• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.1A
• /
• pp.11-15
• /
• 2006

A pre-amplified semiconductor optical amplifier-Mach-Zehnder interferometer(SOA-MZI) wavelength converter (WC) using a continuous wave-holding beam(CW-HB) is proposed and experimentally demonstrated at 10Gb/s. The proposed scheme achieves not only enhancement of input power dynamic range(IPDR) to over 20dB but also higher Q parameter of about 2 to 3 by no output signal distortion and higher extinction ratio(ER) of about 2dB to 5dB by low noise figure (NF), compared with the bias current control method.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.10
• /
• pp.185-190
• /
• 2007

In this paper, minimum sampling rates and method of nonlinear characterization were suggested for low power, quasi-memoryless PAs. So far, the Nyquist rate of the input signal has been used for nonlinear PA modeling, and it is burdening Analog-to-digital converters for wideband signals. This paper shows that the input Nyquist rate sampling is not a necessary condition for successful modeling of quasi-memoryless PAs. Since this sampling requirement relives the bandwidth requirements for Analog-to-digital converters (ADCs) for feedback paths in digital pre-distortion systems, relatively low-cost ADcs can be used to identify nonlinear PAs for wideband signal transmission, even at severe aliasing conditions. Simulation results show that a generic memoryless nonlinear RF power amplifier with AMAM and AMPM distortion can be successfully identified at any sampling rates. Measurement results show the modeling error variation is less than 0.8dB over any sampling rates.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2016.11a
• /
• pp.66-68
• /
• 2016

무선 통신 시스템에서 장거리 신호송출을 위해 사용하고 있는 고전력 증폭기(HPA, High Power Amplifier)는 증폭기의 비선형성 때문에 송출신호에 왜곡을 야기시키며 이 때문에 선형구간만을 사용하게 되어 그 전력 효율이 떨어지게 된다. 이 비선형 특성을 해결하기 위하여 디지털 사전 왜곡기(DPD, Digital Pre-distorter)를 HPA 의 앞단에 채용하여 송출신호를 선형화 시키고 효율도 높이게 된다. 이 DPD는 대부분 HPA를 특정 모델이라고 가정하고 최적화 알고리즘을 통해 설계되는데 HPA의 모델에 대한 가정이 맞지 않을 경우 설계된 DPD의 성능이 떨어질 수 있다. 따라서 HPA의 모델을 정확하게 아는 것은 DPD 설계에 있어서 중요한 이슈가 된다. 본 논문에서는 실제 상용되는 HPA에 대해 이미 알려진 다양한 HPA의 모델 중에서 가장 적합한 모델을 선정하고 또한 그 모델의 계수를 얻어내는 방법을 소개한다. 이렇게 얻어진 HPA의 모델정보는 최적의 DPD 설계에 사용될 수 있다. 각 HPA 모델에 대한 파라메터를 구함에 있어서 알려진 최적화 방법 이외에 직접 적용이 어려운 경우에는 기존 방식을 수정하고 그 방식을 사용하였다. 실제 HPA 의 입출력 신호를 실시간 수집하고 컴퓨터 모의실험을 수행하여 동일한 HPA 입력 신호에 대해 실제 HPA의 출력과 찾아낸 최적 모델의 출력을 비교 분석함으로써 실제 찾아낸 모델이 가장 정확하게 상용 HPA를 모델링 하고 있음을 확인하였다.

• Journal of Advanced Navigation Technology
• /
• v.10 no.1
• /
• pp.41-47
• /
• 2006

In this paper, a predistortion linearizer using the in-phase modulator is proposed. The harmonic generator of the proposed predistorter extracts a second harmonic signals. These signals are divided in-phase and quadrature-phase signals, and then amplifying each signals using variable gain amplifier. An in-phase modulator, modulate fundamental signal with second harmonic signals, generates the predistortion intermodulation distortion (IM) signals and controls amplitude and phase of them with modulation factors. As a result, this predistorter is suppressed intermodulation distortion signals of power amplifier effectively. The proposed linearizer has been implemented to operate in Cellular-band. The test results show that the third order IM is cancelled more than 20dB in case of CW 2-tone signals with ${\Delta}f$=1MHz. Also, it's improved the adjacent channel power ratio (ACPR) more than 7dB for IS-95 CDMA 1FA signals.

• Journal of Navigation and Port Research
• /
• v.27 no.5
• /
• pp.505-511
• /
• 2003

In this paper, a driving amplifier stage with 1 Watt output has been designed and fabricated, which is operating at UHF band( 470 ∼ 806 MHz) for digital TV repeater. In the driving amplifier stage, preamplifier and 1 Watt unit amplifier are integrated by one electric substrate which is 2.53 in dielectric constant and 0.8 mm thickness. When the driving amplifier stage is flown by bias voltage of 28 V DC and current of 900 mA. it has the gain of more than 53.5 dB. the gain flatness of $\pm$0.5 dB and return loss of less than -15 dB in 470 ∼ 806 MHz. Also, when two signals at 2 MHz frequency interval are input port into the driving amplifier stage with 1 Watt output, it resulted in excellent characteristics to designed specification with showing intermodulation distortion characteristics of more than 48 dBc.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.12
• /
• pp.9-15
• /
• 1994

In this paper, the linearized power amplifier using digital adaptive predistorter is implemented in order to restrict spectral spreading and adjacent channel interference. The linearized systems is composed of a DSP56001 processor that executes predistortion in baseband. 90.deg. phase shifter, power splitter/combiner, quadrature modulator/demodulator of 360MHz band, and nonlinear amplifier. A ${\pi}$/4-shift QPSK is used to modulate digital random signals. As the quantized power of baseband signal and the output of amplifier are fed to the predistorter, and predistorting values are calculated using an adaptive algorithm. In the experiment, a peak to sidelobe ratio of the linearized amplifier is improved up to 15dB in comparison with conventional nonlinear amplifier, which means that the distortion of transmitted signal is decreased and adjacent channel interference was reduced.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.2C
• /
• pp.191-199
• /
• 2006

In this paper, we propose a method to implement a predistorter of the $rho$-th order inverse filter structure to prevent signal distortion and spectral re-growth due to the high PAPR (peak-to-average ratio) of the OFDM signals and the non-linearity of high-power amplifiers. We model the memory-less non-linearity of the high-power amplifier with a polynomial model and utilize the inverse of the model, the $rho$-th order inverse filter, for the predistorter. Once the non-linearity is modeled with a polynomial, since we can determine the $rho$-th order inverse filter only with the coefficients of the polynomial, large memory is not required. To update the coefficients of the non-linear high-power amplifier model, we can use LMS or RLS algorithms. The convergence speed is high since the number of coefficients is small, and the computation is simple since manipulation of complex numbers is not necessary.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.4C
• /
• pp.403-413
• /
• 2009

We compare three predistortion methods to prevent signal distortion and spectral re-growth due to the high PAPR (peak-to-average ratio) of OFDM signal and the non-linearity of high-power amplifiers. The three predistortion methods are pth order inverse, indirect learning architecture and look up table. The pth order inverse and indirect learning architecture methods requires less memory and has a fast convergence because these methods use a polynomial model that has a small number of coefficients. Nevertheless the convergence is fast due to the small number of coefficients and the simple computation that excludes manipulation of complex numbers by separate compensation for the magnitude and phase. The look up table method is easy to implement due to simple computation but has the disadvantage that large memory is required. Computer simulation result reveals that indirect learning architecture shows the best performance though the gain is less than 1 dB at $BER\;=\;10^{-4}$ for 64-QAM. The three predistorters are adaptive to the amplifier aging and environmental changes, and can be selected to the requirements for implementation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.1
• /
• pp.33-38
• /
• 2008

The probability of an oscillation occurrence in M/W frequency conversion repeaters is low on account of the different operating frequency of the input and output signals. The probability of interference caused by the M/W frequency conversion repeaters to other systems is also low because the systems are used in the line-of-sight. Therefore M/W frequency conversion repeaters are generally used for retransmitting the signal received from base station to the islands. This paper describes the design and implementation of analog predistorter for M/W frequency conversion repeaters in mobile communications. The M/W repeaters convert IF frequency of 1010+/-10MHz to RF frequency of 11GHz. A predistorter can be designed for the M/W repeater operating in either IF or M/W frequency. In this paper IF predistorter operated in 1010MHz is designed and implemented because a M/W predistorter operated in 11GHz is difficult to implement. The IF predistorter can linearize RF modules in the repeater followed by IF stages. The performance test results show that the implemented analog predistorter improves ACPR of 10dB at the output power of 25dBm with the signal frequency of 10.805GHz.

• Journal of Satellite, Information and Communications
• /
• v.3 no.1
• /
• pp.1-7
• /
• 2008

This Paper studied the design and measured results of a flight model for Ku-Band Linearized Channel Amplifier (LCAMP) for communication satellite onboard system. All MMICs, i.e. Variable Gain Amplifier (VGA), Variable Voltage Attenuator (VVA) with analog/digital attenuator, Branch line Hybrid Coupler and Detector for Pre-distorter are fabricated using Thin-Film Hybrid process. The performance of the fabricated module is verified through Radio Frequency circuit simulations and electrical function test in space environment for flight model at 12.25 to 12.75 GHz.