• Journal of Bio-Environment Control
• /
• v.22 no.3
• /
• pp.270-278
• /
• 2013

The objective of the present study is to provide data needed to decide covering method to be able to increase the thermal insulation and light transmittance efficiency of commercial greenhouse. The thermal insulation effect, PPF transmittance and quantity of condensation water were estimated in experimental tomato greenhouses covered with three types of coverings of single layer, air inflated and conventional double layers covering. The overall heat flow of air inflated double layers greenhouse was similar to that of conventional double layers greenhouse, but the temperature between covering material and thermal screen in air inflated double layers greenhouse was lower than that in conventional double layers greenhouse at the same outside temperature condition due to air leakage through the gap of roof vent. The overall heat transfer coefficients acquired by experiment that was performed in single layer and conventional double layers greenhouses were close to those obtained from model experiment. Even though the PPF transmittance of air inflated double layers greenhouse was lower than that of single layer greenhouse, which was greater than that of conventional double layers greenhouse. The quantity of condensation water on covering surface of single layer greenhouse was greater than that of air inflated double layers greenhouse due to lower covering surface temperature.

• Journal of the Korean Chemical Society
• /
• v.30 no.5
• /
• pp.488-492
• /
• 1986

The $Ca^{++}$ and $Mg^{++}$ released during Ca, Mg-Na exchange on Kampo 78 montmorillonite which was treated with various concentrations of NaCl solution, were measured with EDTA titration metbod in the leaching solutions. Lanthanide montmorillonite was prepared with various neutral lanthanide ions from sodium montmorillonite in which the exchangeable ions are displaced from the exchanger, such as the displacement of $Na^+$ by $Ln^{3+}$ ions, Cation exchange capacity (CEC) is determined on remaining lanthanides in the leaching solutions with E. D. T. A titration method. As a results of this study, there were no difference of C. E. C in series of lanthanide contraction, but C. E. C depends on charge density of montmorillonite. When we conformed the structure of Ln-montmorillonite by X-ray diffraction. It was found that there was much difference of pattern between Na-montmorillonite and Ln-montmorillonite.

• Journal of KIISE:Information Networking
• /
• v.32 no.4
• /
• pp.525-534
• /
• 2005

This paper is concerned with the query slipping and its prevention for trajectory-based matchmaking service in wireless sensor networks. The problem happens when a query propagating along a subscribe trajectory moves through a publish trajectory without obtaining desired information, even though two trajectories intersect geometrically. There follows resubmission of the query or initiation of another subscribe trajectory Thus, query slipping results in considerable time delay and in the worst, looping in the trajectory or query flooding the network. We address the problem formally and suggest a solution. First, the area where nodes are distributed is logically partitioned into smaller grids, and a grid-based multicast next-hop selection algorithm is proposed. Our algorithm not only attempts to make the trajectory straight but also considers the nodal density of recipient nodes and the seamless grid-by-grid multicast. We prove that the publishing and subscribing using the algorithm eventually eliminate the possibility of the slipping. It toms out that our algorithm dissipates significantly less power of neighbor nodes, compared to the non grid-based method, as greedy forwarding, and the fixed- sized grid approach, as GAF (Geographical Adaptive Fidelity)

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.1
• /
• pp.107-119
• /
• 1991

This dissertation analyzes the running mechanism of flexible and thin tape above rotating head through the experiment. The scope of study is confined to measure the vertical deformation of running tape under hydrodynamic pressure invoking phenomena of elasto-hydrodynamic lubrication between the protruded bump on a rotating cylinder ad the running tape. Experimental system is devised to measure the vertical deflection of the running tape by opto-electronical displacement gauge, which enables to detect microscopic surface deflection of high frequency. Thorough the tests of small specimens of groove and bump, the accuracy and reliability of this experimental method is confirmed and achieved an accuracy within 5%(2.mu.m) error for the microscopic deflection with high frequency. In experimental works, the effects of bump size on flying characteristics of the tape were evaluated and examined. For the vertical deformation of the running tape. the numerical results and its trend agree qualitatively with the experimental ones.

• The Journal of the Korea Contents Association
• /
• v.7 no.9
• /
• pp.44-53
• /
• 2007

The purpose of this study is to identify the most efficient expression method by analyzing advertising expression method by 16 types of product in internet advertising. First of all, It made inquiries about expression method and attitude of internet advertising for this study and identified a conception, characteristics, and types of internet advertising through literature reviews about internet advertising. This study offered expression the korean alphabet, hangout about banners ads, sponsorship ads, interstitial ads and pop-up ads. This study analyzed advertising expression, advertising effectiveness and advertising attitude by 16 types of product in internet advertising. In conclusion, the marketers of internet advertising have to effort to make internet advertisements that suit their advertising purpose by using the right expression method of internet advertising because they know internet advertising are quite different the expression method, advertising effectiveness, and advertising attitude. And they have to convert negative attitude or medium size attitude of internet advertising into positive attitude in the future.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.3
• /
• pp.1664-1670
• /
• 2015

As journal bearing has a sliding motion between the shaft and bearing with lubricating oil, it produces a hydrodynamic lubrication condition. Journal bearing can receive a large force because it takes a distributed load at the large friction face. As the oil groove or oil hole is made in the journal bearing surface for the journal bearing smoothly working under a hydrodynamic lubrication condition, sufficient lubricating oil is supplied through the clearance of journal bearing. The performance of the journal bearing is changed according to the shapes, sizes and positions of an oil groove. In this paper, the flow rate according to the oil groove shapes (triangle, semicircle and rectangle) among the various oil supply conditions was measured. The shape that discharges the highest flow rate was observed and the groove shape of optimal performance for the journal bearing was determined. The results showed that the flow rate increases with decreasing operating temperature, the influence of temperature on the flow rate decreased with increasing rotational speed, and flow rate in the triangular groove shape was greater than in other shapes.

• Journal of Environmental Health Sciences
• /
• v.44 no.4
• /
• pp.360-369
• /
• 2018

Objectives: Outdoor tobacco smoke can penetrate into the indoor environment through cracks in the building envelope. This study aimed to characterize the particle size distribution of infiltrated secondhand smoke (SHS) through the gap in a single glazed and a secondary glazed window according to pressure differences in a chamber. Methods: Two polyvinyl chloride sliding windows were evaluated for infiltration, one with a glazed window and the other with a secondary glazed window. Each window was mounted and sealed in a polycarbonate chamber. The air in the chamber was discharged to the outside to establish pressure differences in the chamber (${\Delta}P$). Outdoor smoking sources were simulated at a one-meter distance from the window side of the chamber. The particle size distribution of the infiltrated SHS was measured in the chamber using a portable aerosol spectrometer. The particle size distribution of SHS inside the chamber was normalized by the outdoor peak for fine particles. Results: The particle size distribution of SHS inside the chamber was similar regardless of window type and ${\Delta}P$. It peaked at $0.2-0.3{\mu}m$. Increases in particulate matter (PM) concentrations from SHS infiltration were higher with the glazed window than with the secondary glazed window. PM concentrations of less than $1{\mu}m$ increased as ${\Delta}P$ was increased inside the chamber. Conclusions: The majority of infiltrated SHS particles through window gap was $0.2-0.3{\mu}m$ in size. Outdoor SHS particles infiltrated more with a glazed window than with a secondary glazed window. Particle sizes of less than $1{\mu}m$ were associated with ${\Delta}P$. These findings can be a reference for further research on the measurement of infiltrated SHS in buildings.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.8 no.5
• /
• pp.488-497
• /
• 1984

In the assembling process by industrial robots, many difficulties stem from the fact that the assembly operation is impossible or the parts to be assembled can be damaged by reaction forces due to even little misalignment in part mating. In this paper a flexible and sensible robot wrist is developed to make possible the precision insertion operation. The flexibility of the developed wrist were evaluated both analytically and experimentally in actual insertion process. The results show that without the use of feedback control the wrist is capable of doing insertion operations with a small clearance at a low inserting force. For smaller clearance the assembly process was devised involving insertion force feedback and a control algorithm for this active accommodation was developed. The simulation results show that if the active feedback control is used the insertion action can be performed with much less force, as compared with a passive accommodation method.

• Korean Journal of Plant Taxonomy
• /
• v.35 no.4
• /
• pp.287-294
• /
• 2005

Three unrecorded fern species from the flora of Korea, Nephrolepis cordifolia, Athyrium epirhachis, and Asplenium castaneo-viride, are reported here. Nephrolepis cordifolia, recognized as introduced species and cultivation in Korea until now, is found in the wild at the entrance of small cave in Jeju island. Athyrium epirhachis is found under the Quercus acuta forest at about 400 - 500 m alt. in Jeju island. This species is similar to A. otophorum but different from the latter by having once pinnately divided leaf blade and the decurrent base of ultimate segment. Asplenium castaneo-viride is hybrid between A. ruprechtii and A. incisum and is distinguished from parental species by presence of proliferation, shape of leaf blade, pattern of venation, and leaf texture.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.1
• /
• pp.5-12
• /
• 2011

In this study, correlation between measured deformation modulus using pressuremeter and RMR value conducted in 10 sites is analyzed, and applicability of the conventional empirical formulas to the rock masses in Korea are analyzed, It is found that if RMR is below 40, the correlation between deformation modulus and RMR accords Kim Gyo-won's formula and Aydan, Serafim and Pereira's one well, but if the RMR exceeds 40, the correlation was lower than those from the formula. Such results may be attribute to the fact that during classification of RMR, scores are weighed relatively more in joint conditions and apertures than such highly correlational items as uniaxial compression strength or RQD, and RMR would not be evaluated qualitatively due to different weathering degrees and rock mass types as well as engineers' personal errors. Sandstone among sedimentary rocks are quite well accord with suggested equation, but correlation of other rocks are due to large variance. In this study, correlation expressions of various rocks are proposed as the function of exponential based on the field test data.