• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.3
• /
• pp.225-231
• /
• 2017

This study was carried out for the production of aerial work machinery in high place in the orchard. In the case of orchards, there are many unpaved roads and sloping grounds to solve the problem of overturning or safety problems when working in a orchard. For more stable operation, an automatic leveling system was designed. During the structural analysis, the horizontal sensor was installed in addition to the standard that we wanted. Based on the INVENTOR, the structural analysis through 3D modeling showed that the maximum tilt of the worker was 116.49Mpa on the left and 118.26Mpa on the right.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.3
• /
• pp.232-241
• /
• 2017

This study was carried out to design the stable elements of the aerial work machinery used in the orchard and farmland which had been conducted in the previous research. A hydraulic lifting lift has been developed to work safely at irregular and inclined locations using an auto leveling system and a horizontal sensor. The development of a centralized controller including remote control has been carried out in order to control the elevated work platform. Through the developed module, we carried out on-site test run to check whether the control is stable in the elevation workbench. Through the structural analysis of the elevation workbench, the maximum load and the equal load amount that the worker can safely work on the workbench are presented.

• Transactions of the Korean hydrogen and new energy society
• /
• v.22 no.6
• /
• pp.819-826
• /
• 2011

The proton exchange membrane fuel cell (PEMFC) is regarded as the most promising alternative power sources for unmanned aerial vehicle (UAV) due to its high energy density and silent operation. Since there are many load changes during UAV flight, thermal management is one of the important factor for the performance of PEMFC. In order to reduce the UAV weight for the stable operation of UAV, thermal management system (TMS) studied in this work does not use the fan but use the air flowing into UAV by UAV flight. In order to develop the passive type heat exchanger (HEX) for 1kW PEMFC, four types of HEXs are fabricated and their cooling performances are compared. The parametric study on the cooling performance of HEXs has performed with the variation of operating parameters such as mass flow rates and inlet temperature of air and coolant. Type 4 has the best performance in every case. This study can be helpful to achieve the optimal design of HEX for PEMFC powered UAV.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.4
• /
• pp.350-357
• /
• 2017

This study was conducted as a post - study on the development of a centralized controller and a hydraulic lift system including structural analysis and remote control for the development of a vertically elevated car. The safety review was carried out through the structural modification of the elevator lift which was developed during the previous research. 3D modeling was performed with Solidworks, and a model of finite element was created through Hypermesh S / W. In addition, the loading environment of the work vehicle for the evaluation is a condition in which the loading amount is 250 kg per position (total, upper, upper, lower, and lower) on the work table, ), The structural analysis was carried out under the condition that the load was 600 kg, and safety was examined in various aspects. As a result, when the allowable load of 250 kg and the excess load of 600 kg are excluded (except Case-11), the stress level is below the yield strength. In the case of Case-11, there is a region exceeding the yield strength at the center support portion of the safety bar at the upper end even after excluding the component which generates the maximum stress, but it does not affect the safety aspect of the whole structure Respectively. Looking at the deflection results, it can be seen that in all cases the maximum deflection occurs in the same table, and the tendency of sagging in both 250 kg and 600 kg is the same.