• Cement Symposium
• /
• no.25
• /
• pp.36-40
• /
• 1997

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.42 no.2
• /
• pp.55-62
• /
• 2000

In order to make the reasonable irrigation plan in the unripended tidal reclaimed paddy fields, the estimation of irrigation water requirements by soil textures and water management methods for the normal growth of crops is very important . This study was carried out to determine leaching requirements before cultivating crops. For the purpose of this study, the physical and chemical properties of soil samples used in the desalinization experiments were analyzed, and change of salinity by supplying water and leaching water were investigated in the experimental field with lysimeters. As a result considering the soil textures, desalinization effects of good drainage soils(S1) were better than those of poor drainage soils (S2). In the changes of salinity of the soils with supplying water by water management methods, among the good grainage soils with culvert treatment(S1CW), salinity of S1CW3 with 1, 120mm and S1W4 with 1, 440mm supplying water were 2.6dS/m and 1.1dS/m respectively, and salinity of S1NW4 with 1.680mm among those non-culvert treatment (S1NW) was 3.0dS/m, less than critical salanity value 3.0dS/m. On the other hand, of the poor drainage soils with cultvert treatment , salinity of S2CW3 was ranged 9.4-6.0dS/m with supplied water, and that of non-culverted treatment S2NW as 12.3-8.4dS/m.

• Journal of the Korean Ceramic Society
• /
• v.30 no.1
• /
• pp.7-16
• /
• 1993

Effect of sulfate on the reactionof C3S formation in presence of clinker melt and its appearance in clinker were investigated, using (NH4)2SO4 and CaSO4 as sulfate sources. When (NH4)2SO4 and CaSO4 were added, both showed the similar results, 1.0wt% of sulfate could promoted the reaction of C3S formation, however for its content of more than 2.0wt%, the formation of C3S was prevented. Residual limit of sulfate to C3S formation is about 1.4wt%. Appearances of sulfate were C4A3l and CaSO4 in interstitial phase. For the addition of (NH4)2SO4 or CaSO4 of 20wt%~4.0wt%, C3S grains showed the hypertrophic growth. We might consider that, because sulfate reduced the surface tension and viscosity of the clinker melt, C3S crystals were precipitated below 140$0^{\circ}C$, and the crystlas of C3S were coalesced and linked in the same crystallographical direction with increasing temperature becuase of their rapid growth rate.

• Imaging Science in Dentistry
• /
• v.52 no.3
• /
• pp.289-294
• /
• 2022

Purpose: This study aimed to evaluate the diagnostic performance of panoramic images compared to cone-beam computed tomography (CBCT) imaging for maxillary third molar (M3)-associated external root resorption (ERR), and to identify the risk factors of ERR on panoramic images. Materials and Methods: The study population was composed of all patients who underwent panoramic imaging at Dankook University Dental Hospital from May to October 2019. In total, 397 cases of maxillary M3s in 247 patients(147 men and 100 women) were included. The diagnostic accuracy of ERR in panoramic images compared to CBCT images was evaluated using the chi-square test. To identify risk factors for ERR, dental records and panoramic findings were evaluated by logistic regression analysis. Results: The diagnostic accuracy of ERR on panoramic images was 0.79 compared to CBCT images (P<0.05). Superimposition of M3s onto second molars (M2) was associated with an approximately 33 times higher risk of ERR than separated M3s(P<0.05). Impacted M3s showed a 5 times higher risk of ERR than erupted M3s(P<0.05). Conclusion: ERR related to M3s is a common clinical condition, and superimposition of M3 onto M2 on panoramic images was the most important risk factor for ERR. It seemed that CBCT examinations for maxillary M3s might be indicated for ERR diagnosis especially if panoramic radiographs show superimposition of M3 onto M2. Impaction itself was also a risk factor, and it should be carefully examined.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.27 no.3
• /
• pp.467-476
• /
• 2017

In this paper, we analyze Generalized Feistel Network(GFN) Type I, Type II, Type III that round function use SP update function, secret S-box and $k{\times}k$ MDS matirx. In this case an attacker has no advantage about S-box. For each type of GFN, we analyze and restore secret S-box in 9, 6, 6 round using the basis of integral cryptanalysis with chosen plaintext attack. Also we restore secret S-box in 16 round of GFN Type I with chosen ciphertext attack. In conclusion, we need $2^{2m}$ data complexity and ${\frac{2^{3m}}{32k}},{\frac{2^{3m}}{24k}},{\frac{2^{3m}}{36k}}$ time complexity to restore m bit secret S-box in GFN Type I, Type II, Type III.

• Clean Technology
• /
• v.12 no.3
• /
• pp.165-170
• /
• 2006

When ammonia ($NH_3$) and hydrogen sulfide ($H_2S$) in binary mixture gases were supplied to a biofilter packed with biomedia made of polyurethane, PVA, and worm cast. No odor gases were detected on the outlet of the biofilter when $NH_3$ and $H_2S$ were separately supplied to the biofilter at space velocity(SV) of $50h^{-1}$ until inlet $NH_3$ concentration was increased up to 300 ppmv and inlet $H_2S$ to 428 ppmv. While, inlet $NH_3$ concentration maintained at 50 ppmv, inlet $H_2S$ concentration increased from 1 to 489 ppmv, and the removal efficiency of each gas was investigated. After that, $NH_3$ concentration increased step by step such as 80, 100, 200, 300, 400 and 500 ppmv. $H_2S$ concentration increased gradually when $NH_3$ concentration was set up at each condition. Under each condition, removal efficiency of $NH_3$ and $H_2S$ gas was investigated by analysing the gases sampled from the inlet and outlet of the biofilter. When binary gases were supplied to the biofilter and inlet $NH_3$ concentration was increased from 50 to 300 ppmv, elimination capacity of $NH_3$ increase linearly as inlet loading increased to $11.14g\;N{\cdot}m^{-3}{\cdot}h^{-1}$. However, as inlet $NH_3$ concentration increased over 300 ppmv, both removal efficiency and elimination capacity decreased while inlet loading increased. $H_2S$ removal efficiency was not affected seriously by the simultaneous supply of $NH_3$ when maximum inlet loading of $H_2S$ was under $40.27S{\cdot}m^{-3}{\cdot}h^{-1}$ and maximum inlet loading of $NH_3$ was under $15.25N{\cdot}m^{-3}{\cdot}h^{-1}$.

• Asian-Australasian Journal of Animal Sciences
• /
• v.14 no.3
• /
• pp.338-345
• /
• 2001

An experiment was conducted to determine the optimal inclusion ratio of spray dried plasma protein (SDPP) and dried porcine solubles (DPS) for maximizing growth and improving immunity in weaned pigs. One hundred-fifty male (barrow) pigs were allotted in a completely randomized block design. Treatments were as follows: 1) control (6% SDPP), 2) S6D6 (6% SDPP+6% DPS), 3) S6D3 (6% SDPP+3% DPS), 4) S3D6 (3% SDPP+6% DPS) and 5) S3D3 (3% SDPP+3% DPS). Each treatment has 6 replicates with 5 pigs per replicate. Average daily gain (ADG) and average daily feed intake (ADFI) were highest, but not significantly different when pigs were fed a diet contained 6% SDPP and DPS from d 0 to 7 after weaning. Pigs fed the S6D3 diet showed better weight gain and feed intake than other treatments, especially compared with pigs fed S3D6 diet (p<0.05) from d 8 to 21 after weaning. For the overall experimental period, pigs fed the S6D3 diet showed the best improvement in ADG and ADFI. The digestibilities of dry matter (DM) and crude protein (CP) were higher in pigs fed the S6D6 diet than other diets from d 0 to 7 after weaning. However, pigs fed S6D3 diet showed higher DM, CP and essential amino acids (except methionine and arginine) digestibilities than pigs fed other diets from d 8 to 21 after weaning, although there was no significant difference. From d 8 to 21 after weaning, threonine, valine, isoleucine and leucine digestibilites were higher in S6D6 group, and phenyalanine, histidine, lysine and arginine digestibility were higher in S6D3 group than other groups. The ratio of CD4 and CD8 positive lymphocytes during the overall experimental period was independent of the ratio of SDPP and DPS. However, CD4+:CD8+ ratio was numerically lowered in pigs fed diet the S6D3 diet. Therefore, the present study suggests that an optimal inclusion ratio for maximizing growth performance and maintaining low immune status is 6% of SDPP and 3% of DPS in weaned pigs.

• Journal of the Korean Ceramic Society
• /
• v.40 no.9
• /
• pp.859-866
• /
• 2003

When calcium sulfoaluminate-based expansive cement was hydrated, ettringite and monosulfate were mainly formed. The crack of hardened cement was prevented by compensating drying shrinkage due to formation of the above hydrates. In order to study the hydration properties of calcium sulfoaluminate-based expanding cement, 3CaOㆍ3Al$_2$O$_3$ㆍCaSO$_4$(C$_4$A$_3$S) was prepared by chemical synthesis, and then the hydration of $C_4$A$_3$S-Ca(OH)$_2$-CaSO$_4$.$2H_2O$-C$_3$A system_was characterized. Good $C_4$A$_3$S phase was prepared at $1300^{\circ}C$ by chemical synthesis, and the main hydration product of $C_4$A$_3$S-Ca(OH)$_2$-CaSO$_4$.2$H_2O$ system was ettringite. In the case of hydration $C_4$A$_3$S-Ca(OH)$_2$-CaSO$_4$ㆍ 2$H_2O$-C$_3$A system, ettringite was formed in the early period and it was transformed into monosulfate while consumed gypsum.

• Journal of Bio-Environment Control
• /
• v.15 no.3
• /
• pp.231-238
• /
• 2006

The physical properties of seven perlites different in particle size distribution were investigated to develop perlite bag culture in Korea. Particle sizes of 1.0-2.8mm and larger than 2.8 mm were rather evenly distributed in S-1 (1.2-5 mm), S-2 (0.15-5 mm) and S-5 (parat No.1). Larger particles were less in S-3 (1-3 mm), S-4 (Parat No.2), S-6 (OTAVI) and S-7 (Agroperl B-3). S-4, S-6 and S-7 contained lots of particles less than 1 mm in size. Total porosity was similar among substrates with the value of $59{\sim}62%$. Container capacity was between 35-40% regardless of substrates except in S-2 with 27.7%. Water content, which was about 60% at 0 kPa, was decreased sharply at 4.90 kPa regardless of substrates, which meant the easily available water was plenty in any kind of perlite tested. Substrates, S-1, S-2 and S-3 with different particle size distribution, were investigated to evaluate for perlite bag culture. Six tomatoes (Licopersicon esculentum Mill. cv. Rokkusanmaru) were planted in a perlite bag of 40 liters with the dimension of 120cm in length and 34cm in width. The amount of nutrient solution supplied and its drainage dependent on daily integrated radiation didn't show any regular trend during the growth. Roots in the bag were distributed evenly in S-1 and S-2 than in S-3. Plant grown in S-1 showed the highest total and marketable yield of 8,628 and 7,759 kg/10a, respectively. The number of small size fruits and malformed fruits were more in S-3. Consequently, S-1 with the particle size distribution of 1.2-5 mm is suggested as desirable substrate for perlite bag culture.

• Journal of the Korean Ceramic Society
• /
• v.38 no.8
• /
• pp.732-739
• /
• 2001

산업부산자원으로부터 유입되는 중금속이 시멘트 수화반응에 미치는 영향에 대하여 연구하였다. 출발물질은 순수시약을 사용하여 $C_3$S와 $C_2$S 조성으로 배합하고 여기에 Zn, Cu, Cr의 중금속 산화물을 1000ppm, 2000ppm, 3000ppm 첨가하여 150$0^{\circ}C$에서 1시간 소결하여 중금속의 고용분배, 결정구조, 용출상태 그리고 수화열을 관찰하였다. 중금속중 Zn는 $C_3$S와 간극질에 집중 고용되고 Cu는 간극물질에 집중 고용되며 Cr은 $C_3$S와 $C_2$S에 집중 고용되었다. 광학현미경 및 XRD 관찰결과 중금속 함량별로 $C_3$S와 $C_2$S의 결정상에는 큰 영향이 없는 것으로 나타났다. 그리고 7일간 수화시 Zn는 40~50%, Cu와 Cr은 전량 용출되었다. Conduction calorimeter 분석결과 중금속 함량별 변화에도 $C_3$S와 $C_2$S 수화열에는 차이가 없었다.