• Korean Journal of Agricultural Science
• /
• v.16 no.2
• /
• pp.212-224
• /
• 1989

This paper reports results of an investigation to determine properties of superplasticizered fly ash concrete. The mixture proportions of fly ash were 0, 10, 20 and 30%, by weight of cement, and superplasticizer was added as a percentage of fly ash, 0, 0.6, 12 and 1.8%. To investigate the effective use of the superplasticized fly ash concrete, the basic data were analyzed. The results obtained were summarized as follows : 1. The unit water content was decreased by 1%, 6% and increased by 2% to the ratio of addition of fly ash 10%, 20%, 30%, respectively, but in case of the superplasticized fly ash concrete, it was decreased by 3~16%, 4~14% and 10~17%, at 0.6, 12, and 1.8% dosage of superplasticizer, respectively. 2. In the properties of the fresh fly ash concrete, the slump loss was reduced with the ratio of replacement of fly ash increased, and with times went by. When using superplasticizer in fly ash substituting concrete, the fludity in the concrete was not decreased. 3. The compressive strength of fly ash concrete at early ages was lower than that of ordinary concrete. At the later age of 28 days, the compressive strength with 20% addition of fly ash was increased than that of ordinary concrete. In cased of 10%, 30% addition of fly ash, the compressive strength were reduced. From this, it was proved that the optimum amount of fly ash appears to be about 20%. The compressive strength at all ages of superplasticized fly ash concrete was significantly higher than that of fly ash concrete, with increasing fly ash content. 4. In case of the tensile strength, the effects of the increasing strength with the ages were similar to those of the compressive strtength, and at the later ages was seen a decreasing tendency of strengths. 5. The correlation between compressive and tensile strength of superplasticized fly ash concrete was highly significant. The multiple regression equations of compressive and tensile strength were obtained on a function of the mixture proportion of fly ash and the addition of superplasticizer. The relation between compressive and tensile strength is higher than for ordinary concrete. The strength ratio is 7~11, and it is higher than that of ordinary concrete, 8~10. 6. Bulk density was decreased by 1~3% compared with ordinary concrete with the mixture proportion of fly ash increased, 10~30%, and decreased by 1~2% with the superplasticizer added 0.6~1.8%.

• Korean Journal of Plant Resources
• /
• v.25 no.4
• /
• pp.387-393
• /
• 2012

In order to improve storability of subtropical yam produced in South Korea, the major pathogens found during the storage were isolated and identified of the pathogenicity, and rot inhibition effect was studied based on the curing treatment condition. Penicillium sclerotigenum and Penicillium polonicum were identified as major pathogens causing rot in subtropical yam during storage, and P. sclerotigenum had stronger pathogenicity. Only the cut surface which has been made during a harvest and has been made smooth before curing generated a normal callus layer. The cut surface of tuberous root was cured in 95% of relativity humidity for three days at $23^{\circ}C$, and cured at $28^{\circ}C$ and $33^{\circ}C$. The observation of callus layer showed that the $23^{\circ}C$ treatment group had similar color saturation between tuberous root and pellicle, while the groups treated above $28^{\circ}C$ showed clear distinction. The generation rate of callus 0.5mm or bigger was 93 percent at $28^{\circ}C$ treatment, 96% at $33^{\circ}C$ treatment, but was 52% at $23^{\circ}C$ treatment. The conventional curing treatment group that used wind or sunlight at room temperature created little callus layer. The infection rate of pathogens according to the relative humidity inside the storage room was low at 40% and 60% of humidity, and the curing treatment period did not make a difference. When the humidity inside the storage room was 80%, all treatment groups rapidly increased the fungal pathogens. The rotten rate of each treatment was studied after 180 days during which the storage temperature was maintained at $16^{\circ}C$ and relative humidity 60%. While the rotten rate of tuberous root that has been cut in conventional curing treatment based on solar and wind was 43%, the one cured at over $28^{\circ}C$ and created the callus layer was less than 18%. While even a healthy tuberous root showed 25% of rotten rate in the traditional treatment group, the one cured at over $28^{\circ}C$ was less than 10%. The weight loss was 1-6% lower in the forced treatment group than in the conventional treatment group.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.2
• /
• pp.144-149
• /
• 2018

The eggs are incubated for 18 days through the generator and incubated in the developing incubator. During the developmental period, the weight loss of the fetus is correlated with the ventricular formation, and the proper ventricular formation is also associated with the healthy embryonic hatching and the egg hatching rate. However, in the incubator period of the domestic hatchery, it is a reality to acquire the resultant side by the Iranian standard weight measurement with the experience of the hatchery and the person concerned and the development period without the apparatus for measuring the present weight. As a result, prevalence of early mortality, hunger and illness during hatching are frequent. Monitoring the reduction of weaning weight is crucial to obtaining chick quality and hatching performance with weight changes within the development machine. Water loss is different depending on the size of eggs, egg shell, and elder group. We can expect to increase the hatching rate by measuring the weight change in real time and optimizing the ventilation change accordingly. There is a need to develop a real-time measurement system that can control 10 to 13% reduction of the total weight during hatching. The system through this study is a way to check the one - time directly when moving the existing egg, and it is impossible to control the measurement of the fetal water evaporation within the development period. Unlike systems that do not affect the hatching rate, four load cells are connected in parallel on the Arduino sketch board and the AT-command command is used to connect the mobile phone and computer in real time. The communication speed of Bluetooth was set to 15200 to match the communication speed of Arduino and Hyper-terminal program. The real - time monitoring system was designed to visually check the change of the weight of the fetus in the artificial incubator. In this way, we aimed to improve the hatching rate and health condition of the hatching eggs.

• Korean Journal of Materials Research
• /
• v.4 no.1
• /
• pp.75-80
• /
• 1994

Flexural properties and thermal stability have been studied as a function of blend composition in bifunctional DGERA (diglycidyl ether of hisphenol A)/tetrafunctional TGDDM(tetrag1ycidyl diamino diphenyl methane) cured with DDM(4, 4'-diamino diphenyl methane). The flexural modulus and the glass transition temperature increase with an increase of TGDDM and show discontinuous dependence on blend composition around the composition range of 80/20~60/40(L)GEBA/TGDDM). This can be explained with a structural phase inversion (ductile-to-brittle) in crosslinking networks. With increasing TGDDM, the maximum decomposition temperature(Ts) increases, whereas the activation energy during thermal degradation decreases.

• Proceedings of the KAIS Fall Conference
• /
• 2007.05a
• /
• pp.95-98
• /
• 2007

본 연구에서는 설계기준에 제시된 평지 전도 안전율 계산식을 바탕으로 경사지에서의 지반의 저항모멘트를 산정하기 위해 범용 해석 프로그램 L-Pi1e P1us13.8을 사용하여 기존 연구와 검증하고 지반의 일반적인 토질상태별 특성을 고려한 내부마찰각, 접착력, 흙의 단위중량, 지반종류, 사질토 및 점성토 지반계수를 적용하여 각 전주의 근입깊이에 따른 지반의 저항모멘트를 산정하였다. 또한 토질등급에 따른 토질의 상태별 특성이 고려된 4가지 경우를 선정하여 12m 중하중용 전주를 대상으로 경사지의 경사각을 $0^{\circ}{\sim}35^{\circ}$까지 $5^{\circ}$씩 증가시켜 지반의 저항모멘트를 산정하였다. 그 결과 경사지 경사각에 따른 저항모멘트가 감소하는 것을 확인 할 수 있었으며 그에 따른 경사지의 근입깊이 증가가 필요한 것으로 판단된다.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.7 no.3
• /
• pp.1-7
• /
• 2007

The hollow RC(Reinforced concrete) column has the effect of reducing weight and materials compared to solid RC column. However, the hollow RC column shows a low ductile behavior due to brittle failure of inside concrete. To overcome this problem, the internally confined hollow reinforced concrete column has been developed. In this study, the behavior of internally confined hollow RC columns were evaluated with safety ratio, ductility, total material cost, the total weight of the pier, etc. The hollow ratio is varied from 0.50 to 0.85.

• Polymer(Korea)
• /
• v.29 no.5
• /
• pp.508-517
• /
• 2005

The thermal degradation behavior and reliability analysis were investigated using dynamic thermogravimetric analysis (TGA) and accelerated degradation test (ADT) to characterize the dynamic parameters related to thermal degradation of plastic meterials for household electric appliances. In addition, the weathering of the plastic were performed by ADT using Xenon uc, and the color difference of the samples after ADT were measured with Color Eye 3010 specoophotometer. he activation energy for thermal degradation of the samples increased with increasing the rate of weight loss. The Kim-Park method was found to be more effective analysis in describing thermal degradation of plastic meterials. Plastic materials were very sensitive to ultra-violet rays in faster degradation.

• Journal of the Korean Wood Science and Technology
• /
• v.32 no.4
• /
• pp.74-81
• /
• 2004

The ultrasonic non-destructive method was used for wood decay test. The temperature change and moisture contents of wood were estimated how the ultrasonic wave velocity changes. The relationship between weight loss of wood decayed by T. palustris and ultrasonic wave velocity was investigated. The non-destructive methods of different condition of logwood were estimated. Decay map of old wood was made by non destructive methods. Through these tests, we can accumulate the data to judge the degree of wood decay. The decay map of wood could be used for the analysis of old wood.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.46 no.11
• /
• pp.1350-1357
• /
• 2017

General component and mineral contents according to species of Capsicum annuum were investigated. In addition, chuichung cucumber, white dadagi cucumber, and yellowish overripe cucumber were cooked by using seven different methods (boiling, steaming, pan-cooking, roasting, pan-frying, deep-frying, and microwaving), and retention rates of general components and minerals according to species were evaluated. Weight loss was observed in all cucumber species using all cooking methods. Most general component and mineral contents of C. annuum samples were significantly different according to species, and cooking method (P<0.05), whereas Fe and Cu contents were not significantly affected by species and cooking method, respectively. As a result, the highest protein, fat, ash contents were detected in deep-fried C. annuum, and high moisture contents were detected in raw, boiled, and steamed C. annuum. High mineral contents were detected in roasted and microwaved chuichung cucumber, deep-fried white dadagi cucumber and yellowish overripe cucumber. Retention rates of C. annuum by cooking method, ranged from 30~100% for protein, 10~100% for fat, 35~90% for moisture, and 30~100% for ash. High retention rates were observed for minerals in boiled, roasted, and microwaved chuichung cucumber, and deep-fried white dadagi cucumber and yellowish overripe cucumber. However, in yellowish overripe cucumber, mineral retentions rate were remarkably lowered by boiling and steaming, resulting in rates of 20~45%. These results were the data used as the basis for development of cucumbers.

• Journal of Korean Society of Forest Science
• /
• v.90 no.3
• /
• pp.306-313
• /
• 2001

The objectives of this study were to understand the physiological responses and resistance of red pine trees to ozone exposure in relation to nitrogen and phosphorus fertilization. Potted one-year-old seedlings of Pinus densiflora S. et Z. were exposed in an open-top chamber(OTC) to ozone at concentration of 0.12ppm for 3 hours daily for eight weeks with or without N and P fertilization alone or in combination. The OTC had dimensions of 2.0m in height and 2.5m in diameter, and the air in a control chamber was filtered with activated charcoal to maintain the ozone concentration below 0.02ppm. After eight weeks of ozone exposure, none of the seedlings showed any symptoms of visible injury on leaves. The seedlings fertilized with N and P in a control chamber showed 22 to 95% increase in total dry weight, and similar fertilizer effect was also noticed in an ozone chamber. Ozone treatment did not decrease the total dry weight, but increased shoot/root ratio by 14.5%. Ozone treatment increased sucrose content in the leaves by 23%, but decreased sucrose content in roots by 20% regardless of N or P application. Starch content in the leaves was not affected by either ozone or fertilizer. However, starch content in the roots was decreased by 41% by ozone treatment. Chlorophyll content in the leaves was increased by 70% by N application, but was not affected by ozone treatment. Nitrogen and P fertilization stimulated net photosynthesis by 80% in a control chamber, but stimulatory effect of N and P on net photosynthesis was 22.3% less in an ozone chamber. Net photosynthesis of the seedlings with no fertilization was not affected by ozone treatment. Based on the observed interactions between N, P, and ozone, it was concluded that the stimulatory effect of fertilization on growth of Pinus densiflora would be decreased by ozone treatment, but fertilization would increase resistance to ozone by re-allocation of increased carbohydrates.