• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.2
• /
• pp.169-172
• /
• 2019

Frequency-modulated continuous wave(FMCW) radars with array antennas are widely used because of their light weight and relatively high resolution. A usual approach for the joint range and angle estimation of a target using an array FMCW radar is to create a range-angle matrix with the deramped received signal, and subsequently apply two-dimensional(2D) frequency estimation methods such as 2D fast Fourier transform on the range-angle matrix. However, such frequency estimation approaches cause bias errors since the frequencies in the range-angle matrix are not independent. Therefore, we propose a new maximum likelihood-based algorithm for joint range and angle estimation of targets using array FMCW radar, and demonstrate that the proposed algorithm achieves the Cram?r-Rao bounds, both for range as well as angle estimation.

• Journal of Korean Society for Geospatial Information Science
• /
• v.18 no.2
• /
• pp.55-61
• /
• 2010

Using 3D point data implemented from terrestrial LiDAR, this research has modelled geospatial data in 2 categories(gridded & un-gridded) and conducted LOS analysis experiment using outcome from the modeling exercise. To compare LOS analysis results from each of the 2 models in the above, maximum LOS (line of sight) range in the experimental area was specified as 30m in Area A, 40m in Area B and 50m in Area C and the time taken by LOS analysis and the number of visible points were measured. As for the LOS analysis experiment results, in comparison with the gridded model, the un-gridded model took about 3.9 times more time in Area A, 5.4 times in Area B and 6.5 times in Area C. In addition, about 0.97 times fewer points were measured in Area A, 0.93 times in Area B and 0.94 times in Area C. The difference between gridded model and un-gridded model in terms of the time taken by LOS analysis increased, as the maximum LOS range extended. On the other hand, the number visible points did not vary significantly in reference to the size of visible range.

• The Journal of the Petrological Society of Korea
• /
• v.26 no.1
• /
• pp.83-91
• /
• 2017

In order to determine the runout range of pyroclastic density currents on Jeju island, lava dome collapse on 8 locations of outer rim of Baekrokdam crater were simulated by TITAN2D numerical simulation program. We set parameters as internal friction angle as $30^{\circ}$ and bed friction angle as $20^{\circ}$ to control velocity of currents occurred by lava dome collapse. Then we set the height and radius of lava dome, initial speed of collapse and simulation times. And we carried out numerical simulations for a total of 96 scenarios. The result shows that the maximum runout distance was 13.4 km in case of lava dome collapse. This study can be used database for manufacturing of hazard map to minimize damages caused by pyroclastic density currents occurred on Jeju island.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.6
• /
• pp.5-13
• /
• 2006

Effective stresses may decrease due to generation of excessive pore pressure at the interface between soil and reinforcement in undrained condition such as rapid drawdownof groundwater level, resulting in the decrease in pullout capacity of the reinforcement. In this research, a series of laboratory pullout tests have been performed on different materials (clean sand, 5, 10, 15 and 35% silty sand), different overburden pressures (30, 100 and 200 kPa), and different drainage conditions (drained and undrained) in order to compare drained pullout capacity with undrained pullout capacity. The test results show that both drained and undrained pullout capacity are influenced by silt contents and increase with the increase of friction angle of the soil. The pullout capacity and the pullout displacement required to reach the peak value also increase as the overburden pressure increases. In undrained condition, the effective stresses acting on the reinforcement decrease as excessive pore pressures are generated, resulting in the decrease in pullout capacity and pullout displacement.

• Journal of Korea Water Resources Association
• /
• v.32 no.1
• /
• pp.83-94
• /
• 1999

In continental margins, turbid underflows which are not confined to a given channel, are free to spread laterally as well as longitudinally. Lateral spreading can reduce substantially the run out distance of flows along continental shelves and slopes. Laboratory experiments with a large tank, employing saline density currents as surrogates for fine-grained turbidity flow, coupled with dimensional analysis, have been used to develop a simple expression for lateral spreading rates of two-dimensional flows on sloping beds. characteristic length and time are determined by the flow discharge and buoyancy flux at the inlet. By knowing the initial width of the flow, the spreading law can be used to estimate the maximum width of the current at different times as well as the longitudinal spreading rate. Predictions for flows compare favorably against observations.

• The Journal of the Korea Contents Association
• /
• v.5 no.6
• /
• pp.65-73
• /
• 2005

Request about fast diffusion of internet and high-capacity multimedia service is increasing day after day. Because existent wireless LAN is short range, if subscriber is far away in base station transceiver system(Base Station), subscriber's quality of service becomes low, and wileless internet is expensive. Lately, WiBro(Wireless Broadband Internet) system that is developed in domestic by world first, is high-speed portable internet service that is situated in middle area of mobile phone and wireless LAN. In this paper, service traffic model and characteristics are analyzed to provide multimedia service based on IEEE 802.16 BWA accomplishes base of WiBro and simulation is conducted according to various traffic mixing ratio. Finally, on the basis of these simulation results, maximum allowable number of subscriber per cell is calculated.

• Journal of Bio-Environment Control
• /
• v.5 no.2
• /
• pp.194-201
• /
• 1996

A series of experiments to analyse and to compare performance of various types of mini-sprinkler was carried out. Twelve kinds of the sprinkler, which have various sizes of nozzle orifice diameter and structures of spreader, were selected to be tested. Flow (water sprinkling) rate and sprinkling intensity pattern from a sprinkler were measured as a first part of this study, and the results are as follows. Sprinkler flow rate of various sizes of nozzle orifice and applied water pressures could be predicted by Torricelli's theorem. Discharge coefficients of the Torricelli's theorem for the sprinkler nozzle of various sizes were determined by the experiment as 0.90- 0.95, 0.80-0.82 and 0.76-0.79 for 0.8, 1.2 and 1.6 mm of nozzle orifice diameter, respectively. Experiments on sprinkling intensity pattern resulted that nozzle orifice diameter and applied water pressure are major variables for uniformity of the sprinkling intensity. More uniform sprinklering patterns were noted with smaller nozzle orifice diameter of a sprinkler and at lower sprinkling pressure. Besides the variables, structure of spreader of a sprinkler is also an important variable for the uniformity of sprinkling intensity.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.6
• /
• pp.25-34
• /
• 2011

Dredged and reclaimed ground in progress at the West Coast has a high content of coarse particles. There will be different behaviors depending on the location of outlet and engineering properties of soil when its ground is dredged by a pump. Therefore, the experiments were conducted that were manufactured about the chamber equipment of length 2,650mm, width 770mm, height 735mm, experimented step filling method and water content about 300%, 500% and 700% respectively with SM and ML samples in order to realize segregating sediment characteristics of dredged ground with changing much fine. With results of analysis, ML sample by higher initial water content was reached to the period of complete sedimentation and coefficient of sedimentation consolidation increased with increases of diffusion distance. SM samples showed behavior of coarse soil with diffusion distance 120cm, diffusion distance of more than 120cm showed a similar tendency with ML sample under the influence of fines. In ML sample, it could be also found that lower depth and the more increasing diffusion distance increase in percentage of sieve #200 but water content decreases. In SM sample, it could be also found that coarse soil was piled at near the diffusion distance zone but fine soil was piled at the far diffusion distance zone and prominent difference showed between percentage of sieve #200 and water content(%) by boundary point 120cm~160cm of both samples. Also, shear strength was expressed ML-maximum 2.97kPa, SM-maximum 10.2kPa with diffusion distance.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.5
• /
• pp.182-190
• /
• 1998

Behaviour of ultra-high pressure diesel spray in a constant-volume pressure chamber was studied with injection pressure ranging from 20 to 160㎫. Sprays were observed by the right angle scattering method. As a result, the spray tip penetration is first proportional to a time, and after that, it is proportional to 0.52 of the time during at the time of injection pressure and back pressure increase. An empirical correlation was made for the parameters of injection pressure, air-fuel density ratio, spray tip distance, spray angle, jet angle of spray and max. spray width.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.10a
• /
• pp.135-136
• /
• 2011

자유낙체란 자유로이 낙하하는 물체를 말한다. 즉 물체의 초기 운동 상태와 무관하게 중력의 영향으로만 자유롭게 낙하하는 물체를 말하는 것이다. 본 논문에서는 공기의 저항을 무시하고, 수직방향으로 짧은 거리의 범위 내에서 고도에 의한 자유낙하 가속도의 변화가 없다고 가정한다. 이러한 가정 하에, 자동차가 수직 상 방향으로 출발하여 최고점에 도달하는 시간, 최대높이, 자동차가 출발 위치로 돌아오는 시간과 자동차의 속도, 자동차가 땅에 떨어질 때의 시간 및 속도에 대하여 알아본다.