• Geophysics and Geophysical Exploration
• /
• v.9 no.1
• /
• pp.19-29
• /
• 2006

The first Japanese pilot-scale $CO_2$ sequestration project has been undertaken in an onshore saline aquifer, near Nagaoka in Niigata prefecture, and time-lapse well logs were carried out in observation wells to detect the arrival of injected $CO_2$ and to evaluate $CO_2$ saturation in the reservoir. $CO_2$ was injected into a thin permeable zone at the depth of 1110m at a rate of 20-40 tonnes per day. The total amount of injected $CO_2$ was 10400 tonnes, during the injection period from July 2003 to January 2005. The pilot-scale demonstration allowed an improved understanding of the $CO_2$ movement in a porous sandstone reservoir, by conducting time-lapse geophysical well logs at three observation wells. Comparison between neutron well logging before and after the insertion of fibreglass casing in observation well OB-2 showed good agreement within the target formation, and the higher concentration of shale volume in the reservoir results in a bigger difference between the two well logging results. $CO_2$ breakthrough was identified by induction, sonic, and neutron logs. By sonic logging, we confirmed P-wave velocity reduction that agreed fairly well with a laboratory measurement on drilled core samples from the Nagaoka site. We successfully matched the history changes of sonic P-wave velocity and estimated $CO_2$ saturation a(ter breakthrough in two observation wells out of three. The sonic-velocity history matching result suggested that the sweep efficiency was about 40%. Small effects of $CO_2$ saturation on resistivity resulted in small changes in induction logs when the reservoir was partially saturated. We also found that $CO_2$ saturation in the $CO_2$-bearing zone responded to suspension of $CO_2$ injection.

• Geophysics and Geophysical Exploration
• /
• v.10 no.1
• /
• pp.98-109
• /
• 2007

Over the last twenty years, farmers in Western Australia have begun to change land management practices to minimise the effects of salinity to agricultural land. A farm plan is often used as a guide to implement changes. Most plans are based on minimal data and an understanding of only surface water flow. Thus farm plans do not effectively address the processes that lead to land salinisation. A project at Broomehill in the south-west of Western Australia applied an approach using a large suite of geospatial data that measured surface and subsurface characteristics of the regolith. In addition, other data were acquired, such as information about the climate and the agricultural history. Fundamental to the approach was the collection of airborne geophysical data over the study area. This included radiometric data reflecting soils, magnetic data reflecting bedrock geology, and SALTMAP electromagnetic data reflecting regolith thickness and conductivity. When interpreted, these datasets added paddock-scale information of geology and hydrogeology to the other datasets, in order to make on-farm and in-paddock decisions relating directly to the mechanisms driving the salinising process. The location and design of surface-water management structures such as grade banks and seepage interceptor banks was significantly influenced by the information derived from the airborne geophysical data. To evaluate the effectiveness ofthis planning., one whole-farm plan has been monitored by the Department of Agriculture and the farmer since 1996. The implemented plan shows a positive cost-benefit ratio, and the farm is now in the top 5% of farms in its regional productivity benchmarking group. The main influence of the airborne geophysical data on the farm plan was on the location of earthworks and revegetation proposals. There had to be a hydrological or hydrogeological justification, based on the site-specific data, for any infrastructure proposal. This approach reduced the spatial density of proposed works compared to other farm plans not guided by site-specific hydrogeological information.

• Journal of Intelligence and Information Systems
• /
• v.7 no.2
• /
• pp.153-177
• /
• 2001

Nowadays, product recommendation is one of the important issues regarding both CRM and Internet shopping mall. Generally, a recommendation system tracks past actions of a group of users to make a recommendation to individual members of the group. The computer-mediated marketing and commerce have grown rapidly and thereby automatic recommendation methodologies have got great attentions. But the researches and commercial tools for product recommendation so far, still have many aspects that merit further considerations. To supplement those aspects, we devise a recommendation methodology by which we can get further recommendation effectiveness when applied to Internet shopping mall. The suggested methodology is based on web log information, product taxonomy, association rule mining, and decision tree learning. To implement this we also design and intelligent Internet shopping mall support system based on agent technology and develop it as a prototype system. We applied this methodology and the prototype system to a leading Korean Internet shopping mall and provide some experimental results. Through the experiment, we found that the suggested methodology can perform recommendation tasks both effectively and efficiently in real world problems. Its systematic validity issues are also discussed.

• Economic and Environmental Geology
• /
• v.31 no.1
• /
• pp.53-57
• /
• 1998

Transient electromagnetic (TEM) method is also affected by cultural and natural electromagnetic (EM) noises, since it uses part of the broadband ($10^{-2}$ to $10^5Hz$) spectrum. Especially, predominant EM noise which affects a moving transmitter-receiver TEM system is sensor motion-induced noise. This noise is caused by the sensor motion in the earth magnetic field. The technique for reducing the sensor motion-induced EM noise presented in this paper is based on Halverson stacking. This Halverson stacking is generally used in a time-domain induced polarisation (IP) system to reject DC offset and linear drift. According to spectrum analysis of the vertical component of sensor motion-induced noise, the frequency range affected by the motion of an EM sensor is less than about 700 Hz in this study. With the decrease of the frequency, the spectral power caused by the motion of a sensor increases. For example, at the frequency of 200 Hz, the spectral power of the sensor motion-induced noise is $-90dBVrms^2$ while the spectral power of the EM noise measured with a fixed sensor on the ground is $-105dBVrms^2$, and at the frequency of 100 Hz, the spectral power of the sensor motion-induced noise is $-70dBVrms^2$ while the spectral power of the EM noise measured with a fixed sensor on the ground is $-105dBVrms^2$. With applying Halverson stacking to an artificial noise transient generated by adding a noise-free transient to sensor motion-induced noise measured without pulsing, it is shown that the filtered transient is nearly consistent with the noise-free transient within a delay time of $0.5{{\mu}sec}$. The inversion obtained from this filtered transient is in accord with the true model with an error of 5%.

• Journal of Korea Spatial Information System Society
• /
• v.9 no.1
• /
• pp.105-115
• /
• 2007

Data mining extracts interesting knowledge from a large database. Among numerous data mining techniques, research work is primarily concentrated on clustering and association rules. The clustering technique of the active research topics mainly deals with analyzing spatial and attribute data. And, the technique of association rules deals with identifying frequent patterns. There was an advanced apriori algorithm using an existing bit-clustering algorithm. In an effort to identify an alternative algorithm to improve apriori, we investigated FP-Growth and discussed the possibility of adopting bit-clustering as the alternative method to solve the problems with FP-Growth. FP-Growth using bit-clustering demonstrated better performance than the existing method. We used chess data in our experiments. Chess data were used in the pattern mining evaluation. We made a creation of FP-Tree with different minimum support values. In the case of high minimum support values, similar results that the existing techniques demonstrated were obtained. In other cases, however, the performance of the technique proposed in this paper showed better results in comparison with the existing technique. As a result, the technique proposed in this paper was considered to lead to higher performance. In addition, the method to apply bit-clustering to GML data was proposed.

• Journal of the Korean earth science society
• /
• v.28 no.2
• /
• pp.169-178
• /
• 2007

In this research we diagnosed the actual status of the 7th National science elective curriculum and suggested a way to select and organize the content of the new science elective curriculum. The first science education reform was grounded in the structuralism where the structure of discipline was valued above everything else. On the other hand, the second science education reform suggested alternative interpretations of students' opportunity to learn, putting a brake on the structuralist thinking. According to the survey result, the majority of the science elective courses are in need for revision because the contents are overcrowded, too difficult in light of students' learning readiness, failed to draw students' interest in science, and are overlapped and repeated among the 10th grade science, high school science I and II. In particular, Earth Science II and physics II are the most unfavorable courses among students. Thus, we recommended a fundamental change be made in the new curriculum in addition to the optimization of the content. In this paper, we suggested 'topic-centered content organization' for the science elective course I, i.e., Physics I, Chemistry I, Biology I and Earth Science I that is designed for both science track and non-science track students. Since curriculum provides students with an 'opportunity to learn', a curriculum study should focus on what the 'opportunity to learn' is that students ought to be offered. Based on the result of this study, we recommended one way to select and organize the content of high school elective curriculum.

• Journal of the Mineralogical Society of Korea
• /
• v.27 no.4
• /
• pp.169-181
• /
• 2014

Korea government has consistently investigated the development of economic mineral deposits in the Tofua volcanic arc, Tonga since 2008 for the secure of sea floor mineral resources. We studied the composition and distribution of minerals formed by hydrothermal activity around TA 25 seamounts of the Tofua volcanic arc, Lau Basin, Tonga, using X-ray diffraction analysis, scanning electron microscopy, X-ray fluorescence spectrometry, and inductively coupled plasma atomic emission spectrometry. We used 7 core samples and 9 surface sediment samples. Barite, sphalerite, and clinoclase are present in the most volcanic vent area. Gypsum, smectite, and kaolin mineral are distributed in vent A area, chalcopyrite, pyrite, smectite, and kaolin mineral are in vent B and C area, and gypsum, chalcopyrite, pyrite, and goethite are in vent D area. From the study of clay fraction, smectite and few kaolinite are detected in the most studied area except inner part of caldera, which suggest that argillic alteration are dominant in the volcanic vent areas. Various sulfide or arsenide minerals were found in the hydrothermal vent B, C, and D. The mineralogy and geochemistry suggest higher hydrothermal activities in volcanic vent B, C, and D compared to vent A and inner caldera area. Therefore higher probabilities of massive sulfide deposits may occur in hydrothermal vent B, C, and D.