실험치 잘 일치함을 알았다.