• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.1
• /
• pp.85-95
• /
• 2012

In this thesis, we develop a spectral analysis scheme to eliminate the spurious peaks generated in HRR Millimeterwave Seeker based on FMICW system. In contrast to FMCW system, FMICW system generates spurious peaks in the spectrum of its IF signal, caused by the periodic discontinuity of the signal. These peaks make the accuracy of the system depend on the previously estimated range if a band pass filter is utilized to eliminate them and noise floor go to high level if random interrupted sequence is utilized and in case of using staggering process, we must transmit several waveforms to obtain overlapped information. Using the spectral analysis one of the schemes such as IAA(Iterative Adaptive Approach) and SPICE(SemiParametric Iterative Covariance-based Estimation method) which were introduced recently, the spurious peaks can be eliminated effectively. In order to utilize IAA and SPICE, since we must distinguish between reliable data and unreliable data and only use reliable data, STFT(Short Time Fourier Transform) is applied to the distinguishment process.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.3
• /
• pp.661-669
• /
• 2000

DS-CDMA downlink distinguishes actual user by orthogonal spreading codes ,but its orthogonality may be lost by the multiple access interference(MAI) caused by the multipath channel. Therefore in this paper, we proposed the single-user receiver, which use linear channel equalizer to eliminate the interference due to multipath channel and to recover orthogonality and then use code-matched filter to detect transmitted data. Unlike existing research, which mainly assumed ideal channel information, we use pilot channel assisted methods that is a kind of transmission of a parallel reference method to estimate the channel coefficients. Especially we use guard symbols which are inserted periodically to estimate channel coefficients exactly without interference from user signal. The results show that we accepted an approximately ideal channel information and achieved excellent performance improvement using proposed receiver compared with the conventional receiver especially user populations are high.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.12B
• /
• pp.2391-2400
• /
• 1999

Vector quantizer (VQ) is an efficient data compression technique for low bit rate applications. However, the major disadvantage of VQ is its encoding complexity which increases dramatically as the vector dimension and bit rate increase. Even though one can use a modified VQ to reduce the encoding complexity, it is nearly impossible to implement such a VQ at a high bit rate or for a large vector dimension because of the enormously large memory requirement for the codebook and the very large training sequence (TS) size. To overcome this difficulty, in this paper we propose a novel structurally constrained VQ for the high bit rate and the large vector dimension cases in order to obtain VQ-level performance. Furthermore, this VQ can be extended to the low bit rate applications. The proposed quantization scheme has a form of feed-forward adaptive quantizer with a short adaptation period. Hence, we call this quantization scheme sample-adaptive product quantizer (SAPQ). SAPQ can provide a 2 ~3dB improvement over the Lloyd-Max scalar quantizers.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.05a
• /
• pp.199-204
• /
• 2000

In this paper, we study single-user receiver, which applicable to DS-CDMA downlink. DS-CDMA downlink mainly use wallsh code, its orthogonality may be lost by the multiple access interference(MAI) caused by the multipath channel. In this paper, we use linear channel equalizer to eliminate the interference due to multipath channel and then to recover orthogonalit and use code-matched filter to detect transmitted data. Unlike existing research, which mainly assumed ideal channel information, we use pilot channel to estimate the channel coefficients. Especially we use guard symbols which are inserted periodically to estimate channel coefficients exactly without interference from user signal, and we accept an approximately ideal. The results show that improvement can be achieved using proposed detectors compared with that of that conventional RAKE receiver, especially when the user population is high we accepts excellent performance improvement.

• The Journal of the Korea Contents Association
• /
• v.16 no.1
• /
• pp.362-369
• /
• 2016

Recently, Last to check the security status of various medium and large bridge structures using various kinds of measurement equipment, but most of the methods are used to measure and check the displacement behavior of the bridge by a certain period. In this study, receive GPS satellite signals that can be observed in real time the whole region, a bridge to automatically measure the displacement and behavior characteristics of the structure in real-time in mm over the 24 hours, the measurement information and transmits the data to the wireless network, by making use, it was applied to the real-time monitoring system in connection with a bridge to be able to automatically notify GNSS fine displacement behavior. In fact, analysis and receives the measurement data to GNSS provided in the upper bridge of the middle and large-sized aging for this purpose, measuring USN and at the same time is converted into a three-dimensional position information of a test study was conducted to monitor the bridge displacement in real time. As a result, a vertical displacement of about 0.027~0.037m at the measurement time of day of the measurement point is that the repeated and confirmed.

• Journal of Advanced Navigation Technology
• /
• v.10 no.4
• /
• pp.394-399
• /
• 2006

In this paper, we investigated performance for 5.8GHz dedicated short range communication system using OFDM which will be applied to Intelligent transportation system services. The maximum speed of a vehicle in DSRC channel is very fast as 180km/h, so a service time is very short to serve a various traffic information if hand-off is not occurred. Therefore higher bit rate is required to proved advanced and intelligent service to the drivers of various vehicle and the data transmission rate of the next generation DSRC system if being promoted over 10Mbps. The signals received in Clarke & Gans channel have been simulated using the computer simulator.

• Journal of Internet Computing and Services
• /
• v.16 no.2
• /
• pp.7-17
• /
• 2015

To provide scalability, wireless sensor network has cluster-based architecture. Wireless sensor network can be implemented based on the IEEE 802.15.4 which is exploited in 2.4GHz ISM frequency band. Since this frequency band is used for various data communication, network status of wireless sensor networks frequently changes according to wireless environment. Thus, wireless channel selection to avoid reduction of transmission efficiency is required. This paper estimates network status using the information that a cluster-head collects in a cluster. Through objective function with throughput, RSSI level and reliability as input parameters, this paper proposes proper wireless channel selection. Simulation results show that the proposed method maintains transmission efficiency even though network status changes.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.3
• /
• pp.9-17
• /
• 2000

In this paper we implement computer simulation system of 4FSK signal MODEM using Quadrature detector and analyze overall tranceiver system. We follow the FLEX wireless paging system standards and construct premodulation filter and data frame. We propose an efficient open loop symbol timing recovery algorithm which takes advantage of 128 bit length preamble pattern and also propose a 32 bit UW pattern which Is based on the optimal UW detection method, and excellent aperiodic autocorrelation characteristic. The BER simulation in the fading channel as well as AWGN is performed with BCH coding and Interleaving to the Quadrature detector system and it is shown that a high coding fain occurs in the fading channel rather than AWGN channel.

• Journal of Satellite, Information and Communications
• /
• v.6 no.2
• /
• pp.125-130
• /
• 2011

In this paper, there was compared to the performance of the Auto Correlation Feature of each code using Spreading code for improving the data transmission technology in T-DMB disaster broadcasting. Generally, wireless mobile communication environment such as DMB occur the Inter Code Interference and the Multi-Path Interference in the process of the identification of the transmitter from the receiver. To solve this problem, spreading code technology was able to improve the security property. Also, it will be able to use in many fields of signal processing, because to control a period of the code can be variable. Therefore, in this paper, we studied to compare the performance of excellent orthogonal Golay code, Kasami code and ZCD(Zero Correlation Duration) code.

• Journal of the Korean Society of Safety
• /
• v.38 no.2
• /
• pp.104-111
• /
• 2023

Rolling stock maintenance, which focuses on preventive maintenance, is typically implemented considering the potential harm that may be inflicted to passengers in the event of failure. The cost of preventive maintenance throughout the life cycle of a rolling stock is 60%-75% of the initial purchase cost. Therefore, ensuring stability and reducing maintenance costs are essential in terms of economy. In particular, private railroad operators must reduce government support budget by effectively utilizing railroad resources and reducing maintenance costs. Accordingly, this study analyzes the reliability characteristics of components using field data. Moreover, it resolves the problem of determining an economical replacement interval considering the timing of scrapping railroad vehicles. The procedure for determining the optimal replacement interval involves five steps. According to the decision model, the optimal replacement interval for the onboard signal device components of the "A" line train is calculated using field data, such as failure data, preventive maintenance cost, and failure maintenance cost. The field data analysis indicates that the mileage meter is 9 years, which is less than the designed durability of 15 years. Furthermore, a life cycle in which the phase signal has few failures is found to be the same as the actual durability of 15 years.