• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.6 no.2
• /
• pp.155-165
• /
• 1994

In this study, the following factors are investigated from experiments for a vertical parallel plate heat exchanger under the frosting condition ; the growth of frost layer, the characteristics of heat and mass transfer, the change of mass flow rate of the air passing through the heat exchanger, and the pressure drop of the air in the heat exchanger. The amount of heat and mass flux of water vapor transferred from the air stream to the heat exchanger surface is large at the early stage of frosting and then decreases dramatically, and the extent of decreasing rate becomes moderate with time. The frost layer formed near the inlet of the heat exchanger is thicker and denser than that formed near the outlet. It is found that the gradient of the amount of frost along the flow direction increases with time. In the early period of frost formation, the thermal resistance between the air and the cooling plate increases dramatically and then the extent of change decreases with time. Initially the convective thermal resistance is dominant. Then, while the convective thermal resistance decreases with time, the conductive thermal resistance continues to increase with time and finally the conductive thermal resistance becomes dominant.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.2
• /
• pp.199-203
• /
• 2012

This paper introduces a simple new procedure approach to determine the permittivity of dielectric slabs. The method uses a parallel plate waveguide which supports a TEM mode. The presence of the dielectric slab placed at the bottom of the waveguide makes the speed of the TEM wave slower. The relationship between the change of the speed and the permittivity of the dielectric slab allows the determination of the permittivity. The relationship is analyzed electromagnetically, and the results of measurements are in good agreement with the analysis.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.1614-1617
• /
• 2003

Actuator being used in the ship supplies engine with air. When actuator is out of order, engine is not operated. This out of order is due to fracture of piston or rotating of spindle in the case of plastic deformation of parallel part in locking plate. For this reason, locking plate must be guaranteed enough strength. Therefor in this paper, the effects of changes with the clearance of between spindle and parallel part, the contact height of parallel part and spindle, the side circle diameter of parallel part and the width of locking plate in the designated torque are investigated. The result of this investigation shows the relation between locking plate and spindle.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.6 no.2
• /
• pp.11-18
• /
• 1995

The goal of this research is to get a measuring system for absorption characteristics of electromagnetic wave absorbers in fernite type which are flat, grid-type and special type, etc. It is, however, very difficult to measure the absorption characteristics in as low frequency as 30 MHz. To solve the problem, therefore, we propose a standing wave method and a measurement method in time domain using paralledl striplines, construct the measuring system, and measure the charac- teristics of ferrite microwave absorbers in grid type using the proposed measuring system.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.10
• /
• pp.32-38
• /
• 1997

A characteristic mode analysis of parallel-plate waveguide with finite number of slot as a leaky wav eantenna structure is considered for calculating the characteristics currents, the characteristic patterns, radiatin patterns, and the complex propagation constants. For the cases of 1, 11 and 29 slots, numericl resutls for the equivalent magnetic currents, the radiatin patterns, and thecomplex propagation constants are computed and compared with those obtained by use of the conventional method of moments. Good correspondence between them is observed.

• Journal of Advanced Marine Engineering and Technology
• /
• v.28 no.3
• /
• pp.509-515
• /
• 2004

The PIV(Particle Image Velocimetry) with liquid crystal tracers is used for visualizing and analysis of the mixed convection in the parallel plates with the upper part cooled and the lower part heated. It is found that the flow pattern of mixed convection in the parallel plates can be classified into three patterns which was affected by Reynolds number. Also, the periodic nature is confirmed, and visualized in experiment.

• Proceedings of the KSME Conference
• /
• 2002.08a
• /
• pp.691-694
• /
• 2002

The most unstable situation of laminar plane Poiseuille flow for transition to turbulence is investigated by using a pseudo-spectral method. A number of various disturbance modes are tested and it is found that the flow is the most unstable when it is disturbed by an oblique wave with an angle of $29.7^{\circ}$.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1436-1437
• /
• 2008

In this work, we investigate the electrical and electromagnetic behaviors of the power-bus with a variety of shapes of aperture, on the signal integrity, using a rigorous methods(Modal or MoM) along with Modal analysis method.

• Proceedings of the SAREK Conference
• /
• 2003.07a
• /
• pp.55-55
• /
• 2003

• Proceedings of the SAREK Conference
• /
• 2004.06a
• /
• pp.17-17
• /
• 2004