• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.9 no.1
• /
• pp.23-29
• /
• 1995

There are many articles about the HID lamps about it's characteristics and simulation methods for lamp design or ballast design. For the electronic ballasts of HID lamps, There are some problems caused by acoustic-resonance which destabilizes the arc of HID lamps. So, some studies suggest the methods to avoid it. For example, the methods suggested are high frequence driving over 100[kHz], and mixed frequence driving which alternates high frequence and low frequence, and squarewave driving etc. This study suggests the electronic ballast of HID lamps that solves the problems of acoustic-resonance, and can control the luminance by constant current boostes chopper of which frequence is 30[kHz] and by the squarewave driving of which frequence is 55.5[Hz.] As follows, we have the good electronic ballast for HID lamps which has the characteristics of a light weight, and a function of luminance control and a high quality luminosity and which saves electrical energy.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.16 no.6
• /
• pp.587-593
• /
• 2011

A new high power density and low cost Photovoltaic Power Conditioning System (PV PCS) with energy storage system is proposed. Its high power density and cost effectiveness can be achieved through the unification of the maximum power point tracker and battery charger/discharger. Despite of the reduced power stage, the proposed system can achieve the same performances of maximum power point tracking and battery charging/discharging as the conventional system. Moreover, the high voltage stress across the link-capacitor can be relieved through the series-connected link-capacitor with the battery. Therefore, a large number of series/parallel-connected link-capacitors can be reduced by 4-times. Especially, when the utility power failure happens, both photovoltaic and battery energies can be supplied to the load with only one power stage. Therefore, it features a simpler structure, less mass, lower cost, and fewer devices. Finally, to confirm the operation, validity, and features of the proposed system, theoretical analysis and experimental results from a single phase AC 220Vrms/1.5kW prototype are presented.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.1
• /
• pp.64-69
• /
• 2014

There are 440V and 220V electric source in ship. A 440V source is used to drive the power system such as crane and winch on deck and pump in engine room, and a 220V source is used to drive the power source for residential zones, control devices in engine room. In this paper, we made single phase inverter system for grid connection with 220V source for ship, and analyzed THD(Total harmonic distortion) by variation of parameters of L-C low pass filter and deadtime of inverter switching.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2011.10a
• /
• pp.67-67
• /
• 2011

본 논문에서는 접지시스템의 성능을 평가하기 위한 광대역 접지임피던스 분석기에 대하여 기술하였다. 시제작 측정기는 65 Hz~1.28 MHz의 신호발생부와 이득 20 dB, 출력 임피던스가 $0.1{\Omega}$인 전류 증폭부, 전압 및 전류 측정부, 신호처리부, 표시부로 구성된다. 또한, 외부 노이즈로 인한 측정의 오차를 줄이기 위하여 디지털 대역통과 필터를 적용하였다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.10a
• /
• pp.250-254
• /
• 2001

본 문에서는 Tschebyscheff 다항식 이론을 이용하여 상대적 전류 분포비가 1:2:2:1이 되도록 마이크로스트립 패치 어레이 안테나(MPAA) 설계 제작하였다. 지향성을 갖는 제안된 안테나는 작고 가벼우며 얇다. 또한 빔폭이 14。 인 어레이 안테나이고, 중심 주파수는 10.2553GHz이다. MPAA는 한 개의 마이크로스트립 패치 안테나(SMA:single microstrip antenna)특성과 비교 분석하였다. 그 결과 MPAA는 SMA보다 보다 좁은 복사 전력 빔폭과 큰 최대 복사 전력 이득을 획득했다. PIN 다이오드를 이용한 위상 변환기를 적용하면 전자적 빔스케닝이 가능하고, 소형 레이더 시스템에 적합하다.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.11a
• /
• pp.677-679
• /
• 2005

최근 나노입자를 이용하는 광전 화학전지(PEC, Photoelectrochemical)인 염료감응형 태양전지(DSC)의 효율이 증가함에 따라 DSC 태양광 발전 시스템의 성능 개선 또한 요구되어진다. 본 연구에서는 Fly-Back DC-DC 컨버터(변화비율1:10)를 이용하여 DSC셀의 전압을 DC 300V로 승압시켰다. 또한 풀브릿지 인버터를 사용하여 AC 220V, 60Hz의 출력전압을 얻었다. 연구에서 제안한 회로는 높은 효율의 동작특성과 간단한 제작, 낮은 제조비용, 그리고 안정성을 추구한다. 또 다른 주요점은 부하단에서 Feed back을 받아 동작을 컨트롤하는 것이다. 부하단의 출력 전압과 전류를 Feed back 받아서 DSP320LF2406을 A/D기능을 사용하여 실시간으로 부하의 변화에 대처하여 컨버터와 인버터의 동작을 제어한다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.10
• /
• pp.4308-4313
• /
• 2011

The objective of this study is to investigate the cooling performance of the roof mounted air-conditioning system using electric driven scroll compressor for zero emission vehicles. This air conditioner with air source was used R-134a as a refrigerant and tested under various operating conditions such as refrigerant charge amount and indoor temperature, and compressor frequencies. Experimental results revealed that at all tested compressor frequencies, heat transfer rate of the evaporator increased and the cooling COP increased with the indoor temperature. In addition, the heat transfer rate of the evaporator was over 25.0kW sufficient for the cooling loads of an electric bus.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.12 no.3
• /
• pp.267-275
• /
• 2007

This paper presents about energy input and output modeling for a flywheel energy storage system that can store and supply mechanical energy, which is emerging as one of clean energy sources, and the analysis and control of a PWM inverter system. Moreover, this paper describes flywheel's characteristics related to variations of mechanical and electrical parameters like as voltage and current versus speed characteristics formed as numerical formula and thus simulate behaviour-status of flywheel energy. Also for comparison and analysis between PI control and PDFF control, the modeling, design and analysis to the single-phase full bridge inverter with double loop feedback control is accomplished through numerical description and simulation. Finally, under load condition 0.1[pu], 1[pu]. it is validated that harmonic characteristics for voltage and current wave is controlled within 5% below even dynamics condition.

• The Journal of the Korea Contents Association
• /
• v.20 no.9
• /
• pp.285-295
• /
• 2020

As movies entered the digital age, they quickly changed from group creation to individual creation. In particular, documentary films began to produce diverse and excellent works while dealing with extremely personal subjects and themes rather than heavy subjects. Especially in the 1990s, when the digital era began in earnest, Japan began to shift away from heavy political and social topics from documentaries to extremely personal subjects, and the subject matter became very diverse. In this paper, we would like to examine the concept, type, and characteristics of private documentaries that emerged as new forms of documentaries following the advent of the full-fledged digital era since the 90s, citing concrete examples of representative private documentary works since the 90s in Japan.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.10
• /
• pp.1189-1196
• /
• 2015

In this paper, a microstrip-fed multiband monopole antenna for GPS(Global positioning system)/WiMAX(:Worldwide interoperability for microwave access)/WLAN(Wireless Local Area Networks) for applications was designed, fabricated and measured. The proposed antenna is based on a microstrip-fed structure, and composed of two rectangular double rings and L strips pair and then designed in order to get triple band characteristics. To obtain the optimized parameters, we used the simulator, Ansoft's High Frequency Structure Simulator(HFSS). The proposed antenna is made of $27.0{\times}54.0{\times}1.0mm3$ and is fabricated on the permittivity 4.4 FR-4 substrate. The experiment results shown that the proposed antenna obtained the -10 dB impedance bandwidth 300 MHz (1.325~1.625 GHz), 400 MHz (2.275~2.675 GHz), and 600 MHz (3.15~3.75 GHz) covering the GPS/WiMAX/WLAN bands. Also, the proposed antenna measured gain and radiation patterns characteristics for required operating bands.