• Journal of Korea Water Resources Association
• /
• v.51 no.8
• /
• pp.687-701
• /
• 2018

A multi-function weir is representative control structure in the stream flow. Estimation of accurate flood discharge according to gate operations and prediction of floodwave travel times at the downstream are very important in terms of water use and river management. This study analyzed the limitation and improvement through the current gate operation data on the Young-san river. in addition, flood discharge was calculated considering lower and upper water level condition and gate operating using the modified slope-area method in the Seoung-chon weir. As a result, the current state was required improvement because exceed the theoretical range and rapidly fluctuation of discharge coefficient, can not be considered difference between the upper and lower water level and the estimation by the regression equation. As a result of applying the proposed method in this study, the above mentioned limitations can be compensated, compared with the current discharge data. Also it was analyzed as more physically valid because using the evaluated hydraulic equation and estimate the slope and friction loss of natural stream by iteration and to reduce the error. In conclusion, the process carried out serves as a representative flow control point of the water system through reliable discharge estimation, it is expected that it will be possible to properly river management.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.5
• /
• pp.531-538
• /
• 2016

Driving behaviors such as speeding and illegal u-turn which violate traffic rules are main causes of car accidents, and they can lead to serious accidents. Bus drivers are less aware of dangers of illegal u-turn, and infrastructures such as traffic enforcement equipment and watchmen are deficient. This research aims to develop technology for estimating driving behaviors based on map-matching in order to prevent illegal u-turns. For this research, 23,782 of u-turn permit data and 146,000 of speed limit data are collected nationwide, and an estimation algorithm is built with these data. Then, an application based on android is developed, and finally, tests are conducted to assess the accuracy in data computations and GPS data map-matching, and to extrapolate driving behavior. As a result of the tests, the accuracy results in the map-matching is 86% and the assessment of driving behavior is 83%, while the display of the data output yielded 100% accuracy. Additional research should focus on improvement in accuracy through the development of a robust monitoring system, and study of service scenarios for technology application.

• Journal of Bio-Environment Control
• /
• v.4 no.1
• /
• pp.17-24
• /
• 1995

This study was carried out to make fundamental data for structural safety test of pipe- houses. Experiment on the stress distribution of pipe- houses was conducted to find suitable structural analysis model by examination of end support conditions of pipe. Besides, the loading test and the pile driving test were done to find pull-out capacity and bearing capacity of pipe on the assumption that pipe is pile foundation. For single span pipe - house, the theoretical results assuming the end support condition of pipe is fixed under ground agreed closely with the experimental results of stress distribution. On the other hand for double span pipe -house, the end support conditions of pipe were fixed support when vertical load is applied, and hinged one when horizontal load is applied. The pull - out capacity and allowable bearing capacity of the pipe portion that was buried in the grounds that were soft soil of paddy field and medium or hard soils of dry field derived from experimental results.

• Journal of Bio-Environment Control
• /
• v.18 no.3
• /
• pp.215-224
• /
• 2009

A survey on the actual state of heating, cooling, ventilation, and air-flow and experimental measurement of temperature and humidity distribution in tomato greenhouse were performed to provide fundamental data required in the development of air-flow control technology. In single-span plastic houses, which account for most of 136 tomato greenhouses surveyed, roof windows, ventilation and air-flow fans were installed in a low rate, and installation specs of those facilities showed a very large deviation. There were no farms installed greenhouse cooling facilities. In the hot air heating system, which account for most of heating type, installation specs of hot air duct showed also a large deviation. The exhaust air temperature and wind speed in hot air duct also were measured to have a big difference depending on the distance from the heater. We are using the maximum difference as indicator to determine whether temperature distribution is uniform. However if the temperature slope is not identical in greenhouse, it can't represent the uniformity. We analyzed relation between the maximum difference and the uniformity of temperature and humidity distribution. The uniformity was calculated using the mean and standard deviation of data from 12 measuring points. They showed high correlation but were represented differently by linear in the daytime and quadratic in the nighttime. It could see that the uniformity of temperature and humidity distribution was much different according to greenhouse type and heating method. The installation guidelines for ventilation and air-flow fan, the spread of greenhouse cooling technology for year-round stable production, and improvement of air duct and heating system, etc. are needed.

• Journal of Korean Society of Forest Science
• /
• v.96 no.1
• /
• pp.7-13
• /
• 2007

This study was done to develop PDA based application system for forest geographic information with GPS. The major results obtained in this study were as follows. A PDA based application program was developed to work on $Microsoft^{TM}$ PocketPC 2002 and 2003 operating system. The screen of PDA displays a 1:25,000 digital topographical map adopted DXF format converted from PC, and the map data with 1:2,500 to 1:30,000 on PDA can be zoomed in or out to five levels. Current position and navigating path received from GPS can be displayed on the screen and be saved in PDA. Information selected among layers of digital topographic map in DXF format can be converted into binary files which can be used on forest geographic information software. This can compress DXF files to 90% in size, and the processing speed of PDA was improved. The forest geographic information management system can be used to manage sample plots on which forest inventory is done, with the help of the sub-menus and grid index values with position information received from GPS. Forest workers can in quire forest geographic information such as forest type, location, forest roads, soil erosion control dams using forest geographic information management system in the field. The forest geographic information management system can provide current position and mobile path information to people who enjoy forest related activities like mountain-climbing, sightseeing, and visiting to historic spots.

• Journal of Bio-Environment Control
• /
• v.14 no.3
• /
• pp.166-173
• /
• 2005

This study was carried out to evaluate the structural stability in a non-heating greenhouse with a single cover for Citrus cultivation which was built up in Jeju on the basis of the drawing designed by Jejudo Agricultural Research & Extension Services and also to make use of the data for developing a standardized non-heating greenhouse in Jeju. The analysis of a structural stability was conducted by using CFX-5.7 and ANSYS under the design condition of a maximum accumulated snow-depth of 19.1 cm as well as an instantaneous maximum wind velocity of $36.6\;m{\cdot}s^{-1}$ which was set up on the basis of meteorological statistics in Jeju. As a result, the maximum von-Mises stress applied on pipes under the wind velocity of $36.6\;m{\cdot}s^{-1}$ showed a value of $250\;N{\cdot}mm^{-2}$ which was greater than the allowable stress of the pipe with a value of $235.4\;N{\cdot}mm^{-2}$ (=$2,400\;kg{\cdot}cm^{-2}$) and also $53.8\;N{\cdot}mm^{-2}$ under the snow-depth of 19.1 cm, respectively. This result suggested that the greenhouse be unstable under the design condition of an instantaneous wind velocity of $36.6\;m{\cdot}s^{-1}$ so that it was necessary for the greenhouse to be reinforced to secure the structural stability.

• The Journal of the Korea Contents Association
• /
• v.20 no.1
• /
• pp.460-469
• /
• 2020

Recently, the Supreme Court pointed out that it would be difficult to maintain the existing opinion any more because the overall conditions that were the basis of the past empirical rule were remarkably changed when estimating the lost earnings of a deceased minor. Thus, the court sentenced en banc decision to extend the maximum working age of manual laborers under the empirical rule to 65 years old. The significance of this ruling is to put an end to social confusion caused by courts' different sentences on the maximum working age under the empirical rule depending on lower court decision, and also to acknowledge the maximum working age of physical laborers by applying the new empirical rule in accordance with entering the aged society. It is still unfortunate to conclude the maximum working age as a specific age and also to estimate the lost earnings of a victim by applying the daily wages of urban laborers. Like this, this study aimed to provide the basic data for guaranteeing a proper compensation for damage to victims by analyzing the issues of rulings related to the maximum working age of manual laborers under the empirical rule, and then complementing imperfections in Korean society that has entered the aged society.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.7 no.2
• /
• pp.57-68
• /
• 2004

Recently in order to more effectively and scientifically process forest official tasks, which have been focused on documents and inventories, they should be applied with the up-to-date spatial information technologies. Especially, the forest resource information management based on GIS(geographic information system) and aerial orthophoto is expected not only to play an important role as DSS(decision support system) for domestic forest conservation policy and forestry development industry but also to service forest resource information toward people such as the owners of a mountain rapidly. In this study, the important forest information such as digital topography map, digital forest type map, digital forest cadastral map, digital aerial photographs and attribute data were first reprocessed and constructed in DBMS(data base management system). In addition, forest officials could analyze and retrieve forest information by using detail sub-application systems such as forest cadastral retrieval, forest land development information management, reserved forest information management and forest resource information retrieval. For this, the user interface is developed by using Visual Basic 6.0 and MapObjects 2.1 of ESRI based on CBD(component based development) technology. The result of developing this system will not only perform constructing economical forest and better environment but also be the foundation of domestic spatial technology for forest resource management.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.16 no.2
• /
• pp.1-15
• /
• 2013

It is important to empirically investigate the typological characteristics of subway station areas considering the comprehensive elements of transit-oriented development (TOD) planning so that its implementation can be effective in attaining both increase in transit ridership and decrease in inordinate automobile dependence. This article aims to identify diverse features of subway station areas in Seoul known for good public transit system. After collecting and manipulating the measures on planning elements such as density, diversity and accessibility for TOD planning by distance-based buffer from a subway station, the article tried to interpret analysis results on their typological characteristics. They can be summarized with two conclusions. First, characteristics of landuse and public transit system can be distinctly differentiated in the Seoul subway station areas. It implies that both planning elements should have not been integrated for now. Second, the characteristics of public transit system can be divided by modes. They provide us that public transit system in Seoul needs to be more strongly integrated than current system.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.190-193
• /
• 2015

The current sea route sign system based on an electronic marine chart only has a data manufacture specification for uses at ECDIS. Therefore, it has a limitation in expressing various sea route data and falls short of productivity as it is frozen to prevent being changed for a long time. Also, it cannot satisfy requirements from high tech such as lattice structure data and time series information. Currently, although it builds each independent operation system based S-57, it has been found that it is the most important requirement from consumers that the entire monitoring system can mutually interwork by standardizing and uniting formats of all protocols. In addition, current status information and alarm system is using AIS, TRS, WCDMA telecommunication and processing all the data after saving it into each different server. Lighthouse lantern which currently has used was utilized to do a performance test of a developed system. All of created data was trasmitted through the RS-232, It is clear that the data was received by a situation monitoring system. In addition, when the data was transmitted after saving in a database, same data was ordinarily received. In this thesis, we will implemented the status information and alarm system of Marine transportation facilities which is a sea route sign system based on S-63 electronic marine chart, S/W, after uniting each different protocol and making combined system.