• Proceedings of the KIEE Conference
• /
• 1991.11a
• /
• pp.427-430
• /
• 1991

In this study, in order to observe treeing of prebreakdown phenomena, time variation of acoustic emission properties due to initiation and propagation of tree in LDPE was investigated under AC voltage. The experimental results were as following, pulse number and average amplitude of AE were increased along with near breakdown rather than tree initiation, also, according to increasing of applied voltage, tree propagation was blunted, while pulse number and average amplitude of AE was promoted. In each applied voltage, ${\phi}-a$ distributions during propagation of tree were changed to special patterns, skewness S and kurtosis K reflected well time variation of ${\phi}-a$ distribution patterns. It is thought that initiation and propagation state of tree can be easily monitored, so long as time variation of pulse number and average amplitude of AE, skewness Sand kurtosis K of ${\phi}-a$ distribution are always monitored.

• Proceedings of the KIEE Conference
• /
• 1998.11c
• /
• pp.901-903
• /
• 1998

Crosslinked Degree is an important factor to determine dielectric property of crosslinked polyethylene(XLPE) used for the insulation material in power cables. Recently, though it is necessary to investigate electrical properties according to crosslinked degree as a part of the whole characterization of cable. it is not examined closely. In this study, crosslinked degree of samples were measured according to temperature and holding time of crosslinking, electrical tree characteristics of these samples were analyzed by crosslinked degree and applied temperature that was changed from normal temperature to operating temperature of power cables. As a result. when the crosslinked degree was low, dielectric properties were decreased and influence of temperature was increased. but the crosslinked degrees were high. initiation voltages of treeing were increased and dielectric properties were improved. It is proved that the optimum. crosslinked degree was one of most important factor for aging time and residual lifetime of power cable.

• Magazine of the Korea Concrete Institute
• /
• v.2 no.1
• /
• pp.79-90
• /
• 1990

The purpose of this paper is to study on the effect of cutting off tension bars in reinforced concrete beams. that is, the ultimate strength, the failure mode and thl} tension stress distribution through the span. To achieve this purpose, a full-scale frame and seven small scale model beams (five rectangular and two T-section beams) were tested. The four main model specimens and two speciml}ns without cutting off tension bars 1,'{ere analyzed as plane stmss element with package program ADINA. As a result of test and analysis, the shorter' distance bet ween the reaction point and the cutting off point, the higher the ultimate strength of a bl}am will be when other physical properties are equal.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.29 no.3
• /
• pp.187-196
• /
• 2009

The objectives of this study were to evaluate the different cutting dates on the changes of feed quality among five cereals (barley, wheat, rye, triticale and oat) for whole crop silage. Field trials were conducted at paddy field in Yesan, Chungnam Province and the aerial parts were clipped 10 days from 15 March to 15 June. Changes of acid detergent fiber (ADF) content in relation to different cutting dates was described by a quadratic curve for 5 winter cereals crops. ADF content reached a maximum at 5 days after heading in barley cultivar 'Youngyang', 7 days in wheat 'Keumkang', 18 days in rye 'Gogu', 1 days in triticale 'Shinyoung' and 10 days in oat 'Samhan'. Neutral detergent fiber (NDF) content were linearly increased as growing after overwintering and stagnated or slightly decreased after heading. The crude protein were linearly decreased throughout the growth period of 5 whole crop cereals. Digestible dry matter (DDM) content were decreased from early stages to heading and subsequently increased as grain filling. Relative feed value (RFV) for 5 crops were decreased as growing and subsequently increased as grain filling after heading. Barley cultivar for only forage use 'Youngyang' were lower at ADF and NDF content and higher at DDM and RFV after heading than those of other cereals for forage use. So, barley for whole crop silage was a good crop with high feed quality and high proportion of spikes compared with other winter cereal crops. Wheat cultivar for grain 'Keumkang' were higher at crude protein than those of other four cereals from overwintering to maturing and were higher at DDM and RFV after heading than those of rye, triticale and oat. Rye cultivar with cold tolerant and high fresh yielding 'Gogu' were highest at ADF and NDF content and lowest at DDM content and RFV. So, rye was a crop with low quality for forage use compared to other winter cereal crops. Triticale cultivar with flourishing and high yielding 'Shinyoung' was intermediated between barley and rye, and were linearly increased at DDM yield by different cutting dates. Oat cultivar with cold tolerant and high tillering 'Samhan' were lower at ADF and NDF content and higher at crude protein before heading, but after heading, there are not especially advantages compared to barley, wheat or triticale.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.30 no.3
• /
• pp.301-309
• /
• 1985

This experiment was conducted to know a substantial body of information about the differences of the important forage characteristics; green fodder yield, dry matter yield, TDN%, TDN yield and so forth of the seven cultivars selected as the forage crops (Rye, Triticale, Wheat and Barley) depending on the specific times of cutting stage, on the Wheat and Barley Research Institute from October, 1983 to June, 1984, and the results summarized as follows. Green fodder yield & dry matter weight, when clipped at 20, 30 April and 10 May, of varieties Homil #2 showed the most yielding capacity, but when clipped at 20 May, Suweon#8 (triticale) showed the most green fodder yield whereas Homil #1 the most significant dry matter weight. Plant height, in the cases of Paldanghomil, Homil #1 & Homil #2, showed distinctly longer than that of Bunong, Suweon #8 & Suweon #9 and continued to grow even after the heading date. Dry matter ratio increased with time (Dry matter yield/green fodder yield x100). TDN % decreased but TDN yield increased with time but Homil #1, Homil #2 and Paldanghomil showed relatively the higher values. In the elements of nutrient of cell wall, Suweon #8 & Bungong among 7 cultivars have good quality. The reasonable clipping date of wheat &barley as green fodder crops are 10 May to 20 May, but if clipped before 10 May and 20 May, Homil #2 and Suweon #8 became the promising forage crops, respectively.

• Journal of Korean Society of Transportation
• /
• v.28 no.4
• /
• pp.19-30
• /
• 2010

It has become important to have some proper guidelines of how to provide public transport information services in response to the rapid IT developments and the wide spread of public information services. The current study takes a contextual approach to the analysis of public transportation information use under a dynamic decision situation, complementing the conventional cross-sectional approaches. Using the CHAID of decision tree induction based on decision table formalism applied to the survey data of activity travel and information use, the study found that the information type and medium choices are strongly affected by the decision contexts in addition to the individuals' socio-demographic characteristics. The results suggest an important implication to the market segmentation of information services for public transportation.