• 대한의용생체공학회:의공학회지
• /
• 제30권1호
• /
• pp.23-33
• /
• 2009

It can be used easily to reduce rehabilitation and treatment time if diagnostic and therapeutic devices are attached to cloth or body. Therefore we developed neuromuscular wearable ultra-miniature lighting modules which can improve the neuromuscular function and verified its clinical effectiveness. The system is based on the ultra-miniature lighting treatment module and there are two types of systems. One of them is designed as an attached type and the other type is combined with clothing. The wearable ultra-miniature lighting module is composed of controller (battery, MCU, bidirectional transmitter and receiver), cable, treatment medium generating device and other peripheral devices. To verify the clinical effectiveness of this device, we observed the difference of the strength of a muscle before and after 650nm and 25mW laser irradiation on the reflex point for 1 to 4 seconds. Among 48 patients having the degenerative osteoarthritis, the muscle strength before and after irradiation of laser was $21.8{\pm}7.99$ and $27.3{\pm}8.43$. According to the result, the muscle strength after treatment was significantly increased (p<0.01). To whom having difficulty in visiting to OPD(Out-Patient Department), doctors medically examine the patients and find the therapeutic point, attachment of this wearable ultra-miniature lighting module can function as self treatment (treating instrument) and treatment assist at home. If doctor can remotely control the patient and take part in treatment, the therapeutic device could contribute to prevention and care device.

• 한국소음진동공학회논문집
• /
• 제23권4호
• /
• pp.332-337
• /
• 2013

This paper presents a subsequent research work on the roller design of IRB(isolation roller bearing) seismic isolation device presented in Part 1 by focusing on heat treatment. The hardness and friction factor are very important factors of material and after-treatment process selection. Normally, roller bearing consists of roller and retainer. The roller gets high pressure constantly, while the retainer gets tensile and compressive stress. Therefore, sensitive material selection and heat treatment of each part is quite important. In this experimental evaluation, carbon steel, chrome special steel and others are employed and their characteristics after heat treatment are identified. Each material is prepared by refining high frequency heat treatment. The friction factor and static load capacity of manufactured material are experimentally identified and destructive test of material is processed. Optimal material and heat treatment conditions for IRB roller bearing are determined based on experiment results.

• 한국멀티미디어학회논문지
• /
• 제21권12호
• /
• pp.1379-1386
• /
• 2018

In this paper, we proposed eyeglass type periorbital wrinkle treatment device for reducing and improving periorbital wrinkles using near infrared LED of 850nm wavelength and galvanic current. The proposed periorbital wrinkle treatment device is equipped with a control system based on F-PCB. It consists of eight near-infrared LEDs and four indicator LEDs for treatment of right and left periorbital wrinkles. The eyeglass frame is coated with conductive material, so galvanic current can flow to the skin of periorbital wrinkle contacted to it. One male adult in the mid-40s was allowed to use the device for 10 minutes every day for 4 weeks. After 4 weeks, image analysis using optical equipment for measuring wrinkles indicated that wrinkle indexes were reduced.

• Journal of Chest Surgery
• /
• 제26권11호
• /
• pp.890-893
• /
• 1993

The first successful percutaneous transcatheter occlusion technique for patent ductus arteriosus achived by Rashkind in 1977.Transcatheter occlusion with the Rashikind double umbrella device is now widely accepted as treatment for patent ductus arterisus. The reported complications include embolization of the device, psudocoarctation left pulmonary artery stenosis, residual shunts, and mechanical hemolysis. We report two cases of severe hemolysis after occlusion of PDA with Rashkind occluder.

• The Journal of Korean Physical Therapy
• /
• 제23권5호
• /
• pp.29-34
• /
• 2011

Purpose: The purpose of this study is to evaluate the short term effects of the traction and decompression device, which is a newly developed domestic medical device, on pain and functional activity in patients with chronic low back pain with or without radicular pain. Methods: Forty patients with chronic low back pain were included and allocated to decompression (n=20) and traction groups (n=20). They received decompression or traction therapy for 20 minutes a day, 3 days per week for two weeks. For evaluating pain and functional activity, a visual analogue scale (VAS) for low back pain and the Oswestry back pain disability index (ODI) were obtained on pre-treatment, and at 6, 12 and 15 days after treatment. Patients'satisfaction levels were measured 15 days after treatment. Results: VAS was significantly decreased at 12 days and 15 days post-treatment compared to pre-treatment in both groups (p<0.05). ODI was significantly decreased at 12 days and 15 days post-treatment compared to pre-treatment in the decompression group (p<0.05). However, there was no significant difference between the two groups in the VAS and ODI scales (p>0.05). Patients' satisfaction levels were significantly higher in the decompression group than in the traction group (p<0.05). Conclusion: These findings suggest that decompression therapy might be effective for increasing functional activity in patients with low back pain and could provide patients with higher satisfaction than traction therapy. This study provided validity data for the therapeutic effects of the decompression device in patients with low back pain and it will be useful for medical cost development and patient education of this device.

• 웰빙융합연구
• /
• 제5권4호
• /
• pp.51-56
• /
• 2022

Purpose: By applying an ultrasonic mechanical device to the liquid fertilizer storage in the pig dropping treatment plant, the initial odor of the odor source is reduced, and the air dilution drainage of the complex odor is fundamentally recognized to facilitate odor treatment on the mechanical and chemical biological treatment devices at the rear. Research design, data and methodology: The odor concentration on the site boundary was measured to confirm the state of reduction. In order to prevent the spread of odor from the collection of the pig dropping treatment plant, it was measured by installing an ultrasonic generator inside the installation wall after installing the sealing wall. Results: The average value of the March and April measurement data remained close to neutral at 8.2 after 8.6 treatment before pH treatment, decreased 97.3% from 462 mg/L before SS treatment to 10.5 mg/L after treatment, and the composite odor was reduced by 85% from 20 to 3 before treatment. It was confirmed that ammonia (NH3) was reduced by 99% from 5.8 ppm to 0.09 ppm, and general bacteria were also reduced by 99% from 3,200 CFU/mL to 57 CFU/mL Conclusion: Applying the ultrasonic air ejector hybrid system and zigzag air complex module development product to resource circulation centers or sewage treatment facilities is thought to reduce inconvenience to residents due to odors caused.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• 제31권1호
• /
• pp.53-60
• /
• 2009

Maxillary deficiency, anterior cross bite, constriction of maxillary arch, malaligned teeth are frequently observed in patients with cleft lip and palate. Surgery and orthodontics, combined intervention are needed to correct maxillary deficiency. Distraction osteogenesis that currently used has many advantages like less relapse tendency, more advancement of maxilla, capable in growing patients. In case 1, 18 years old girl with BCLP had severe midfacial deficiency and multiple missing of teeth. LeFort I osteotomy, followed by maxillary distraction osteogenesis utilizing rigid external distraction device(RED) system, was performed. After a 6-day latency period, distraction proceeded at a rate of 1mm per day (at 1st week, 1.5mm/day). Total advancement was 19mm. The RED device left in place for the additional 4 weeks for consolidation. After the RED device was removed, face mask was applied with elastic traction for 5 weeks. After achieving acceptable facial appearance and occlusion, orthodontic appliance was removed. The results after 4 years follow-up was sustained pretty well without aggravation of velopharyngeal function. In case 2, 22 years old man with UCLP had severe midfacial deficiency and palatally erupted upper 2nd premolars due to arch length discrepancy, but the anterior segment of maxillary did not show constriction and crowding. patient had no arch width discrepancy, crowding was concentrated on premolar region. Segmental LeFort I osteotomy was performed. After a 6 - day latency period, using internal distraction device, distraction proceeded at a 0.5mm per day(at 1st week, 0.75 - 1 mm/day). Total advancement was 15mm. After internal distraction device was removed, face mask was applied with elastic traction for 4 weeks. After surgical-orthodontic treatment, facial appearance and occlusion was improved pretty good, and after 46 months follow-up the result was retained well.

• 한국정보전자통신기술학회논문지
• /
• 제16권3호
• /
• pp.152-160
• /
• 2023

최근 코로나19 사태 이후에 건강관리에 신경을 쓰는 사람이 늘어나고 있으며, 많은 사람들이 취미활동으로 스포츠나 운동 후 근육통의 발생으로 생활에 불편함을 느끼고 운동을 쉬는 경우가 많다. 오랜만에 운동하거나, 무리해서 운동하고 나면 운동 후 24~48시간 이내에 온몸에 알이 배긴 것 같은 통증이 나타난다. 이러한 통증을 '지연성 근육통(DOMS(Delayed onset muscle soreness))'이라고 한다. 본 연구에서는 심부열을 발생시키는 고주파 통증치료기를 사용하여서 지연성 근육통의 통증을 완화에 효과가 있는지 유효성 검증을 진행하였다. 평상시, 통증치료 전, 통증치료 후의 근전도를 측정하고 분석을 통해 RMS 값을 구하고 SPSS 프로그램을 이용해서 통계분석을 진행하였고, 통계적으로 유의성이 있는 것으로 판단하였다. 그리고 평상시와 통증치료 후의 RMS 값의 통계분석을 진행하여서 유의성이 없는 것을 확인하여서 통증치료 후 얼마만큼 평상시로 회복했는지 확인하였다. 또한, 통증은 같은 통증의 크기라도 사람마다 느끼는 기준이 다르기 때문에 통증의 크기에 대한 NRS 설문지를 진행하여서 피험자들이 느끼는 통증의 크기를 SPSS 프로그램을 이용해서 통계분석을 진행하였고, 통계적으로 유의성이 있는 것으로 판단하였다. 그래서 본 연구 결과 고주파 통증치료기가 통증부위의 심부열을 발생시켜 온도를 상승시키고, 동맥 및 모세혈관을 확장시켜 혈류량을 증가시켜서 혈액순환 및 신진대사가 증가되면서 지연성 근육통의 통증이 완화되는 효과가 있는 것으로 판단된다.

• 대한치과교정학회지
• /
• 제49권4호
• /
• pp.265-276
• /
• 2019

Patients with obstructive sleep apnea (OSA) whose phenotype belongs to a craniofacial vulnerability are referred from sleep doctors to orthodontists. In adults, for osseo-pharyngeal reconstruction (OPR) treatment, permanent maxillomandibular advancement (MMA) surgery and use of a temporary mandibular advancement device (MAD) are applied. This case report demonstrates successful treatment of OSA through application of phased MAD and MMA in a 16-year-old male with craniofacial deformity and residual growth potential. This patient showed skeletal and dentoalveolar changes after 7-year MAD use throughout post-adolescence, which affected the design and timing of subsequent MMA surgery, as well as post-surgical orthodontic strategy. This case report suggests that OPR treatment can be useful for treatment of OSA in post-adolescent patients, from an orthodontic point of view, in close collaboration with sleep doctors for interdisciplinary diagnosis and treatment.

• 동력기계공학회지
• /
• 제18권4호
• /
• pp.52-59
• /
• 2014

The purpose of this study is to evaluate the performance of after-treatment equipment and thermal storage devices for a heat recovery and combustor-type $CO_2$ generator fuelled a kerosene. To reduce the levels of harmful exhaust gases produced by a $CO_2$ generator, a catalyzed particulate filter(CPF) has been selected as an after-treatment device, by considering back pressure and exhaust gas temperature. The CO conversions of the catalyzed SiC filter(full plugging) were 92%, and the concentration of PM(particulate matter) was near ambient. A thermal recovery device was used to recover 13% of the heat energy from the exhaust gas through heat exchangers installed on the exhaust line of the $CO_2$ generator. 69% of the moisture within the exhaust gases was removed by condensing water, in order to minimize excessive humidity within the greenhouse.