• Journal of the Korea institute for structural maintenance and inspection
• /
• v.8 no.1
• /
• pp.195-202
• /
• 2004

The shell due to the effect of initial normal pressures on the shell surface was based on the assumption that the directions of the pressures are always normal to the undeformed shell surface, and that the change in the surface area of the shell is negligible. But the fact that the pressure are always normal to the deforming surface leads "follower force". The follower effect in the analysis can significantly alter the solution for natural frequency and buckling load as compared to the case when the direction of the pressures are assumed to be normal to the uniform shell surface. The expression for the part of strain energy contribution from normal pressure due to the effect of follower force was derived and added to the element stiffness matrix of axisymmetric shell. In the case of increasing external pressure, the natural frequencies decrease until one of them reaches zero. Theoretically the smallest applied load that reduces the frequency of any mode to zero, will have same magnitude as that of the buckling load. In order to determine the bucking load of the shell a few sets of frequencies are computed and the results considering the follower effects are well with the exact solution while the case without that are quite different. But in case of hemispherical dome, there are little difference in buckling pressure between with and without the effect of follower force.

• Composites Research
• /
• v.14 no.1
• /
• pp.39-46
• /
• 2001

Experimental studies on the adaptive multi-mode vibration control of composite beams have been performed using neuro-controller. Neuro-controllers require too much computational burden, which blocks wide real-time applications of neuro-controllers. Therefore, in this paper, an adaptive notch filter is proposed to separate a vibration signal into each modal vibration signal. Two neuro-controllers with fewer weights are connected to the corresponding modal signals to generate proper modal control forces. The vibration controls using the adaptive notch filter and neuro-controllers have been performed for two specimens. A and B, which have different natural frequencies because of different positions of tip masses. Significant vibration reduction has been observed in both cases. The vibration control results show that the present neuro-controller has good adaptiveness under the system parameter variations.

• Journal of KSNVE
• /
• v.11 no.1
• /
• pp.96-103
• /
• 2001

Past research has repeatedly demonstrated the fact that hydraulic semiactive systems, if operated Properly, can provide levels of control authority in structural vibration control systems that are comparable to a fully active hydraulic damper. The performance of the semiactive system when used to provide vibration mitigation for a laboratory test structure is described in this paper Numerical and experimental verification of the effectiveness of the proposed bistate controller which relies on a Lyapunov approach that seeks to dissipate the energy of the system is also presented. The results based on the bistate control are compared with those of two different control strategies. The work indicates that hydraulic semiactive actuator provides a reliable, and inexpensive means of achieving structural control.

• Journal of KSNVE
• /
• v.8 no.2
• /
• pp.313-323
• /
• 1998

This paper addresses a sliding mode control of vibration in a flexible structure using ER(electro-rheological) dampers. A clamped-clamped flexible structure system supported by two short columns is considered. Three ER dampers to be operated in shear mode are designed on the basis of Bingham model of the arabic gum-based ER fluid, and attached to the flexible beam structure. After deriving the governing equation of motion and associated boundary conditions, a sliding mode controller is formulated to effectively suppress the vibration of the beam structure caused by sinusoidal and random excitations. In the formulation of the controller, parameter variations such as natural frequency deviation are treated to take into account the robustness of control system. The effectiveness of the proposed control system is confirmed by both simulation and experimental results.

• Proceeding of KASS Symposium
• /
• 2008.05a
• /
• pp.139-144
• /
• 2008

Experimental studies using tuned liquid damper(TLD) and multiple tuned liquid damper(MTLD), which are passive control devices consisting of a rigid tank filed with liquid, are used to suppress vibration of structures. This TLD and MTLD are attributable to several potential advantage -low costs, easy; easy to install in existing structures: effective even for small amplitude vibrations. For this, we conducted shaking table experiments for two natural frequencies (0.44Hz, 0.55Hz) according to the excitation amplitude(1mm, 3mm, 5mm, 10mm, 20mm) So, the majority of studies suggested optimized natural frequence and excitation amplitude for control devices.(TLD and MTLD type : circle, rectangular) As the analysis result, we verified vibration reduction effects of a MTLD by analyzing the performance experiment of TLD and MTLD

• Journal of Korean Association for Spatial Structures
• /
• v.6 no.2 s.20
• /
• pp.115-121
• /
• 2006

In recent years vibration control damper made of low yield point steel is expected to play an important role in controlling structural vibration induced earthquake and wind. But their dynamic characteristics and energy dissipation effects on the whole structure model are not clarified. In this paper, firstly, we presents the results of cyclic tests on low yield steel dampers. Secondly, forced vibration tests on existence three stories steel structure model with low yield point steel dampers are presented. Lastly, it is estimated energy amount which is dissipated through the hysteresis dampers by using two types of analytical models, hysteresis model and equivalent linear model.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2009.04a
• /
• pp.678-678
• /
• 2009

환경 소음,진동 개선의 측면에서 철도 레일 하부로 전달되는 진동 및 구조소음을 효과적으로 차단하기 위하여 국내에서도 탄성지지 구조의 플로팅 슬라브를 적용하는 경우가 증가하고 있다. 플로팅 슬라브 구조설계에 있어 주안점은 슬라브 자체 중량에 비하여 열차 중량과 열차 주행간에 발생하는 동하중이 2$\sim$3배 이상 높아 열차 주행 안정성을 고려해야 하는 점이며 열차의 고속화 경향에 따라 동하중의 증가는 더욱 커지고 있다. 특히, 열차의 구조 동특성과 동하중의 주파수 특성을 고려할 경우 슬라브 구조의 동적 설계변수(고유진동수, 감쇠비 등) 결정이 매우 제한되고 있음을 고려하면 탄성지지부의 감쇠 및 강성의 가변 특성의 부여는 매우 중요하다 할 수 있다. 본 연구에서는 MR 댐퍼와 MR 방진고무 등의 반능동 소재를 사용하여 열차 주행간에 발생하는 탄성지지 슬라브의 진동을 제어하는 시뮬레이션을 수행함으로써 적용 가능성을 확인하고자 한다.

• The Journal of the Acoustical Society of Korea
• /
• v.16 no.5
• /
• pp.12-17
• /
• 1997

In this work, we developed a new type ultrasonic dehumidifier with piezoelectric ceramics, which and efficiently repel waterdrops on outdoor glass plates exposed to raindrops. Through finite element analysis of a certain type of glass plates to analyze its dynamic behavior, the structure of the ultrasonic device we determined to get the optimal performance. A supplemental metal plate was attached to the glass plate for uniform cleaning. Based on the theoretical results, experimental samples were fabricated and evaluated with various dimensions of the glass plate and the piezoceramic vibrator. Driving circuit for the dehumidifier made use of the frequency sweeping technique to keep track of the resonant frequency of the glass plate that was variant with environmental conditions.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.21 no.4
• /
• pp.357-364
• /
• 2008

This paper deals with the free vibrations of arches with rectangular hollow section having constant area. The differential equations governing free vibrations of arches are derived in polar coordinates, in which the effect of rotatory inertia is included. Natural frequencies is computed numerically for parabolic arches with clamped-clamped, clamped-hinged and hinged-hinged ends. Comparisons of natural frequencies between this study and reference are made to validate theories and numerical methods developed herein. The lowest four natural frequency parameters are reported, with the rotatory inertia, as functions of three non-dimensional system parameters: the breadth ratio, the thickness ratio and the shape ratio

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.15 no.5
• /
• pp.19-24
• /
• 1978

In this paper, the functional propertied of vibrotactile sense of skin were studied by means of psycophysical experiments with respect to frequency and waveform of mechanical vibration, two-point threshold, contactor size of stimulators. Furthermore, leased on the experimental result, a small vibrotactile stimulator made of piezoelectrc ireed vibrator array was proposed for a aid blind to recognition of the Korean letters. A tactile output image is presented by an 8 row$\times$1 column array of samall vibrator reeds with 200 Hz rectangular wave, the array fitting on a fore-finger. Under the control of the NOVA mini-computer, the bimorph reeds array could represent any of one of the 24 characters of the Korean vowel and consonant at the 8 positions from left to right on the array. Without learning effect, the identification test of the Korean characters by the designed experimental system was carried out. The average rate of correct response was 90%.