• Journal of the Mineralogical Society of Korea
• /
• v.15 no.4
• /
• pp.273-282
• /
• 2002

Al-pillared montmorillonite was synthesized from Na-saturated montmorillonite which was prepared by ionic substitution from Ca-montmorillonite of the Jabut mine, Gyeongiu City d(001), surface areas, and dehydration and ionic substitution properties have been compared for both Ca-montmorillonite and Al-pillared montmorillonite. d(001) spacings of Ca-montmorillonite and Al-pillared montmorillonite were 15.1 $\AA$ and $18.3\AA$, respectively. Dehydration took place before $350 ^{\circ}C$ in Ca-montmorillonite, whereas linealy up to $550^{\circ}C$ in Al-pillared montmorillonite. BET surface areas are 5～6 times larger in Al-pillared montmorillonite ($192 \m^2$/g) than Camontmorillonite. Ca-montmorilonite shows high selectivity for $Na^{＋}$ /, whereas Al-pillared montmorillonite for $Ca^{2＋}$ . The former shows decreasing d(001) spacing with increasing substitution of $Na^{＋}$ and irregular interstratified structure at high substitution of $Ca^{2＋}$ /, whereas the latter shows linear decreasing pattern in d(001) spacing with increasing $Ca^{ 2+}$.

• Journal of the Mineralogical Society of Korea
• /
• v.15 no.4
• /
• pp.315-327
• /
• 2002

Al-pillared clay was synthesized by constructing pillars of aluminum oxides at the interlayer of montmorillonite in bentonite. XRD, DTA and chemical analyses of Al-pillared clay were performed to examine mineralogical properties. Batch adsorption experiments were also conducted to determine the adsorption properties of this synthesized clay for phosphate ions. XRD analyses showed that the interlayer space of Al-pillared clay expanded to 18.03 $\AA$ at room temperature and shifted to $17 \AA$ after heating to $550^{\circ}C$. A small change in interlayer space after heating indicates high thermal stability. The interlayer expansion by glycerol was also very small. From DTA analyses, pillared clay showed the characteristic endothermic peaks at 270 and $420^{\circ}C$ , which might be caused by dehydration in framework of pillars between interlayers. Adsorption experiment revealed that Al-pillared clay had an excellent adsorption capacity to the phosphate ions, whereas montmorillonite had very low adsorption capacity to phosphate ions. In phosphate solution concentration up to 300 mg/L, 2 g of pillared clay could uptake almost 100% of phosphate ions from 20 mL of solution. After heat treatment of the phosphate adsorbed pillared clay at 50$0^{\circ}C$ to remove phosphate, the calcined pillared clay could adsorb phosphate ions with a little decreased adsorption efficiency. This fact indicates that Al-pillared clay can be recycled for the adsorption of phosphate ions.

• Journal of Korean Society on Water Environment
• /
• v.34 no.6
• /
• pp.621-631
• /
• 2018

In this study, catalyst was made through incipient wetness method using palladium (Pd) as noble metal, indium (In) as secondary metal, and montmorillonite (MK10) and Al pillared montmorillonite (Al-MK10) as supporters. The nitrate reduction rate of the catalysts was measured by batch experiments where H2 gas was used as reducing agent and formic acid as pH controller. Transmission electron microscopy (TEM) equipped with energy dispersive spectroscopy (EDS) and X-ray photoelectron spectroscopy (XPS) were all used to determine the elemental distribution of Pd, In, Al, and Si on catalysts. It was observed that Al pillaring increased the Al/Si elemental composition ratio and point of zero charge of MK10, but decreased its BET specific surface area and pore volume. The nitrate reduction rate of Al-MK10 Pd/In was 2.0 ~ 2.5 times higher than that of MK10 Pd/In using artificial groundwater (GW) in ambient temperature and pressure. Nitrate reduction rates in GW were 1.2 ~ 1.7 times lower than those in distilled deionized water (DDW). Nitrate reduction rates in acidic conditions were higher than those in neutral condition in both GW and DDW. The amount of produced NH3-N over degraded NO3- at acid conditions was lower than that of neutral condition. Even though the leaching of Pd after reaction was measured in DDW it was not detected when both Al-MK10 Pd/In and MK10 Pd/In were used in GW. The modification of montmorillonite as a supporter significantly increased the reductive catalytic activities of nitrates. However, the ratio of producing ammonia by-products to degraded nitrates in ambient temperature and pressure was similar.