• Tunnel and Underground Space
• /
• v.16 no.1 s.60
• /
• pp.11-25
• /
• 2006

The world's largest nucleon decay experiment facility is constructed at a depth of approximately 1,000 meters, in the Kamio Mine, Japan. The excavated cavern is consisted of a cylinder of 42.4 m high and a semi elliptical dome of 15.2 m high, with a bottom diameter of 40 m. The total excavation volume is approximately $69,000\;m^3$. Because of the character as a large cavern excavation in deep underground, there is many unknown factors in rock mechanics. Based on the results of rock test and numerical analysis, the monitoring of rock mass behavior accompanying progress of construction was performed by various instruments installed in the rock mass surrounding the cavern. The monitoring data was used in the study of measures for cavern stability.

• Explosives and Blasting
• /
• v.24 no.2
• /
• pp.1-8
• /
• 2006

In this study, a charging density has been differently applied to all holes to improve an excavated length per round on excavating a tunnel in quartzite mine and to prevent a dead pressure phenomena and sintering phenomena. A composition initiating system using simultaneously a direct initiating system and a indirect initiating system with 2 detonators in one hole has been introduced to cut holes. As a bottom part which is difficult to make a free face are charged with a higher charging density and a column part are charged with a lower charging density, the composition charging and initiating system which the power of explosives works effectively in the rock mass is developed. As the results, a dead pressure phenomena and a sintering phenomena being often produced in a hard rock or in a long hole could be prevented. Besides, the workability was improved by about 15% and the specific charge was reduced to about 20%, as an excavated length vs. a drilled length per round could be increased over 95%.

• Weed & Turfgrass Science
• /
• v.3 no.4
• /
• pp.329-335
• /
• 2014

This study was performed to study characteristics of new zoysiagarass cultivar 'Green Ever' (Plant Variety Protection Application no. 2014 - 02). 'Green Ever' was developed by selection breeding among 100 native zoysiagrasses collected in South Korea. 'Green Ever' showed specific bands (1.48 kb with OPC14 and 1.05 kb with OPD5) which were distinct from 'Anyang Joonggi' or 'Dongrae Koryogi' in RAPD analysis. 'Green Ever' was classified as Z. matrella in morphological evaluations including plant height ($6.8{\pm}0.5cm$), leaf width ($2.0{\pm}0.1mm$), height of lowest leaf ($1.9{\pm}0.1cm$) and seed length ($3.0{\pm}0.1mm$), which was similar with morphological characteristics of 'Dongrae Koryogi'. Turf quality, shoot density and chlorophyll content of 'Green Ever' were higher than them of 'Anyang Joonggi' and 'Dongrae Koryogi' under intensive management such as fairway on golf course, especially shoot densities of 'Green Ever' were excellent higher than 'Anyang Joonggi' and 'Dongrae Koryogi' during experimental periods. It could be extensively used in fairway, teeing ground of golf courses and landscape garden after further study about various environmental adaptabilities such as winter kill, wear tolerance etc.

• Applied Biological Chemistry
• /
• v.49 no.4
• /
• pp.315-321
• /
• 2006

Inhibitors of acetylcholinesterase(AchE), such as organophosphates and carbamates, interfere the action of AchE in nerve and may lead to a severe impairment of nerve functions or even death. Therefore, insect AchE is the biological target of predominant insecticides used in agriculture. Biosensors are sensitive and can be used as dispoisable sensors for environmental control. In recent years, the use of AchEs in biosensor technology has gained enormous attention, in particular with respect to insecticide detection. The principle of biosensors using AchE as a biological recognition element is based on the inhibition the catalytic activity by the agents to be detected. We here present a strip-type biosensor based on AchE inhibition. In this study, acetylcholinesterase and PVA-SbQ(polyvinyl alcohol functionalized with methyl pyridinium methyl sulfate) were co-immobilized on immobilone-P membranes. Immobilization of the enzymes showed a stability in 6 months without activity loss in $4^{\circ}C$ storage. Enzymes immobilized on surfaces of membrane responded to organophosphates and carbamate more sensitivitive than enzyme in solution. Organophosphates and carbamates concentrations could be detected by entrapped and surface immobilized enzymes, in 5 min. For chlorpyrifos, carbofuran, cabaryl, and methidathion, the detection limits of AChE-strip were similar to that of HPLC/GC method.

• The Korean Journal of Pesticide Science
• /
• v.11 no.3
• /
• pp.144-153
• /
• 2007

One of the most recent issues facing the pesticides regulatory process is the assessment of the potential for pesticides to leach through soil and appear in groundwater. Since Jeju island depends on a hydrogeologically vulnerable aquifer system as its principle source of drinking water, it is important to identify which pesticides are the most likely to result in groundwater contamination. The objective of this study was to assess groundwater contamination risk of 21 pesticides (12 insecticides, 6 herbicides and 3 fungicides) in Jeju soils using groundwater ubiquity score (GUS). Considering GUS estimated in 21 representative series of Jeju soils, generally herbicides showed relatively higher leaching potentials and insecticides showed lower leaching potentials. Groundwater contamination risk was higher in the order of bromacil > metolachlor > alachlor > linuron pretilachlor > butachlor for herbicides, carbofuran > ethoprophos > diazinone > dimethoate > penthoate > mecarbam > methidathion > endosulfan > fenitrothion > parathion > chlorpyrifos > terbufos for insecticides, and metalaxyl > chlorothalonil > triadimefon for fungicides. Among the tested pesticides alachlor, metolachlor, bromacil, ethoprophos and carbofuran were classified as the pesticides of very high or high groundwater contamination potential. Although the ranking of the leaching potential was essentially determined on the base of the intrinsic properties of the chemicals and environmental properties, variation of the relative groundwater contamination potentials of each pesticides in different soils were not significant. Therefore, the above ranking of groundwater contamination risk would be applied in most of Jeju soils. To lower the possibility of pesticide contamination of groundwater, the use of those pesticides classified as high or very high leaching potential should be strictly regulated in Jeju Island.

• Explosives and Blasting
• /
• v.39 no.3
• /
• pp.15-23
• /
• 2021

Ventilation shafts are pathways in mines and tunnels for the removal of dust or smoke during underground space construction and operation. In mines, blasting with long blast holes is preferred for the excavation of a ventilation shaft in the 10~20m long crown pillar section. In this case, the bottom part of the blast hole is completely drilled in order to determine the drilling error, and this causes a problem of lowering the explosive charge and blasting efficiency. It is possible to solve the problem of explosive loading and to increase the blast efficiency by covering the curb of the blasthole by using stemming material. In this study, simulations for the blasting of a ventilation shaft were performed with various stemming lengths and the blasthole diameters(45, 76mm) using AUTODYN 2D SPH(Smooth particle hydrodynamics) analysis technique. Also the optimal bottom stemming column was derived by checking the size of the boulder and burden line according to blasting. Analysis result, blasting efficiency is lessened in case of stemming length less than 30cm and the optimal length of the stemming material should be 30cm or higher to achieve high efficiency of blasting.

• Korean Journal of Soil Science and Fertilizer
• /
• v.41 no.3
• /
• pp.199-205
• /
• 2008

This study was carried out to find out causes of high Ni content and characteristics of potential increase of Cu and Zn contents in the soils of Jeju area. Soil samples were collected from 4 series of Alfisols, 35 series of Andisols, 9 series of Entisols, 16 series of Inceptisols, and 1 series of Ultisols, respectively. Parent material (gravel) samples were also collected from the same sites where soil samples were taken. Both soil and parent material samples were analyzed for Ni, Cu, and Zn. The average Ni content of all the soil samples was $79.2mg\;kg^{-1}$, which was exceeded warning standard for Ni against the Soil Conservation Act in Korea, whereas that of Cu and Zn contents were lower than the warning standard for Cu and Zn. The difference of Ni, Cu and Zn content was not consistent depending upon soil color. Ni content in the soil samples from Entisols was particularly high, whereas that from the other soil orders was similar to each other. Cu and Zn contents in the soil samples were similar regardless of the difference in soil order. Ni content in Seongsan Formation(SSF), Cinder cone(C) and acicular Feldspar Olivine Basalt(FOB) was high, while that in Feldspar Basalt(FB) and Trachy Andesite lava(TA) was low. Ni content in the non-agricultural land was higher compared with that in the agricultural land, whereas Cu and Zn contents in the non-agricultural land were significantly lower than that of agricultural land. The topsoil/subsoil ratios for Ni content in most of the soil samples were less than 1, while that for total contents of Cu and Zn in many of the soil samples were larger than 1 indicating potential Cu and Zn accumulation in topsoil by artificial reasons.

• Economic and Environmental Geology
• /
• v.44 no.4
• /
• pp.313-320
• /
• 2011

The Taebaegsan Mineralized District is the most prospective region for the useful mineral commodities such as a coal, non-metallic, metallic mineral in South Korea. From a general point of view, Cambro- Ordovician limestone formations, Myobong slate and Pungchon (Daegi) limestone, are the most fertilizable formations in the Taebaegsan Mineralized District. The geology around Weondong mine area consists mainly of Carboniferous-Triassic formations and Cambro-Ordovician formations intruded by rhyolite/quartz porphyry. The great overthrusted fault of N40~$50^{\circ}E$ direction, so called Weondong overthrust fault, is observed in the central part of the mine area and the NS fault system cuts the overthrusted fault. By postulating from the favorable geological and structural condition around Weondong area, the possibility of deep seated hidden ore bodies is expected. In 2010, on the basis of the results of LOTEM and CSAMT survey, the cross-hole survey was performed for the investigation of the hidden polymetallic ore body in the deep parts of the Weondong mine area and the grade of the newly-discovered orebody is as follows; (1) The cut-off grade for lead-zinc 3%; an weighted average grade 5.50% (2.7 m), (2) The cutoff grade for copper 0.1%; an weighted average grade 0.91% (14.65 m), (3) The cut-off grade for iron 30%; an weighted average grade 38.18% (3.3 m), (4) $WO_3$ for each cut-off grade(0.01%, 0.05%, 0.1%); an weighted average grade 0.29 wt. % (8.8 m), 1.15 wt. % (2.1 m), 1.97 wt. % (1.2 m), (5) $MoS_2$ for each cut-off grade(0.01%, 0.1%); an weighted average grade 0.15 wt. % (6.3S m), 0.28 wt. % (3.15 m), (6) $Ta_2O_5$ for each cut-off grade (0.01%, 0.1%); an weighted average grade 0.13% (19.S m), 1.11% (1.8 m), (7) $Nb_2O_5$ for each cut-offgrade (0.01%, 0.1%); an weighted average grade 0.06% 11.5 m), 0.15% (3.0 m).