• Proceedings of the KSR Conference
• /
• 2004.06a
• /
• pp.171-176
• /
• 2004

Electro chemical corrosion tests were conducted on two structural steels, SS400 and SM490A, in various solutions with different pH values, All materials showed typical active corrosion behaviors in the solutions, and corrosion potential and current density were measured from the slopes obtained from the Tafel curves using linear polarization method. Corrosion potential increased in the acidic region and then decreased depending on the pH values of the solutions. All materials showed the fast corrosion rate in artificial acid rain(pH=4.7), but the slower corrosion rate was observed in NaOH solution(pH=12.0) for SS400 and in distilled water(pH=7.0) for SM490A, respectively, which is thought to come from the difference in chemical composition of two alloys. Generally homogeneous corrosion occurred in acid rain condition, and almost no corrosion was observed in distilled water in both alloys. NaOH solution produced more corrosion than distilled water, and more corrosion had progressed in SS400 than in SM490A in $3.5\%$ NaCl solution.

• Journal of Environmental Impact Assessment
• /
• v.8 no.1
• /
• pp.29-40
• /
• 1999

This study focuses on one of typical energy-intensive industries, the cement industry. The purpose of the study is to propose $SO_2$ emission reduction measures in the cement industry. This study partially employed and modified AIM(Asia-Pacific Integrated Model) developed by Japan National Environmental Research Institute to develop AIM/KOREA SULFUR model for simulation. In the study, a base scenario, and mitigation scenarios(a use of low-sulfur contain fuel, fuel conversion to cleaner energy, an induction of desulfurization systems, and energy saving) were employed. The results of the simulation are summarized below: The sulphur dioxide emission from the cement industry in 1992 was estimated to be 106,000 metric tons; however, according to base scenario, sulphur dioxide emission is expected to be increased to 219,000 metric tons, which is 2.1 times greater than that in 1992 by year 2020. To alleviate such increasement, simulation results under various scenarios proved that some degrees of reduction may be possible by an induction of desulfulization systems although there may be numerous ways to interpretate the simulation results.

• Corrosion Science and Technology
• /
• v.3 no.6
• /
• pp.251-256
• /
• 2004

Exposure of zinc samples in simulated acid rain solution (SARS) was investigated under a periodic wet-dry conditions using an AC impedance technique. The periodic wet and dry exposure consisted of the immersion of zinc samples in SARS for one hour followed by exposure to 7 hours drying at 60% RH. Phases of the corrosion products were indentified by X-ray diffraction (XRD). The influence of relative humdiity (RH), temperature, and surface inclination on the atmospheric corrosion of zinc is described. The reciprocal of polarization resistance (1/Rp) decreases rapidly during the initial stages then slowly and eventually attains a steady state as exposure time progresses. The average of reciprocal of polarization resistance per cycle, (ARPR) was calculated and found to decrease as number of exposure cycle increases. An increase of temperature enhances the corrsion rate of zinc. The values of ARPR, of a sample inclined at 30 o are lower than those for a sample oriented horizontally. The experiment result shows a pronounced dependence of reciprocal of polarization resistance on RH. Exposure in the presence of carbonate anions gives rise to more protective corrosion products than in nitrate anion solution. The corrosion mechanism during the initial stages of atmospheric zinc corrosion under wet-dry cyclic conditions is suggested.

• Journal of Environmental Health Sciences
• /
• v.20 no.4
• /
• pp.72-79
• /
• 1994

This study was performed to improve many problems of leaching test of industrial waste sludge analysis. We analyze sludges by variation of leachant, pH and leaching time.The results were as follows: 1. As leaching at pH 5.8 by our leaching test without control of pH during leaching, the leaching rates were very low as below 1%. 2. As leaching at pH 5.8 continuously by hydrochloric acid every 2 hour, the leaching rates were higher than before 1. 3. As leaching at pH 5.0 continuously by acetic acid every 2 hour, the leaching rates were higher than 1, 2. 4. The variations of leaching rate by leaching time were smaller increase after 10 hours than before. 5. It will be recommendable that the pH of leachant maintain constantly during leaching as level of acid rain, and the acetic acid is more effective than hydrochloric acid as leachant.

• Journal of Korean Society of Forest Science
• /
• v.86 no.3
• /
• pp.342-351
• /
• 1997

The objective of this study was to compare acid-neutralizing and buffering capacity of four tree species against soil acidification by acid rain. About 30-year-old forests composed of Pinus rigida, Alnus hirsuta, Quercus mongolica, and Liriodendron tulipifera in a provincial experimental forest located 15km east from Banwol Industrial Complex in Kyonggido were used in this study. Incident precipitation, throughfall and stemflow, and soil samples were collected from May to September, 1996 to analyze their pH and canon concentrations. Internal leaf pH, external acid neutralizing capacity(ENC), and buffering capacity index(BCI) of leaves were also determined. The incident precipitation showed an average pH of 4.56, with the percentage of acid rain incidents being 74%. The average soil pH of the study area was 4.15. The pH of throughfall and stemflow in all four species was higher than that of precipitation except that of the stemflow of Pinus rigida which showed a pH of 3.73. The throughfall of Liriodendron tulipifera showed the highest pH of 5.38. The pH of throughfall and stemflow showed a positive correlation and no correlation, respectively, with precipitations. The most abundant cation in precipitation was Ca. The canon concentraions in throughfall and stemflow decreased in the following order of K, Na, Ca, and Mg. Cation concentrations in stemflow were highest in Lirioendron tulipifera and lowest in Pines rigida. Nutrient leaching from above ground increased with decreasing pH of precipitation. The pH of stemflow showed a positive correlation with ENC and BCI. The highest values in ENC, BCI, soil pH, and soil cation concentrations were observed in Liriodendron tulipifera, while the lowest values were obtained in Pinus rigida, It was concluded that Liriodendron tulipifera had highest neutralizing capacity against acid rain, while Pinus rigida had the lowest capacity and even promoted acidification of soil.

• The Korean Journal of Ecology
• /
• v.16 no.4
• /
• pp.409-416
• /
• 1993

After spraying simulated sulphuric acid rain (SSAR) to the leaves of Glycine max, Quercus aliena var. pellucida and Pinus rigida, the leachates were consecutively collected and quantitatively determined for the concentration of K and Ca. The amount of the leached ion decreased with subsequent acid treatment for all plants. But as the pH of SSAR decreased, the amount of the leached ion increased. The cumulative quantities of K leached from each species were 1.04 to 1.46 times higher at pH 4.0, 1.09 to 1.58 times higher at pH 3.5 and 1.24 to 2.03 times higher at pH 3.0 compared with pH 5. 6 treatments. The cumulative quantities of Ca leached from each species were 1.23 to 1.47 times higher at pH 4.0, 1.50 to 1.92 times higher at pH 3.5, and 2.45 to 3.30 times higher at pH 3.0 compared with pH 5.6 treatments. The Ca /K ratio in 1000 ml leachate was 1.10 to 2.91 for Q. aliena var. pellucida and 1.68 to 2.98 for P. rigida, but 0.66 to 0.91 for G, max. The Ca /K ratio in 1000 rnl leachate increased for all three species, as the pH of SSAR decreased. Foliage analysis after acid rain treatment showed leaching effect at pH 3.0.

• Journal of Environmental Science International
• /
• v.5 no.5
• /
• pp.663-676
• /
• 1996

The analyzed results of observed precipitation and its pH in Kwangiu for 262 days from fan. 1, 1991 to Dec. 31, 1995 are as follows. The annual mean pH was 5.7, and the monthly mean pH values of January-May and November were less than 5.6 in Kwangiu. The ratio of acid rain for these periods was about 48.1%, almost half that of the total observed days. In March, the pH was 5.4 and the ratio of acid precipitation was 69%, an especially serious situation. In the spring, the pH value was 5.5, thus weakly acidic. The pH of precipitation tended to decrease with greater precipitation. The relation between persistent time and pH of precipitation is variable, but if the persistent time is long, the pH is constant and low. It is fortunate that there is an increasing trend of pH in interannual variation, but it is thought important that the amplitude of variation of pH in 1995 was high and the pH value was 4.1 in October and November. Because heavy and persistent precipitation effects the accumulation of acidity, more concern about acid rain is needed.

• Journal of Korean Society for Atmospheric Environment
• /
• v.12 no.2
• /
• pp.179-187
• /
• 1996

Sampling of precipitation occurred at Woongchon in Choongnam from the period between May 1994 and April 1995 was made, and analysis on the data was carried out on observed pH values of the precipitations. It was found that weighted mean pH values were .sim. 4.8 and that acid rain occurred at the site of the Yellow Sea's coastal area. The results agree well with the earlier observations made at other sites of a background monitoring network. The annual values observed at the background monitoring sites were too low in comparison with the mean pH values (5.3 .sim. 5.9) obtained from urban stations of the Ministry of Environment. It was observed that values of pH in rain water often changed with time during the event of precipitation, and the low values usually depended on an airflow and a cyclone that originated in the source region.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.394-398
• /
• 2004

This study was carried out to plan the prevention of the generation and discharge of acid mine drainage (AMD). Hydraulic characteristics were tested with the disk tension infiltrometer around the waste rock dump of the Imgi abandoned pyrophyllite mine in Busan, Korea. Because the waste rock dump of the Imgi mine have very low infiltration rate, most of rain was expected flowing into adjoined stream through the slope or plane as surface flow rather then throughflow or ground water. But slopes of the waste rock dump have many 'V' type erosion gullies and consist multi-layers. These gullies and multi-layers have coarse clastic particle layer which have very large hydraulic conductivity. So through these coarse clastic particle layers a large part of rain flow into ground. And also these layers could be played a function of aeration path, which induced oxidation of sulfide minerals and generation of AMD continuously.tinuously.

• Journal of the Mineralogical Society of Korea
• /
• v.28 no.2
• /
• pp.135-145
• /
• 2015

In order to predict the deterioration of stone monument due to acid fog, an artificial fog test using pH4.0 and pH5.6 was applied to the Gyeongju Namsan granite, decite and marble. After the test had weathered Gyeongju Namsan granite a larger weight reduction due to acid fog than fresh one. Decite has shown the most significant changes among the tested rocks with about 0.005 % of weight reduction. Decite and weathered granite will have considerable weight reduction due to acid rain than the acid fog, whereas the marble was expected to show a weight reduction regardless of the phase of water. The porosity and water absorption rate of weathered granite had significantly increased. This result means that the weathered rock is predicted to be more susceptible to acid fog than the fresh rock. The absorption rate of the marble after the test had shown approximately 50 % increase. The color of the samples had slightly changed towards yellow, such tendency was greater shown in weathered rocks. The marble reacted with acid fog had an increased whiteness. A large amount of cation in the samples is caused mainly by the dissociation of minerals through the reaction with acid fog.