• Journal of the Korea institute for structural maintenance and inspection
• /
• v.21 no.3
• /
• pp.86-92
• /
• 2017

The possibility to development of floor vibration problem is larger in case of long span structure under service loads. Therefore, to improve the vibration performance of the floor, increasing of its thickness is a common method. But, increasing of thickness can lead to increase of slab self weight and reduce the effectiveness of the building. For this reason, attention for voided slab which reduces the self-weight is increasing. Hence, voided deck slab combined with deck plate and polystyrene void foam which has buoyancy prevention capacity and much developed construct ability has bee developed. By using the developed voided slab, vibration performance of a mock-up building structure has been investigated in the current study. The results according to analysis showed that they can be implemented in living and bedroom which are considered as 1st grade on the basis of "Residential Evaluation Guidelines for Vibration of Buildings" by the Architectural Institute of Japan.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.1
• /
• pp.53-60
• /
• 2021

High voltage CV cables have been widely installed underground due to their convenience and urban aesthetics. However, cable accidents have occurred frequently owing to poor construction and natural degradations. This paper proposes the method to measure the multi parameter measurement for optimum diagnostics of high voltage cable connection parts and verifies its technical usefulness. This measurement is intended to diagnose degradations of cable connection parts by using simultaneous vibration and thermography as well as partial discharge(PD). The experiment in a shielded laboratory was carried out to verify the usefulness of the multi parameter measurement. The experiment defined the degradation of the cable connection part as 12 types, and produced each degradation sample. As a result of experiment, it was possible to check the correlation of vibration signals with regard to progress in some defects. In the case of thermography, the coherence with regard to the progress of some defects was found. We figure that the proposed method would be useful also in the noise environment.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.3 no.4
• /
• pp.205-214
• /
• 1999

구조물의 동특성(고유진동수, 감쇠, 모드형상 등)의 변화는 구조물의 안전도를 평가할 수 있는 한 방법이다. 본 연구에서 콘크리트 세그먼트의 웨브 부분에 상당히 많은 균열이 진전되고 있는 상태의 Post-Tensioned Segmental 콘크리트 교량의 안전도 평가를 시도하였다. 안전도 평가를 위한 근간 데이터로 1986년 측정했던 데이터와 2차원 유한요소해석에서 얻은 결과값을 사용했다. 손상의 정도와 손상의 위치를 보다 정확히 찾아내기 위한 기술 중의 한 방법으로 Modal Test를 이용하였다. 이 방법이 Post-Tensioned Segmental 콘크리트 교량에 적용되어 교량의 안전도를 분석 평가하였다.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.38 no.2
• /
• pp.205-210
• /
• 2014

Recently, pattern recognition methods have been widely used by researchers for fault diagnoses of mechanical systems. A pattern recognition method determines the soundness of a mechanical system by detecting variations in the system's vibration characteristics. Hidden Markov models (HMMs) and artificial neural networks (ANNs) have recently been used as pattern recognition methods in various fields. In this study, a HMM-ANN hybrid method for the fault diagnosis of a mechanical system is introduced, and a rotating wind turbine blade with a crack is selected for fault diagnosis. The existence, location, and depth of said crack are identified in this research. For improving the diagnostic accuracy of the method in spite of the presence of noise, a moment with a few specific frequencies is applied to the structure.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.5
• /
• pp.951-961
• /
• 2000

A diagnosis system that provides early warnings regarding machine malfunction is very important for rolling mill so as to avoid great losses resulting from unexpected shutdown of the production line. But it is very difficult to provide early warnings in rolling mill. Because dynamics of rolling mill is non-linear. This Paper proposes a new method for diagnosis of rolling mill using wavelet transform(W) to solve this problem. Proposed method that measures the vibration signals of rolling mill on-line and analyze it using wavelet to acquire pattern data. And we design a fault-diagnosis system that diagnose a rolling mill using this data. Validity of the new method is asserted by real numerical data experiment.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.12 no.6
• /
• pp.1-6
• /
• 2008

This work proposes a fuzzy trend monitoring method for the fault detection of a gas turbine engine through analyzing measured performance data trend. The proposed trend monitoring technique can diagnose the engine status by monitoring major engine measured parameters such as fuel flow rate, exhaust gas temperature, rotor rotational speed and vibration, and then analyzing their time deppendent changes. In order to perform this, firstly the measured engine performance data variation is formulated using Linear Regression, and then faults are isolated and identified using fuzzy logic.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.1
• /
• pp.77-84
• /
• 2017

Generally, a time-varying vibration signal is generated in a rotating machine system, and when there is a failure in the rotating machine, the signal contains noise. In this paper, we propose a system consisting of an adaptive predictor and a binary tree filter bank for analyzing time - varying vibration signals with noise. And the vibration signal analyzed results in this system is used for fault diagnosis of the rotating machine. The adaptive predictor of the proposed system predicts the periodic signal components, and the filter bank system decomposes the difference signal between the input signal and the predicted periodic signal into subband. Since each subband signal includes a noise signal component due to a failure, it is possible to diagnose the failure of the using rotary machine. The validity of the proposed vibration signal analysis method is shown in the simulations, where the periodic components cancelled vibrating signals are decomposed to 32 subband, and the signal characteristics related faults are analyzed.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.9 no.3
• /
• pp.161-168
• /
• 2005

The influence of spandrel wall and fill above the extrados on the structural behavior and load capacity of stone masonry arch bridges has not been thoroughly studied yet. One can estimate the structural characteristics and behavior of stone masonry structures by measuring the dynamic characteristics. To investigate the influence of spandrel wall and fill on the dynamic characteristics of historic stone masonry arch bridges, on-site free vibration tests were performed for 5 stone bare arches with no spandrel wall and backfill. And the natural frequencies of those arches were compared with the natural frequencies of 18 stone arch bridges with spandrel walls. Experimental results show from the experiments show that the presence of spandrel wall and fill may increase the natural frequency of arch bridge because the stiffness increase exceeds the mass increase due to spandrel wall.

• The Journal of the Korean dental association
• /
• v.46 no.4
• /
• pp.232-242
• /
• 2008

관절잡음의 발생은 측두하악 관절의 구조적, 기능적 이상의 징후로 여겨져왔다. 이러한 관절잡음을 평가하는데 electrovibratography가 비침습적이고 신뢰할만한 방법으로 제시되어 왔으며 이를 통해 관절잡음의 진동수와 진폭 및 전체 에너지 양상을 숫자화하고 도식화 하는 것이 가능하게 되었다. 기존의 연구에서 여러 가지 관절잡음의 양적, 질적 분석이 시도되어 왔다. 이번 연구의 목적은 관절 잡음이 도식화되어 나타나는 frequency spectrum pattern을 integral>300Hz/<300Hz ratio와 함께 분석하는 것이다. 본 실험에서는 Joint Vibration AnalysisTM를 사용하여 측두하악 관절 장애의 증상이 없는 10명의 대조군과 관절 잡음과 동통이 있으나 개구제한을 보이지 않는 정복성 관절원판 변위의 범주에 있는 20명의 실험군에서 관절진동을 분석하였으며 관절진동 기록 시에 Jaw tracker를 함께 사용하여 개폐구시 관절잡음 발생의 위치를 감별하고 치아접촉음을 배제하여 관절잡음을 분석하였다. 그 후 실험군을 frequency spectrum pattern에 따라 4가지 하위 그룹으로 나누어 분석하였다. 실험 결과 실험군과 대조군의 하위 그룹 1에서 유사한 frequency spectrum pattern과 ratio범위를 보였으며 실험군의 하위 그룹 2,3,4 에서는 더 불규칙한 에너지 양상을 보이는 frequency spectrum pattern과 더 큰 ratio가 관찰 되었다. 이번 연구를 통해 Joint Vibration AnalysisTM가 악관절 진동의 특성을 감별하는데 유용함을 알 수 있었고 Joint Vibration AnalysisTM를 이용한 지속적인 진동 분석이 환자 교육뿐 아니라 성공적인 턱관절 기능이상의 진단과 치료에 유용할 것으로 사료된다.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2000.11a
• /
• pp.809-814
• /
• 2000

이 연구의 목적은 비침투적으로 펌프의 유량을 알아내고, 이를 이용하여 펌프의 성능을 감시하는데 있다. 그리고 운전중인 펌프의 상태를 감시함으로써 펌프의 결함을 진단하는데 있다. 위 목적을 달성하기 위하여 본 연구에서는 비침투적으로 측정이 가능한 변수인 모터 토크와 회전속도를 이용하여 펌프의 성능을 예측할 때 필수석인 유량을 알아내는 Simulator를 개발하였다. 유량의 변화를 감시함으로써 펌프의 성능 변화를 감시하는 일반적인 방법을 적용하면 펌프의 성능을 효율적이며 경제적으로 감시를 하는데 이용할 수 있다.