• Journal of the Korean Electrochemical Society
• /
• v.14 no.4
• /
• pp.214-218
• /
• 2011

The electrochemical characteristics and performance of redox flow battery using the soluble lead has been evaluated. Cyclic voltammetry was performed on the materials to evaluate deposition and dissolution of lead and lead dioxide. In the negative region, a reduction peak is not observed, and on the reverse scan, on-set voltage is observed at -0.47 V(vs SCE). In the positive region, the distinct peak is observed on the forward and reverse scan. The charge/discharge experiments were carried out graphite electrode in the beaker cell. The charging(deposition) of lead occurs at around 0.5 V(vs SCE) and discharging(dissolution) of lead occur at around 0.25 V(vs SCE). The potential difference is about 0.25 V. The charging(deposition) of dioxide lead is at 1.77 V(vs SCE) and discharging(dissolution) is at around 0.95 V(vs SCE) during first cycle. On subsequent cycles, the charging of dioxide lead starts at below 1.5 V(vs SCE), after a period the voltage increase to 1.7 V(vs SCE). The voltage of discharging is stable at around 1.0 V(vs SCE).

• Journal of the Korean Electrochemical Society
• /
• v.11 no.2
• /
• pp.125-129
• /
• 2008

Rechargeable lithium-ion polymer batteries have been considered to be next-generation power sources for portable electronic devices and electric vehicles. In this work, we tried to improve the cycling performances of lithium-ion polymer cells by coating aluminum fluoride and acrylonitrile-methyl methacrylate copolymer to the polyethylene separator. It was found that the addition of aluminum fluoride to the surface-modified separator reduced the interfacial resistances and thus the cell exhibited a less capacity fading and better high rate performance. The cell showed an initial discharge capacity of 150 mAh/g and good capacity retention at 0.5 C rate.

• Journal of the Korean Electrochemical Society
• /
• v.19 no.1
• /
• pp.21-27
• /
• 2016

Vanadium redox flow batteries (VRFBs) using the electrolytes containing various vanadium ions in sulfuric acid as supporting solution are one of the energy storage devices in alternatively charging and discharging operation modes. The positive electrolyte contains $V^{5+}/V^{4+}$ and the negative electrolyte $V^{2+}/V^{3+}$ depending on the operation mode. To prevent the mixing of two solutions, proton exchange membranes are mainly used in VRFBs. Nafion 117 could be the most promising candidate due to the strong oxidative property of $V^{5+}$ ion, but causes high crossover of electroactive species to result in a decrease in coulombic efficiency. In this study, the composite membranes using Nafion ionomer and porous polyethylene substrate were prepared to keep good chemical stability and to decrease the cost of membranes, and were compared to the properties and performance of the commercially available electrolyte membrane, Nafion 117. As a result, the water uptake and ionic conductivity of the composite membranes increased as the thickness of the composite membranes increased, but those of Nafion 117 slightly decreased. The permeability of vanadium ions for the composite membranes significantly decreased compared to that for Nafion 117. In a single cell test for the composite membranes, the voltage efficiency decreased and the coulombic efficiency increased, finally resulting in the similar energy efficiency. In conclusion, the less cost of the composite membranes by decreasing 6.4 wt.% of the amount of perfluorinated sulfonic acid polymer due to the introduction of porous substrate and lower vanadium ion permeability to decrease self-discharge were achieved than Nafion 117.

• Clean Technology
• /
• v.22 no.4
• /
• pp.308-315
• /
• 2016

$SiO_x/ZnO$ composites were prepared from sol-gel method for excellent cycle life characteristics. The composites were coated by PVC as a carbon precursor. ZnO removal to create a void space therein was able to buffer the volume change during charge and discharge. To determine the crystal structure and the shape of the synthesized composite, XRD, SEM, TEM analysis was performed. The carbon contents in the composites were confirmed by TGA. The pore structure and pore size distribution of the composite was measured with the BET specific surface area analysis and BJH pore size distribution. Enhanced electric conductivity by carbon addition was determined from powder resistance measurement. Electrochemical properties were measured with the AC impedance and the charge and discharge cycle life characteristics. When carbon was coated on the $SiO_x/ZnO$ sample, the electrical conductivity and the discharge capacity were increased. After removal of ZnO with HCl the surface area of the sample was increased, but the discharge capacity was decreased. $SiO_x/ZnO$ sample without acarbon coating showed very low discharge capacity, and after carbon coating the sample showed high discharge capacity. For cycle life characteristics, $C-SiO_x/ZnO$ composite (Zn : Si : C = 1 : 1 : 8) with a capacity of $815mAh\;g^{-1}$ at 50 cycle and 0.2 C has higher capacity than existing graphite-based anode materials.

• 한국전기화학회:학술대회논문집
• /
• 2002.10a
• /
• pp.54-54
• /
• 2002

• 한국전기화학회:학술대회논문집
• /
• 1999.10a
• /
• pp.60-60
• /
• 1999

• 한국전기화학회:학술대회논문집
• /
• 2002.04a
• /
• pp.41-41
• /
• 2002

• 한국전기화학회:학술대회논문집
• /
• 2000.10a
• /
• pp.32-32
• /
• 2000

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 1998.11a
• /
• pp.186-191
• /
• 1998

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.25 no.2
• /
• pp.74-79
• /
• 2015

$Na-ZnCl_2$ battery, which operates as the same mechanism of $Na-NiCl_2$ battery using solid-electrolyte, is able to reduce its material cost by 40 % comparing to the $Na-NiCl_2$ battery. It has been known that the $Na-ZnCl_2$ battery produces $Na_2ZnCl_4$ as an intermediate phase during charge/discharge process. Therefore, the redox process is divided into four steps having the voltage range of 1.92~2.13 V. However, effects of the critical factors such as the composition of cathode materials, depth of charge and discharge, and additives have not been reported yet. We examined the effect of the Zn/NaCl ratios and revealed that its optimum ratio was in the range of 1.3~1.7.