• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.37 no.11
• /
• pp.1053-1060
• /
• 2013

The purpose of this study is to estimate the packing friction of power-operated valve in nuclear power plants. The roll of packing in valve is preventing leakage through stem. Packing friction is highly depend on gland nut tightness which means higher reliability in sealing is lower operability. For the estimation of friction, we used statistical analysis and experimental analysis. In experimental approach, we have performed packing fY test and applied it to valve field test. In statistical approach, we have used 10 years DB of safety-related valve in nuclear power plant and analyzed packing friction based on confidence interval of sample. The comparison of two results shows that statistical analysis for packing friction are more accurate than fY analysis even though both approach have error compared to measured value but we confirmed that statistical approach is proper way to estimate packing friction.

• Journal of the Korean Institute of Gas
• /
• v.11 no.1 s.34
• /
• pp.34-39
• /
• 2007

In this paper, the FEM result has been presented for a sealing safety between a valve packing and a valve seat during a open and close operation in a LPG cylinder. The sealing operation of a LPG valve is completed when the valve packing in which is made by a nylon-66 polymer is to stop a LP gas flow, which flows out from the outlet of a brass pipe in a LPG cylinder. The contact sealing mechanism of the valve may be classified by a flat contact of an unused valve packing and a circular groove contact of an used valve packing in a current LPG valve. Based on the FEM and experimental investigations the sealing force, 4.9 MPa for a flat contact mode of the unused valve packing is a little high compared to that of the used valve packing, which shows a circular groove contact geometry against a valve seat. But these sealing pressures for two contact modes are very low compared to the ultimate strenath 83 MPa of the nylon-66 and this may be designed with a excess strength of the valve.

• Proceedings of the KSME Conference
• /
• 2001.06e
• /
• pp.613-618
• /
• 2001

For the evaluation of operability of MOV(Motor Operated Valve), the precision prediction of thrust/torque acting on the valve is important. In this paper, the analytical prediction method of thrust/torque was proposed. The design basis stem thrust calculation typically considers the followings: Packing thrust, Stem rejection load, design basis differential pressure load. In general, test results show that temperature, pressure, fluid type, and differential pressure, independently and combination, all have an effect on the friction factor. The prediction results of thrust/torque are well agrement with dynamic test results.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.40 no.6
• /
• pp.613-619
• /
• 2016

A pneumatic control valve performs a major role in controlling the flow of a system or the level of a key tank in many power plants, and its performance should be guaranteed during the plant's lifetime. Its operation starts by supplying air to the pneumatic actuator or by exhausting the air from the actuator. To control the valve position, the amount of air supply or exhaust is adjusted by a control loop where various accessaries are equipped. In this paper, air leakage in the air supply line, changes in the valve packing force, and false adjustments of zero and the span of the positioner are simulated and analyzed using a 2-in pneumatic valve with a position control loop including an I/P converter and positioner, where the valve position is controlled within ${\pm}2%$ of the control pressure at 67% opening position.