• Journal of the Korean GEO-environmental Society
• /
• v.15 no.10
• /
• pp.15-21
• /
• 2014

In this study, biochemical methane potential test was conducted to estimate ultimate methane and carbon dioxide yield for anaerobic digestion and pretreatment with sewage sludge cake. Two of 0.2 % TS of sewage sludge cakes were treated with 5M NaOH or sonication of 0.51 W/mL during 30 min respectively. Another sample was treated simultaneously with NaOH and sonication in same condition. Then, initial soluble COD increased from 33.1 mg/L to 494 mg/L. After BMP test, methane production ranged from 3.12 and 84.2 mL $CH_4$ per g of Volatile Solid (VS) and 9.2 and 13.5 mL $CO_2$ per g of Volatile Solid (VS) for carbon dioxide. In other tests, injection of nutrient media or sludge supernatant produced 73.1 and 73.8 mL $CH_4$ per g of Volatile Solid (VS) and 11.2 and 13.6 mL $CO_2$ per g of Volatile Solid (VS) respectively. When BMP test finished, 62 % of initial volatile solids decreased to 33.8~45.4 %. Simultaneous pretreatment increased soluble COD, reduction rate of volatile solids and digestion efficiency than those for alkaline and ultrasonic pretreatment.

• Korean Journal of Food Science and Technology
• /
• v.53 no.6
• /
• pp.749-755
• /
• 2021

The objective of this study was to investigate the physicochemical properties of rice starch extracted from stale rice using alkaline steeping (AKL) and improved enzymatic digestion (iENZ) methods. The crude protein content (0.5-0.7%) of stale rice starch (SRS) was less than 1% by iENZ, but not so when measured by the existing ENZ methods. SRS is an intermediate amylose rice starch. AKL-SRS and iENZ-SRS exhibited typical A-type crystal packing arrangements with similar relative crystallinities. iENZ-SRS showed higher gelatinization onset and peak temperatures with a narrower gelatinization temperature range, compared to those of AKL-SRS, indicating that iENZ annealed SRS. Thus, iENZ-SRS exhibited lower swelling power and solubility, and higher pasting viscosities with delayed viscosity development. Overall, the use of stale rice as a rice starch source could make economical production of rice starch possible, and iENZ may diversify rice starch characteristics, which expands the utilization of rice starch in food and non-food industries.

• Analytical Science and Technology
• /
• v.13 no.3
• /
• pp.297-303
• /
• 2000

Isotope-dilution inductively coupled plasma mass spectrometry was used to determine trace amounts of Cd, Cu, Pb, Ni and Zn in sediment. Sediment samples were dissolved by microwave digestion with addition of mixed acid ($HNO_3$, HF and $HClO_4$). Lead was determined after separation of alkaline and alkaline earth metals by an ammonium pyrrolidenedithiocarbarmate (APDC) solvent extraction. The other elements were determined after separation of iron, tin and titanium by hydroxide precipitation. Recovery efficiency of the analyte elements was not satisfactory, but most of matrix elements causing the isobaric interference could be effectively eliminated by the separation. Good agreement was achieved with the certified values in the analysis of the two sediment reference materials.

• Korean Journal of Microbiology
• /
• v.7 no.3
• /
• pp.115-124
• /
• 1969

The mash of Takjoo, Korean flour wine, is fermented through two brewing processes ; the primary brewing process to saccharify and the main one to produce ethyl alcohol. The activities of acid proteinase (pH3), weak acid proteinase (pH 6), and alkaline proteinase (Ph 80 on the processes are determined with time by the Folin phenol method as a strength of casein digestion. Hydrogen ion concentration, the content of total organic acids, protein, free amino acids and oligopeptides, which effect the activities of proteinase, are also measured. The results are briefly summarized as follows : 1. In general, the activities of acid proteinase and weak acid proteinase in the mesh of primary brewing process are stronger than those in main brewing process. 2. The activities of acid proteinase are remarkably stronger than those of weak acid proteinase in both processes. It reveals that they decrease slowly through the fermentation. Activities of alkaline proteinase are weaker than others. 3. As the raw materials are mixtured, the total amount of organic acids is equivalent to 0.150 mg/ml acetic acid in the mesh of primary brewing process and 0.02 mg/ml acetic acid in the main one. They increase gradually with time. 4. Hydrogen ion concnetration shows 3.9 in the mesh of main brewing process and 3.28 in the primary one. They increase to the maximum in 60-72 hrs., and decrease since 108 hrs. 5. The content of crude protein shows 66.90mg/ml in the mesh of main brewing process, while shows 64.29mg/ml in the mesh of primary one. they decrease slowly with time. it seems that a small content of crude protein, as a substrate, converts into amino acids and soluble nitrogen compounds by proteinase. 6. The content of free amino acids and oligopeptides shows 0.36 mg/ml in the mesh of primary brewing process and 0.24mg/ml in the main brewing process. It is evident that the reason they increase continuously through the fermentation is the effect of proteinase. 7. According to the results, the strong activities of proteinase in primary brewing process has been derived from the decrease of hydrogen ion concentration due to the production of organic acids.

• Analytical Science and Technology
• /
• v.37 no.3
• /
• pp.174-188
• /
• 2024

This review summarized research trends regarding sample collection methods, pretreatment method, and types of analysis devices for microplastics (MPs) in soil and groundwater matrices. Soil sampling considers the selection of sampling location, depth, and volume. The typically sampling depth is within 15 cm (topsoil), and about 1 kg of mixed each sample. Among spot sampling and continuous flow sampling, groundwater sampling mainly used a continuous flow sampling, with collection rates 2 to 6 L/min in the range of 300~1,000 L, and followed by immediate on-situ filtration. Pretreatment method, applied to soil and groundwater, consist of organic digestion and density separation. In the organic digestion method, H₂O₂ is recommended among H₂O₂, acidic, alkaline, and enzymatic method. NaCl is primarily used as a reagent in density separation. However, depending on the density of MPs, other regents can be selectively used like ZnCl₂, ZnBr₂, and etc. Representative analysis device includes Fourier Transform Infrared (FTIR) and Raman spectroscopy for non-destructive analysis and Pyrolysis Gas Chromatography Mass Spectrometry (Py-GC/MS) for destructive analysis. µ-FTIR and Raman can count MPs of larger than 10 and 1 ㎛, and analyze MPs materials. However, it is need to sufficiently remove interference, like organic matter, in spectroscopic analysis using essential pretreatment method. Py-GC/MS is being continuously researched because it doesn't require complex pretreatment method and allows quantitative analysis of specific materials.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.23 no.6
• /
• pp.945-949
• /
• 1994

Chondroitin sulfate (Chs) contents in edible snail , Achatina fulica Bowdich , andits processed meat extracts were determined by high-performance liquid chormatogrpahy(HPLC) and spectrophotometric method. Spectrophotometric method was based on the precipitation of acriflavine by ChS, and HPLC method was based on the detection of two unsaturated disaccharides, 2-acetamido-2-deoxy-3-O-($\beta$ -D-gluco-4-enepyranosyluronic acid)-4-O-sulfo-D-galactose($\Delta$Di-4S) and 2-acetamido-2deoxy-3-O-($\beta$-D-gluco-4-eepyranosyluronic acid)-6-O-sulfo-D-galactose ($\Delta$야-6S) librated from ChS byenzymeatic digestion with chondroitinase ABc. the ratio of 125$\mu$mol of sodium hydroxide to mg of ChS and 8$0^{\circ}C$ of reaction temperature were proper for alkaline hydrolysis to remove protein residue form ChS. In assay preparation for HPLC ethod, the iptimum concentration of the enzyme chondroitinase ABc was 0.15 unit per 50 $\mu\textrm{g}$ of ChS at a fixed reaction time (30 min) and pH 8.0 using Tris buffer. ChS content in edible snail was 177.6mg% by spectrophotometric method and 153.5mg% by HPLC method and those in the processed meat extract was 71.3mg% by spectrometric method ad 62.8mg% by HPLC method, respectively.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.48 no.3
• /
• pp.66-72
• /
• 2016

The applicability of rice husk fiber as a raw material for eco-friendly pulp mold was evaluated in this study. The higher demand of environmental friendly packaging material resulted in the more interest for the natural fiber based pulp mold. The rice husk which is an abundant agricultural byproduct in Asia could be defiberized by an alkaline digestion process. The changes in the pulp mold making process and the properties of pulp mold by the addition of the rice husk were investigated. The addition of rice husk fiber to the pulp mold made with OCC or UBKP resulted in the increase in drainage at the pulp mold forming process. In case of UBKP pulp mold, the addition of rice husk fiber increased the drying efficiency after pulp mold forming since the structure of pulp mold became more bulkier by the addition of the rice husk fiber. Those results showed the rice husk fiber could be applied to the pulp mold manufacturing as one of the eco-friendly natural fiber resources.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.10 no.4
• /
• pp.185-192
• /
• 1990

A two-phase UASB system was operated for high-rate treatment of concentrated distillery wastewater. The phase separation was obtained by adjusting pH in each reactor. When influent SS concentration was 4.1/g/l, the first phase UASB reactor was effectively operated up to the loading rate of 16.5kg $COD/m^3.day$, producing 3.9g HAc/l.day. In the methanogenic UASB reactor, loading rate up to 44kg $COD/m^3.day$ could be applied while removing 80% of influent COD with a specific gas production of 16.5 l/l. day. After the formation granular sludge in both reactors, it was possible to maintain the appropriate pH in the first phase only by recirculating the effluent from methanogenic phase without the addition of alkaline chemicals.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.12
• /
• pp.2293-2298
• /
• 2007

In this study, a dithizone extraction technique involving purge & trap GC-MS was developed for the determination of methylmercury in biological samples, especially blood and fish. After alkaline digestion, methylmercury in biological samples was extracted into dithizone and back-extracted into aqueous sulfide solution. The extracted methylmercury was converted to the volatile ethyl derivative, purged and trapped onto a solid-phase collection medium, and then introduced into the GC-MS system. The determined MDLs of the established method were 0.9 ng·g?1 for biological samples and its accuracy and precision were found to be 93% and 3.8%, respectively. The method was validated by analysis of CRMs such as SRM 966, BCR 463 and IAEA 407 and all analytical results were within certified ranges with average RSDs of less than 6%. The analytical results of field-sampled fish also showed that the method can be successfully used as an alternative for commonly used distillation method followed by GC-CVAFS detection.

• Analytical Science and Technology
• /
• v.8 no.2
• /
• pp.167-170
• /
• 1995

A simple and rapid permanganate value test procedure for the estimation of COD, based on the photometric measurement of the remained permanganate after the color bleaching by oxygen demand organics during digestion, has been described. Optimized conditions were 1% NaOH, 0.6mM $KMnO_4$, with a closed reflux in the boiling water bath for 90 sec using sample size of 5mL.