• The Journal of Engineering Geology
• /
• v.27 no.4
• /
• pp.475-487
• /
• 2017

We performed landslide flume tests to analyze characteristics of landslide occurrence and change in the ground materials due to rainfall infiltration. The test apparatus is composed of flume, rainfall simulator, and measurement sensors and landslides were triggered by heavy rainfall (Intensity=200 mm/hr) sprinkled at the above of an artificial slope. The measurement sensors for matric suction and volumetric water content were installed with 3 sets at shallow (GL-0.2 m), middle (GL-0.4 m), and deep depth (GL-0.6 m) in the slope and the tests were performed with in-situ, loose, and dense condition of each weathered soils of granite, gneiss, and mudstone. The analyses show that surface erosion was dominant in initial time of the test due to heavy rainfall and then landslides occur following locally happened transverse tension cracks. The characteristics of landslide were both shallow failure because of a spread of wetting front induced by the rainfall infiltration and retrogressive failure. While the matric suction was decreased rapidly without any precursor in the soil saturation, the volumetric water content was increased gradually, reached its maximum value, and then decreased rapidly with landslide.

• Journal of the Korean Geotechnical Society
• /
• v.31 no.8
• /
• pp.17-28
• /
• 2015

The purpose of this study is to measure the volumetric water content of unsaturated soils during drying and wetting process by using volumetric pressure plate extractor (VPPE) incorporated with time domain reflectometry (TDR). The VPPE consists of a pressure cell, a pressure regulator, a burette system and a TDR probe. Two samples with different initial void ratios were prepared in the pressure cell, and the air pressure at the range of 0.1 kPa - 50 kPa was applied to adjust the matric suction by the pressure regulator. The burette system was used to measure the volumetric water content change of the sample according to the matric suction. In addition, the TDR probe, installed in the cell, was used to evaluate the dielectric constant from the reflected signal of the electromagnetic wave at the probe. The volumetric water content of specimen was estimated by the empirical equation between the volumetric water content and dielectric constant, which was calibrated with the Jumunjin sand. The test results show that the volumetric water content calculated by TDR probe is strongly correlated to the measured value by burette system. The hysteresis occurs during drying and wetting process. Furthermore, the degree of hysteresis reduces in the repeated process. This study suggests that TDR may be effectively used to evaluate the water content soil for the determination of water characteristic curve of unsaturated soils.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.33 no.3
• /
• pp.522-528
• /
• 2006

When tooth is displaced within the alveolar bone, it could apply pressure and rupture the apical vessels. Pulpal reaction in such case is affected by the stage of root formation, amount of intrusion and pulpal infection. Determining the need of pulp treatment depends on the pulp vitality. Therefore, periodic vitality tests, coronal color changes and radiographic root resorption signs should be observed through periodic post-trauma follow-up. Pulp necrosis, pulp canal obliteration, external root resorption, root ankylosis and marginal bone loss could result from periodontal injuries. Negative sign changes from positive signs of vitality tests suggest pulp necrosis. In this case, pulp treatment should be held before root resorption occurs. By comparing the following two cases, complications of intrusion and factors producing them could be confirmed, thus we propose to report these two cases.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.5
• /
• pp.117-127
• /
• 2008

The volumetric pressure plate extractor (VPPE) was modified for the measurement of shear wave velocity ($V_s$) at various levels of matric suction as well as soil water characteristic curve (SWCC). A non-destructive technique with a pair of bender element (BE) was employed in order to measure the $V_s$ and the corresponding maximum shear modulus ($G_{max}$) of unsaturated soil specimens. Three types of soil were collected from different road construction sites in Korea. For all test soils, the variations in $G_{max}$ with the various levels of water content and matric suction were investigated using the developed apparatus. Compared with the preceding results from the suction-controlled torsional shear (TS) testing system and in-situ seismic tests, the feasibility fur evaluating modulus characteristics of unsaturated compacted soils with the developed VPPE-BE system was assessed. It was confirmed that the newly developed system would be potentially helpful in modeling seasonal variation of modulus.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.42 no.4
• /
• pp.319-326
• /
• 2015

Short root anomaly (SRA) is very rare, but can be problematic for physicians because patients with SRA are more vulnerable to root resorption with orthodontic forces. During the mixed dentition period, it may be difficult to diagnose generalized SRA. This article reports the treatment of an orthodontic patient with SRA at the early mixed dentition stage. Despite local tooth loss, a relatively favorable outcome was obtained without excessive root resorption. Ultimately, orthodontic therapy is possible for patients with generalized SRA, but precautions should be taken to avoid complications, such as tooth loss or root resorption.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.39 no.2
• /
• pp.158-164
• /
• 1994

These experiment were conducted to evaluate the environmentally acceptable polymers, and 10 polymers were used in these study, and to investigate conductivity, germination percentage, water uptake of polymeric coating soybean seed. The conductivity of polymeric coating seed is higher than that of none coating seed and the highest conductivity was obtained with waterlock coating seed among the 10 polymer coating seed. As the soaking time was long, the conductivity was increased. The conductivity of large seed was higher than that of small seed, and that of long period storage seed was higher than that of short period storage seed. The effects of seed coating polymers on uptake water were various, and daran 8600 inhibited uptake water of low quality seed. The waterlock, captan, klucel and sacrust was rised germination percentage, and daran 8600 was declined germination percentage, and the effect of coating polymers on germination percentage of low quality seed was higher than that of high quality seed.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.4
• /
• pp.284-290
• /
• 2014

To successfully explore the moon by lunar lander, it is essential to guarantee the safe landing of lunar lander. Therefore, efficient shock absorption system of lunar lander should be designed in order to reduce landing impact force. Also, for more practical design of lunar lander, it is important to consider the effect of lunar regolith. In the line of thought, finite element model of lunar lander considering the effect of lunar regolith is developed. To reduce landing impact force, optimization of shock absorption system for lunar lander has been carried out. In optimization, sequential approximate optimization method based on meta-model is used. Through the result of optimization, it is verified that landing impact force on lunar lander can be efficiently reduced by the present optimization procedure.

• The korean journal of orthodontics
• /
• v.25 no.1 s.48
• /
• pp.101-110
• /
• 1995

The purpose of this study was to observe the tissue response to the orthodontic force applied immediately after buccal horizontal subapical osteotomy of maxilla. Five mongrel cats weighing about 2.5 Kg were used for this experiment. The left upper canine and premolar of each cat served as a experimental side and the right ones as a control side. On the experimental side, a 100gm orthodontic force was applied between the upper canine and premolar immediately after the osteotomy. On the control side, the same orthodontic force was applied without the osteotomy. After 7days, the experimental animals were sacrificed. The results were as follows: 1. In the pressure zones of the experimental group, significant increase of osteoclasts and direct resolution along the alveolar bone surface was observed as compared with those of the control group. 2. In the pressure 2ones of the experimental group, a less extensive hyalinized zone was observed than those of the control group. 3. In the pressure zones of both group, no root resorption was found. 4. Tn the tension zones of the experimental group, new bone deposition increased along the alveolar bone surface as compared with those of the control group. In conclusion, the results suggest the possibility that early orthodontic treatment after orthognathic surgery may have some benefits if the stability of the repositioned segment at surgery is secured.

• Korean Journal of Optics and Photonics
• /
• v.29 no.2
• /
• pp.77-84
• /
• 2018

We analyze the link availability of terrestrial free-space optical (FSO) communication systems in Korea. For this purpose, we utilize several theoretical models to calculate the power losses induced by absorption and scattering in the atmospheric channel, using five-year meteorological data for three major cities in Korea (Seoul, Busan, and Daejeon). Also, we estimate the power variations at the receiver caused by scintillation in the data. Those power losses and variations are used to estimate the availability of FSO links in the three cities. The results show that link availability is estimated to be over 95% in Daejeon for a 3.5-km FSO link, when the transmitter power and receiver diameter are greater than 10 dBm and 7 cm respectively. Slightly worse link availabilities are obtained for Busan and Seoul.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.02a
• /
• pp.170-171
• /
• 2000

현재 사용하고 있는 디스플레이 장치에는 표면에 무반사(antireflection), 무정전(antistatic) 코팅이 되어 있다. 이것은 전기적으로 음극선관(CRT)에서 발생되는 전자에 의해 표면에 생기는 전하의 적층을 제거하여 정전기를 방지하고 인체에 유해한 전자기파를 차단하는 무정전 기능과, 광학적으로 디스플레이 장치 표면에서 외부의 조명등과 같은 빛의 반사를 줄여 내부에서 나오는 정보(빛)가 보다 더 눈에 선명하게 들어오도록 해준다. 무반사 무정전 코팅의 투과 전도층으로는 비저항값이 낮고 가시광선 영역에서 굴절률이 높고 흡수가 적어 투과율이 높은 indium tin oxide(ITO)가 널리 연구, 사용되어 왔다. 이러한 ITO 박막 대신에 TiN 박막을 사용하여 그 위에 유전체층을 증착하여 단 2층으로 무반사 무정전 코팅을 제작 할 수 있다. TiN 박막은 절삭공구 등의 표면에 마모방지용 코팅재료로서 사용되고 있고, 부착력이 우수하며 화학적 안정성이 뛰어나 수명이 긴 박막을 제작 할 수 있는 장점을 가지고 있다. 또한 가시광선 영역에서 흡수로 인해 투과율이 ITO에 비해 상대적으로 낮지만 이점이 오히려 명도대비(contrast)의 향상을 가져온다. (중략)