• Korean Journal of Optics and Photonics
• /
• 제10권5호
• /
• pp.430-438
• /
• 1999

We have utilized soft-aperturing by gain media to develop a high-power tunable Ti:Sapphire laser with sub-40-fs and broad tuning range. The tunable spectral range was only limited by the bandwidth of mirrors. We made use of knife-edge slits near an intra-cavity prism controlled by micro-stepping-motors to tune the center wavelength continuously. The tunability of the center wavelength was ranged from 770 nm to 870 nm, and the measured pulsewidth was sub-40 fs throughout the above spectral range. The shortest pulsewidth was about 17 fs at the center wavelength of 820 nm and the spectral bandwidth was 72 nm. At 5 W pumping power of the Ar-ion laser we obtained average output power of 440 mW~580 mW. For the cw and Kerr-lens mode-lodking conditions, we have evaluated the value of an amplitude modulation to be ${\gamma}=2.5{\times}10^{-8}/W$ from the calculated waists of a Gaussian beam on the Ti:sapphire crystal surface. Using this result we demonstrate that the generation of sub-40-fs Kerr-lens mode-locked pulse can be described by the Ginzberg-Landau model which is a weak pulse shaping model.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 한국해양정보통신학회 2007년도 추계종합학술대회
• /
• pp.271-274
• /
• 2007

본 연구는 $1.3{\mu}m$ 파장의 초고속 Nd:YAG레이저 펄스를 얻기 위해 AOM을 이용하여 모드록킹 Nd:YAG레이저 공진기를 구성하였다. 여기용 반도체 레이저는 중심파장 810nm, 출력 1.2W이며, 레이저 매질은 직경 3mm, 길이 10mm로 $Nd^{3+}$가 1.0at%로 도핑된 Nd:YAG Rod를 사용하였다. 모드록킹에는 음향광학 변조기(변조 주파수 40MHz)를 사용하여 펄스폭 ${\tau}p=80ps$의 극초단 펄스를 얻었다.

• Proceedings of the KIEE Conference
• /
• 대한전기학회 1983년도 하계학술회의강연.논문초록집
• /
• pp.25-27
• /
• 1983

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• 제39권5호
• /
• pp.43-50
• /
• 2002

To improve the current waveform of diode rectifiers, we propose a new operating principle for the voltage -doubler diode rectifiers. In the conventional voltage-doubler rectifier circuit, relatively large capacitors are used to boost the output voltage, while the proposed circuit uses smaller ones and a small reactor not to boost the output voltage but improve the input current waveform. A high input power factor of 97[%] and an efficiency of 98[%] are also obtained. The harmonic guide lines of proposed rectifier is no interfered with inverter switching, resulting in a simple, reliable and low-cost ac-to dc converters in comparison with the boost-type current-improving circuits.It compared conventional pulse-widthmodulated(PWM)inverter with half pulse-widthmodulated (HPWM) inverter. Proposed HPWM inverter eliminated dead-time by lowering switchingloss and holding over-shooting.

• The Transactions of the Korean Institute of Power Electronics
• /
• 제4권5호
• /
• pp.397-404
• /
• 1999

In this paper, several control methods for the discontinuous mode PWlvl-SRC are investigated with the l linearized small signal model. In order to analyze the stability and dyncunic characteristics of the controlled s system, the root locus as a function of the normaliz떠 output current(]\iOC) for a given normalized output v voltage(NOV) is employed. FurLhem10re, in this paper, the “Optimal trajectory control of PWM-SRC" is newly p propos(xl and its good dvnamic performances are evaluated with other four control laws.laws.

• Journal of the Korean Society for Railway
• /
• 제13권6호
• /
• pp.559-564
• /
• 2010

This paper proposes an advanced filter design to improve power quality of a head electric power (HEP) as a power conversion unit in centralized-power type electric railway vehicle. First of all, we have measured waveform of output power of transformer connected HEP to design the filter. Throughout experiment and simulation results, it is estimated that switching technique used HEP is advanced selected harmonic elimination PWM (SHEPWM) and the applied switching frequency is about 300Hz. In this paper, a filter to improve power quality considering estimated parameters is designed. As a result, the reduction of the magnitude of the overall harmonic is achieved and confirmed through simulations.

• Journal of the Korean Society of Propulsion Engineers
• /
• 제10권2호
• /
• pp.95-101
• /
• 2006

A fuel metering unit using PWM(Pulse Width Modulated) solenoid valve has some advantages such as low cost, small size and simple structure. The mathematical model and its experimental rig of the fuel metering unit using PWM solenoid valve and CPDV(Constant Pressure Drop Valve) for miniature turbo engines were constructed. As the results of simulation, some major parameters which have dominant effects on the performance were found. And the experimental results verified the validity of established model by showing the good agreement with the numerical simulation results. Hence, this system modeling could be used effectively in the actual development of a PWM fuel control system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• 제42권3호
• /
• pp.649-660
• /
• 2017

In electronic warfare, the pulse amplitude, one of information of a pulse signal emitted by an enemy, is used for estimating distance from the source and for deinterleaving mixed source signals. An estimate of pulse amplitude is conventionally determined as the maximum magnitude of a Fourier transformed signal within its pulse width which is estimated pre-step in an electronic warfare receiver. However, when frequency modulated signals are received, it is difficult to estimate their pulse amplitudes with this conventional method because the energy of signals is dispersed in frequency domain. In order to overcome this limitation, this paper proposes an enhanced pulse amplitude estimation method which calculates the average power of the received pulse signal in time domain and removes the noise power of the receiver. Simulation results show that even in case the frequency modulated signal is received, the proposed method has the same performance as estimating the pulse amplitude when unmodulated signal is received. In addition, the proposed method is shown to be more robust to an estimation error of pulse width, which affects the estimation performance of pulse amplitude, than the conventional method.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• 제9권4호
• /
• pp.861-864
• /
• 2005

In this paper, we system the system design and numerical analysis of the ultrafast optical delay line using by optical phase modulator. The numerical analysis carried out with 1310nm, lops laser and electro-optic phase modulator. As the results of numerical analysis, we show a scanning rate of 0.5 GHz and a delay range of 19.0ps. Compare with mechanical delay line, the optical delay line has a high scanning speed and a high repetition rate.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 한국해양정보통신학회 2005년도 춘계종합학술대회
• /
• pp.438-440
• /
• 2005

광위상변조기를 이용하여 OCT용 초고속 광지연단을 설계하고 수치해석을 수행하였다. 수치해석은 electro-optic 위상 변조기에 1310nm, 10ps의 펄스폭을 갖는 레이저 광원을 적용하여 수행하였다. 수치해석결과로 500MHz의 변조 주파수일때 19ps의 시간 지연을 얻었으며, 이는 기존의 기계적 검출방식(수십kHz)의 OCT장치에 비해 1000배이상 빠른 검출이 가능할 것으로 예상된다.