• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.12S
• /
• pp.1205-1209
• /
• 2003

We investigated the effects of calcination temperatures on the sintering behaviors and microwave dielectric Properties of (Z $n_{0.8}$M $g_{0.2}$)Ti $O_3$ system. Highly densified samples were obtained at the sintering temperatures below 100$0^{\circ}C$ with additions of 0.45 wt.%B $i_2$ $O_3$ and 0.55 wt.% $V_2$ $O_{5}$. From the examination of the existing phases and microstructures before and after sintering of (Z $n_{0.8}$M $g_{0.2}$)Ti $O_3$ system which is calcined at the various temperatures ranging from 80$0^{\circ}C$ to 100$0^{\circ}C$, it was found that higher Q${\times}$ $f_{o}$ values were obtained when unreacted phases in calcined body were reduced. When calcined at 100$0^{\circ}C$ and sintered at 90$0^{\circ}C$, it consists of hexagonal as. a main phase with uniform microstructure and exhibits Q${\times}$ $f_{o}$ value of 42,000 GHz and dielectric constant of 22. 22. 22.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.6
• /
• pp.10-15
• /
• 2008

In this paper, a new NMOS gate cross-connected current-mirror type bridge rectifier for UHF RFID applications is presented. The DC converting characteristics of the proposed rectifier are analyzed with the high frequency equivalent circuit and the gate capacitance reduction technique for reducing the gate leakage current due to the increasing of operating frequency is also proposed theoretically by circuitry method. As the results, the proposed rectifier shows nearly same DC output voltages as the existing NMOS gate cross-connected rectifier, but it shows the gate leakage current reduced to less than 1/4 and the power consumption reduced more than 30% at the load resistor, and it shows more stable DC supply voltages for the valiance of load resistance. In addition, the proposed rectifier shows high enough and well-rectified DC voltages for the frequency range of 13.56MHz HF(for ISO 18000-3), 915MHz UHF(for ISO 18000-6), and 2.45 GHz microwave(for ISO 18000-4). Therefore, the proposed rectifier can be used as a general purpose one to drive RFID transponder chips on various RFID systems which use specified frequencies.

• Journal of the Korean institute of surface engineering
• /
• v.47 no.5
• /
• pp.263-268
• /
• 2014

Nanocrystalline diamond(NCD) coated SiC balls were applied in a ball-on-disk tribometer. After seeding in an ultrasonic bath containing nanometer diamond powders, $2.2{\mu}m$ thick NCD films were deposited on sintered 3 mm diameter SiC balls at $600^{\circ}C$ in a 2.45 GHz microwave plasma CVD system. Bare $ZrO_2$ and SiC balls were prepared for comparison as test balls. Tribology tests were performed in air with pairs of three different balls and mirror polished steel(SKH51) disk. The wear tracks on balls and disks were examined by optical microscope and alpha step profiler. Under the load of 3 N, the friction coefficients of steel against $ZrO_2$, SiC and NCD-coated balls were between 0.4 and 0.8. After a few thousands sliding laps, the friction coefficient of NCD-coated balls dropped from 0.45 to below 0.1 and maintained thereafter. Under a higher load of 10 N or 20 N with a long sliding distance of 2 km, $ZrO_2$ and SiC balls exhibited the similar friction coefficients as above. The friction coefficient of NCD-coated balls was less than 0.1 from the beginning and increased to above 0.1 steadily or with some fluctuations as sliding distance increased. NCD coating layers were found worn out after long duration and/or high load sliding test, which resulted in the friction coefficient higher than 0.1.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.27 no.6
• /
• pp.1262-1266
• /
• 1998

The purpose of this study was to investigate peroxidative damage and antioxidative defense systems such as superoxide dismutase(SOD), glutathione peroxidase(GSH Px), glutathione S transferase (GST) and vitamin E of liver in rat exposed microwave. Sprague Dawley male rats 200$\pm$10gm were randomly assigned to normal and microwave(MW) groups. After rats were irradiated with microwave at frequency of 2.45GHz for 15min, the change patterns of antioxidative defense system and peroxidative damage of liver tissue in MW group were investigated for 16 days(the 2nd, 4th, 6th, 8th and 16th days) compared with those of normal group. The activity of superoxide dismutase(SOD) in MW group was increased at the 2nd day compared with that of normal group, but not significantly. The glutathione peroxidase(GSH Px) in MW group was decreased to 24% and 25% at the 4th and 6th days, respectively, compoared with that of normal group, but GSH Px was increased to level of normal group at the 16th day. The activity of glutathione S transferase(GST) in MW group was decreased at the 2nd day after irradiated with microwave, but GST showed to that of normal group at the 16th day. The content of vitamin E in MW group was lower than that of normal group at the 6th and 8th days after the irradiation, but was recovered to the level of normal group at the 16th days. The content of thi obarbituric acid reactive substances(TBARS) of liver in MW group was increased to 28.9%, 53.8%, 69.7% and 30.2% of normal group at the 2nd, 4th, 6th and 8th days after the irradiation, respectively, but recovered to the level of normal group at the 16th day. The present results indicated that antiox idative defense systems of rats irradiated microwave was weaken more than that of normal group, which lead to acceleration of lipid peroxidation.

• Journal of the Korean Ceramic Society
• /
• v.43 no.6 s.289
• /
• pp.338-343
• /
• 2006

The effects of lead-borosilicate glass frits on the sintering behavior and microwave dielectric properties of ceramic-glass composites were investigated as functions of glass composition of glass addition ($10{\sim}50vol%$), softening point (Ts) of the glass, and sintering temperature of the composites ($500{\sim}900^{\circ}C$ for 2 h). The addition of 50 vol% glass ensured successful sintering below $900^{\circ}C$. Sintering characteristics of the composites were well described in terms of Ts. PbO addition in to the glass enhanced the reaction with $Al_{2}O_3$ to form liquid phase and $PbAl_{2}Si_{2}O_8$, which was responsible to lower Ts. Dielectric constant(${\epsilon}_r$), $Q{\times}f_0$ and temperature coefficient of resonant frequency (${\tau}_f$) of the composite with 50 vol% glass contents ($B_{2}O_{3}:PbO:SiO_{2}:CaO:Al_{2}O_3$ = 5:40:45:5:5) demonstrated 8.5, 6,000 GHz, $-70\;ppm/^{\circ}C$, respectively, which is applicable to substrate requiring a low dielectric constant. When the same glass composition was applied sinter $MgTiO_3\;and\;TiO_2,\;at\;900^{\circ}C$ (50 vol% glass in total), the properties were 23.8, 4,000 GHz, $-65ppm/^{\circ}C$ and 31.1, 2,500 GHz, $+80ppm/^{\circ}C$ respectively, which is applicable to filter requiring an intermidiate dielectric constant.

• Electronics and Telecommunications Trends
• /
• v.21 no.2 s.98
• /
• pp.161-169
• /
• 2006

IT 839 정책 중 하나인 RFID는 기업의 수요 예측, 생산, 재고, 유통의 관리, 상점에서의 제품 판매 방식을 변화시킨다는 비전을 제시하고 있다. 향후 그 시장 규모가 막대할것으로 전망되고 있다. 본 고에서는 IDTech사의 RFID 구축사례에 대한 심층분석을 통해 현재 실제 시장 현황을 살펴보았다. IDTech사의 RFID 구축 데이터베이스에 의해, RFID 구축사례가 가장 많은 국가는 미국으로 나와 있으며, 전세계적으로 RFID가 가장많이 적용 되 어진 분야는 소매 및 소비재 분야로 나타났다. 가장 많이 사용 되 어지는 주파수 대역은 HF(13.56MHz)였다. 태그의 형태로는 라벨이 가장 많은 비중을 차지하는것으로 나타났다. HF(13.56MHz)와 LF(125~135kHz) 방식은 모든 국가에서 활용되고 있으나 Microwave(2.45GHz)와 UHF(868~960MHz)의 비중도 상대적으로 높게나타났다.

• Journal of electromagnetic engineering and science
• /
• v.5 no.3
• /
• pp.126-131
• /
• 2005

To increase the efficiency of an applicator during microwave hyperthermia therapy, first, the length from the antenna end to a slot is varied to get the optimal matching of the characteristic impedance at the frequency of 2.45 GHz. Using the electric and thermal constants of biological tissue, we compose a phantom to calculate temperature increment as well as the resonance characteristics and the SAR distributions. The proposed 3-slot sleeve antenna inserted in an applicator plays an effective role in increasing the therapy size in the view of heating performance as electromagnetic energy tends to concentrate on not feed point direction but treatment area. The SAR is then used in combination with a finite difference heat transfer equation to determine the temperature distribution. Also, in order to shorten treatment time and increase therapy size, a square-array structure is suggested and analyzed.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.9 no.4
• /
• pp.164-167
• /
• 2010

In this paper, an artificial transmission line of triangular-patch type with slots is proposed. This artificial transmission line is useful for miniaturizing the electrical lengths of conventional transmission lines. Also, this structure is easy to regulate the characteristic impedance and electrical lengths. The electrical lengths and the characteristic impedances of the proposed artificial transmission line with some parameters are researched and summarized The proposed artificial transmission line could be useful for compact designs for most of the passive microwave components. The optional-artificial transmission line is fabricated and measured at 2.45GHz.

• Journal of the Korean Society for Precision Engineering
• /
• v.25 no.9
• /
• pp.103-108
• /
• 2008

In-plane shear tests were performed to investigate the shear property change of FRP by plasma modification. Graphite/epoxy prepreg was used as a test material and plasma source was a microwave (2.4GHz) type. Plasma was induced by oxygen gas and its flow rate was kept $4{\sim}5$sccm with low vacuum state of $10^{-3}$ Torr. Prepreg was stacked unidirectionally ($[0^0]_8$) after plasma modification. Wettability was determined by measuring a contact angle. The results showed that the contact angle was decreased from $86^0$ to $45^0$ after plasma modification. Shear strength was also improved by ${\sim}10%$. SEM examination was made on the fracture surface and functional group produced by the plasma modification was investigated by XPS.

• Current Optics and Photonics
• /
• v.7 no.4
• /
• pp.378-386
• /
• 2023

A wideband instantaneous frequency measurement (IFM) system is been proposed, designed and analyzed. Phase modulation to intensity modulation conversion is implemented based on the stimulated Brillouin scattering (SBS) effect, and the microwave frequency can be measured by detecting the change in output power. Theoretical analysis shows that the frequency measurement range can be extended to 4f_b by adjusting the two sweeping signals of the phase modulators with a difference of 2f_b. The IFM system is set up using VPI transmission maker software and the performances are simulated and analyzed. The simulation results show that the measurement range is 0.5-45.96 GHz with a maximum measurement error of less than 9.9 MHz. The proposed IFM system has a wider measurement range than the existing SBS-based IFM system.