• The Journal of Korean Academy of Prosthodontics
• /
• v.37 no.5
• /
• pp.607-619
• /
• 1999

Cortical support is an important factor, as the engagement of the fixture in strong compact bone offers an increased load-carrying capacity and initial stability. Because of the poor bone quality in the posterior mandible and other anatomic considerations, it has been suggested that implant fixtures be placed in these locations with apical engagement of the lingual cortical plate for so-called bicortication. The purpose of this investigation was to determine the effect of cortical engagements and in addition polyoxymethylene(POM) intramobile connector(IMC) of IMZ implant on implant load transfer in edentulous posterior segment of mandible, using three-dimensional (3D) finite element analysis models composed of cortical and trabecular bone involving single implant. Variables such as (1) the crestal peri-implant defect, (2) the apical engagement of lingual cortical plate, (3) the occlusal contact position (a vertical load at central fossa or buccal cusp tip), and (4) POM IMC were investigated. Stress patterns were compared and interfacial stresses along the bone-implant interface were monitored specially. Within the scope of this study, the following observations were made. 1) Offset load and angulation of fixture led to increase the local interfacial stresses. 2) Stresses were concentrated toward the cortical bones, but the crestal peri-implant defect increased the interfacial stresses in trabecular bone. 3) For the model with bicortication, it was noticed that the crestal cortical bone provided more resistance to the bending moment and the lingual cortical plate provided more support for the vertical load. But Angulation problem of the fixture from the lingual cortical engagement caused the local interfacial stress concentrations. 4) It was not clear that POM IMC had the effect on stress distribution under the present experimental conditions, especially for the cases of crestal peri-implant defect.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.3
• /
• pp.296-303
• /
• 2014

In this paper, we propose an algorithm to visualize radio wave environment based on the measured Received Signal Strength Indication( RSSI) and 3D geographic information. We estimate the source position using the circumcenter of the triangle and visualize the radio wave environment using the empirical propagation models. A mode seeking algorithm(mean-shift clustering) is used to seek the peak points and the center of gravity is utilized to reduce the estimation errors. Our approach finds its applications in the radio wave monitoring systems for the efficient utilization of radio resources.

• Journal of the Korean Society for Railway
• /
• v.14 no.3
• /
• pp.240-247
• /
• 2011

Finite element analysis was undertaken to investigate the effect of freezing force of water unexpectedly penetrated into inserts used in railway sleeper on pullout capacity of anchor bolts for fixing base-plate onto concrete sleeper. Based on the in-situ investigation and measurement of geometry of railway sleeper and rail-fastener, the railway sleeper was modeled by 3D solid elements. Nonlinear and fracture properties for the finite element model were assumed according to CEB-FIP 1990 model code. And the pullout maximum load of anchor bolt obtained from the model developed was compared with experimental pullout maximum load presented by KRRI for verification of the model. Using this model, the effect of position of anchor bolt, amount of fastening force applied to the anchor bolt, and compressive strength of concrete on pull-out capacity of anchor bolts installed in railway sleeper was investigated. As a result, it is found that concrete railway sleepers could be damaged by the pressure due to freezing of water penetrated into inserts. And the pullout capacity of anchor bolt close to center of railway is slightly greater than that of the others.

• Journal of Chest Surgery
• /
• v.22 no.2
• /
• pp.246-255
• /
• 1989

A total and consecutive 291 patients of isolated single mitral valve replacement using the Ionescu-Shiley bovine pericardial xenograft valve operated on between October 1978 and June 1983 were retrospectively studied for the durability of the substitute valves based on the structural degeneration of primary tissue failure which had been proved on their re-replacement surgery. The mean age at the initial surgery was 32.4*12.5 years, and the operative mortality rate was 5.2 %. The early survivors of 276 patients were followed up for a total 1148.3 patient-years[mean\ulcornerD, 4.16*2.57 years]at the follow-up end of June 1988. They experienced 4 major late complications: 1.045 % thromboembolism/patient-year [pt-yr]; 0.871 % bleeding/pt-yr; 0.610% endocarditis/pt-yr; and 3.309% overall valve failure/pt-yr or 1.655% primary tissue failure/pt-yr. The actuarial survival rates were 89.4*2.2% and 87.7*2.5% at 5 and 10 years after initial surgery respectively. The probabilities of freedom from thromboembolism were 95.1*1.6% and 93.2*2.0% at 5 and 10 years after surgery. Nineteen patients underwent re-replacement of the Ionescu-Shiley valve because of primary tissue failure, and there was no operative mortality. The incidence of primary tissue failure was highest for the patients less than 15 years of age occurring in 9 out of 27 patients [33.3 %] or 8.68 %/pt-yr, while it was 4.0 % or 0.96 %/pt-yr for the rest of patients older than this age. The probabilities of freedom from primary tissue failure were 96.7*1.4 % and 84.2*3.8% at 5 and 9 years after surgery. The freedom from tissue failure increased as the age limits of cumulative younger patients were increased while it decreased as the age limits of cumulative older patients were decreased. Although it is clear that the Ionescu-Shiley valve would degenerate prematurely in young patients, the definite age limit could not be identified when the risk of early failure was significantly high.

• Journal of the Korean Society of Radiology
• /
• v.6 no.6
• /
• pp.465-471
• /
• 2012

In this study, three dimensional X-ray dose distribution from dental X-ray generator system was measured by ALOKA PDM-117 dosimeter. The X-ray dose distribution will be change with XCP-DS FIT in oral shot, because the distance between X-ray generator and the dosimeter. The X-ray dose change affects on patient exposure and radiograph image quality. Therefore, it is important to obtain relation between the X-ray dose and the distance. The X-ray dose at the central position was decreased with increasing the distance. Furthermore, the dose at the edge of the X-ray flux was increased with increasing the distance. The increased dose affects on the patient radiation exposure. The present results will provide for good dental radiograph image and reducing radiation over-exposure on patient.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.22 no.6
• /
• pp.533-539
• /
• 2009

In this study, the femur, the tibia, the articular cartilage and the menisci are three dimensionally reconstructed using MR images of healthy knee joint in full extension of 26-year-old male. Three dimensional finite element model of the knee joint is fabricated on the reconstructed model. Also, the FE models of ligaments and tendons are attached on the biologically suitable position of the FE model. Bones, articular cartilages and menisci are considered as homogeneous, isotropic and linear elastic materials, and ligaments and tendons are modeled as truss element and nonlinear elastic springs. The numerical results show the contact pressure and the von Mises stress distribution in the soft tissues such as articular cartilages and menisci which can be regarded as important parameters to estimate the failure of the tissues and the pain of the patients.

• The Journal of the Korean dental association
• /
• v.55 no.5
• /
• pp.328-338
• /
• 2017

Introduction: The aim of the current study was to describe the prevalence and treatment of mandibular first molar eruption disturbances. Methods: A total of 38 mandibular first molars(M1mn) from 36 patients(17 males and 19 females; aged 9 years 2 months?35 years 10 months) were identified from the 13,391 patients that received orthodontic treatment from 1983?2012. The subjects were classified into 3 categories based on panoramic radiographic examination: impaction due to ectopic position of the tooth germ relative to the contra-side same tooth(Group 1), impaction due to obstruction of the eruption path with cyst or calcium mass (Group 2), and primary and secondary retention due to defects in the follicle or periodontal ligament(PDL; Group 3). The treatment outcomes were evaluated into four categories: no treatment(A), orthodontic traction(B), autotransplantation(C), and extraction due to orthodontic traction failure(D). Results: The prevalence rate of M1mn eruption disturbances in this sample was 0.27%. In Groups 1 and 2, most of the impacted M1mn were erupted successfully by orthodontic traction. In Group 3, most of the retained M1mn were failed to erupt and recommended for extraction. Conclusions: Treatment prognosis was favorable on Group 1 & 2 than Group 3. After removing an element of the cause in case of Group 1 & 2, orthodontic traction or periodic observation will be recommended.

• Bulletin of the Korean Space Science Society
• /
• 1993.10a
• /
• pp.15-15
• /
• 1993

Revised Yale Isochrone(Green et al, 1987)과 Lee의 HB simulation data(LEE '||'&'||' Demarque 1990)을 이용하여 Park이 만든 CMD simulation program(Park 1983).에 쌍성을 첨가하면 CMD에 어느 정도의 영향을 나타내게 되는가를 조사하였다. MS, SGB와 RGB는 큰 변화가 없었으나, HB에서는 많은 변화를 나타내었다. 193919 S02401193919 ^x We have observed the emission of HC3N J= 4-3, 5-4 10-9 and 12-11 transitions toward the Sgr B2 central region in an area of 150"XISO" with resolutions of16"-48". The intensities and central velocities of line profiles show significant variations with positions. In contrast to the in tensities of the low J-level transitions which gradually increase from the central source toward the outside region the HC3N emission of the high J-level transition become stronger toward the central radio continuum source MO5. Systematic chainge in the radial velocity of each line profile occurs along north-south direction there are a few peaks in most line profiles, and these indicate that there not multiple velocity components along the line of sight. Distributions of excitation temperah at and column density which were estimated from the excitation calculations show the existence of a small(IxEpc),hot(Tex> SOK) core which contains two tempegatlue peaks at -15" east and north of MDS. The column density of HCaN is (1-3):n1014cm-2. Column density at distant position from MD5 is larger than that in the (:entral region. We have deduced that this hot-core has a mass of 10sR1 which i:s about an order of magnitude larger those obtained by previous studies.previous studies.

• Journal of radiological science and technology
• /
• v.21 no.1
• /
• pp.29-34
• /
• 1998

The purpose of simple abdomen erect projection is to see the fluid level which indicates gastrointestinal ileus or free air due to perforation. we do not have to insist on low kVp technique in simple abdomen erect position as long as we can detect the fluid level and free air shadow. Therefore, the author tried to decrease patient dose by high kVp technique and to improve the image quality due to motion artifact by reduction of exposure time. [Methods] Experiment 1. * screen/film SRO1000/HRH * exposure factor : $140\;kvp{\pm}5\;kv$ with added filters, 200 mA, 0.01 sec * phantom : Acryles : 15.0 cm(equivalent to 17 cm body thickness) 17.5 cm(equivalent to 21 cm body thickness) 20.0 cm (equivalent to 25 cm body thickness) With the exposure factor for same film density($D=0.8{\pm}0.1$) and with the materials above, we tried to find out entrance skin dose and gonad dose for both male and female. Experiment 2. Burger's phantom radiography were checked to see whether there was any change of image quality according to the kVp and the added filters. Experiment 3. Using rotating meter(self made), we examined the motion artifact and the exposure time limitation. [Results and conculution] 1. Using high voltage technique of 140 kVp with added filter, Skin dose, testicle dose and ovary dose decrease to 89.3%, 47% and 71.4% respectively compare to 70 kVp technique, 2. No great changes of Burger's phantom image has detected as from 70 kVp to 140 kVp and the air hole size of Burger's phantom over 0.028 cc(Diameter 3 mm, hight 4 mm) can be distinghished. 3. 0.01 sec(1 pulse) exposure time is possible in the single phase full wave rectification that why we can quitely reduce the unsharness caused by patient's movement.

• Korean Journal of Applied Biomechanics
• /
• v.24 no.4
• /
• pp.417-423
• /
• 2014

The purpose of this study was to compare two saddle height determination methods by the effectiveness of pedal reaction force. Ten male subjects (age: $24.0{\pm}2.4years$, height: $175.1{\pm}5.4cm$, weight: $69.3{\pm}11.1kg$, inseam: $77.8{\pm}4.5cm$) participated in three minutes, 60 rpm cycle pedaling tests with the same load and cadence. Subject's saddle height was determined by $25^{\circ}$ knee flexion angle (K25) when the pedal crank was at the 6 o'clock position (knee angle method) and 97% (T97), 100% (T100), 103% (T103) of trochanter height (trochanteric method). The RF (resultant force), EF (effective force), and IE (index of effectiveness) were compared by measuring 3D motion and 3-axis pedal reaction force data during 4 pedaling phases (phase1: $330^{\circ}-30^{\circ}$, phase2: $30^{\circ}-150^{\circ}$, phase3: $150^{\circ}-210$, phase4: $210^{\circ}-330^{\circ}$). Results showed that there were significant differences in EF at phase1 between T97 and K25, in EF at phase4 between T100 and T103, in IE at total phase between T97 and K25, between T100 and T103, in IE at phase1 & phase2 between T97 and K25. There was higher IE in the K25 than any other saddle heights, which means that K25 was better pedaling effectiveness than the trochanteric method. Therefore it was suggested the saddle height as 103.7% of trochanter height that converted from K25.