• Magazine of the Korean Society of Agricultural Engineers
• /
• v.57 no.4
• /
• pp.16-24
• /
• 2015

Desalination technology is a process to remove salt from water. There are three classified In accordance with the concentration of salt The concentration of sea water 15,000~50,000mg/l, brackish water 1,500~15,000mg/l, desalination less than 500mg/l.. In general, salt to remove for using a pre-treatment UF filter, but this study is new pre-treatment technology RO Membrane process technology Suspended particulate matter is said most were treated at the pre-treatment equipment, wheat affluent particulate material was removed from the MF filter. Influent SS 16.2mg /l The treatment was effective in treatment 0.05mg /l of 99% is removed. COD is reduced to 60% in the pre-treatment device, after treatment was reduced to 30% RO membrane. Influent COD 10.2mg/l treatment was removed 1.9mg/l. The removal rate is 81.9%. Desalination removes the ionic substances in the RO Membrane. Influent EC $978.8{\mu}s/cm$ and treatment showed a result of $18.7{\mu}s/cm$.

• Journal of Drive and Control
• /
• v.17 no.4
• /
• pp.1-7
• /
• 2020

In orchard or crop-growing environments, pesticides are sprayed using various nozzles to prevent pests and improve productivity. Nozzles currently in use are restricted for use in multi-purpose environments, thus, it is necessary to develop new nozzles. In this study, new two-phase nozzles are proposed to improve the performance of the nozzle (flow rate, spray angle, spray particle size). The performance of the two-phase nozzles are predicted through the CFD analysis and the performance of the nozzles is compared with the experiment. The experimental results showed that the proposed two-phase nozzles are available at relatively low operating pressure condition and are capable of extensive spray particle size control. Thus, the proposed nozzles are expected to be available in various orchard environments.

• Proceedings of the Korean Society for Bio-Environment Control Conference
• /
• 1996.05a
• /
• pp.63-73
• /
• 1996

The importance of plant factory which blend agriculture and manufacture has been discussed widely. This company has researched hydroponics technique for cultivation which has been mainly developed in the sites of Okinawa and Hyougo Prefecture. In 1987, we stopped the previous research there, and started a new one far plant factory at the Agricultural Research Center of Chiba Prefecture. In 1989, we built four experimental plant factories (120㎡) at Chiba Oil Factory Refinery in Ichihara-city, developing techniques of cultivation, equipment production and environmental control for cultivation system of tomato, strawberry and leaf vegetables. (omitted)

• Proceedings of the Korean Society for Bio-Environment Control Conference
• /
• 1997.11a
• /
• pp.20-26
• /
• 1997

The design or analysis of beehouse inside temperature environment based on steady heat transfer theory causes much deviation and theoretically it is impossible to control the inside temperature lower than the outside temperature under the condition that the bee produces heat and no cooling equipment is installed. But in practical use of beehouse, the inside temperature is somehow lower than the outside temperature because of the heat inertia of concrete floor. (omitted)

• Agricultural and Biosystems Engineering
• /
• v.7 no.1
• /
• pp.1-7
• /
• 2006

A need exists to monitor and control the localized high temperatures often experienced in solar grain dryers, which result in grain cracking, reduced germination and loss of cooking quality. A verified finite element model would be a useful to monitor and control the drying process. This study examined the feasibility of the finite element method (FEM) to predict temperature distribution in solar grain dryers. To achieve this, an indirect solar grain dryer system was developed. It consisted of a solar collector, plenum and drying chambers, and an electric fan. The system was used to acquire the necessary input and output data for the finite element model. The input data comprised ambient and plenum chamber temperatures, prevailing wind velocities, thermal conductivities of air, grain and dryer wall, and node locations in the xy-plane. The outputs were temperature at the different nodes, and these were compared with measured values. The ${\pm}5%$ residual error interval employed in the analysis yielded an overall prediction performance level of 83.3% for temperature distribution in the dryer. Satisfactory prediction levels were also attained for the lateral (61.5-96.2%) and vertical (73.1-92.3%) directions of grain drying. These results demonstrate that it is feasible to use a two-dimensional (2-D) finite element model to predict temperature distribution in a grain solar dryer. Consequently, the method offers considerable advantage over experimental approaches as it reduces time requirements and the need for expensive measuring equipment, and it also yields relatively accurate results.

• The Korean Journal of Pesticide Science
• /
• v.17 no.1
• /
• pp.60-64
• /
• 2013

This study was performed in order to assess the risk of pesticide operator in korean rice paddy. The amount of exposure was calculated based on the informations of 48 kind of items that are used the form of a spraying in korean rice paddy. The risks of these pesticides were assessed to compare the exposure dosage with AOEL (acceptable operator exposure level) which was released form developed countries. When the operator spraying pesticides using motor sprayer, 17 items showed the risk for operator if the operator have not worn the personal protective equipment (PPE), and 6 items showed the risk for operator if the operator have worn the PPE. These result were indicated that the risk of pesticide operator was very high in korean rice paddy.

• Asian-Australasian Journal of Animal Sciences
• /
• v.26 no.11
• /
• pp.1622-1629
• /
• 2013

The objective of this study was to develop a new method to separate phosvitin from egg yolk without using organic solvents. Phosvitin was extracted from yolk granules using 10% NaCl or 10% $(NH_4)_2SO_4$ (final concentration) and then treated with heat to precipitate the lipoproteins from the extracted solution. The optimal pH for the phosvitin extraction from yolk granules was determined, and the iron-binding ability of the extracted phosvitin (final product) was tested. Adding 10% $(NH_4)_2SO_4$ disrupted the granules, and the subsequent thermal treatment at $90^{\circ}C$ for 1 h precipitated low density and high density lipoproteins, which enabled separation of phosvitin by centrifugation. The phosvitin concentration in the extract was significantly higher when the pH of the solution was adjusted to pH ${\geq}9$. The purity and recovery rate of phosvitin at the end of the separation process were approximately 78% and 56%, respectively. The separated phosvitin was confirmed to have ferrous and ferric iron binding ability. The advantages of this new method compared with the traditional methods include no organic solvents and high-priced equipment are needed for the separation. Also, this method is more environment and consumer friendly than that of the traditional methods.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.47 no.5
• /
• pp.356-360
• /
• 2002

The seedlings of yacon (Polymnia sonchifolia Poeppig ＆ Endlicher), which were cuttings, plug seedling (PS), crown bud before sprouting (CBBS), crown bud after sprouting (CBAS), and divided seedling after budding (DSAB) were planted at 70$\times$50 cm planting distance on ridge; that was interow spacingintrarow spacing, and about 28,500$\pm$71 plants/ha. CBBS didn't need work and equipment to raise seedlings. PS and DSAB grew taller to 140.5 and 143.3cm, respectively, than others at 150 days after planting. In the changes of plant height, PS and DSAB showed taller than others during growth period, cuttings, CBBS, and CBAS grew rapidly in middle growth stage. Excepting main stem and petiole length, other characters were significant for seedling. Fresh weights were different among seedlings. Even though the yield of plants grown from CBAS and CBBS were lower with 34.7 and 36.4 ton/ha, respectively, than 3.6 ton/ha of DSAB; its yield index were over 95%, hence, those of plants grown from cutting and PS were lower with 73 and 87%, respectively. The ratio of tuberous roots over 200g to total tuberous roots per plant was the highest from DSAB. Most of tuberous roots were under 200g per tuberous root from cuttings. CBBS, CBAS, and DSAB are suitable to use seedlings for high yield of yacono. Yacon plant by DSAB much produced tuberous root of over 200g.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.50 no.3
• /
• pp.31-41
• /
• 2008

There are many agricultural facilities (46.7%) that have been over 30 years in the Republic of Korea (the ratio of reservoirs built before 1945 is 53%, from 1946 to 1971 is 35%). In the case of reservoirs which do most important functions among these facilities, only 3,000 reservoirs are managed by Korea Rural Community & Agriculture Corporation (KRC) and the other 15,000 reservoirs are managed by local authorities (City and Gun). But, 15,000 reservoirs included in City. Gun have been built in more wide area than KRC and the reservoir management system has not been operated well because of shortage of budget and manpower of the local authorities. Particularly, the abnormal weather happened during every summer season recently has ruined a lot of rural community facilities. So flood control function have been more important than irrigation function in agricultural reservoir system and it may be required to introduce new safe, management and maintenance techniques in City Gun reservoirs. So we investigated landscapes and deteriorations of agricultural reservoirs managed by local small governments for revealing not only present usage but also future value. Survey shows that there are no structural managements except typical hydrological reportings and the deterioration of small darn is very serious. There are needs for more systematic management system and equipment methods. Therefore, this study may suggest that reservoir (that takes charge of the greatest deal of weight in all agricultural facilities) must be considered as new concept of the usage and the unification. On the other hand, reservoir must be also developed as amenity resources, natural circumstances and district values.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.32 no.11
• /
• pp.1792-1801
• /
• 2008

This study was to develope the pesticide-proof clothes(PPC) for fruit-grower which has been well known over applied agricultural chemicals. The ergonomic evaluation of PPC were tested in two ways. Male adults volunteered the tests to evaluate the safety to pesticide in the field and the thermal comforts in the climate-chamber($30^{\circ}C$, 60%R.H.). PPC were made of 4 different fabrics. Two of them were on the market(coated non-woven and coated nylon). Others were water-repellent treatment and coated waterproof film by developed polyester. The field study was conducted for farmers growing apples to evaluate pesticide exposure. In this experiment, we collected data with patch test on the head, chest, back, right upperarm, right forearm, left thigh and left calf. From the results, the developed PPC showed the more excellent comfort than an existing PPC with nylon coated polyurethane. But the developed PPC of water-repellent fabric was penetrated into the PPC. Therefore, we designed the functional pesticide-proof clothes of 2 different developed polyester fabrics(water-repellent treatment in chest, abdomen, the lower of back, waist, and calf; coated waterproof film in head, shoulder, the upper of back, the crotch, hip, upper arm and thigh).