• Transactions of the Korean hydrogen and new energy society
• /
• v.20 no.6
• /
• pp.464-470
• /
• 2009

In order to analysis the possibility of high expansion and performance without backfire in a hydrogenfueled engine using external mixture injection, combustion characteristics and performance enhancement were analyzed in terms of retarding valve timing and increasing the boosting pressure. As the results, it was found that thermal efficiency increased by retarding intake valve timing with the same level of supplied energy is over 6.6% by the effect of high expansion including effect of combustion enhancement due to supercharging. It was also shown that the achievement of high power (equal to that of a gasoline engine), low brake specific fuel consumption and low emission (NOx of less than 16 ppm) without backfire in a hydrogen-fueled engine is possible around a boosting pressure of 1.5 bar, intake valve opening time of TDC and $\Phi$=0.35 in fuel-air equivalence ratio.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.1 no.2
• /
• pp.27-33
• /
• 1993

Using the solenoid driven gas injection valve, Hydrogen fuel supply system was made. It was attached to a single cylinder research engine and intake port injection type hydrogen fueled S.I. engine was constructed. Engine performance, emission characteristics, and abnormal combustion were studied through the engine test performed with the variations of fuel-air equivalence ratio and spark timing. Compared with gasoline, hydrogen burns so fast that cylinder peak pressure and temperature are higher and NO is emitted more at full load condition. IN the case of intake port injection type engine, COVimep becomes lower due to the well-mixing of air and fuel, and engine output is lower owing to the low volumetric efficiency. As fuel-air equivalence ratio goes up, the combustion speed increases, and COVimep decreases. NO emission peaks slightly lean of stoichiometric. As spark timing advances and fuel-air equivalence ratio goes up, the cylinder peak pressure and temperature become higher, so abnormal combustions take place easily.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.5 no.5
• /
• pp.104-113
• /
• 1997

In this paper, the effects of intake manifold systems on volumetric efficiency were investigated in the 4-cylinder 4-stroke cycle diesel engines. The effects of intake manifold system were analyzed on resonant speed and on volumetric efficiency. Resonant speed was calculated by acoustic theory and volumetric efficiency by the method of characteristics. The calculation results agreed well with rest results. It was assured that between the resonant speed and the volumetric efficiency there exists good correlation in multi-cylinder engines. As the results, the prediction of resonant speed was useful to design the optimum intake system. It was assured that the intake manifold systems for BOX-type and RAM-type have different characteristics on the trend of volumetric efficiency. Also a procedure to design the desirable intake manifold system was proposed.

• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.2186-2191
• /
• 2003

This study is to investigate the effects of water induction through the air intake system on the characteristics of combustion and exhaust emissions in diesel engine. The effects of water induction through the air intake port were considered in IDI diesel engine in this study. The formation of NOx was significantly suppressed by decreasing the gas peak temperature during the initial combustion process because the water play a role as a heat sink during evaporating in the combustion chamber, but the smoke was slightly increased with increased water amount. Also, NOx significantly decreased with increase in water amount. A simultaneous reduction in smoke and NOx emissions can be obtained when water is injected into the combustion chamber by retarding the fuel injection timing more than without water injection.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.4
• /
• pp.512-518
• /
• 2000

A wall fuel-film flow model is developed to predict the effect of a wall-fuel-film on air-fuel ratio in an SI engine in transient conditions. Fuel redistribution in the intake port resulting from charge backflow and a simple liquid fuel behavior in the cylinder are included in this model. Liquid fuel film flow is calculated of every crank angle degree using the instantaneous air flow rate. The model is validated by comparing the calculated results and corresponding engine experiment results of a commercial 4 cylinder DOHC engine. The predicted results match well with the experimental results. To maintain the constant air-fuel ratio during transient operation. the fuel injection rate control can be obtained from the simulation result.

• Journal of the korean Society of Automotive Engineers
• /
• v.9 no.4
• /
• pp.15-22
• /
• 1987

이상 최근 10년 사이 현저하게 보여준 엔진관계의 신기술과 그 배경 등을 돌아 보았을 때 발전하 는 가운데 특히 4륜차용 2사이클 엔진의 몰락이나 엔진의 주요 부품인 기화기의 쇠태는 그 어느 것이나 시대의 요구에 대한 기술의 한께 혹은 신기술의 개발 템포에 추종키 여려웠던 때문인 것 으로 생각된다. 2사이클 엔진은 비출력이 높고 밸브기구가 없어서 구조가 간단한 등의 장점이 있는 반면 배출가스대책(특히 HC), 경부하시의 부정연소 등의 문제를 가지고 있어 4륜차용으로 서는 배출가스규제를 계기로 SAAB(스웨덴), DKW(서독)의 2사이클 엔진이 자취를 감추게 되었 고 현재 남아있는 것은 일본의 경트럭용 엔진에 지나지 않는다. 또 기화기에 대해서도 배출가 스규제에 대한 대응에 밀려 공연비의 제어성, 고도에 대한 보정성, 내열신뢰성, 제어성, 고도에 대한 보정성, 내열신뢰성, 운전성 등의 요구에 엄해진 반면 흡기포트내(PI), 혹은 흡기관 중양부 내(SPI) 가솔린분사방식에 눌려서 가변벤투리식 등도 미국(1982), 일본(1983)에서 발표되었으나 1985년형의 미국차 엔진에는 기화기의 정착율이 50%에 지나지 않는등승용차용 분야에서는 그 사용이 점차 줄어두는 추세에 있다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.24 no.4
• /
• pp.421-426
• /
• 2000

A study on the combustion and exhaust emissions characteristics of diesel engine with various suction air humidity is performed experimentally. In this paper, suction air humidity is changed from RH 50% to RH 90%, the experiments are performed at engine speed 1800rpm, and main measured parameters are cylinder pressure, fuel consumption rate, CO, HC, NOx and Soot emissions etc. Increase of suction air humidity from RH 50% to RH 90% does not effect specific fuel consumption, decreases maximum pressure in cylinder, ratio of maximum pressure rise and net heat release, and delays ignition timing. Also, that increases CO and HC emissions, decreases NOx emissions, but does not constant in changing tendency on emission.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.8 no.1
• /
• pp.71-78
• /
• 1984

본 논문은 왕복동 내연기관의 방열에 관한 연구의 하나로서 디이젤 기관 실린더 헤드와 흡 배기 밸브의 온도 분포와 열유속의 분포를 구한 것이다. 방열 해석은 기관의 정상 작동된 다음의 실린 더 헤드의 열부하가 일정하다고 생각하여 실린더 헤드의 밸드 시이트 양단의 온도와 연소 가스 배출 온도, 흡기 및 냉각수 온도를 측정하고 온도분포 및 열유속을 유한요소법을 적용하여 구하 였다. 본 연구의 결과 실린더 헤드 및 밸브의 과부하는 밸브의 경우에는 밸브 헤드 중심과 밸브 헤드 중심 부근에서 일어나며, 실린더 헤드의 경우에는 헤드 중심부 표면에서 발생하였다. 흡 배 기 밸브 및 물재킷부의 온도 분포 및 열유속의 분포를 주어진 냉각수 온도 조건에 대하여 구한 후 이들을 비교 검토 하였다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.8
• /
• pp.1050-1056
• /
• 2010

Diesel engines introduce only air into the cylinder, and the air is high lycompressed. Fuel is directly injected into the combustion chamber in high temperature and pressure. Therefore diesel engines have high thermal efficiency because of the high compression ratio, while having high level of particulate matter and nitrogen oxide emissions because of the direct fuel injection. Many technologies have been developed to reduce particulate matter and nitrogen oxide emissions from diesel engines. One of the technologies is hydrogen fuel introduced into the combustion chamber with diesel fuel. In this thesis tiny amount of hydrogen is supplied into the combustion chamber in order to enhance the combustion performance. The engine, in which hydrogen is introduced, is tested. There are 20 test conditions given as 5 torque values of 100%, 75%, 50%, 25%, 0%, and 4 engine speeds of 700rpm, 1000rpm, 1500rpm and 2000rpm for the two cases with or without hydrogen addition. Maximum torques and Idle torques at each engine speed are measured, then the torque values are divided into 4 levels with 25% increasing step. The result shows that the fuel consumption, smoke, CO are reduced while the NOx emission is slightly increased, and the hydrogen addition has not a great effect on the performance at low loads but a great effect at a maximum load.

• Tuberculosis and Respiratory Diseases
• /
• v.53 no.3
• /
• pp.332-336
• /
• 2002

Bacterical tracheitis is a very rare complication in adults after endotracheal intubation. We report a case of bacterial tracheitis associated with endotracheal intubation and corticosteroids. The patient was discharged with a permanent tracheostomy, and a resection and an end-to-end anastomosis of the trachea is planned.