• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.10
• /
• pp.1179-1182
• /
• 2016

In this paper, a new method to reduce the size of ROM in the direct digital frequency synthesizer (DDFS) is proposed. This method use the sine-linear phase difference method and differential PCM. The new ROM compression method can reduce the ROM size by using the two ROM. The quantized value of sine-linear phase difference is saved by the ROM1 of the $2^N$ sample period. The ROM2 save the difference between the original sine-linear phase difference value and the saved sample value of the ROM1. The ROM compression ratio of 37% is achieved by this method. Also, the power consumption is decreased according to the ROM size reduction.

• Journal of Ocean Engineering and Technology
• /
• v.12 no.2 s.28
• /
• pp.33-42
• /
• 1998

In the presence of incident waves with different frequencies, the second order sum and difference frequency waves due to the nonlinearity of the incident waves come into existence. Although the magnitudes of the forces produced on a Tension Leg Platform(TLP) by these nonlinear waves are small, they act on the TLP at sum and difference frequencies away from those of the incident waves. So, the second order sum and difference frequency wave loads produced close to the natural frequencies of TLPs often give greater contributions to high and low frequency resonant responses. The second order wave exciting forces and moments have been obtained by the method based on direct integration of pressure acting on the submerged surface of a TLP. The components of the second order forces which depend on first order quantities have been evaluated using the three dimensional source distribution method. The numerical results of time domain analysis for the nonlinear wave exciting forces in regular waves are compared with the numerical ones of frequency domain analysis. The results of comparison confirmed the validity of the proposed approach.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.168-176
• /
• 2019

When an array receives a signal with a frequency higher than the design frequency, there is an ambiguity in beamforming due to spatial aliasing. In order to overcome this problem, Abadi proposed frequency-difference beamforming. However, there is a constraint that the minimum frequency bandwidth is required according to the value of the difference frequency. In this paper, we propose a method to find the direction of the target signal with spatial aliasing based on the frequency-wavenumber spectrum combined with Radon transform. The proposed method can estimate the direction of the target without ambiguities when the signal has nonnegligible bandwidth. We tested the algorithm by simulating a broadband signal and verified the results with the frequency-difference beamforming method using SAVEX15 (Shallow Water Acoustic Variability EXperiment 2015)'s shrimp noise data.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.154-159
• /
• 2019

When measuring the radiating noise of an underwater moving source, the range information between the acoustic source and the receiver is an important evaluation factor, and the measurement standards such as a receiver position, a moving source depth and a speed are set. Although there is a method of using the cross correlation as a method of finding the range of the underwater moving source, this method requires a time synchronization process. In this paper, we proposed the method to estimate the range by comparing the Doppler frequency difference of the theoretically calculated multipath signal with the Doppler frequency difference of the multipath signal estimated from the received signal. The proposed method does not require a separate time synchronization process. Simulations were performed to verify the performance, and the ranging error of the proposed method reduced by about 95 % than that of the conventional method.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.51 no.3
• /
• pp.305-312
• /
• 2018

This study was carried out to investigate euphausiid abundance in an acoustic survey from March 2010 to July 2010 to suggest reasonable usage and management of the euphausiid Euphausia pacifica in the coastal area of Guryongpo Pohang. The acoustic data were analyzed by the 2-frequency difference method and the distorted wave born approximation acoustical theoretical model, which is used for organisms of weak target strength with small scatter, such as euphausiid scatter, among other marine organisms. The distribution and monthly density of euphausiids were estimated in the survey area. The results show that the volume back scattering strength frequency difference for euphausiid was 13.91-7.6 dB, and their monthly averag density was $28.2g/m^2$.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.58 no.1
• /
• pp.49-58
• /
• 2022

In September and October 2020, combined acoustic and trawl surveys were conducted in the northwestern sea of Jeju Island. In the survey area, a region, so called Jeju region, was designated to esimate the biomass of chub mackerel and jack mackerel using a trawl survey method and frequency difference method. In the September survey, the weight ratios of jack mackerel and chub mackerel to the total catch were 24.6% and 2.8%, respectively, and in the October survey, those ratios were 24.9% and 20.7%, which were used to calculate their biomass (trawl survey). Using the frequency difference range (-8 to -3dB) corresponding to two species in 120 and 200 kHz, their biomass was estimated (frequency difference method). As a result, the biomass of two species from the trawl method was 3252.3 tons in September and 5777.0 tons in October. The estimated biomass by the frequency difference method was 4926.6 tons in September and 7521.5 tons in October. It was the first trial to estimate the biomass of two species using the trawl and frequency differencing methods in South Korea although there were some differences between two methods. In addition, horizontal distributions of acoustic backscattering strength over the entire survey area were mapped.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.10
• /
• pp.2514-2526
• /
• 2013

This paper presents a detection method for least significant bit matching revisited (LSBMR) steganography. Previous research shows that the adjacent pixels of natural images are highly correlated and the value 0 appears most frequently in pixel difference. Considering that the message embedding process of LSBMR steganography has a weighted-smoothing effect on the distribution of pixel difference, the frequency of the occurrence of value 0 in pixel difference changes most significantly whereas other values approximately remain unchanged during message embedding. By analyzing the effect of LSBMR steganography on pixel difference distribution, an equation is deduced to estimate the frequency of difference value 0 using the frequencies of difference values 1 and 2. The sum of the ratio of the estimated value to the actual value as well as the ratio of the frequency of difference value 1 to difference value 0 is used as the steganalytic detector. Experimental results show that the proposed method can effectively detect LSBMR steganography and can outperform previous proposed methods.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.50 no.6
• /
• pp.788-798
• /
• 2017

Antarctic krill Euphausia superba are important components of the Antarctic marine ecosystem both economically and ecologically; to manage this species effectively, their distribution and abundance must be understood. Using the Kwang Ja-Ho (3,012 tonnage), a commercial fishing vessel, we conducted acoustic surveys during April 13-24, 2016, to estimate the distribution and population size of krill around the South Shetland Islands of the Antarctic Continent, We used acoustic techniques based on the dB-difference, a method used mainly to classify of marine species. We found that Antarctic krill were present in numbers over 99% at six survey stations, with the exception of Station 3, where we only found Electrona carlsbergi. There was no difference in cell size due to frequency differences, but echo signals differed between species: 4.7-12.0 dB for Antarctic krill, and -4.1~0 dB for Electrona carlsbergi.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.260-263
• /
• 2003

Lasers are used as the source of the interferometers in the industrial field. These lasers need 2 requirements. The first is the narrow linewidth of laser for the long coherence length. The second is the stabilized frequency of laser for the precision measurement. Now HeNe lasers are mostly used and the frequency stability is about 10$^{-9}$ . In this paper, we construct the HeNe laser systems of frequency stabilization using typical 2 method, the beat frequency stabilization method and the intensity difference method. So, we get the frequency stabilities of 2.01$\times$10$^{-9}$ (0.1s), 3.4$\times$10$^{-9}$ (0.1s).

• Structural Engineering and Mechanics
• /
• v.46 no.2
• /
• pp.269-294
• /
• 2013

This paper is concerned with the determination of exact buckling loads and vibration frequencies of variable thickness isotropic plates using well known finite difference technique. The plates are subjected to uni, biaxial compression and shear loadings and various combinations of boundary conditions are considered. The buckling load is found out as the in plane load that makes the determinant of the stiffness matrix equal to zero and the natural frequencies are found out by carrying out eigenvalue analysis of stiffness and mass matrices. New and exact results are given for many cases and the results are in close agreement with the published results. In this paper, like finite element method, finite difference method is applied in a very simple manner and the application of boundary conditions is also automatic.